间隔流动分析法测定水中总磷

采用间隔流动分析法(SFA)测定地表水和城镇污水处理厂废水中的总磷,并与现行国标方法作比对,发现悬浮物对SFA法的结果存在一定的干扰,并对此进行了详细讨论且设计了一系列实验。实验结果表明使用均质机对水样均质能够有效消除悬浮物对测定结果的影响。水样经均质处理后两种方法测定结果相对误差小于3.0%。SFA法绘制的校准曲线线性大于0.999 5,标准样品的平行测定RSD≤1.5%,方法检出低限为0.009 mg/L,地表水样品加标回收率为91.4%～97.7%。     

LNAPL在砂质含水层中动态迁移的电阻率法监测试验研究

在海滨潮间带采集细砂,通过室内柴油泄漏模拟试验,利用自制电阻率监测系统对轻非水相液体在砂土-地下水系统垂向渗透过程进行电阻率变化动态监测;通过配制不同含油率砂土测定其静态电阻率变化规律,探讨电阻率变化的影响因素;最后取样分析测定污染含水介质稳定后含水率及含油率,对监测结果有效性进行了验证;并利用显微成像法对污染砂土进行了微观形态分析.结果表明,柴油污染砂土微观形态上胶结现象明显;柴油渗透海滨砂土过程电阻率大小同含水饱和度,比电阻率和含油饱和度之间存在良好的相关性,均可用Archie公式拟合,n值分别为2.36和0.15;通过电阻率测定可以有效估算柴油透镜体厚度;电阻率随深度的变化可以反映含油率和含水率的垂向分布.本研究为轻质油品储罐或者海上油品输运过程泄露造成的海滨砂土地下污染扩散过程监测及机制研究提供了一种有效的方法,也可为其他典型石油泄漏污染场地的电阻率法探测或监测提供参考.     

人群密度对人群拥挤事故的影响

为了研究公共场所的人群密度与拥挤事故的发生概率.基于连续人群流动模型,从人群密度角度探讨了人群拥挤事故发生的机理.由于不同民族个体生理尺寸的差异,人群最大忍受密度不同,以此作为判断人群拥挤事故的标准,并结合我国情况提出我国人群最大忍受密度为9人/m2.最后模拟了某个拥挤事故场景,用该模型对其进行拥挤事故分析.结果表明,连续人群流动模型可以用于预测拥挤事故的发生,对预防和控制人群拥挤事故具有一定的指导意义.     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

连续流动氢化物发生原子荧光法测定水中硒

文章介绍连续流动一氢化物发生一原子荧光测定水中硒的方法,研究了盐酸浓度、硼氢化钾浓度、灯电流、光电倍增管负高压、泵速、载气和屏蔽气流量等对测定硒的影响,找出测定水中硒最佳条件,在最佳条件下,校准曲线相关系数为0.9999.方法检出限为0.0095μg/L,方法的测量范围为0.038-300μg/L,回收率在91.8%-...     

餐饮废油均相法制取生物柴油研究进展

阐述了餐饮废油(WCO)制备生物柴油的均相催化方法,介绍了餐饮废油生物柴油的特性和排放性能,并展望了生物柴油生产的发展趋势.     

模拟环境条件下δ-MnO_2氧化As(Ⅲ)的搅拌流动动力学特征

采用搅拌流动法研究了酸性水钠锰矿及水羟锰矿2种δ-MnO2矿物氧化As(Ⅲ)的动力学过程,构建了可用于多相体系的搅拌-流动氧化还原反应动力学模型.经过As吸附量的校正后,该模型对酸性水钠锰矿及水羟锰矿氧化As(Ⅲ)动力学数据拟合度分别为0.980和0.951,模型拟合得到pH 7时2种矿物单位比表面上氧化As(Ⅲ)的初始反应速率常数k分别为0.131,0.014min-1·m-2.相比而言,该速率常数明显高于批量法得到的表观速率常数kobs,0.021,0.001min-1?m-2更接近真实的化学动力学参数.搅拌流动法与批量法得到的不同矿物的速率常数大小趋势一致,即尽管酸性水钠锰矿对As(Ⅲ)的氧化率低于水羟锰矿,单位比表面上酸性水钠锰矿氧化As(Ⅲ)初始反应速率却远高于水羟锰矿.反应过程分析表明,反应初始阶段,As(Ⅲ)的吸附为主要限速步骤;而随着反应的进行,矿物表面反应位点逐渐钝化或减少,反应位点数量成为限速步骤.     

Aerobic granules cultivated and operated in continuous-flow bioreactor under particle-size selective pressure

A novel method based on the selective pressure of particle size （particle-size cultivation method, PSCM） was developed for the cultivation and operation of aerobic granular sludge in a continuous-flow reactor, and compared with the conventional method based on the selective pressure of settling velocity （settling-velocity cultivation method, SVCM）. Results indicated that aerobic granules could be cultivated in continuous operation mode by this developed method within 14 days. Although in the granulation process, under particle-size selective pressure, mixed liquor suspended solids （MLSS） in the reactor fluctuated greatly and filamentous bacteria dominated the sludge system during the initial operation days, no obvious difference in profile was found between the aerobic granules cultivated by PSCM and SVCM. Moreover, aerobic granules cultivated by PSCM presented larger diameter, lower water content and higher specific rates of nitrification, denitrifieation and phosphorus removal, but lower settling velocity. Under long term operation of more than 30 days, aerobic granules in the continuous-flow reactor could remain stable and obtain good chemical oxygen demand （COD）, NH4^＋-N, total nitrogen （TN） and total phosphorus （TP） removal. The results indicate that PSCM was dependent on the cultivation and maintenance of the stability of aerobic granules in continuous-flow bioreactors.     

硅胶表面壬基酚印迹材料的制备及其固相萃取应用

采用表面分子印迹技术,以壬基酚为模板分子,4-乙烯吡啶为功能单体,乙二醇二甲基丙烯酸酯为交联剂,通过溶胶凝胶法在无定型硅胶表面合成了壬基酚分子印迹聚合物。通过扫描电镜和红外光谱表征证明成功在硅胶表面合成了表面印迹聚合物。对印迹聚合物吸附性能考察的结果表明,该印迹聚合物对壬基酚仅15 min左右达到吸附平衡,去除率达75.13%,具有明显的快速吸附性和良好的选择吸附性。与C18柱相比,该分子印迹聚合物为填料的固相萃取柱对纺织品中的壬基酚具有显著的选择性分离和富集的能力,对壬基酚的加标回收率为86.4%~95.3%,相对标准偏差为2.8%~4.9%,表现出较高的回收率和准确性。     

流动注射系统测定海水中Cr~(6+)

设计了Cr6+流动注射自动在线检测系统,并对海水中Cr6+含量的检测条件进行了优化。本系统采用二苯碳酰二肼(DPC)比色原理,通过流动注射技术,结合光电检测、数字信号处理及自动化控制技术,实现了样品的全自动化分析。结果证明,本系统测定速度快(60样/时),线性范围宽(0.004~1.00 mg/L),检出限低(2.17μg/L),精密度高(RSD7.62%),实际水样的加标回收率为92.0%~100.8%。该系统具有简便快速、灵敏稳定、经济环保等优点,适用于海水、地表水、污水等各种水质中Cr6+的在线监测。