Roles of manganese oxides in degradation of phenol under UV-Vis irradiation: Adsorption, oxidation, and photocatalysis

The effect of crystal structure on photocatalytic activities of manganese oxides and underlying reaction mechanism were investigated.     

中心组合设计优化S-Cr-TiO2催化剂光降解工艺条件

在确定的温度和光照条件下,采用中心组合设计法研究了固相反应法合成的硫与铬共掺杂二氧化钛(S-Cr-TiO2)光催化剂与水溶苯胺蓝(ANB)可见光降解过程中的三个作用因子:催化剂的浓度、水溶苯胺蓝水溶液的pH值及其初始浓度之间的相互作用关系,得到了影响因子与降解速率之间的回归方程及因素之间相互作用的响应面图.结果表明,S...     

吸附树脂负载铁酞菁催化降解硝基苯的研究

在可见光照射下,采用吸附树脂负载铁酞菁催化过氧化氢降解硝基苯.考察了光照、催化剂投加量、双氧水投加量、温度及pH值等因素对催化效果的影响.结果表明,在功率为50W卤钨灯照射下,硝基苯溶液初始质量浓度为200 mg/L,初始pH值为3,催化剂投加量为1.5 g/L,双氧水投加量为1.0 mL/L,温度为35℃下反应10h,硝基苯去除率可达到79.9％.     

Photocatalytic activity of Fe-doped CaTiO3 under UV-visible light

The photocatalytic degradation of methylene blue（MB） over Fe-doped CaTiO3 under UV-visible light was investigated. The as-prepared samples were characterized using X-ray diffraction（XRD）, scanning electron microscope（SEM） equipped with an energy dispersive spectrometer（EDS） system, Fourier transform infrared spectra（FT-IR）, and UV-visible diffuse reflectance spectroscopy（DRS）. The results show that the doping with Fe significantly promoted the light absorption ability of CaTiO3 in the visible light region. The Fe-doped CaTiO3 exhibited higher photocatalytic activity than CaTiO3 for the degradation of MB.However, the photocatalytic activity of the Fe-doped CaTiO3 was greatly influenced by the calcination temperature during the preparation process. The Fe-doped CaTiO3 prepared at500°C exhibited the best photocatalytic activity, with degradation of almost 100% MB（10 ppm）under UV-visible light for 180 min.     

Efficient dechlorination of chlorinated solvent pollutants under UV irradiation by using the synthesized TiO2 nano-sheets in aqueous phase

Titanium dioxide(TiO2), which is the widely used photo-catalyst, has been synthesized by simple hydrothermal solution containing tetrabutyl titanate and hydrofluoric acid. The synthesized product has been applied to photo-degradation in aqueous phase of chlorinated solvents, namely tetrachloroethene(PCE), trichloroethene(TCE) and 1,1,1-trichloroethane(TCA). The photo-degradation results revealed that the degradation of these harmful chemicals was better in UV/synthesized TiO2 system compared to UV/commercial P25 system and UV only system. The photo-catalytic efficiency of the synthesized TiO2 was 1.4, 1.8 and 3.0 folds higher compared to the commercial P25 for TCA, TCE and PCE degradation, respectively. Moreover, using nitrobenzene(NB) as a probe of hydroxyl radical(.OH), the degradation rate was better over UV/synthesized TiO2, suggesting the high concentration of.OH generated in UV/synthesized TiO2system. In addition,.OH concentration was confirmed by the strong peak displayed in EPR analysis over UV/synthesized TiO2system. The characterization result using XRD and TEM showed that the synthesized TiO2 was in anatase form and consisted of well-defined sheet-shaped structures having a rectangular outline with a thickness of 4 nm, side length of 50 nm and width of 33 nm and a surface 90.3 m2/g. XPS analysis revealed that ≡Ti-F bond was formed on the surface of the synthesized TiO2. The above results on both photocatalytic activity and the surface analysis demonstrated the good applicability of the synthesized TiO2 nano-sheets for the remediation of chlorinated solvent contaminated groundwater.     

