宁波市“十二五”与“十一五”期间酸雨污染特征变化趋势分析

基于地面观测数据,分析了"十一五"和"十二五"期间宁波市酸雨污染特征变化趋势。结果表明,2015年降水pH从2010年的4.37上升到4.89;2010—2015年酸雨发生频率降低了17.4百分点;重酸雨区范围不断缩小,轻酸雨区范围不断扩大,酸雨污染程度有所改善。降水中化学组成变化显示,与"十一五"末相比,2015年除NO_3~-、Cl~-外其他离子浓度均有所下降;2015年SO_3~(2-)与NO_3~-的当量浓度之比从2010年的3.10下降到1.73,表明酸雨污染从硫酸型向硫酸与硝酸混合型转变。     

电石渣－铁屑法去除硫酸废水中的氟和砷

对各种处理含氟、砷废水的方法进行了探讨，选择了以电石渣和废铁屑为药剂去除硫酸废水中氟和砷的方法，取得了较好的效果。该法以废治废、工艺简便、运行费用低，处理后的废水可达排放标准。     

含氟废气对农业环境的影响

叙述了某厂氢氟酸生产过程排出的含氟废气对厂区周围水稻和蔬菜的污染及其与气象条件的关系，并提出了防止农业环境氟污染的措施。     

T酸一次洗水初步处理的研究

采用重氮化－偶合－混凝沉淀和重氮化－混凝沉淀两种方法对Ｔ酸一次洗水的初步处理进步了研究。Ｔ酸一次洗水经两种方法处理后,ＣＯＤ去除率分别为６１．３％、５０．５％,色度去除率分别为７４．６％、７１％。     

萃取法分离回收不锈钢酸洗污泥硫酸浸出液中的重金属

采用非皂化P204和皂化P204萃取剂对不锈钢酸洗污泥的硫酸浸出液进行萃取。在浸出液pH为0.80、非皂化P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取时间为5 min的条件下,Fe~(3+)萃取率达99.64%,Cr~(3+)和Ni~(2+)萃取率为3.98%和6.99%,一次萃余液pH为0.64。采用皂化P204对除Fe~(3+)后的一次萃余液进行萃取,在P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取剂皂化率为60%、一次萃余液pH为1.50、萃取时间为5 min的条件下,Ni~(2+)萃取率为93.12%,Cr~(3+)萃取率为20.69%,二次萃余液pH为2.63。     

皂素和柠檬酸复合淋洗土壤中的钍

采用振荡淋洗和土柱动态淋洗实验研究了皂素和柠檬酸复合对土壤中钍的淋洗性能。实验结果表明:将质量浓度为20 g/L的皂素与浓度为20 mmol/L的柠檬酸以体积比1∶10配制复合淋洗液对污染土壤中钍的去除效果最佳,淋洗3.0 h,钍去除率为84.98%;准一级动力学方程能更好地描述复合淋洗液对钍的淋洗动力学特征;动态淋洗实验中当复合淋洗液用量为1 600 mL时,钍的累积去除量为73.66 mg/kg;淋洗后土壤中钍的酸可提取态、氧化结合态和有机结合态含量分别减少了79.63%、38.13%和20.34%,残渣态含量变化不大;淋洗后土壤中钍的稳定性增加。     

Preliminary studies on potential remediation of acid mine drainage‐impacted soils by amendment with drinking‐water treatment residuals

