铁离子掺杂TiO2薄膜光催化降解无水肼废水的研究

研究Fe^3＋掺杂的TiO2薄膜对无水脐废水光催化降解作用,考察了影响Fe^3＋掺杂的TiO2薄膜光催化降解无水肼废水的效果的相关因素,结果表明：当Fe^3＋掺杂TiO2薄膜的摩尔分数为0．5％,煅烧温度为500℃,煅烧时间为3h,并且无水肼废水为中性或弱碱性,催化降解温度在30℃左右时,Fe^3＋掺杂的TiO2薄膜的催化效果最好。     

溶胶-凝胶掺杂铁对微弧氧化TiO_2膜光催化性能影响

以磷酸钠为电解液,采用微弧氧化技术在钛片上直接制备TiO2膜,利用溶胶-凝胶法和硝酸铁掺杂方法对该膜表面进行修饰处理,以罗丹明B溶液模拟废水来评价TiO2膜光催化降解水中有机污染物的能力。利用EDX对微弧氧化膜表面成分进行分析。实验结果表明:微弧氧化TiO2膜具有一定的光催化活性。溶胶-凝胶法负载TiO2且硝酸铁掺杂处理后可以使铁离子进入微弧氧化TiO2负载膜,改善膜的光催化性能。溶胶-凝胶法负载TiO2膜对废水的光催化降解效率由13.8%提高到42.5%;铁离子掺杂1%可以使负载TiO2膜对废水的光催化效率由42.5%提高到68.9%。     

Photocatalytic performance of TiO2 catalysts modified by H3PW12O40, ZrO2 and CeO2

The binary composite photo-catalysts CeO2/TiO2, ZrO2/TiO2 and the ternary composite photo-catalysts H3PW12O40-CeO2/TiO2,H2PW12O40-ZrO2/TiO2 were prepared by sol-gel method. The catalysts were characterized by thermogravimetric-differential thermal analysis (TG-DTA), scanning electron microscopy (SEM) and X-ray diffraction (XRD). The photocatalyfic elimination of methanol was used as model reaction to evaluate the photocatalytic activity of the composite catalysts under ultraviolet light irradiation. The effects of doped content, activation temperature, time, initial concentration of methanol and gas flow rate on the catalytic activity were investigated. The results showed that after doping a certain amount of CeO2 and ZrO2, crystaniTation process of TiO2 was restrained, particles of catalysts are smaller and more uniform. Doping ZrO2 not only significantly improved the catalytic activity, but also increased thermal stability. Doping H3PW12O40 also enhanced the catalytic activity. The catalytic activities of binary and ternary composite photocatalysts were significantly higher than tin-doped TiO2. The dynamics law of photocatalytic reaction over the binary CeO2/TiO2 and ZrO2/TiO2 catalysts has been studied. The activation energy 15.627 and 15.631 kJ/mol and pre-exponential factors 0.5176 and 0.9899 s-1 over each corresponding catalyst were obtained. This reaction accords to the first order dynamics law.     

Preparation methods and thermal stability of Ba-Mn-Ce oxide catalyst for NOx-assisted soot oxidation

Manganese oxide-loaded and -doped ceria as well as the corresponding barium-modified oxide catalysts were prepared for soot oxidation in the presence of NOx, and were characterized by using X-ray diffraction, Brunauer-Emmett-Teller and NO temperatureprogrammed oxidation measurements. The activity of catalyst depended strongly on the NO2 production capacity, and the importance of surface nitrates was weakened without heat transfer limitations. The formation of perovskite-type oxides after the high-temperature calcination caused the loss of NOx storage capacity for the Ba-modified catalysts, but did not seem to affect the NO oxidation activity obviously. The addition of barium did not prevent the phase separation of MnOx-CeO2 solid solutions, whereas it inhibited the sintering of oxide crystallites effectively. This, as well as the relatively high surface area, resulted in a small increase in soot oxidation temperature for the thermally aged Ba/Mn-Ce catalyst.     

