在线监测氨氮浓度的电导测量方法研究

建立了适用于氨氮在线监测的干法蒸馏-电导法和湿法蒸馏-电导法。该方法是通入一定流量的气量于含氨试样中,全沸腾加热,蒸发出的氨和水蒸气一起经冷凝器后,进入酸吸收液中。酸吸收液的电导率随氨氮蒸馏液的吸收发生变化,其变化的值和样品中氨氮的浓度呈一定的比例关系。研制出的氨氮在线监测仪结构简单,运行稳定可靠,测量结果准确。     

High concentrations and dry deposition of reactive nitrogen species at two sites in the North China Plain

Atmospheric concentrations of major reactive nitrogen (N_r) species were quantified using passive samplers, denuders, and particulate samplers at Dongbeiwang and Quzhou, North China Plain (NCP) in a two-year study. Average concentrations of NH₃, NO₂, HNO₃, pNH₄⁺ and pNO₃⁻ were 12.0, 12.9, 0.6, 10.3, and 4.7 μg N m⁻³ across the two sites, showing different seasonal patterns of these N_r species. For example, the highest NH₃ concentration occurred in summer while NO₂ concentrations were greater in winter, both of which reflected impacts of N fertilization (summer) and coal-fueled home heating (winter). Based on measured N_r concentrations and their deposition velocities taken from the literature, annual N dry deposition was up to 55 kg N ha⁻¹. Such high concentrations and deposition rates of N_r species in the NCP indicate very serious air pollution from anthropogenic sources and significant atmospheric N input to crops.     

Comparison of annual dry and wet deposition fluxes of selected pesticides in Strasbourg, France

This work summarizes the results of a study of atmospheric wet and dry deposition fluxes of Deisopropyl-atrazine (DEA), Desethyl-atrazine (DET), Atrazine, Terbuthylazine, Alachlor, Metolachlor, Diflufenican, Fenoxaprop-p-ethyl, Iprodione, Isoproturon and Cymoxanil pesticides conducted in Strasbourg, France, from August 2000 through August 2001. The primary objective of this work was to calculate the total atmospheric pesticide deposition fluxes induced by atmospheric particles. To do this, a modified one-dimensional cloud water deposition model was used. All precipitation and deposition samples were collected at an urban forested park environment setting away from any direct point pesticide sources. The obtained deposition fluxes induced by atmospheric particles over a forested area showed that the dry deposition flux strongly contributes to the total deposition flux. The dry particle deposition fluxes are shown to contribute from 4% (DET) to 60% (cymoxanil) to the total deposition flux (wet + dry).     

球形氧化铝负载Ni-Co双金属催化剂上沼气重整制氢——操作条件的影响

前期研究开发出了活性、稳定性和抗积碳性能都较好的沼气重整制氢Ni-Co/La2O3-Al2O3催化剂。在此基础上选用商业球形氧化铝作为载体(4~5 mm)并掺杂La2O3,用浸渍法制备了Ni-Co/La2O3-Al2O3球形催化剂,以CH4/CO2体积比为1的混合气模拟沼气,考察了操作条件对工业尺度催化剂沼气重整反应性能的影响。结果表明:负载活性组分的γ-Al2O3球形催化剂的沼气重整活性基本达到小试的水平。反应温度升高有利于提高催化剂的重整活性,850℃以上催化剂的活性趋于稳定。反应温度升高有利于减少催化剂的表面积碳,却加速了金属颗粒的团聚。随着空速的增加,催化剂的活性显著降低。较好的催化剂还原方式为用纯H2在700℃下还原2 h,用该方式还原的催化剂反应后金属粒径较小,平均积碳速率较低。     

新型干法水泥回转窑废气产生量与产量的关系浅谈

本文通过对四川省采用新型干法水泥生产企业回转窑废气监测数据进行统计分析,建立了新型干法水泥回转窑废气产生量与水泥熟料产量的关系数学模型,并对模型进行了验证,该模型既可以用于监测人员现场核查企业填报生产量真实性,也可以用于判断实测废气量的合理性。     

Biomonitoring spatial and temporal impact of atmospheric dust from a cement industry

The objective of this work was to evaluate the spatial and temporal impact of dust-pollution in the vicinity of a cement industry, located in an area with dry climate. The spatial impact integrated over time was evaluated from the concentrations of Ca, Fe and Mg in in-situ Xanthoria parietina. The temporal pattern was assessed through one-month transplants of the lichen Ramalina canariensis. Four potential sources of atmospheric dust were evaluated: the limestone-quarry; the unpaved roads, the deposit area and the cement mill. Calcium concentration in lichens was considered the best cement-dust indicator. Different types of dust (clinker and grinded-limestone-dust) resulted in different time-patterns of Ca accumulation, which was also related with the different influence that wet and dry periods have in the lichen accumulation process. The dust pollution was found to be deposited locally and dependent on: the nature of dust particles and the volume and frequency of precipitation.     

