基于提升能源化工基地清洁生产水平的节能减排潜力分析

文章以榆林能源化工基地代表性的支柱产业为例,开展依靠科技进步提升清洁生产水平的节能减排潜力分析。分析结果表明,至"十二五"末期榆林能源化工基地的支柱产业分别将清洁生产水平提高至一级或二级,可减少的二氧化硫排放量是3 451.8吨/年和1 094.3吨/年,氮氧化物排放量是5 333.5吨/年和1 962.5吨/年。     

间隔流动分析法测定水中总磷

采用间隔流动分析法(SFA)测定地表水和城镇污水处理厂废水中的总磷,并与现行国标方法作比对,发现悬浮物对SFA法的结果存在一定的干扰,并对此进行了详细讨论且设计了一系列实验。实验结果表明使用均质机对水样均质能够有效消除悬浮物对测定结果的影响。水样经均质处理后两种方法测定结果相对误差小于3.0%。SFA法绘制的校准曲线线性大于0.999 5,标准样品的平行测定RSD≤1.5%,方法检出低限为0.009 mg/L,地表水样品加标回收率为91.4%～97.7%。     

潜流人工湿地填料筛选及其对小城镇微污染水的修复性能评价

为了选择适合小城镇潜流人工湿地的填料,选取小城镇较为常见的材料(废砖、卵石、碎石),结合物化性质,研究25℃下填料对磷的吸附效果,并分析了填料种类对野外潜流人工湿地运行的影响。结果表明:(1)25℃时,3种填料对磷的吸附量随着溶液中初始磷浓度的增加而增加,吸附能力依次为废砖>碎石>卵石;(2)野外潜流人工湿地运行过程中,随HRT的延长,组合填料湿地WL1和废砖填料WL2湿地对总磷的净化效果有所提高,且WL2湿地对总磷的去除效果略优于WL1。因此,可以选择废砖作为小城镇潜流人工湿地系统的填料。     

寒冷地区亚麻废水处理工艺的对比分析

亚麻废水是一种较难降解的废水,采用气浮-完全推流曝气工艺和UASB法处理亚麻加工厂废水,从能耗、工艺特点、运行管理上进行对比。结果表明,采用气浮-完全推流曝气工艺在处理此类废水中可收到良好成效,且废水处理成本为0.6-0.7元/m3。     

铁阳极电解脱色直接黄11染料模拟废水

研究采用铁为阳极电化学法处理直接黄11染料模拟废水脱色性能的影响进行研究。影响因素包括:电流密度、pH值、染料浓度和电解质浓度。研究结果表明,电流密度大有利于染料废水脱色,但能耗消耗大;初始溶液在中性条件下不仅取得很好的处理效果,而且脱色能耗较低;随着染料初始浓度增加脱色率和脱色能耗降低的趋势;随着电解质浓度升高染料脱色率下降的趋势,脱色能耗先减少,然后缓慢增大。在染料初始浓度50 mg/L、pH值为7.11、电流密度2.083 mA/cm2、电解质Na2SO4浓度0.01 mol/L、温度20℃、搅拌速度600 r/min、电解时间60min条件下,脱色率达到92.2%,脱色能耗1.709 kW.h/kg染料。     

城镇生活污水厂实行清洁生产途径分析

结合企业清洁生产理论,根据污水处理厂实际情况,从“节能、降耗、减排、增效”出发,详细阐述了污水厂实行清洁生产的途径。指出节约电能、新鲜水、药剂,减少污染物排放是污水处理厂清洁生产的主要出发点。并进行实例分析。     

沼液复合型杀虫剂的田间应用试验研究

通过沼液复合型杀虫剂的田间应用试验,对各种沼液复合型杀虫剂的抗病防虫性能进行了深入研究.在大田应用条件下测试了沼液复合型杀虫剂的杀虫效果.结果表明,该沼液复合型杀虫剂对蚜虫的毒杀作用均比较明显.为了推进沼液复合型杀虫剂的商业化进程,提出便于其田间应用的各种最佳配比浓度,即BP01号、BP02号、BP03号、BP04号、BP05号沼液复合型杀虫剂抗病防虫性能最佳的配比分别为9 500倍液、26000倍液、11 667倍液、22 000倍液和13 333倍液.     

人群密度对人群拥挤事故的影响

为了研究公共场所的人群密度与拥挤事故的发生概率.基于连续人群流动模型,从人群密度角度探讨了人群拥挤事故发生的机理.由于不同民族个体生理尺寸的差异,人群最大忍受密度不同,以此作为判断人群拥挤事故的标准,并结合我国情况提出我国人群最大忍受密度为9人/m2.最后模拟了某个拥挤事故场景,用该模型对其进行拥挤事故分析.结果表明,连续人群流动模型可以用于预测拥挤事故的发生,对预防和控制人群拥挤事故具有一定的指导意义.     

Experimental investigation of the e ect of flow turbulence and sediment transport patterns on the adsorption of cadmium ions onto sediment particles

The mechanism of flow turbulence,sediment supply conditions,and sediment transport patterns that affect the adsorption of cadmiumions onto sediment particles in natural waters are experimentally simulated and studied both in batch reactors and in a turbulencesimulation tank.By changing the agitation conditions,the sediment transport in batch reactors can be categorized into bottom sediment-dominated sediment and suspended sediment-dominated sediment.It is found that the adsorption rate of bottom sediment is much lessthan that of suspended sediment,but the sediment transport pattern does not affect the final(equilibrium)concentration of dissolvedcadmium.This result indicates that the parameters of an adsorption isotherm are the same regardless of the sediment transport pattern.Inthe turbulence simulation tank,the turbulence is generated by harmonic grid-stirred motions,and the turbulence intensity is quantifiedin terms of eddy diffusivity,which is equal to 9.84F(F is the harmonic vibration frequency)and is comparable to natural surfacewater conditions.When the turbulence intensity of flow is low and sediment particles stay as bottom sediment,the adsorption rateis significantly low,and the adsorption quantity compared with that of suspended sediment is negligible in the 6 h duration of theexperiment.This result greatly favors the simplification of the numerical modeling of heavy metal pollutant transformation in naturalrivers.When the turbulence intensity is high but bottom sediment persists,the rate and extent of descent of the dissolved cadmiumconcentration in the tank noticeably increase,and the time that is required to reach adsorption equilibrium also increases considerablydue to the continuous exchange that occurs between the suspended sediment and the bottom sediment.A comparison of the results ofthe experiments in the batch reactor and those in the turbulence simulation tank reveals that the adsorption ability of the sediment,andin particular the adsorption rate,is greatly over-estimated in the batch reactor.     

Kinetics of selective catalytic reduction of NO by NH3 on Fe-Mo/ZSM-5 catalyst

The catalyst of Fe-Mo/ZSM-5 has been found to be more active than Fe-ZSM-5 and Mo/ZSM-5 separately for selective catalytic reduction (SCR) of nitric oxide (NO) with NH3. The kinetics of the SCR reaction in the presence of O2 was studied in this work. The results show that the observed reaction orders were 0.74-0.99, 0.01-0.13, and 0 for NO, O2 and NH3, respectively, at 350-450℃. And the apparent activation energy of the SCR was 65 kJ/mol on the Fe-Mo/ZSM-5 catalyst. The SCR mechanism was also deduced. Adsorbed NO species can react directly with adsorbed ammonia species on the active sites to form N2 and H2O. Gaseous O2 might serve as a reoxidizing agent for the active sites that have undergone reduction in the SCR process. It is also important to note that a certain amount of NO was decomposed directly over the Fe-Mo/ZSM-5 catalyst in the absence of NH3.