雷达吸波复合材料外观失效机理分析及控制方法研究

目的 解决多层泡沫夹芯结构的雷达吸波复合材料在环境效应下产生外观失效的问题。方法 制备3种类型的雷达吸波复合材料,开展典型自然环境试验。观察试验样品外观状态,并检测变形量。通过观察泡沫的微观组织形貌,检测热膨胀量变化及泡沫与树脂间的粘黏强度,用气相色谱质谱联用仪GCMS检测复合材料裂解气体成分,分析复合材料外观失效成因,并提出解决技术途径。结果 6个月自然环境试验后,1#、2#样品外观失效,而3#样品无明显变化。复合材料100℃裂解气体成分为氮气、二氯一氟乙烷、甲基膦酸二甲脂。4种泡沫在22～85℃的最大热膨胀量分别为–0.18%、–0.37%、–0.30%、–0.45%。环氧树脂与4种泡沫的粘黏强度在41～52N,而聚氨酯树脂达到了54～81N。结论 雷达吸波复合材料泡孔内残留气体的释放,是导致外观失效的根本原因。通过热处理工艺,减少样品残留气体量,并提升胶黏剂与泡沫的粘黏复合强度,是提升复合材料环境适应性的有效技术途径。     

炼油企业挥发性有机物无组织排放通量监测现状与发展

炼油企业是重要的挥发性有机物(VOCs)人为排放源,排放的VOCs主要来自无组织源,监控及排放核算困难。笔者总结了国内外炼油企业VOCs排放通量监控及核算技术体系,综述了各类VOCs无组织排放通量监测技术的原理及适用范围,着重评述了工业场地VOCs无组织排放通量监测最佳实用技术——红外掩日通量监测(SOF)和差分吸收激光雷达(DIAL)及其在炼油企业的应用进展。总体上,SOF仪器及监测费用适中,但易受阳光等天气条件限制; DIAL几乎可全天候监测,但仪器及监测费用较高。SOF和DIAL监测的欧美炼油企业VOCs排放系数一般为0. 02%～0. 10%,约为排放清单值的3～10倍。国内炼油厂VOCs排放核算采用的排放系数约为美国排放清单值(0. 01%～0. 02%)的10倍,尚待实测校验和修订。VOCs无组织排放通量监测技术也可用于检查或评估炼油企业泄漏检测与修复(LDAR)等VOCs无组织排放控制效果。     

真鲷去毒相关基因cDNA序列的克隆与肝脏组成型表达分析

赤潮发生时产生的一些海洋生物毒素对人类和海洋动物的安全形成潜在的威胁甚至导致死亡.为从分子水平探讨鱼类中海洋藻毒素的去毒分子机理,采用RT-PCR法克隆了真鲷(Pagrus major)肝脏芳香烃受体核转位蛋白(ARNT)和I时相异生素代谢酶细胞色素P4501A(CYP1A)基因cDNA核心序列,同时,应用半定量RT-PCR方法,以β-肌动蛋白作为外参照,在其指数期增长的范围内研究了芳香烃受体(AHR)、ARNT、CYP1A、II时相异生素代谢酶alpha型谷胱甘肽S-转移酶(GSTA1、GSTA2)、rho型谷胱甘肽S-转移酶(GSTR)、热休克蛋白70(HSP70)基因组成型表达水平.结果发现,真鲷ARNT、CYP1A基因cDNA核心序列片段分别长438bp和908bp,分别编码146和302个氨基酸.序列同源性分析发现,真鲷与门齿鲷(Stenotomus chrysops)、石首鱼(Micropogon undulatus)ARNT基因氨基酸序列同源性高达97.2%、95.2%,与斑马鱼(Brachydanio rerio)、人、大鼠、小鼠ARNT同源性较低(77.2%～79.3%).真鲷与门齿鲷、金头鲷(Sparus auratus)、欧洲川鲽(Rhombus maximus)、欧洲海鲈(Dicentrachus labrax)CYP1A基因氨基酸序列同源性较高,为84.8%～94.0%,与斑马鱼、人、小鼠CYP1A同源性较低,为59.6%～77.8%.真鲷肝脏AHR、ARNT、CYP1A、GSTA1、GSTA2、GSTR和HSP70基因组成型表达水平分别为(25.32±6.56)%、(26.22±4.24)%、(146.5±16.06)%、(55.42±3.75)%、(48.82±10.89)%、(79.47±3.13)%、(107.42±14.34)%.     

基于固态碳源的自养-异养耦合生物脱氮工艺研究

采用基于固态碳源的厌氧氨氧化与反硝化耦合脱氮工艺处理高氮低碳的金属热处理废水。通过接种城市生活污水处理厂剩余污泥和厌氧氨氧化絮状污泥,研究了以固态碳源（3-羟基丁酸脂和3-羟基戊酸脂共聚物,PHBV）和沸石为组合填料的分区式耦合反应器的启动和运行特性。经过76 d的运行,耦合反应器的总氮去除速率达1.05 kg/（m³·d）,且具有良好的出水COD稳定性。废水经过反应器沸石区后,氨氮去除率达97%,亚硝态氮去除率达81%,而硝态氮去除率几乎为零;经过PHBV区后,硝态氮去除率达76%,亚硝态氮去除率达99%,氨氮去除率达97%。沸石区主要进行厌氧氨氧化反应,PHBV区主要进行反硝化反应,功能分区明确,耦合效果较好。     

