Preparation of rare-earth metal complex oxide catalysts for catalytic wet air oxidation

Catalytic wet air oxidation (CWAO) is one of the most promising technologies for pollution abatement. Developing catalysts with high activity and stability is crucial for the application of the CWAO process. The Mn/Ce complex oxide catalysts for CWAO of high concentration phenol-containing wastewater were prepared by coprecipitation. The catalyst preparation conditions were optimized by using an orthogonal layout method and single-factor experimental analysis. The Mn/Ce serial catalysts were characterized by Brunauer-Emmett-Teller (BET) analysis and the metal cation leaching was measured by inductively coupled plasma torch-atomic emission spectrometry (ICP-AES). The results show that the catalysts have high catalytic activities even at a low temperature (80°C) and low oxygen partial pressure (0.5 MPa) in a batch reactor. The metallic ion leaching is comparatively low (Mn<6.577 mg/L and Ce<0.6910 mg/L, respectively) in the CWAO process. The phenol, COD_Cr, and TOC removal efficiencies in the solution exceed 98.5% using the optimal catalyst (named CSP). The new catalyst would have a promising application in CWAO treatment of high concentration organic wastewater. Translated from Techniques and Equipment for Environmental Pollution Control, 2005, 6(2): 40–44 [译自: 环境污染治理技术与设备]     

多环芳烃的几种理化参数与LC_(50)的相关性研究

对多环芳烃(PAHS)4种理化参数(K;W、Sw。X Vv。)与 LCO的相关关系进行了研究,建立了 4种一元线性回归方程。结果表明,4种参数的相关系数分别为:0.刀66、08083、09488、0.9570,经r检验,后两种属高度显著相关.用所建立的一元线性回归方程对7种PAHS的LC。进行估算,估算值与实测值相比,平均相对误差分别为58.84％、32.23％、1761％、198％,用l和V＊.H对LClj进行估算的估算精度也较高。经比较,提出用(。估算P＊比对麦穗鱼＊CO的新方法。     

Occurrence and congeners specific of poiychlorinated biphenyls in agricultural soils from Southern Jiangsu, China

A total of 198 agricultural soil samples were collected from Zhangjiagang and Changshu in Southern Jiangsu for analysis of 13 polychlorinated biphenyls (PCBs) in order to assess the levels of pollution, sources, area distribution, and potential risk for the environment. All methods were rigorously tested and an adequate quality control was ensured. Only one site had no PCBs residues, and the highest total PCBs concentration in the surface soils was 32.83 ng/g. The average concentration in all the soil samples was 4.13 ng/g, signaling low-level pollution. Tetra-, penta-, and hexa-chlorinated biphenyls were dominant species in soil samples, accounting for more than 75% ofΣPCBs in the soil samples. PCB118 was the most abundant congener in all the samples. The PCB118 was about 20% ofΣPCBs. The soil organic matter content showed only a weak correlation with the levels of all PCB congeners, in which a better correlation was noted for the more volatile lighter PCB congeners than for the heavier homologues. To a certain extent, the sources and land use seemed to influence the levels of PCBs.     

Promotive effect of pyridine on indole degradation by activated sludge under anoxic conditions

Batch experiments were carried out to investigate the promotive effect of pyridine on indole degradation under denitrifying conditions. The seed sludge was obtained from a local coal-coking wastewater treatment facility and was acclimated in the laboratory. Indole and pyridine were supplemented to the synthetic wastewater at different ratios. The optimum ratio of chemical oxygen demand (COD) to nitrate (C/N) was 8.4–8.9 for both denitrification and indole and pyridine degradation. At a temperature of 28°C and pH of 7.0–7.5, the nitrate reductase activity (NRA) was in the best state. The addition of pyridine could promote NRA and the degradation of indole. When the initial concentration of indole was 150 mg/L, the concentration ratio of indole to pyridine was in the range of 1–10. Under optimum C/N conditions, the degradation of indole could be described with pseudo-zero-order kinetics. There was no accumulation of nitrite during the reaction. When the concentration ratio of pyridine to indole was less than 0.25 with an increase in the pyridine proportion, there were more significant augment rates for NRA and the degradation of indole than the situation when the concentration ratio was more than 0.25. __________ Translated from Environmental Science, 2006, 27(2): 300–304 [译自: 环境科学]     

Quantitative structure - activity study on the reductivedehalogenation potency of the halogenated aromatics

Ｑｕａｎｔｉｔａｔｉｖｅｓｔｒｕｃｔｕｒｅ－ａｃｔｉｖｉｔｙｓｔｕｄｙｏｎｔｈｅｒｅｄｕｃｔｉｖｅｄｅｈａｌｏｇｅｎａｔｉｏｎｐｏｔｅｎｃｙｏｆｔｈｅｈａｌｏｇｅｎａｔｅｄａｒｏｍａｔｉｃｓＨｕａｎｇＱｉｎｇｇｕｏ；ＷａｎｇＬｉａｎｓｈｅｎｇ；Ｈａｎ...     

金属铁还原降解2,4-二硝基甲苯的实验研究

研究了金属铁对2,4-二硝基甲苯(2,4-DNT)的还原降解情况.实验结果表明,2,4-DNT的还原降解与溶液初始pH值、初始浓度和溶解氧等因素有关.氯离子能消除金属铁的钝化现象.金属铁表面附载的铜对2,4-DNT的还原降解具有催化作用.     

MBBR处理低浓度污水的工程应用

用 2座体积 12 0m3的移动床生物膜反应器处理抚顺乙烯有限公司厂区的低浓度 (CODCr6 0～ 80mg L)生活污水 ,停留时间 2 4h ,出水通过高效纤维球过滤罐 ,CODCr降至 2 0mg L ,BOD5降至 5mg L ,SS降至 5mg L ,氨氮降至 1mg L ,达到了循环冷却水的回用标准。进水浓度过低 ,对MBBR挂膜不利 ,工程中采用外加营养物质的措施后 ,3d内反应器成功挂膜启动。     

催化快速法测定COD_(Cr)定量下限的研究

催化快速法测定CODCr是我国目前环境监测中普遍使用的最快速、简便、可靠的方法 ,该法的检测范围是 60～ 1 0 0 0mg/l,我们经过研究测出催化快速法的定量下限为 1 0mg/l,扩大了该法的应用范围。     

圆杯—多边形杆复合挤压的上限研究

此文采用三次多项式表示的流线速度场和基元圆环技术相结合的混合流动模型对国杯—多边形截面杆型复合挤压进行了上限分析,得到挤压力的上限解,分析了杆部截面形状对复合挤压分流点位置及变形力的影响规律并对理论计算进行了实验验证.     

ASM1中废水和污泥组分浓度的测定方法研究

对呼吸计量法应用于校准ASM1作了简明的阐述。在呼吸速率与模型组分关系的基础上,介绍了ASM1中废水与污泥各组分浓度的测定方法,并指出模型组分细化的意义。