CMC-膨润土交联固定镰刀菌反应器对对氯苯酚废水的降解特性

采用CMC-膨润土交联方法固定镰刀菌,研究了其固定方法对4-CP废水的降解效果,考察了固定化生物反应器间歇与连续运行处理4-CP废水的降解性能.结果表明,CMC-膨润土包埋固定镰刀菌对4-CP的降解速率最大;反应器问歇运行时,4-CP的降解率随其初始浓度增加而有所下降,浓度高于50 mg·L-1的4-CP降解过程基本上...     

潮汐流人工湿地低温下 NH4+ -N去除模型的比较和优化

针对目前人工湿地在低温条件下脱氮效能降低的问题,本研究对每天3个运行周期的潮汐流人工湿地在低温条件下对NH4+ -N的处理效能进行研究,同时利用表观动力学模型、多元参数回归模型及Monod机制模型对NH4+-N的去除过程进行拟合.结果显示,在平均水温为9～13℃条件下,每天3个运行周期的潮汐流人工湿地对NH4+-N有良...     

The recycling cycle of materials as a design project tool

Currently, a large number of companies consider recycling of materials as an opportunity to maximize profits and to reduce the environmental impact generated by these materials after they are disposed. However, there is also a strong constraint on the use of recycled materials mainly due to the lack of technical/scientific information, which would relate their physical properties to their recycling cycle. This information should be used in the initial phase of the product design to serve as reference for the simulation of a project to point out the physical properties obtained from recycling the Projected material (Pm). Thus, it would be possible to foresee some recycling strategy to keep the good characteristics of recycled materials by encouraging their use, regardless of the product to be designed.Therefore, the Recycling Cycle of Materials (RCM) is a tool that provides scientific/technical support in the selection of materials. It uses the information related to the physical properties of the Pm as a parameter for product design after five recycling cycles. For the case study, this tool has been applied to obtain the basic material of ABS/PC blend. Subsequently, this blend was evaluated using DSC, FTIR, traction and impact methods to obtain delimiting data for the definition of the mechanical properties resulting from the application of RCM.     

北京转河河岸带生态修复对河流水质的影响

以北京转河为例,探讨一系列河岸带生态修复措施(尤其是河漫地和护岸的改造)对河流水质的影响.于2009年7～9月进行实地调查,沿河岸选取13个采样点,并定期采集水样,测定其中营养物质和溶解氧(DO)等的浓度.结果表明,转河氨氮(NH4+-N)、硝氮(NO3--N)、总磷(TP)和DO的浓度均有非常明显的季节变化.在居民用...     

Arbuscular mycorrhizal fungi alter the response of growth and nutrient uptake of snap bean（Phaseolus vulgaris L.） to O_3

The effects of arbuscular mycorrhizal fungi (AMF) Glomus mosseae on the responses to elevated O3 in growth and nutrition of snap bean (Phaseolus vulgaris L. cv Guangzhouyuan) were investigated. Exposure was conducted in growth chambers by using three O3 concentrations (20 (CF), 80 (CFO1) and 120 nL/L (CFO2); 8 hr/day for 75 days). Results showed that elevated O3 slightly impacted overall mycorrhizal colonization, but significantly decreased the proportional frequency of hypha and increased the proportional frequency of spores and vesicles, suggesting that O3 had significant effects on mycorrhizal structure. Elevated O3 significantly decreased yield, dry mass and nutrient contents (N, P, K, Ca and Mg) in both non-mycorrhizal and mycorrhizal plants. However, significant interactive effects were found in most variables due to that the reduction by O3 in the mycorrhizal plants was less than that in the non-mycorrhizal plants. Additionally, AMF increased the concentrations of N, P, Ca, and Mg in shoot and root. It can be concluded that AMF alleviated detrimental effects of increasing O3 on host plant through improving plant nutrition and growth.     

