Biodegradation of benzo[a]pyrene in soil by Mucor sp. SF06 and Bacillus sp. SB02 co-immobilized on vermiculite

Two indigenous microorganisms, Bacillus sp. SB02 and Mucor sp. SF06, capable of degrading polycyclic aromatic hydrocarbons （PAHs） were co-immobilized on vermiculite by physical adsorption and used to degrade benzo[a] pyrene （BaP）. The characteristics of BaP degradation by both free and co-immobilized microorganism were then investigated and compared. The removal rate using the immobilized bacterial-fungal mixed consortium was higher than that of the freely mobile mixed consortium. 95.3% of BaP was degraded using the co-immobilized system within 42 d, which was remarkably higher than the removal rate of that by the free strains. The optimal amount of inoculated co-immobilized system for BaP degradation was 2%. The immobilized bacterial-fungal mixed consortium also showed better water stability than the free strains. Kinetics of BaP biodegradation by co-immobilized SF06 and SB02 were also studied. The results demonstrated that BaP degradation could be well described by a zero-order reaction rate equation when the initial BaP concentration was in the range of 10--200 mg/kg. The scanning electronic microscope （SEM） analysis showed that the co-immobilized microstructure was suitable for the growth of SF06 and SB02. The mass transmission process of co-immobilized system in soil is discussed. The results demonstrate the potential for employing the bacterial-fungal mixed consortium, co-immobilized on vermiculite, for in situ bioremediation of BaP.     

钾细菌在剩余污泥资源化中的应用

通过对钾细菌在剩余污泥中的接种,利用钾细菌将土壤中难溶性钾转化为可溶性钾是增加作物钾素营养的一个途径,将含大量钾细菌的剩余污泥制成的微生物肥料应用于农田中,从而达到剩余污泥的资源化利用,为剩余污泥的科学处理提供依据。     

多菌灵降解菌NY97-1的鉴定及降解条件

分离筛选出一株能高效降解多菌灵的芽孢杆菌菌株NY97-1,经生理生化和序列同源性分析,将该菌株鉴定为短小芽孢杆菌Bacillus pumilus.该细菌降解多菌灵的最适pH值为6.0～10.0,最适温度为35.0～40.0℃.该菌在多菌灵浓度为10、30、50、100、300 mg·L-1的无机盐培养基中,30℃振荡培养24 h后,其对多菌灵的降解率分别为42.44％、48.97％、77.19％、78.66％和90.07％.添加少量有机氮源如酵母浸出粉、胰蛋白胨、酵母膏可促进菌株NY97-1对多菌灵的降解作用,添加少量无机氮源尿素会抑制菌株NY97-1对多菌灵的降解作用.     

十溴联苯醚(BDE209)对蜡状芽胞杆菌吸附/释放金属离子的影响

针对重金属及多溴联苯醚(PBDEs)复合污染问题,以蜡状芽孢杆菌(Bacillus cereus)复合菌为吸附材料,研究了十溴联苯醚(BDE209)对蜡状芽孢杆菌复合菌吸附及释放金属离子的影响.结果表明,蜡状芽孢杆菌复合菌对低浓度的Pb(II)(0.712mg·L-1)、Zn(II)(4.844mg·L-1)具有快速、高效、稳定的吸附能力,最高吸附率分别达到98.31%和97.83%;对低浓度的Cu(II)(1.915mg·L-1)也能起到一定的去除作用,吸附率最高可达59.90%.复合菌吸附重金属离子的同时,释放了其他金属离子:Ca(II)、K(I)、Na(I),且释放总量大于吸附总量.不同浓度的BDE209对复合菌吸附重金属产生不同的影响.1mg·L-1的BDE209基本表现为促进复合菌对重金属的吸附;而10mg·L-1的BDE209在0～4h之间促进复合菌对Pb(II)、Zn(II)的吸附,在反应4h后明显抑制吸附作用,而对Cu(II)则始终表现为促进作用.BDE209对金属离子释放的影响主要体现在反应的初始阶段(0～4h),表现为高浓度的BDE209减缓K(I)、Na(I)的释放.     

一株高效解磷细菌的紫外诱变选育及其在红壤稻田施用效果

红壤对磷有强大吸附固定力,磷肥易被土壤中活性铁、铝固定而使有效态磷转化为各种形态的非有效磷,从而大大降低磷肥的利用率。解磷菌能使土壤中难溶性或不溶性的磷转化为易于被植物吸收利用的磷。通过对江西鹰潭红壤分离筛选并经过紫外诱变获得一株性状稳定的高效解磷细菌Y8。经鉴定,菌株Y8为蜡状芽孢杆菌（Bacillus cereus）。通过与生产中应用的徐州华龙高效复合菌肥厂的解磷细菌X3相比,菌株Y8降解有机磷、溶解Ca3（PO4）2的能力均比较高,分别为155.3mg·L^-1和240.1mg·L^-1。研究各种理化因子对菌株Y8解磷能力的影响,确定了菌株Y8的最佳培养条件为葡萄糖20g·L^-1、NH4（SO4）21.5g·L^-1、pH7.0、温度为35℃,在该条件下菌株Y8溶解Ca3（PO4）2的量为295.6mg·L^-1。在江西鹰潭红壤稻田的施用试验表明,将菌株Y8制成微生物菌剂施用于水稻田可起到减施化肥的作用。     

