Membrane fouling control by ultrasound in an anaerobic membrane bioreactor

In this study, ultrasound was used to control the membrane fouling online in an anaerobic membrane bioreactor (AMBR). Short-term running experiments were carried out under different operating conditions to explore feasible ultrasonic parameters. The experimental results indicated that when the crossflow velocity was more than 1.0 m/s, membrane fouling could be controlled effectively only by hydrodynamic methods without ultrasound. When ultrasound was applied, an ultrasonic power range of 60–150 W was suitable for the membrane fouling control in the experimental system. The experimental results showed that the membrane fouling was controlled so well that membrane filtration resistance (ΣR) could stay at 5 × 10¹¹ m⁻¹ for more than a week with the crossflow velocity of 0.75 m/s, which equaled the effect of crossflow velocity of more than 1.0 m/s without ultrasound. Translated from Techniques and Equipment for Environmental Pollution Control, 2006, 7(4): 25–29 [译自: 环境污染治理技术与设备]     

膜生物反应器膜污染的水力学控制实验研究

叙述了膜污染是影响膜-生物反应器处理技术推广应用的关键因素，采用水动力学方法是控制膜污染的有效方法。在不同污泥浓度条件下。对不同曝气强度下膜污染的发展速率及其形成机理进行了试验研究，研究结果表明：对应于不同污泥浓度均存在一个经济曝气强度，其大小随污泥浓度升高呈线性增加，膜生物反应器在经济曝气强度条件下运行可控制膜污染的发展；并从理论上推导出一个临界污泥浓度，其值为5．15g／L。对应于临界污泥浓度，并且污泥絮体在膜面可形成比较稳定的动态膜，膜过滤压差上升的速率最慢，膜生物反应器在此临界污泥浓度条件下运行膜污染发展最为缓慢。     

膜生物反应器在污水处理中的应用前景

介绍了膜及膜分离技术。膜生物反应器（MBR）的原理。综述了膜生物反应器在污染处理领域应用开发情况；指出了膜生物反应器在发展中存在的主要问题；展望了膜生物反应器技术的发展前景。     

DOM纳滤膜污染及对膜截留卡马西平性能的影响

研究了天然原水中溶解性有机物(DOM)对HL和ESNA1-K两种纳滤膜造成的膜污染及其对膜截留卡马西平(CBZ)性能的影响.结果表明,DOM的存在造成了严重的膜污染和通量衰减.膜污染对CBZ截留率的影响与膜本身的特性和污染物特性有关,DOM通过在膜表面形成污染滤饼层和进入膜孔内部造成的膜孔堵塞,影响弱疏水性的CBZ从水中的分离,青草沙水库原水中的DOM引起的膜污染提高了两种纳滤膜对CBZ的截留效果,而太湖DOM造成的膜污染会降低CBZ的截留效果.研究还发现,中等相对分子质量(1 500~10 000)有机物会紧密地黏附在膜表面形成滤饼层,从而改变膜表面的疏水性能,小分子主要通过进入膜孔导致膜孔径堵塞.滤饼层的疏水性和浓差极化作用以及膜孔径的堵塞造成膜通量衰减并影响CBZ去除率.应用XDLVO理论对DOM造成的膜污染的分析结果表明,太湖DOM的疏水性明显强于青草沙DOM,其分子间的聚合自由能更负,与膜的黏附自由能更负,因而造成的膜污染和通量衰减更严重.     

正常污泥和膨胀污泥中EPS膜污染特性及其与膜表面作用能分析

胞外聚合物(Extracellular polymeric substance,EPS)是导致膜污染的重要物质,且不同形态污泥的EPS具有不同的性质,研究正常污泥和膨胀污泥的EPS膜污染特性具有重要意义.因此,实验考察了正常污泥和膨胀污泥的膜污染速率.结果表明,膨胀污泥膜污染速率远高于正常污泥,膨胀污泥EPS(Bulking sludge-EPS,BS-EPS)浓度((172.9±10.4) mg·g-1)明显高于正常污泥EPS(Normal sludge-EPS,NS-EPS)浓度((95.9±6 6) mg·g-1),且膨胀污泥的蛋白质/多糖(Protein/Carbohydrate,P/C)值(2.26)高于正常污泥的P/C值(1 97)此外,通过序批式吸附实验研究了正常污泥和膨胀污泥的EPS膜污染差异,并基于Derjaguine-Landaue-Verweye-Overbeek (XDLVO)理论计算了EPS与PVDF膜表面之间的作用能结果表明,EPS-膜系统的总界面能为负值,即EPS-膜系统之间会发生自吸附行为,而膜与BS-EPS的总界面能(-63.943mJ.m2)较膜与NS-EPS(-56.366 mJ·m2)具有较高的能量,因此,BS-EPS与膜的吸附力较强;NS-EPS和BS-EPS主要能量壁垒分别为8.89 kT和7.51 kT,表明NS-EPS与膜之间的排斥力更强,因而BS-EPS更容易造成膜污染     

