废干电池填埋处理的重金属浸出特征及健康风险评估

以醋酸缓冲溶液和垃圾填埋场渗滤液为浸提剂,运用翻转振荡法与静置法模拟废干电池进入垃圾填埋场后,重金属从废干电池中浸出的情形,并对废干电池与生活垃圾一起填埋处理的健康风险进行了评估。结果表明:不同实验条件下,废干电池中金属的浸出浓度与废干电池的破碎程度密切相关,废干电池破碎程度越大,电池中金属的浸出浓度越高,因而废干电池与生活垃圾一起填埋处理的健康风险也越高。以静置实验结果为依据,对废干电池与生活垃圾一起填埋处理的健康风险进行评估,表明废干电池与生活垃圾一起填埋处理的健康风险指数小于1,因此废干电池与生活垃圾可以一起填埋处理。     

Reaction mechanism and metal ion transformation in photocatalytic ozonation of phenol and oxalic acid with Ag+/TiO2

Photocatalytic ozonation of phenol and oxalic acid （OA） was conducted with a Ag^＋/TiO2 catalyst and different pathways were found for the degradation of different compounds. Ag^＋ greatly promoted the photocatalytic degradation of contaminants due to its role as an electron scavenger. It also accelerated the removal rate of OA in ozonation and the simultaneous process for its complex reaction with oxalate. Phenol could be degraded both in direct ozonation and photolysis, but the TOC removal rates were much higher in the simultaneous processes due to the oxidation of hydroxyl radicals resulting from synergetic effects. The sequence of photo-illumination and ozone exposure in the combined process showed quite different effects in phenol degradation and TOC removal. The synergetic effects in different combined processes were found to be highly related to the properties of the target pollutants. The color change of the solution and TEM result confirmed that Ag＋ was easily reduced and deposited on the surface of Tit2 under photo-illumination, and dissolved again into solution in the presence of ozone. This simple cycle of enrichment and distribution of Ag^＋ can greatly benefit the design of advanced oxidation processes, in which the sequences of ozone and photo-illumination can be varied according to the needs for catalyst recycling and the different properties of pollutants.     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines

This study investigated the filtration and continuous regeneration of a particulate filter system on an engine test bench, consisting of a diesel oxidation catalyst（DOC） and a catalyzed diesel particulate filter（CDPF）. Both the DOC and the CDPF led to a high conversion of NO to NO2 for continuous regeneration. The filtration efficiency on solid particle number（SPN） was close to100%. The post-CDPF particles were mainly in accumulation mode. The downstream SPN was sensitively influenced by the variation of the soot loading. This phenomenon provides a method for determining the balance point temperature by measuring the trend of SPN concentration.     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

Mo-modified Pd/Al2O3 catalysts for benzene catalytic combustion

Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction（XRD）, X-ray photoelectron spectroscopy（XPS）, temperatureprogrammed desorption of NH3（NH3-TPD）, H2temperature-programmed reduction（H2-TPR）, and high-angle annular dark-field scanning transmission electron microscopy（HAADF-STEM）. The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion.     

FBC-DPF在柴油机颗粒物控制中的应用研究

目前针对加装FBC-DPF(燃油添加剂-柴油机颗粒捕集器)后的柴油机放特性研究较少,并且缺乏FBC-DPF对颗粒物中PAHs排放量的影响效果研究.为全面评估加装FBC-DPF后柴油机颗粒物排放特性和FBC-DPF对柴油机尾气中的颗粒物排放污染控制效果,在发动机台架上对装有FBC-DPF的重型柴油机进行了颗粒物排放特性试验.利用电子低压撞击仪(ELPI)测量加装FBC-DPF前、后柴油机颗粒物的数浓度与粒径分布,用玻璃纤维滤膜采集加装FBC-DPF前、后尾气中的固相PAHs,利用色谱质谱联用仪对加装FBC-DPF前、后尾气中的固相PAHs进行定量分析.结果表明:①加装FBC-DPF后柴油机排放的颗粒物数浓度大幅降低,FBC-DPF对尾气中颗粒物的捕集效率平均值在95%左右;②加装FBC-DPF后柴油机固相PAHs总比排放量有所降低,在大负荷区域降幅在25.0%～88.0%之间;③加装FBC-DPF前的颗粒物中位直径为30～89 nm,而加装FBC-DPF后的颗粒物中位直径为41～98 nm,平均增幅为38.2%.对于国Ⅳ及未来国Ⅴ柴油机排放法规,FBC-DPF是解决柴油机颗粒物排放的有效手段;此外,FBC-DPF可以大幅降低柴油机尾气中的有毒成分,并且能够适应高含硫量的燃油环境.     

失效催化剂的问题有多大？

四川大学化学学院教授、催化材料研究所所长陈耀强指出．汽车行驶10万公里以后,催化剂逐渐失去作用。而中国车主没有更换尾气净化催化剂的习惯。政府也没有强制措施,导致大量催化剂失效的车辆仍在行驶．加剧了机动车排放污染。     

SCR催化剂对汞的催化氧化研究进展

文章综述了目前国内外选择性催化还原(SCR)催化剂催化氧化燃煤烟气中汞的研究现状。介绍了钒基、铜基、铁基、锰基、铈基以及贵金属SCR催化剂对汞的催化氧化性能;分别分析了烟气温度、烟气组分(Cl2、HCl、SO2、NH3等)、空速等因素对各催化剂汞氧化性能的影响;最后运用文献对比方法综合概括了燃煤烟气条件对汞氧化的影响,并结合我国燃煤电厂现状,对SCR催化脱汞技术的发展方向提出建议:利用SCR催化剂实现燃煤烟气中汞的氧化,结合现有污染物控制设备实现汞的脱除,是一种经济、高效的燃煤烟气脱汞技术;当前应深入研究SCR催化剂对汞的催化氧化机理,开发能够实现NOx与汞协同控制的,稳定、高效、普适性强的低温SCR催化剂。     

MIL-101(Cr~(3+))可见光催化氧化降解甲基橙的研究

以金属有机多孔材料MIL-101(Cr3+)为非均相催化剂,过硫酸钠(Na2S2O8)为类Fenton体系的氧化剂,在可见光(300 W)下对甲基橙进行催化氧化降解研究。结果表明,MIL-101(Cr3+)在反应时间为120 min时对甲基橙降解率高达91.0%,且回收利用3次后仍表现出优异的降解性能(降解率达到81.0%)。同样条件下,把MIL-101(Cr3+)替换为TiO2或者不添加任何催化剂,甲基橙的降解率分别为25.6%和8.8%。采用紫外-可见漫反射光谱考察了常温下MIL-101(Cr3+)的禁带宽度大小,进一步证明其优异的光催化降解性能;同时还探讨了MIL-101(Cr3+)催化降解甲基橙的可能机理。