MIL-101(Cr~(3+))可见光催化氧化降解甲基橙的研究

以金属有机多孔材料MIL-101(Cr3+)为非均相催化剂,过硫酸钠(Na2S2O8)为类Fenton体系的氧化剂,在可见光(300 W)下对甲基橙进行催化氧化降解研究。结果表明,MIL-101(Cr3+)在反应时间为120 min时对甲基橙降解率高达91.0%,且回收利用3次后仍表现出优异的降解性能(降解率达到81.0%)。同样条件下,把MIL-101(Cr3+)替换为TiO2或者不添加任何催化剂,甲基橙的降解率分别为25.6%和8.8%。采用紫外-可见漫反射光谱考察了常温下MIL-101(Cr3+)的禁带宽度大小,进一步证明其优异的光催化降解性能;同时还探讨了MIL-101(Cr3+)催化降解甲基橙的可能机理。     

TiO2/g-C3N4在泡沫陶瓷表面的负载及光催化空气净化性能增强

以市售P25(TiO_2)和g-C_3N_4为原料,以多孔氧化铝泡沫陶瓷为载体,进行了负载型光催化组件的设计与环境应用.运用浸渍提拉-热处理法制备负载P25/g-C_3N_4的泡沫陶瓷组件,对其微结构进行了表征测试,并将其应用于空气中NO的去除.结果表明,P25/g-C_3N_4在氧化铝泡沫陶瓷表面负载牢固,P25/g-C_3N_4禁带结构匹配有利于光生电荷的分离.研究了P25/g-C_3N_4比例对光催化性能的影响,当g-C_3N_4占P25的量为30%时,负载组件的光催化性能最佳,对NO的去除率达到79.6%.在5次循环反应后,负载型光催化剂表现出良好的稳定性.本研究为P25/g-C_3N_4复合光催化剂的空气净化应用提供了思路和技术基础.     

水中腐殖酸可见光降解阿特拉津的动力学研究

探讨了天然水体中存在的腐殖酸(HA)可见光降解水中阿特拉津的动力学特征和影响因素。结果表明,pH对HA可见光降解阿特拉津具有明显影响,水中HA质量浓度为5.0mg/L时,pH为3、5、7、9的条件下,受可见光照6.00h后阿特拉津(初始质量浓度5mg/L)的去除率分别为75.5%、77.3%、91.7%、84.9%,中性条件下阿特拉津可见光降解效果最佳;当HA质量浓度分别为1.5、3.0、5.0、10.0mg/L时,HA对水中阿特拉津的可见光降解均表现为促进作用,且降解过程符合一级反应动力学方程,其一级反应动力学常数分别为0.337 0、0.361 4、0.445 4、0.314 6h-1,HA为5.0mg/L时阿特拉津的可见光降解效果最佳。实际应用中,可以通过优化HA与阿特拉津的浓度比值,发挥HA促进阿特拉津可见光降解的最佳效能。     

预氧化聚丙烯腈/g-C3N4光催化降解罗丹明B

以聚丙烯腈(PAN)和g-C_3N_4为原料,采用超声波辅助分散的溶液浸渍法及煅烧法制备了具有共轭结构的预氧化聚丙烯腈/g-C_3N_4复合光催化剂(CPAN/g-C_3N_4),采用XRD、SEM、FTIR、UV-Vis DRS、EIS等技术对光催化剂进行了表征,考察了CPAN/g-C_3N_4对罗丹明B(Rh B)的可见光催化降解性能。结果表明:CPAN与g-C_3N_4具有良好的协同作用,使g-C_3N_4片状结构堆叠体颗粒显著减小,明显增强了光催化剂在全部光谱范围内的光吸收,有效提高了光生电子-空穴分离效率;在PAN与g-C_3N_4质量比为1∶200、煅烧温度250 ℃、煅烧时间1 h条件下所制备的CPAN/g-C_3N_4光催化活性最高,且具有良好的光催化活性稳定性。超氧自由基和光生空穴为CPAN/g-C_3N_4复合光催化剂光降解罗丹明B的主要活性物种。