荷电超滤膜对天然有机物去除及膜污染行为的影响

以Aldrich 腐殖酸溶液为水样,研究比较了溶液环境(pH值、离子强度和钙离子)对荷电改性再生纤维素超滤膜和传统中性未改性再生纤维素超滤膜过滤过程的影响.结果表明, ①pH值主要通过质子化作用影响荷电膜以及腐殖酸分子的荷电量,进而影响荷电超滤过程.溶液pH值从7.5下降到3.5时,荷电超滤膜对腐殖酸的截留率从92%减少到79%,超滤4 h时,膜通量下降从26%增加到36%.②离子强度的改变是通过影响腐殖酸分子的物化性质和静电屏蔽作用来影响超滤过程的.当溶液离子强度为0、 3和100 mmol/L时,初始截留率依次降低,分别为92%、 87%和48%,超滤4 h时,荷电超滤膜的通量下降依次增加,分别为26%、 35%和63%.③Ca2+浓度的影响,需要综合考虑静电屏蔽作用、Ca2+的架桥作用以及滤饼层的压实性等各方面的影响.④pH值、离子强度和钙离子对中性超滤膜过滤行为的影响趋势与荷电超滤膜相似,但其影响程度有着较大的差别.研究结果对荷电超滤膜技术在实际应用中选择合适环境条件提供了参考.     

臭氧/混凝预处理工艺降低膜污染的研究

采用臭氧和混凝工艺分别处理黄浦江原水后进行MF膜过滤试验,考察2种预处理工艺对有机物的作用,进而考察其对MF膜过滤特性的影响.结果表明,2种预处理工艺都存在一个使膜污染下降率达到最大的最佳投药量.2种预处理工艺中,混凝降低膜污染的效果要好于臭氧,这主要与2种预处理工艺所去除的有机物性质有关.黄浦江水中有机物相对分子质量主要集中在3×103～5×103范围内,膜化学清洗液的分析表明造成膜污染的有机物相对分子质量主要集中在4.5×103附近,臭氧对相对分子质量在3×103附近的有机物去除效果较好,而混凝主要去除5×103附近的较大相对分子质量的有机物,因而混凝对这部分污染膜物质的去除效果要好于臭氧,从而有效降低了膜污染.     

Chemical cleaning of fouled PVC membrane during ultrafiltration of algal-rich water

Cleaning of hollow-fibre polyvinyl chloride (PVC) membrane with di erent chemical reagents after ultrafiltration of algal-rich water was investigated. Among the tested cleaning reagents (NaOH, HCl, EDTA, and NaClO), 100 mg/L NaClO exhibited the best performance (88.4% 1.1%) in removing the irreversible fouling resistance. This might be attributed to the fact that NaClO could eliminate almost all the major foulants such as carbohydrate-like and protein-like materials on the membrane surface, as confirmed by Fourier transform infrared spectroscopy analysis. However, negligible irreversible resistance (1.5% 1.0%) was obtained when the membrane was cleaning by 500 mg/L NaOH for 1.0 hr, although the NaOH solution could also desorb a portion of the major foulants from the fouled PVC membrane. Scanning electronic microscopy and atomic force microscopy analyses demonstrated that 500 mg/L NaOH could change the structure of the residual foulants on the membrane, making them more tightly attached to the membrane surface. This phenomenon might be responsible for the negligible membrane permeability restoration after NaOH cleaning. On the other hand, the microscopic analyses reflected that NaClO could e ectively remove the foulants accumulated on the membrane surface.     

Fouling distribution in forward osmosis membrane process

Fouling behavior along the length of membrane module was systematically investigated by performing simple modeling and lab-scale experiments of forward osmosis （FO） membrane process. The flux distribution model developed in this study showed a good agreement with experimental results, validating the robustness of the model. This model demonstrated, as expected, that the permeate flux decreased along the membrane channel due to decreasing osmotic pressure differential across the FO membrane. A series of fouling experiments were conducted under the draw and feed solutions at various recoveries simulated by the model. The simulated fouling experiments revealed that higher organic （alginate） fouling and thus more flux decline were observed at the last section of a membrane channel, as foulants in feed solution became more concentrated. Furthermore, the water flux in FO process declined more severely as the recovery increased due to more foulants transported to membrane surface with elevated solute concentrations at higher recovery, which created favorable solution environments for organic adsorption. The fouling reversibility also decreased at the last section of the membrane channel, suggesting that fouling distribution on FO membrane along the module should be carefully examined to improve overall cleaning efficiency. Lastly, it was found that such fouling distribution observed with co-current flow operation became less pronounced in counter- current flow operation of FO membrane process.     

曝气膜生物反应器运行过程中污泥活性特征变化及其对膜污染的影响

研究了曝气膜生物反应器运行过程中活性污泥主要活性特征变化及其对膜污染的影响.通过排出剩余污泥的办法维持活性污泥浓度在4000 mg·L-1左右,并连续运行75 d.运行期间,每日检测活性污泥的各项性质指标便于反映污泥特性的变化.结果表明,随着反应器运行时间的延长,污泥脱氢酶活性逐渐增加,其对反应器的运行有着两方面的作用,一方面会强化微生物对污染物的去除,但另一方面则导致了胞外聚合物的增加,并加速膜污染.而污泥表观产率则随着运行时间的延长先增加后有所减少,其粒径逐渐减小,且胞外聚合物呈现增加的趋势,总的出水水质情况逐渐提高,与此同时,反应器内原生动物及后生动物在运行前期较少,而在后期大量出现.膜污染分析结果表明运行后期膜污染速度明显加快,其原因在于:污泥粒径的减小以及胞外聚合物的增加导致细小颗粒及胞外聚合物堵塞或在膜表面沉积数量增加.