Fe_3O_4@SiO_2复合气凝胶的制备及其对刚果红的吸附

以Fe Cl_3·6H_2O和正硅酸四乙酯为原料,通过溶胶-凝胶法结合醇溶剂热法制备了Fe_3O_4@Si O_2复合气凝胶。采用XRD,FTIR,SEM,EDS等技术对Fe_3O_4@Si O_2的结构进行了表征。考察了Fe_3O_4@Si O_2对刚果红溶液的吸附性能。表征结果显示,Fe_3O_4@Si O_2复合气凝胶是由直径为10~20 nm的近球形颗粒组装而成的具有三维网络结构的纳米材料,比表面积为457.93 m~2/g,平均孔径为10.7 nm。在溶液p H为5、吸附时间为35 min的最佳工艺条件下,采用Fe_3O_4@Si O_2吸附处理质量浓度为10 mg/L的刚果红溶液,刚果红去除率为99.39%,此时溶液中刚果红的质量浓度仅为0.052 mg/L。Fe_3O_4@Si O_2复合气凝胶吸附刚果红后具有较好的解吸和再生能力。     

富氧条件下在Ag/Al2O3催化剂上C3H6选择性还原NO

比较富氧条件下,Ｃ₃Ｈ₆ 在溶胶－凝胶和浸渍２种方法制备的Ａｇ／Ａｌ₂Ｏ₃ 催化剂上还原ＮＯ的活性和热稳定性． 结果表明,从活性角度考虑,采用溶胶－凝胶法制备Ａｇ／Ａｌ₂Ｏ₃ 催化剂时,最佳Ａｇ 负载量（ｗｔ）为４％ ～６％ ,其最大活性与浸渍法制备的２％ Ａｇ／Ａｌ₂Ｏ₃ 催化剂相同,而溶胶－凝胶法制备的催化剂有更宽的活性温度范围． 随着焙烧温度提高,溶胶－凝胶法制备的Ａｇ／Ａｌ₂Ｏ₃ 催化剂的比表面和活性下降比浸渍法慢．此外,还考察了气氛中含有ＣＯ对Ａｇ／Ａｌ₂Ｏ₃ 催化剂活性的影响,结果表明活性降低,其原因可能是活性高的氧化态Ａｇ 被ＣＯ部分还原为活性低的还原态Ａｇ．     

基于氧猝灭的有机改性溶胶-凝胶微生物传感器测定BOD的研究

通过有机改性溶胶凝胶PVA包埋方法固定微生物菌株，以氧光化学传感器作为二次传感，制备了响应良好的光化学BOD微生物传感器．在此基础上，考察了微生物传感膜的活化浓度、温度、pH、无机盐及部分金属离子对传感器响应的影响．并对传感器的重现性、储存稳定性和线性范围进行了考察，实验结果表明BOD含量在0—100mg/L浓度范围内与传感器的荧光值成线性关系，传感膜的响应活性保持较好，具有较长的使用寿命和良好的稳定性．     

氧化铈/活性炭催化臭氧氧化技术去除水中邻苯二甲酸二甲酯

用浸渍法在活性炭(AC)上负载氧化铈(CeO2)制备催化刺CeO2/AC催化臭氧氧化去除邻苯二甲酸二甲酯(DMP),考察了臭氧投加量,DMP初始浓度和溶液初始pH的影响.结果表明,CeO2/AC催化臭氧氧化去除DMP的最佳臭氧投加量为50mg/h,DMP初始浓度和溶液初始pH对CeO2/AC催化臭氧氧化DMP过程都有一定的影响.在DMP初始质量浓度为30 mg/L、溶液初始pH为5、臭氧投加量为50 mg/h、反应60 min时,CeO2/AC的加入(1.5g/L)有利于催化臭氧氧化DMP过程中总有机碳(TOC)的去除,TOC去除率由AC催化臭氧氧化的48%提高到68%.而单独臭氧氧化过程中的TOC去除率仅22%;且单独臭氧氧化与AC、CeO2/AC催化臭氧氧化DMP的矿化过程均符合二级反应动力学方程,CeO2/AC催化臭氧氧化DMP时TOC降解的二级反应动力学常数为0.0015L/(mg·min),分别是AC催化臭氧氧化的2.5倍和单独臭氧氧化的7.5倍.     

纳米Au/TiO2复合物光催化降解亚甲基蓝

以纳米金棒为掺杂物,采用溶胶-凝胶法制备了纳米Au/TiO2复合材料,在紫外光下对亚甲基蓝溶液进行光催化降解。结果表明,在紫外光下,Au/TiO2复合物对亚甲基蓝的脱色率最高可达99.6%,是纯TiO2的1.3倍。这主要归结于掺杂纳米尺寸的Au可增加TiO2对光的吸收以及减少电子-空穴对的复合,由此提高其光催化能力。     

氧化铈基催化剂在气相挥发性有机物降解领域的研究进展

挥发性有机化合物(VOCs)作为大气污染物的主要来源日益受到关注.催化氧化技术被认为是最有效的VOCs降解方法之一,其核心是催化剂.氧化铈(CeO2)基催化剂因具有良好的储氧和释氧能力、价格相对低廉而备受关注.本文在论述CeO2基催化剂降解VOCs机理的基础上,分别从单一CeO2和CeO2基复合金属或金属氧化物两个方面...