Estimation of nitrogen balance between the atmosphere and Lake Balaton and a semi natural grassland in Hungary

The paper summarises the results to determine the fluxes of different N-compounds within the atmosphere and an aquatic and a terrestrial ecosystems, in Hungary. In the exchange processes of N-compounds between atmosphere and various ecosystems the deposition dominates. The net deposition fluxes are -730, -1270 and -1530 mg Nm(-2)yr(-1) for water, grassland, and forest ecosystems, respectively. For water, the main source of nitrogen compounds is the wet deposition. Ammonia gas is close to the equilibrium between the water and the air. For grassland the dry flux of nitric acid and ammonia is also an important term beside the wet deposition. Dry deposition to terrestrial ecosystems is roughly two times higher than wet deposition. A total of 8-10% of the nitrates and NH(x) deposited to terrestrial ecosystems are re-emitted into the air in the form of nitrous oxide (N2O) greenhouse gas.     

Dry reforming of methane over oil palm shell activated carbon and ZSM-5 supported cobalt catalysts

In this study, cobalt supported oil palm shell activated carbon (Co/OPS-AC) and ZSM-5 zeolite (Co/ZSM-5) catalysts have been prepared for dry reforming of methane. Cobalt ratios of 6.0 and 14.0 wt% were deposited via wet impregnation method to the OPS-AC and ZSM-5 catalysts. The catalysts were characterized by XRD, N₂ adsorption--desorption isotherms, BET surface area, SEM, FESEM-EDX, TPR-H₂, and TPD-NH₃. The dry reforming of methane was performed using a micro reactor system under the condition of 10,000 ml/h.g-cat, 3 atm, CH₄/CO₂ ratio of 1.2:1.0 and temperature range from 923 K to 1023 K. The gaseous products were analyzed by gas chromatography (GC) with thermal conductivity detector (TCD) and further quantified to determine the conversions of CH₄ and CO₂, and the yields of CO and H₂. Experimental results revealed both catalysts exhibited lower conversions of CO₂ and CH₄ with the increase in temperature from 923 K to 1023 K. The reduced conversions may be due to the formation of carboneous substance on the catalyst known as coking. Comparatively, Co/OPS-AC gave higher conversions of CO₂ and CH₄ as well as higher yields of H₂ and CO as it has a higher surface area than Co/ZSM-5 which subsequently rendered higher activity for the reforming of methane. With the increasing cobalt loadings and reaction temperature, OPS-AC(14) catalyst exhibited improved activity and H₂/CO ratio. Based on these results, cobalt supported OPS activated carbon catalyst was suggested to be more effective for CO₂ and CH₄ conversions.     

Parametric study along with selection of optimal solutions in dry wire cut machining of cemented tungsten carbide (WC-Co)

This work deals with parametric study of dry wire EDM (WEDM) process of cemented tungsten carbide. Experiments have been conducted using air as dielectric medium to investigate effects of pulse on time, pulse off time, gap set voltage, discharge current and wire tension on cutting velocity (CV) surface roughness (SR) and oversize (OS). Firstly, a series of exploratory experiments were carried out to identify appropriate gas and its pressure. Afterward, preliminary experiments were conducted to investigate effects of process parameters on dry WEDM characteristics and find appropriate ranges for each factor. Then a central composite rotatable method was employed to design experiments based on response surface methodology (RSM). Empirical models were developed to create relationships between process factors and responses by considering to analysis of variances (ANOVA). To increase the predictability of the process, intelligent models have been developed based on back-propagation neural network (BPNN) and accuracy of these models was compared with mathematical models based on root mean square error (RMSE) and prediction error percent (PEP). In order to select optimal solutions in the cases of single-objective and multi-objectives optimization problems, optimization includes two main approaches. First approach was based on mathematical model and desirability function. Also second approach was designed based on neural network and particle swarm optimization. These approaches were applied in both cases of single-objective and multi-objectives optimization problems and their results were compared with together. Results indicated that selection of air at inlet pressure of 1.5 bar is really appropriate for conducting experiments of next stages. Also, the BPNN creates more accurate prediction rather than mathematical model. Moreover, the BPNN-PSO approach was more efficient in optimization of process rather than mathematical model-desirability function in respect with validation tests.     

Interception of dry and wet deposited radionuclides by vegetation

Interception of dry and wet deposited radionuclides by vegetation is a key process in radioecological models that assess ingestion doses to the population following releases of radionuclides to the atmosphere. Radionuclides may be deposited during precipitation or as dry particles. Interception of wet deposited radionuclides is the result of a complex interaction of the vegetative development of the plant canopy, the amount of rainfall, and the chemical form of radionuclides. For the interception of dry deposits, particle size is a key parameter; interception is more effective for small particles and reactive gases. Due to the dependence on plant development, interception of both dry and wet deposits is subject to pronounced seasonality.