Adsorption characteristics of humic acid-immobilized amine modified polyacrylamide/bentonite composite for cationic dyes in aqueous solutions

Humic acid-immobilized amine modified polyacrylamide/bentonite composite (HA-Am-PAA-B) was prepared and used as an adsorbent for the adsorption of cationic dyes (Malachite Green (MG), Methylene Blue (MB) and Crystal Violet (CV)) from aqueous solutions. The polyacrylamide/bentonite composite (PAA-B) was prepared by intercalative polymerization of acrylamide with Nabentonite in the presence of N,N0-methylenebisacrylamide as a crosslinking agent and hexamethylenediammine as propagater. PAA-B was subsequently treated with ethylenediammine to increase its loading capacity for HA. The surface characterizations of the adsorbent were investigated. The adsorbent behaved like a cation exchanger and more than 99.0% removal of dyes was detected at pH range 6.0–8.0. The capacity of HA-Am-PAA-B was found to decrease in the following order: MG > MB > CV. The kinetic and isotherm data were interpreted by pseudo-second order rate equation and Freundlich isotherm model, respectively. Experiments were carried out using binary solute systems to assess the competitive adsorption phenomenon. The experimental isotherm data for each binary solute combination of MG, MB and CV were analyzed using Sheindrof-Rebhun-Sheintuch (SRS) (multicomponent Freundlich type) equation.     

Infiltration characteristics of non-aqueous phase liquids in undisturbed loessal soil cores

The widespread contamination of soils and aquifers by non-aqueous phase liquids (NAPL), such as crude oil, poses serious environmental and health hazards globally. Understanding the infiltration characteristics of NAPL in soil is crucial in mitigating or remediating soil contamination. The infiltration characteristics of crude and diesel oils into undisturbed loessal soil cores, collected in polymethyl methacrylate cylindrical columns, were investigated under a constant fluid head (3 cm) of either crude oil or diesel oil. The infiltration rate of both crude and diesel oils decreased exponentially as wetting depth increased with time. Soil core size and bulk density both had significant effects on NAPL infiltration through the undisturbed soil cores; a smaller core size or a greater bulk density could reduce oil penetration to depth. Compacting soil in areas susceptible to oil spills may be an effective stratage to reduce contamination. The infiltration of NAPL into soil cores was spatially anisotropic and heterogeneous, thus recording the data at four points on the soil core is a good stratage to improve the accuracy of experimental results. Our results revealed that crude and diesel oils, rather than their components, have a practical value for remediation of contaminated loessal soils.     

阳离子聚丙烯酰胺（PAM）改善污泥脱水性能的研究

通过对污泥含水率的测定和滤液蛋白质的测定,考察了阳离子聚丙烯酰胺（PAM）对污泥脱水性能的影响。结果表明,PAM能够改善污泥的脱水性能,最佳的投加量为0.96mg/g,污泥的含水率73.38%。通过激光粒度分析研究PAM对污泥的作用机理,发现投加PAM之后,污泥的絮体变大,占体积分数90%的颗粒粒径大于206.170μm,明显的大于原泥。实验表明,PAM是通过＂架桥吸附＂和＂水化作用＂改善污泥的脱水性能。     

H2O2氧化提高含聚污水悬浮固体测定值准确性研究

重量法测定含聚采油污水过程中呈网络结构的聚丙烯酰胺(HPAM)分子在滤膜上滞留,引起污水中无机阳离子及平衡电荷的无机阴离子截流在滤膜表层,导致悬浮固体测定值偏高。针对这一问题,笔者研究了利用过氧化氢(H2O2)预氧化处理聚驱污水,重量法测定预处理后水样中悬浮固体新方法,并将其应用于现场水样测定中,效果良好。     

SiO_2对PVDF/PMMA/TPU五孔膜结构与性能的影响

在PVDF/PMMA/TPU铸膜液中添加SiO2,采用相转化法制备有机/无机共混五孔膜,并经接触角实验、扫描电子显微镜、超滤实验和拉伸实验分别对不同SiO2添加量下膜的亲水性能、微观结构、超滤性能和机械性能进行了分析。结果表明,当SiO2添加量为0.5%时,膜的亲水性较好,结构形态也有所改善,此时纯水通量为164.8 L/(h.m2),同时截留率可达76.8%,膜的拉伸性能也有所提高;但是SiO2含量过高的情况下,膜的各项性能指标会因SiO2颗粒的团聚现象而下降。     

涡凹气浮在化工区污水处理厂中的应用

摘要：化工园区中炼油、皮革、植物油生产与精炼、电镀、印染等的固体悬浮物、油脂及各种胶状物均需有效去除,防止污染水体．气浮单元去除各种工业废水中油脂及各种胶状物效果较好,现其广泛应用于工业废水的处理工艺中。汉沽现代产业区污水处理厂进水中总油含量较高,严重影响后续MBR．单元的运行,因此在生化池前增加气浮单元已保证MBR．膜组正常运行。此文章介绍了污水处理厂在气浮单元上的选择,通过对油的去除率来选择混凝剂和助凝剂及相应的药品投加量。     

灰色聚类法在闽江闽清段水质评价中的应用

本文应用灰色类聚法对闽江闽清段河流2004-2008年水质指标中5个污染因子进行了水质综合评价,结果表明:2004-2008年以来闽江闽清段的水质良好,可以作为饮用水源;从2004年起水质逐年变好,但是2008年则状况不佳.该研究可为水资源的管理提供科学依据.     

聚硅氧烷添加剂的合成研究

聚烷氧基硅氧烷一般是由正硅酸甲酯或正硅酸乙酯水解缩聚制得.选择了反应活性小,水解速度较易控制的正硅酸乙酯,制备了稳定的聚乙氧基硅氧烷.简要介绍了正硅酸乙酯水解缩聚的反应机理,分析了水用量和催化剂用量对合成反应以及产物的影响.     

海水中活性硅酸盐的流动注射-分光光度快速测定法及其应用

基于酸性条件下硅酸盐与钼酸铵反应生成硅钼黄而后被还原成硅镅蓝的原理,利用流动注射分析技术,建立了快速测定海水中活性硅酸盐的分析方法.在优化的条件下,方法检测限为0.5 μmol·L-1,线性范围为2.5～110.0 μmol·L-1,实际海水的加标回收率为103.6%～109.3%,同一水样连续测3次仅需4.5 min...     

共振散射光谱法测定部分水解聚丙烯酰胺的水解度

在1.0 mol/L醋酸介质中,部分水解聚丙烯酰胺(HPAM)与次氯酸钠溶液作用生成疏水性的氯酸胺微粒,该微粒体系在480nm处产生强的共振散射峰。HPAM的酰胺基团浓度在1.12~56.0 mg/L范围内与480nm处共振散射光强度成线性关系,检出限为0.21 mg/L。研究了共存物质对共振散射光谱法测定HPAM酰胺基浓度的影响,该方法的选择性较好,应用于样品中HPAM水解度的测定,结果满意。