超滤技术的应用和发展研究

本文介绍了超滤技术的相关知识,在水处理、食品工业、染料工业的应用。最后探讨了超滤技术的发展趋势。     

Regulated emission characteristics of in-use LNG and diesel semi-trailer towing vehicles under real driving conditions using PEMS

On-road driving emissions of six liquefied natural gas(LNG) and diesel semi-trailer towing vehicles(STTVs) which met China Emission Standard IV and V were tested using Portable Emission Measurement System(PEMS) in northern China.Emission characteristics of these vehicles under real driving conditions were analyzed and proved that on-road emissions of heavy-duty vehicles(HDVs) were underestimated in the past.There were large differences among LNG and diesel vehicles, which also existed between China V vehicles and China IV vehicles.Emission factors showed the highest level under real driving conditions, which probably be caused by frequent acceleration, deceleration, and start-stop.NOx emission factors ranged from 2.855 to 20.939 g/km based on distance-traveled and 6.719–90.557 g/kg based on fuel consumption during whole tests, which were much higher than previous researches on chassis dynamometer.It was inferred from tests that the fuel consumption rate of the test vehicles had a strong correlation with NOx emission, and the exhaust temperature also affected the efficiency of Selected Catalytic Reduction(SCR) aftertreatment system, thus changing the NOx emission greatly.THC emission factors of LNG vehicles were 2.012–10.636 g/km, which were much higher than that of diesel vehicles(0.029–0.185 g/km).Unburned CH_4 may be an important reason for this phenomenon.Further on-road emission tests, especially CH_4 emission test should be carried out in subsequent research.In addition, the Particulate Number(PN) emission factors of diesel vehicles were at a very high level during whole tests, and Diesel Particulate Filter(DPF)should be installed to reduce PN emission.     

曝气生物滤池处理啤酒废水的研究

曝气物滤池使用了新型的粒状填料,能同时发挥生物降解,过滤和吸附等多种功能。实验结果表明：曝气生物滤池处理啤酒废水效果较好,当ＣＯＤ容积负荷为１０ｋｇ／（ｍ＾３．ｄ）时,在０．８ｍ／ｈ、１．４ｍ／ｈ和２．５ｍ／ｈ３种不同水力负荷下ＣＯＤ的出水度分别在５９ｍｇ／Ｌ、８２ｍｇ／Ｌ和５１ｍｇ／Ｌ以下;     

城市污水处理厂中水回用初探

以沈阳市污水处理厂实际工程为例 ,提出了中水回用项目的可行性、项目方案及工程投资预测     

二维平流扩散模型下的集合卡尔曼滤波模拟同化研究

为提高环境数值预报水平,构建了一个针对污染物扩散的模拟数据同化系统。采用集合卡尔曼滤波方法对二维平流扩散模型的状态变量进行了实时校正,实现污染物浓度的实时模拟预报,完成了敏感性实验中集合数目变化、观测方差变化和同化窗口长度变化研究。比较考察观测点位置与污染源距离不同时的预报效果,探讨了优化条件下的同化策略,提出一种根据距离远近动态调节卡尔曼增益权重的方法。在集合数目较小时,可降低计算代价,得到优化的同化效果。     

集合卡曼滤波算法对FARSITE模型林火蔓延预测的修正效果研究

针对火源位置输入偏差导致的FARSITE林火行为模型火线预测不准确的问题,提出了一种基于集合卡曼滤波算法的动态修正方法。利用FARSITE对复杂工况下的林火蔓延过程进行数值模拟,以火线位置为待修正参量,以均方根误差(RMSE)为评价指标,对算法的可行性进行了验证,并研究了算法的集合元素个数,观测数据标准差及同化频率对FARSITE预测偏差的修正效果的影响。结果表明:算法能显著提高FARSITE火线预测精度;逐时同化时:集合元素个数为5 时,算法的修正效果并不理想,随着集合元素个数增大,样本误差减小,修正效果得到改善,但增大到30以上时, 修正能力的提升就不再明显;观测数据标准差大小与RMSE值呈正相关;给定条件下当同化频率由1 h/次降低至2 h/次,整个模拟时长内的误差仍能得到较好控制,RMSE曲线并不会过快增长。     

卡尔曼滤波理论在预报地面径流污染中的应用

本文主要介绍流域径流污染的系统分析方法，并提出采用卡尔曼滤波理论进行仿真，从而实现污染的预报。     

中小型燃煤锅炉湿法除尘废水水质净化技术研究

介绍了利用稀土陶瓷和燃煤炉渣净化锅炉湿法除尘废水的技术研究．并列举实例介绍了该技术在工程中的应用．     

应用OCMA-220型油分仪测定水样中油含量在实际工作中的几个问题

ＯＣＭＡ－２２０型油分仪应用非散红外光谱法测定水样中油的含量，测定结果较稳定，准确度较高，在环境监测中应用广泛。实际操作中，水样中悬浮料粒子较多且萃取层与ＣＣＬ４层为乳化状态时，必须经滤纸过滤和无水Ｎａ２ＳＯ４脱水处理，才能进行测定。但经滤纸过滤和无水Ｎａ２ＳＯ４脱水处理后，空白值分别在５ｐｐｍ和１６ｐｐｍ以上，如果样品油含量较低时，产生的系统误差，将导致分析结果准确度降低。     

BAF+过滤在炼油污水回用中的应用

采用BAF＋过滤处理炼油污水，CODcr石油类、氨氮、SS去除率可以达到51．8％、62．8％、75％、100％，在BAF进水指标符合GB8978—1996污水综合排放标准一级标准，处理后出水指标可以达到CODcr≯55mg／L，Oil≯2m/L，NH3-N≯5mg／L,SS≯1mg／L，达到中石化循环水补充水标准。