有机改性成都粘土预处理垃圾渗滤液

以成都粘土为原料,十六烷基三甲基溴化铵(HDTMA)为改性剂制备有机改性土,并将其应用于垃圾渗滤液的预处理。采用单因素静态吸附实验,以粘土对垃圾渗滤液COD和氨氮的去除率作为考查指标,初步探究有机改性土预处理垃圾渗滤液的适宜条件;并对有机改性粘土及原土进行性能表征,初步分析其吸附机理。研究结果表明,有机土的处理效果明显优于原土,处理效果上比原土提高了1.6~2.3倍;有机土预处理垃圾渗滤液适宜条件为:投加量120 g/L、搅拌速度200 r/min、搅拌时间50 min、pH=7、静置时间为6 h。     

MCM-41介孔分子筛的合成及其对铜离子的吸附性能简

以微硅粉为硅源,CTAB和PEG-6000为模板剂,合成MCM-41介孔分子筛。采用XRD、N₂吸附-脱附曲线、FTIR以及TEM表征了其结构、比表面积、孔径分布及晶体形貌,并且以该样品为吸附剂,对含Cu²⁺的溶液进行了静态吸附实验。结果表明,以微硅粉为硅源成功合成了具有典型六方排列孔道结构的MCM-41,其比表面积为869.5 m²/g,孔容为0.97 cm³/g,平均孔径为3.3 nm;溶液pH为5~6时,MCM-41对Cu²⁺的去除效果最好;MCM-41对Cu²⁺的最大吸附吸附容量36.3 mg/g;MCM-41对Cu²⁺的吸附性能符合Langmuir吸附方程的特征。动力学研究表明,该过程符合准二级动力学模型。     

负载型Mn-Ce/TiO2催化剂的制备及其低温脱硝活性简

以成型TiO₂作为载体,通过浸渍法制备了Mn-Ce/TiO₂低温SCR催化剂,并系统研究了制备方法、煅烧条件、活性组分担载量、Mn含量等参数对催化剂催化还原NO性能的影响。结果表明,煅烧温度的升高会促使活性组分结晶度的提高,从而引起催化活性的降低,在500℃和600℃下所得Mn-Ce/TiO₂催化剂活性组分为无定型态,表现出较高的脱硝活性。活性组分担载量的增加有利于催化活性的提高。Mn含量对Mn-Ce/TiO₂催化剂的活性有较大影响,当Mn/（Mn+Ce）摩尔比为40%和85%时,催化剂活性最高。     

突变灰盖鬼伞过氧化物酶降解刚果红的响应面法优化分析简

酶法降解偶氮染料刚果红是一个复杂的过程,受温度、pH、酶量、刚果红浓度和双氧水浓度显著影响。为研究各因素及因素间交互作用对刚果红降解影响,提高刚果红的降解率,分别使用单因素法和响应面分析法对刚果红降解条件进行了优化。单因素实验结果显示灰盖鬼伞过氧化物酶降解刚果红的最适条件为：pH 5.0、32℃、酶量4.98 U、双氧水0.1 mmol/L、刚果红20 mg/L,此时刚果红最高降解率为34.84%。然后选双氧水浓度、刚果红浓度和灰盖鬼伞过氧化物酶量作为3个因素,通过中心组合设计实验,用响应面法对刚果红降解进行优化分析,最后得到一个拟合度良好的二次多项方程模型（R²=0.9900）。方差分析结果显示,刚果红浓度和酶量是影响最显著的因素,双氧水与酶以及染料与酶之间的交互作用极显著。响应面分析优化后的反应体系为：双氧水浓度0.15 mmol/L,刚果红浓度为27.21 mg/L,酶为2.0 7 U,在此条件下,刚果红降解率达58.13%。     

Investigation into the effect of high concentrations of volatile fatty acids in anaerobic digestion on methanogenic communities

A study was conducted to determine whether differences in the levels of volatile fatty acids (VFAs) in anaerobic digester plants could result in variations in the indigenous methanogenic communities. Two digesters (one operated under mesophilic conditions, the other under thermophilic conditions) were monitored, and sampled at points where VFA levels were high, as well as when VFA levels were low. Physical and chemical parameters were measured, and the methanogenic diversity was screened using the phylogenetic microarray ANAEROCHIP. In addition, real-time PCR was used to quantify the presence of the different methanogenic genera in the sludge samples. Array results indicated that the archaeal communities in the different reactors were stable, and that changes in the VFA levels of the anaerobic digesters did not greatly alter the dominating methanogenic organisms. In contrast, the two digesters were found to harbour different dominating methanogenic communities, which appeared to remain stable over time. Real-time PCR results were inline with those of microarray analysis indicating only minimal changes in methanogen numbers during periods of high VFAs, however, revealed a greater diversity in methanogens than found with the array.     