短小芽孢杆菌A—30耐碱性木聚糖酶基因的分子生物学研究

采用PCR方法对短小芽孢杆菌A－30菌株的耐碱性木聚糖酶基因进行克隆。在木聚糖选择平板上用刚果红染色法筛选出阳性克隆,提取阳性克隆的重组质粒进行酶切鉴定和测序。该基因在大肠杆菌中表达,过夜培养物胞外、胞内和周质空间的木聚糖酶酶活分别为0．159IUmL^-1、0.322IUmL^-1和0.007IUmL^-1。此木聚糖酶表现出较宽的pH作用范围,最适作用pH7左右,在pH9时仍有60％以上的酶活性。图4参14     

集约化养猪废水SBR中17β-雌二醇高效降解菌的分离鉴定及其降解特性

从集约化养猪废水生物处理SBR的活性污泥中分离到3株高效降解17β-雌二醇(E2)的菌株,分别命名为ha、chs和hc。研究表明,这3株菌以E2为惟一碳源,在4 d内对初始浓度为1 mg/L E2的降解率为70%～95%。25℃条件下菌ha、chs和hc的一级反应动力学常数分别为0.0086、0.072和0.013。在温度为37℃时,3株菌的降解效率最高,在高浓度的氨氮和碱性pH的条件下,这3株菌均存在降解作用。其中,pH 9.05时,一级动力学常数菌ha降至0.0066,菌chs升至0.076,菌hc降至0.012。同时,在添加C源后,对降解有促进作用,并且C/N比在15∶1时降解效果较好。3株菌的一级反应动力学常数分别升到0.027、0.73和0.021。经16S rRNA基因序列分析鉴定为枯草芽孢肝菌(Bacillus subtilis)。     

耐盐性毒死蜱降解混合菌的构建及其降解特性

为明确蜡状芽孢杆菌(Bacillus cereus)混合菌株对毒死蜱的降解效果,采用正交实验的方法构建混合菌。以混合菌对毒死蜱的降解率和菌株的生长量为依据,利用单一因素实验考察了不同因素对混合菌降解毒死蜱的影响。结果表明:构建的混合菌中三菌株的体积比为1∶1∶3。在含80 mg/L毒死蜱的反应体系中,最适接菌量为8%(V/V),最适pH为7。在实验浓度下,混合菌对毒死蜱的降解符合一级动力学方程。混合菌对盐分有较高的耐受度,当反应液中氯化钠浓度在20～100 g/L之间时,混合菌对80 mg/L毒死蜱的降解率最高达61%。     

Molecular characterization of soil bacteria antagonistic to Rhizoctonia solani,sheath blight of rice

Bacillus pumillus MTCC7615 has been identified as a potent isolate against Rhizocotonia solani, the fungal pathogen causing sheath blight in rice. The study aimed at probing the role of a 23kb size plasmid pJCP07 of Bacillus pumillus MTCC7615 in its fungal antagonism towards Rhizocotonia solani. Plasmid pJCP07 was found to be involved in production of a fungal antagonistic compound as demonstrated by plasmid curing and conjugational transfer experiments. Tn5 insertional studies further confirmed that the plasmid pJCP07 of Bacillus pumillus MTCC7615 carries some of the gene(s) involved in production of compound antagonistic to Rhizocotonia solani. The plasmid pJCP07 is thus a mobilizable medium-sized plasmid carrying genes responsible for antagonism of Bacillus pumillus MTCC7615 towards Rhizocotonia solani.     

Dose transfer of Bacillus thuringiensis from cabbage to the diamondback moth: A graphical simulator

Abstract

The application of agrichemicals is a highly inefficient process and one of the main causes of the environmental and health risks currently associated with pesticide usage. Efforts to mitigate this inefficiency have largely been unsuccessful, due principally to the poor understanding of the processes involved in the spray application of pesticides, from atomization to biological effect. A generalized model of the application system for pesticides from atomization to biological result is described in this overview. The model allows the investigation of the biological consequences of altering the application parameters for the bacterial insecticide Bacillus thuringiensis when used against the diamondback moth (Plutella xylostella L.) with cabbage as the substrate. Parameters input into the model include the in‐flight droplet size frequency distribution of the spray cloud, spatial distribution of the deposit, spread and subsequent environmental degradation of the deposit, and behavioral and toxicological effects.

It is hoped that such a modelling approach can afford insights into the application process, and, through a better understanding of the inefficient but still highly effective hydraulic application systems used worldwide, reduce that inefficiency to tolerable levels.