负载型TiO2薄膜光催化剂降解亚甲基蓝

采用溶胶-凝胶法制备了玻璃负载的TiO2薄膜光催化剂,研究了该催化剂对亚甲基蓝溶液的光催化降解,考察了反应时间、水样的初始浓度、溶液的pH等对光催化降解效果的影响。     

固定化真菌漆酶对分散兰-2BLN的脱色和降解

采用改良壳聚糖固定化的真菌漆酶对染料分散兰-2BLN进行脱色和降解条件的研究,探索了固定化漆酶活力、处理时间、染料浓度、温度和pH对其降解效果的影响。结果表明,固定化漆酶脱色降解分散兰-2BLN的适宜条件为：固定化漆酶活力18.2U／mL,染料浓度100mg／L,温度40℃,pH4.6,在上述条件下降解1.5h,分散兰-2BLN脱色率能达到87.68％。重复分批使用固定化漆酶处理2BLN兰,在使用6批次后,脱色率仍能保持在55％以上,其催化效率得到了较大提高。     

HPA／ZnFe2O4-TiO2光催化剂的制备及对马拉硫磷的可见光降解

以纳米TiO2载体,利用浸渍法制备了HPA／ZnFe2O4-TiO2光催化剂。对制备的催化剂进行了XRD、BET、TEM和UV-vis DRS表征。结果表明,催化剂样品均为锐钛矿相且ZnFe2O4很好地分散在载体表面,HPA／ZnFe2O4-TiO2光催化荆的平均粒径为10nm且在380-670nm均有强的光响应;反应最佳的HPA浓度为O.08molfL,最佳的ZnFe2O4负载量为1％。考察了HPA溶液初始浓度、ZnFe2O4负载量、溶液初始pH值、H2O2用量、催化剂用量对催化剂活性的影响。在溶液初始pH=13,H2O2=6mmol／L,催化剂用量为2g/L的最优条件下,光照反应进行100min后,马拉硫磷的降解率可达87％;重复4次后马拉硫磷的降解率仍可以达到67％。     

臭氧同时脱硫脱硝技术研究进展

对利用臭氧同时脱硫脱硝技术进行了综述,分析了臭氧对NOx的脱除机理。臭氧同时脱硫脱硝技术具有明显的一体化脱除特性,但臭氧的发生费用却制约了它的应用。介绍了目前国外在工程上应用的低温氧化技术（LOTOX）,分析了其脱除效果及优缺点。     

CO_2 Emission Induced by Urban Household Consumption in China

Household consumption is one of the important factors that induce COL emission. Based on input-output model, this article calculated the intensity of CO2 emission of different income groups and seven provinces in China, and then estimated total CO2 emission induced by urban household consumption from 1995 to 2004 in China based on statistic data of household living expenditure. The results show that CO2 emission per capita induced by household consumption had increased from 1583 to 2498 kg CO2 during 1995-2004. The ratio of consumption-induced CO2 emission to total CO2 emission had risen from 19% to 30% in the past decade. Indirect CO2 emission accounted for an important part of the consumption-induced emission, the ratio of indirect emission to consumption-induced emission had risen from 69% to 79% during the same period. A significant difference in consumption-induced CO2 emission across different income groups and different regions has been observed. COs emission per capita of higher income groups and developed regions increased faster than that of lower income groups and developing regions. Changing lifestyle has driven significant increase in CO2 emission. Especially, increases in private transport expenditure （for example, vehicle expenditure） and house building expenditure are key driving factors of growth in consumption-induced COL emission. There are big differences in the amount of CO2 emission induced by change in lifestyle across different income groups and provinces. It can be expected that lower income households and developing regions will increase consumption to improve their livings with income growth in the future, which may induce much more CO2 emission. A reasonable level of CO2 emission is necessary to satisfy human needs and to improve living standard, but a noticeable fact is that CO2 emission per capita induced by household consumption in developed areas of China had reached a quite high level. Adjustment in lifestyle towards a low-carbon society is in urgent need.     

利用中巴地球资源卫星数据反演武汉市湖泊营养状态指数

以武汉市主要湖泊为例,研究了利用中巴地球资源卫星（CBERS2）数据反演水体营养状态指数（TLI）。研究旨在评估利用中巴地球资源卫星数据来估算内陆水体富营养化程度的可能性。首先利用地面水质监测数据计算武汉市某些湖泊监测点的“真实的”营养状态指数（包括综合营养状态指数和修正的Carlson营养状态指数）,同时,在事先经过辐射校正和几何校正的CBERS2图像上,以9×9像元为采样窗口,提取各个对应地点的灰度值均值（从波段1至波段4）;然后,采用多元逐步回归分析,以各波段灰度值均值为自变量,建立营养状态指数经验遥感反演模型;最后,利用模型对整个湖泊水体的营养化状态指数进行反演,并绘制了其空间分布图。 结果显示,营养状态指数的自然对数值与CBERS2图像各波段灰度值之间存在较好相关关系,回归系数平方值(R²)为0.51。利用反演模型反演得到的湖区水质分布与实际情况基本相符。由于CBERS2图像数据可以从我国许多数据分发中心免费获取,这为低成本的水质遥感监测提供了一条途径。     