利用白云石石灰去除与回收污泥厌氧消化液中氮和磷

以白云石石灰为实验材料去除与回收污泥厌氧消化液中的氮磷,通过小试实验研究不同投药固液比S/L、初始pH值、反应温度、搅拌速度及反应时间对去除与回收氮磷效果的影响。实验结果表明,在最佳投药固液比S/L为300mg/L,最佳初始pH值范围为8.5~9.5,反应温度为25.0℃,搅拌速度为150 r/min,反应时间为24 h条件下,氨氮(NH+4-N)和磷(PO3-4-P)的去除率分别为37.26%和89.60%。利用X射线衍射仪(XRD)、扫描电镜(SEM)对沉淀产物进行了表征,通过分析可知沉淀产物中含有磷酸铵镁(MAP),可实现废水中氮磷经济有效的回收。     

循环流化床锅炉燃煤技术热电厂生命周期评价

运用生命周期评价方法,应用Gabi5.0软件对采用循环流化床锅炉燃煤技术的热电企业进行资源耗竭和环境影响分析,计算各生产单元生命周期清单的全球变暖潜值、酸化效应潜值、富营养化潜值、非生物资源耗竭潜值、人体毒性潜值以及光化学烟雾和臭氧生成潜值等主要环境影响类型,对燃煤发电过程进行生命周期评价。结果表明,全球变暖和非生物资源耗竭为发电运行过程中主要的环境影响因素,分别占53%和15.05%;锅炉燃烧阶段的环境影响最重,占整个生命周期影响值的77.12%,并且除生物耗竭潜值外的其他5项指标均为发电运行阶段各个单元中最高。采用SNCR脱硝技术减少燃烧过程中NOx的排放量,并对该技术方案进行生命周期评价,比较方案实施前后的环境影响。     

介质阻挡放电协同Ag/Al_2O_3对NO_x脱除的影响

为有效去除发电厂烟气中产生的NOx,利用介质阻挡放电(DBD)产生低温等离子体并结合催化剂Ag/Al2O3进行烟气脱硝实验,研究了在加入乙烯的条件下,平均负载量、催化温度和装置的布置方式对NOx脱除的影响。结果表明,随着负载的增多,NO脱除率呈现先增大后减小的趋势,5种负载量中最佳为1.76%;随着催化温度的升高,NO脱除率同样呈现先增大后减小的趋势,最佳的催化温度为150℃左右;3种不同布置方式对NO和NOx脱除有明显差别,单独催化剂在NO和NOx的脱除率都比较低;单独介质阻挡放电NO脱除率很高,但是NOx很却很低;而两者结合在NO和NOx都达到了很好的效果。     

石墨气体扩散电极的制备与性能优化

电极的制备工艺及参数直接影响电极材料的活性。主要考察了C/PTFE质量比、碾压压力、煅烧温度、造孔剂NH4HCO3及稀土掺杂等因素对电极产出H2O2的影响规律。研究结果表明,电极最佳制备条件为:石墨和PTFE质量比为2∶1、石墨、造孔剂和稀土元素质量比为6∶1∶1、碾压压力10 MPa、煅烧温度330℃。在pH=3、电解质Na2SO4浓度为0.05mol/L条件下,电解2 h后,改性电极产生的H2O2从95 mg/L提高到350 mg/L,提高了268.4%。     

Gold Mining: Is It Worth Its Weight?

Gold (Au) accounts for only 0.004 g/ton of the earth's crust and is the most desired element. With an average annual world production of approximately 2,500 tons, the current methods of Au mining in developing countries cause major environmental issues. These issues vary from deforestation to cyanide and mercury (Hg) contamination. This article presents several cases of environmental catastrophes caused by Au mining in different regions of the world (Africa, the Middle East, Eastern Europe, and South America). It discusses the currently available processes for the large-scale extraction of metallic Au grains and supports the need for an alternative sustainable process.