航空装备腐蚀维护维修新材料研究进展

针对海洋环境下服役航空装备极易发生腐蚀的问题,介绍了清洗剂、去腐蚀产物膏、缓蚀剂等腐蚀维护维修新材料的研究进展,包括功能、分类、技术指标等。清洗剂用于航空装备的日常清洗、维护以及维修,去除油污等污染物,防止腐蚀;去腐蚀产物膏用于外场航空装备腐蚀产物的原位去除;缓蚀剂用于在不能对现役航空装备的防护体系进行大幅改动的情况下,针对海洋环境下航空装备的防腐蚀需求,对航空装备进行附加防护或临时防护。综合运用腐蚀维护维修新材料进行航空装备的腐蚀防护,可以预防和减少腐蚀的发生,及时对腐蚀部位进行修复,保障航空装备的使用性能和战斗力。     

EDTA直接滴定测定镍

参考磷酸在345~356℃时有强腐蚀性的特点,采有硫磷混合酸消解矿样,能使样品消解完全。本方法经加标校核证明,检测结果重现性好,准确度高。     

有机改性粘土去除赤潮生物的机制研究

研究了季铵化合物改性粘土的制备条件对其去除赤潮藻效果的影响,探讨了该粘土体系高效除藻的机制.实验表明,十六烷基三甲基铵(HDTMA)可以有效地提高粘土的絮凝能力,同时HDTMA改性粘土中含有亚稳态HDTMA,增加了该改性粘土对赤潮生物的灭杀能力.改性粘土去除赤潮藻的能力与所吸附季铵化合物的杀藻能力、吸附量正相关,当老化时间延长、吸附季铵化合物稳定性增强时改性粘土除藻能力大大降低.结构不同的粘土对于吸附HDTMA的稳定化产生的空间阻力不同,在吸附量相同的情况下3层结构的蒙脱土中会有更多的亚稳态HDTMA产生;由于同离子效应,反应介质中高价金属阳离子的存在提高了亚稳态HDTMA的量,因此相应的改性粘土具有更高的赤潮藻去除能力.在60℃条件下吸附的HDTMA会更有效地占据粘土中的阳离子交换位,达到稳定态;而升高或降低温度都会有利于亚稳态HDTMA的出现,相应的改性粘土具有更高的赤潮藻去除能力.     

电解浮选用于活性污泥固液分离的研究

在装有Ti/RuO₂-IrO₂-TiO₂阳极、Ti阴极的电解浮选槽中进行了活性污泥固液分离的研究.考察了影响电解浮选性能的操作参数,这些参数包括水力停留时间、电流密度、进水SS浓度和进水pH值.研究表明,电解浮选是高效的固液分离单元,水力停留时间和电流密度是主要的影响因素.SS的去除率随着水力停留时间和电流密度的增加而增大;污泥负荷增加,SS的去除率下降;pH值影响电解产生微气泡的尺寸和污泥性质,但对SS的去除影响不大,实际应用中可以不调节pH值.进水SS约1 000mg/L时,当水力停留时间为20min,接触室电流密度为5 mA/cm²,分离区电流密度为2.5 mA/cm²,SS的去除率可达97%以上,此时的能耗为0.4～0.5(kW.h)/m³废水.电解浮选产生的浮渣含水率为95.9%,低于溶气气浮和二沉池的污泥含水率,对污泥减量化及其最终处置有较大的意义.     

基于微生物相互作用机理的完全耦合活性污泥模型研究

根据微生物生长机理,推导出微生物的耦合作用机理并在该机理的基础上改进了ASM3 Bio-P模型.假设活性污泥系统中有机物氧化过程、生物硝化过程、生物反硝化过程、生物除磷过程可同时存在,在ASM3 Bio-P模型上添加相关的开关函数,推导出完全耦合活性污泥模型(FCASM).基于计算机程序进行数值模拟,并将FCASM模拟结果与实测值以及ASM3 Bio-P模型模拟值进行对比.结果表明,完全耦合活性污泥模型对氨氮模拟的稳态出水值为1.90 g·m-3,ASM3 Bio-P模型模拟的氨氮稳态出水值为0 g·m-3,而实测的氨氮稳态出水值为1.50 g·m-3,完全耦合活性污泥模型的结果更接近真实值.     

煤燃烧过程中有机钙固氟效果研究

选择醋酸钙镁、醋酸钙2种有机钙为固氟剂,在固定床管式炉上对它们的固氟效果进行了初步研究,并分析了粒径、温度、钙硫比等对试验结果的影响.通过与传统固氟剂碳酸钙的固氟效果进行比较发现:在相同实验条件下,这2种有机钙具有良好的固氟效果,高温阶段效果更加明显,温度为1 000～1 100℃时,醋酸钙镁的固氟率是碳酸钙的1.68～1.74倍,醋酸钙的固氟率为碳酸钙的1.28～1.37倍.     