Mining operations result in a wide range of environmental impacts: acid mine drainage (AMD) and acid sulfate soils being among the most common. Due to their acidic pH and high soluble metal concentrations, both AMD and acid sulfate soils can severely damage the local ecosystems. Proper post‐mining management practices are necessary to control AMD‐related environmental issues. Current AMD‐impacted soil treatment technologies are rather expensive and typically not environmentally sustainable. We conducted a 60‐day bench‐scale study to evaluate the potential of a cost‐effective and environment‐friendly technology in treating AMD‐impacted soils. The metal binding and acid‐neutralizing capacity of an industrial by‐product, drinking water treatment residuals (WTRs) were used for AMD remediation. Two types of locally generated WTRs, an aluminum‐based WTR (Al‐WTR) and a lime‐based WTR (Ca‐WTR) were used. Highly acidic AMD‐impacted soil containing very high concentrations of metals and metalloids, such as iron, nickel, and arsenic, was collected from the Tab‐Simco coal mine in Carbondale, Illinois. Soil amendment using a 1:1 Al‐ and Ca‐WTR mix, applied at 5 and 10 percent rates significantly lowered the soluble and exchangeable fractions of metals in the AMD‐impacted soil, thus lowering potential metal toxicity. Soil pH increased from an extremely acidic 2.69 to a near‐neutral 6.86 standard units over the 60‐day study period. Results from this preliminary study suggest the possibility of a successful scale‐up of this innovative, cost‐effective, and environmentally sustainable technology for remediating AMD‐impacted acid sulfate soils.     

化学环境下的应力-渗流耦合对尾 矿库稳定性影响试验

通过扫描电镜（FE-SEM）、能谱分析（EDX）、X射线衍射（XRD）、LMS-30激光粒度分析等室内试验探究了尾矿库内存在的酸、碱离子对尾矿颗粒的沉降、微观形貌、物质组成以及粒径级配的影响;建立酸、碱影响下的孔隙比与渗透系数的数学关系模型,并将建立的模型用来表征尾矿库内的应力渗-流场两场耦合机制,实现代入有限元计算软件的目的。结果表明:化学因素的存在影响着尾矿颗粒的多项性状,酸性环境下尾矿颗粒发生溶蚀,部分金属元素流失;碱性环境下尾矿颗粒间生成胶结物质,孔隙出现以含氢氧化铁为主的絮状、团簇状堵塞物,改变了渗流速度;尾矿库内浸润线高度在碱性、中性、酸性环境下依次降低,而渗流速度依次升高。     

A comparison of pretreatments on release of sugars from sweet sorghum bagasse for bioethanol production

Dilute acid pretreatment and steam pretreatment were evaluated for maximum sugars release and ethanol production from sweet sorghum bagasse (SSB). The fermentation potential of the condensate and hydrolysate obtained from steam pretreatment (10 kg/cm², 10 minutes) and dilute acid hydrolysis (1% (w/w) sulphuric acid, 25% substrate loading) respectively, was checked with Pichia stipitis NCIM 3497 and Debaryomyces hansenii sp. Ethanol production and yield using acid hydrolysate was higher with Debaryomyces hansenii sp. (28.4 g/L and 0.37 g/g respectively) as compared with Pichia stipitis NCIM 3497 (21.9 g/L and 0.29 g/g respectively).     

羟基乙叉二膦酸镀铜废液的处理及Cu~(2+)的高附加值资源化回收

采用Na BH4还原法将羟基乙叉二膦酸(HEDP)镀铜废液中的Cu~(2+)制备成纳米铜粉,并采用聚丙烯酰胺(PAM)对还原反应后的废液进行絮凝处理。研究了n(Cu~(2+))∶n(Na BH4)、还原反应温度、还原反应时间及PAM添加量对废液中剩余Cu~(2+)质量浓度的影响,并对回收的纳米铜粉进行了XRD和TEM表征。实验结果表明:当n(Cu~(2+))∶n(Na BH4)=4∶6、还原反应温度为50℃、还原反应时间为2 h时,废液中剩余Cu~(2+)质量浓度降低至1.1 mg/L,Cu~(2+)还原率达99.99%;可获得粒径为20~45 nm的近球型、高纯度、由多晶组成的纳米铜粉;当PAM添加量为10 mg/L时,废液中剩余Cu~(2+)质量浓度降至0.35 mg/L以下,达到GB 21900—2008《电镀污染物排放标准》(小于0.5 mg/L)的要求。