Gas/particle partitioning of atmospheric PCDD/Fs in a satellite town in Eastern China

Gas/particle partitioning of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in ambient air was investigated in a satellite town in Eastern China from April 2007 to January 2008 comprehending large temperature variations (from 3 to 34 °C, daily average). Molecular weight, molecular structure and ambient temperatures are the three major factors that govern the gas/particle partitioning of atmospheric PCDD/Fs throughout the year. Generally, good agreements were obtained (except for winter) between measured particulate fractions and theoretical estimates of both the Junge–Pankow adsorption model and Harner Bidleman absorption model using different sets of subcooled liquid vapor pressure and octanol–air partition coefficient (K_oa), respectively. Models utilizing estimates, derived from gas chromatographic retention indices (GC-RIs), are more accurate than that of entropy-based. Moreover, during winter, the K_oa-based model using the GC-RIs approach performs better on lower chlorinated PCDD/Fs than that of -based. Furthermore, possible sources of mismatch between measured and predicted values in winter (3–7 °C) were discussed. Gas adsorption artifact was demonstrated to be of minor importance for the phenomena observed. On the other hand, large deviations of slopes (m_r) and intercepts (b_r) in logK_p vs. plots from theoretical values are observed in the literature data and these are found to be linearly correlated with ambient temperatures (P<0.001) in this study. This indicates that the non-equilibrium partitioning of PCDD/Fs in winter may be significantly influenced by the colder temperatures that may have slowed down the exchange between gaseous and particulate fractions.     

Influence of titanium dioxide nanoparticles on speciation and bioavailability of arsenite

In this study, the influence of the co-existence of TiO₂ nanoparticles on the speciation of arsenite [As(III)] was studied by observing its adsorption and valence changing. Moreover, the influence of TiO₂ nanoparticles on the bioavailability of As(III) was examined by bioaccumulation test using carp (Cyprinus carpio). The results showed that TiO₂ nanoparticles have a significant adsorption capacity for As (III). Equilibrium was established within 30 min, with about 30% of the initial As (III) being adsorbed onto TiO₂ nanoparticles. Most of aqueous As (III) was oxidized to As(V) in the presence of TiO₂ nanoparticles under sunlight. The carp accumulated considerably more As in the presence of TiO₂ nanoparticles than in the absence of TiO₂ nanoparticles, and after 25-day exposure, As concentration in carp increased by 44%. Accumulation of As in viscera, gills and muscle of the carp was significantly enhanced by the presence of TiO₂ nanoparticles.     

A statistical analysis of the carbon dioxide capture process

Post combustion carbon dioxide (CO₂) capture is one of the most commonly adopted technologies for reducing industrial CO₂ emissions, which is now an important goal given the widespread concern over global warming. Research on amine-based CO₂ capture has mainly focused on improving effectiveness and efficiency of the CO₂ capture process. Our research work focuses on studying the relationships among the significant parameters influencing CO₂ production because an enhanced understanding of the intricate relationships among the parameters involved in the process is critical for improving efficiency of the CO₂ capture process. This paper presents a statistical study that explores the relationships among parameters involved in the amine-based post combustion CO₂ capture process at the International Centre for CO₂ Capture (ITC) located in Regina, Saskatchewan of Canada. A multiple regression technique has been applied for analysis of data collected at the CO₂ capture pilot plant at ITC. The parameters have been carefully selected to avoid issues of multicollinearity, and four mathematical models among the key parameters identified have been developed. The models have been tested, and accuracy of the models is found to be satisfactory. The models developed in this study describe part of the CO₂ capture process and can help to predict performance of the CO₂ capture process at ITC under different conditions. Some results from a preliminary validation process will also be presented.     

Model prediction on the rise of pCO2 in uniform flows by leakage of CO2 purposefully stored under the seabed

A numerical study was conducted to predict pCO₂ change in the ocean on a continental shelf by the leakage of CO₂, which is originally stored in the aquifer under the seabed, in the case that a large fault connects the CO₂ reservoir and the seabed by an earthquake or other diastrophism. The leakage rate was set to be 6.025 × 10⁻⁴ kg/m²/sec from 2 m × 100 m fault band, which corresponds to 3800 t-CO₂/year, referring to the monitored seepage rate from an existing EOR field. The target space in this study was limited to the ocean above the seabed, the depth of which was 200 or 500 m. The computational domain was idealistically rectangular with the seabed fault-band perpendicular to the uniform flow. The CO₂ takes a form of bubbles or droplets, depending on the depth of water, and their behaviour and dissolution were numerically simulated during their rise in seawater flow. The advection–diffusion of dissolved CO₂ was also simulated. As a result, it was suggested that the leaked CO₂ droplets/bubbles all dissolve in the seawater before spouting up to the atmosphere, and that the increase in pCO₂ in the seawater was smaller than 500 μ atm.