Effects of cultivation strategies on the cultivation of Chlorella sp. HQ in photoreactors

Heterotrophic cultivation caused high level of ROS and high lipids accumulation. HMTC is the best culture strategy for improving the microalgal biomass. Chlorella sp. HQ had great nutrient removal capacity under five culture strategies. The effects of cultivation strategies (including autotrophic cultivation (AC), heterotrophic cultivation (HC), fed-batch cultivation (FC), heterotrophic+ autotrophic two-stage cultivation (HATC), and heterotrophic+ mixotrophic two-stage cultivation (HMTC)) on the growth and lipid accumulation of Chlorella sp. HQ and its total nitrogen (TN) and total phosphorus (TP) removal in secondary effluent were investigated in column photoreactors. The results showed that the TN and TP removal rates ranged between 93.72%–95.82% and 92.73%–100%, respectively, under the five different strategies. The microalgal growth potential evaluated by the maximal growth rate (R_max) was in the order of HMTC>HC>FC>AC>HATC. The values of biomass, total lipid yield, triacylglycerols (TAGs) yield, and total lipid content of the microalga cultivated in the last 5 d increased significantly, but the TAGs productivities of the five strategies were lower than those in the first 7 d. Compared with all the other cultivation strategies, the TAGs productivity and yield after 12 d of cultivation under the heterotrophic condition reached the highest values accompanying the highest level of intracellular reactive oxygen species (ROS), in which the TAGs yield reached 40.81 mg/L at the end of the cultivation period. The peaks in TAGs yield and ROS level suggested that HC was beneficial for lipids accumulation via regulating the cellular redox status and exerting ROS stress on microalgal cells. In summary, HMTC was the best cultivation strategy for improving the microalgal biomass and HC was the best strategy for microalgal TAGs accumulation to produce biodiesel.     

Recovery of Ni(II) from real electroplating wastewater using fixed-bed resin adsorption and subsequent electrodeposition

Resin adsorption and subsequent electrodeposition were used for nickel recovery. Treated wastewater can meet the Electroplating Pollutant Discharge Standard. The spent resin is completely regenerated by 3 BV of 4% HCl solution. 95.6% of nickel in concentrated eluent was recovered by electrodeposition. Effective recovery of high-value heavy metals from electroplating wastewater is of great significance, but recovering nickel ions from real electroplating wastewater as nickel sheet has not been reported. In this study, the pilot-scale fixed-bed resin adsorption was conducted to recover Ni(II) ions from real nickel plating wastewater, and then the concentrated Ni(II) ions in the regenerated solution were reduced to nickel sheet via electrodeposition. A commercial cation-exchange resin was selected and the optimal resin adsorption and regeneration conditions were investigated. The resin exhibited an adsorption capacity of 63 mg/g for Ni(II) ions, and the average amount of treated water was 84.6 bed volumes (BV) in the pilot-scale experiments. After the adsorption by two ion-exchange resin columns in series and one chelating resin column, the concentrations of Ni(II) in the treated wastewater were below 0.1 mg/L. After the regeneration of the spent resin using 3 BV of 4% (w/w) HCl solution, 1.5 BV of concentrated neutral nickel solution (>30 g/L) was obtained and used in the subsequent electrodeposition process. Using the aeration method, alkali and water required in resin activation process were greatly reduced to 2 BV and 3 BV, respectively. Under the optimal electrodeposition conditions, 95.6% of Ni(II) in desorption eluent could be recovered as the elemental nickel on the cathode. The total treatment cost for the resin adsorption and regeneration as well as the electrodeposition was calculated.     

Subcritical water oxidation of propham by H2O2 using response surface methodology (RSM)

This study was conducted to investigate the degradation of propham, which is a compound that pollutes water and seriously threatens human health, by subcritical water oxidation and using H₂O₂ as an oxidising agent. The maximum total organic carbon removal rate of propham was obtained as 73.65% at 40 min of treatment time and 60 mM of H₂O₂ concentration and 373 K of temperature. In addition, response surface method based on the Box-Behnken design was applied to design the degradation experiments of propham for determination of the combined effects of process variables, namely temperature, concentration of oxidising agent and treatment time. The proposed quadratic model of propham degradation, which was examined with the analysis of variance, was used for navigating the design space. The R² and adjusted R² values of the model were determined as 0.9921 and 0.9819 respectively. It was shown that propham was effectively degraded, thus could be removed from the water by using an environmentally friendly method.     

聚合氯化铝铁絮凝剂的性能研究

煤矸石是采煤过程之废料。本文利用煤矸石制备出了聚合氯化铝铁（ＰＡＦＣ）：一种新型无机高分子絮凝剂，探讨了Ｆｅ＾３＋的稳定性与溶液离子强度之间的关系，发现溶液的离子强度越大，则产生Ｆｅ（ＯＨ）３沉淀时的ＰＨ越高。研究了ＰＡＦＣ水解产物的ζ电位及絮凝效果随ＰＨ的变化情况，比较了ＰＡＦＣ、ＰＡＣ和ＰＦＳ的除浊性能，ＰＡＦＣ在ＰＨ为７．０－８．２范围内除浊效果最佳，ＰＡＦＣ的除浊效果优于ＰＡＣ。