基于激光雷达走航车的大气污染物探测技术及其应用

大气气溶胶对人体健康环境和全球气候都有一定的影响,是大气污染的主要来源。为了提升空气质量,大气污染防治刻不容缓。把气溶胶探测激光雷达和测风激光雷达集成在车辆上,进行走航和扫描探测可获得立体的大气气溶胶时空变化状态图。以合肥和芜湖等地大气气溶胶探测为例,基于激光雷达走航车的探测数据,获得大气气溶胶消光系数时空分布图,搜寻污染物排放源和估算颗粒物的PM_2.5输送通量。由此可知,激光雷达走航式探测技术是获得大气污染立体图像便捷的、有效的方法,可为大气污染防治提供精准的科学依据,具有重要的应用价值。     

Mine rescuers’ heat load during the expenditure of physical effort in a hot environment,using ventilated underwear and selected breathing apparatus

Mine rescuers’ heat load under the same physical effort load (25% of the maximal oxygen uptake), using three types of breathing apparatus, in newly developed heat-removing underwear and outerwear was assessed for typical work conditions of mine rescuers, under milder and harsher ambient conditions of 32 and 38?°C, respectively, both at relative humidity of 85% and air velocity of 1.0?m/s. Expending physical effort at the same load while using different kinds of breathing apparatus resulted in a similar heat load. Under both milder and harsher ambient conditions, heat storage and sweating intensity were greater than the average limit value recommended by hygienic standards, which indicates that the use of breathing apparatus significantly hinders heat exchange with the environment. The developed clothing for mine rescuers was highly rated, and was considered by most people to be better than that used currently.     

低温取芯过程热传递方式的数值模拟和实验研究

为了研究热量在低温取芯过程中传递的方式,以型煤为研究对象,使用自制低温取芯模拟装置,通过实验并结合数值模拟,对低温取芯过程热量传递方式进行研究,进而分析煤芯温度的变化规律。研究结果表明:甲烷的存在降低了煤样的热交换速率,使煤芯温度变化滞后于煤样罐壁温度变化;煤体内部温度分布存在差异,煤样中心轴线不同半径处的圆柱面构成变温过程的等温面,在降温过程,热量沿径向由煤样内部向外部传递,升温过程,热量沿径向由外部向内部传递;低温取芯过程热量传递同时存在3种方式:热传导、热对流,煤体表面与罐体内壁表面之间的热辐射,以热传导方式为主。     

An experimental and a numerical study of horizontal earth-air heat exchanger in a hot climate

Earth-air heat exchangers (EAHE) are devices used in the geothermal technique in order to reduce energy consumption in buildings. In this study, a simulation was conducted through the computational fluid dynamics platform FLUENT 6.3 for the prediction of thermal performance of the EAHE that describes the variation of the air temperature inside the tube. For this, it was necessary to design the heat exchanger while respecting the design and the actual dimensions of the experimental set-up, and stating that the temperature of the wall of the horizontal tube of the exchanger is equal to that of ground at 3 m depth. It should be noted that in assessing the temperature along the two sections vertical (input and output) of the exchanger, opting for a function (UDF) the user define function. Finally, noting a good agreement between both experimental and numerical study, and showing that a significant reduction in temperature at the outlet of the exchanger to a difference of 20 °C, confirming the effectiveness of the heat exchanger.     

An investigation of a heat pump system using CO2/propane mixture as a working fluid

In order to decrease the heat rejection pressure of heat pump using pure working fluid, CO₂ or R744, other natural component including hydrocarbons (R290, R600a, R600, R1270, R170, R601) and dimethyl ether (RE170) is added to CO₂, respectively, and then six binary mixtures are achieved. By environmental and thermodynamic comparisons, R290 is selected to be the most appropriate component candidate to mix with CO₂, and meanwhile to weaken the flammability and explosivity for pure R290. Then, the system performances of heat pump using mixture of CO₂ and R290 were experimentally studied when R290 is added to CO₂ with a small fraction, and compared with that of the pure CO₂. The experimental test rig is designed and set up for the transcritical heat pump system. When the refrigerant charge is variable, the heating coefficient performance, optimum heat rejection pressure, compressor power, mass flow rate of refrigerant, and total heat coefficient of gas cooler were researched. The variation ratios of heating coefficient performance and heating capacity with deviation from the optimum refrigerant charge were also investigated. The optimum refrigerant charge of CO₂/R290 is obtained and the research results show that the addition of R290 to CO₂ can efficiently reduce the heat rejection pressure and improve the system performance. The results in the present work could provide useful guidelines for the design and operation of heat pump system using CO₂-based mixture.     

The influences of recycle effect on double-pass V-corrugated solar air heaters

The study of the heat transfer enhancement for the recycling double-pass V-corrugated solar air heaters, which implement the external recycle of flowing air, was investigated experimentally and theoretically. The comparison among different designs of V-corrugated, baffled and fins attached, and flat-plate collectors was made to show the device performance improvement with various operating parameters under the same working dimensions. The recycling double-pass V-corrugated device developed here was proposed in aiming to strengthen the convective heat-transfer coefficient and enlarge the heat transfer area. The error analysis of experimental results deviate by 0.85–2.46% from the theoretical predictions with the fairly good agreement, and both results show that the device performance of the recycling double-pass V-corrugated operation is better than those of the other configurations under various recycle ratios and mass flow rates. The suitable selections were obtained for operating recycling double-pass V-corrugated devices while considering with an economic viewpoint by both the collector efficiency enhancement and the power consumption increment.