物化法处理生活垃圾渗滤液新进展

概述了物化法处理垃圾渗滤液的研究现状和最新进展,并展望了物化法处理垃圾渗滤液的研究方向。     

Photocatalytic activity of Fe-doped CaTiO3 under UV-visible light

The photocatalytic degradation of methylene blue（MB） over Fe-doped CaTiO3 under UV-visible light was investigated. The as-prepared samples were characterized using X-ray diffraction（XRD）, scanning electron microscope（SEM） equipped with an energy dispersive spectrometer（EDS） system, Fourier transform infrared spectra（FT-IR）, and UV-visible diffuse reflectance spectroscopy（DRS）. The results show that the doping with Fe significantly promoted the light absorption ability of CaTiO3 in the visible light region. The Fe-doped CaTiO3 exhibited higher photocatalytic activity than CaTiO3 for the degradation of MB.However, the photocatalytic activity of the Fe-doped CaTiO3 was greatly influenced by the calcination temperature during the preparation process. The Fe-doped CaTiO3 prepared at500°C exhibited the best photocatalytic activity, with degradation of almost 100% MB（10 ppm）under UV-visible light for 180 min.     

Fast increasing of surface ozone concentrations in Pearl River Delta characterized by a regional air quality monitoring network during 2006-2011

Based on the observation by a Regional Air Quality Monitoring Network including 16 monitoring stations, temporal and spatial variations of ozone(O3), NO2and total oxidant(Ox) were analyzed by both linear regression and cluster analysis. A fast increase of regional O3concentrations of 0.86 ppbV/yr was found for the annual averaged values from 2006 to 2011 in Guangdong, China. Such fast O3increase is accompanied by a correspondingly fast NOx reduction as indicated by a fast NO2 reduction rate of 0.61 ppbV/yr. Based on a cluster analysis, the monitoring stations were classified into two major categories – rural stations(non-urban) and suburban/urban stations. The O3concentrations at rural stations were relatively conserved while those at suburban/urban stations showed a fast increase rate of 2.0 ppbV/yr accompanied by a NO2 reduction rate of 1.2 ppbV/yr. Moreover, a rapid increase of the averaged O3 concentrations in springtime(13%/yr referred to 2006 level) was observed, which may result from the increase of solar duration, reduction of precipitation in Guangdong and transport from Eastern Central China. Application of smog production algorithm showed that the photochemical O3production is mainly volatile organic compounds(VOC)-controlled. However, the photochemical O3production is sensitive to both NOx and VOC for O3pollution episode. Accordingly, it is expected that a combined NOx and VOC reduction will be helpful for the reduction of the O3 pollution episodes in Pearl River Delta while stringent VOC emission control is in general required for the regional O3 pollution control.     

轻型汽油车CH4和N2O排放因子研究

我国的机动车温室气体排放研究多集中于CO2排放,而CH4和N2O排放的相关研究主要是依据欧美开发的模型进行的,缺乏CH4和N2O实车测试的研究.本研究选取22辆轻型汽油车,利用底盘测功机开展了整车台架测试和采样分析,获得了车辆在NEDC工况下的CH4和N2O排放因子.结果表明,国Ⅰ~国Ⅳ阶段轻型汽油车CH4平均排放因子分别为0.048、0.048、0.038和0.028 g·km-1,N2O则分别为0.045、0.039、0.026和0.021 g·km-1.在轻型汽油车单车排放的CO2、CH4和N2O三类温室气体(以CO2当量计)中,CH4和N2O排放的分担率均随排放标准的加严而逐渐降低,其中CH4排放在温室气体排放中不足0.5%,N2O排放分担率在3.03%~6.35%之间.因此,排放标准的加严可以有效减少CH4和N2O的排放,以减缓机动车排放带来的温室效应.     

不同施磷量(KH2PO4)作用对Cu、Zn在红壤中的迁移转化

为了比较不同施磷量对土壤中重金属Cu、Zn迁移转化的影响,采用土壤柱进行室内淋溶实验,研究常见的磷肥磷酸二氢钾在少量5 mg·kg-1,适量15 mg·kg-1以及过量25 mg·kg-1条件下对Cu、Zn在红壤中的淋溶效应.结果表明土壤施用磷酸二氢钾降低了土壤渗滤液的pH,不同施磷量对土壤渗滤液pH影响不大,在整个淋滤过程,渗滤液pH呈现上升的趋势.磷酸盐作用下重金属Cu在土壤中的迁移主要集中表层土壤中,而Zn逐渐向深层土壤中迁移.土壤深层渗滤液中Cu、Zn浓度均比较低,对浅层地下水的危害性不大.淋滤结束后,重金属主要以残渣态存在土壤中,重金属Cu残渣态的比例为60%左右,重金属Zn残渣态比例为40%左右.高浓度磷酸二氢钾作用下有利于重金属Zn从残渣态及有机结合态向交换态转化.