无排泥运行MBR处理不同浓度氨氮废水及其生物特性

考察了水力停留时间(HRT)为10 h时无排泥运行下膜-生物反应器(MBR)处理不同浓度氨氮无机废水的运行性能及微生物特性.结果表明,在处理NH₄⁺-N≤500 mg/L的废水时,氨氮转化率可达99%且反应器内微生物增长缓慢,比硝化速率从0.2kg/(kg·d)升至0.52 kg/(kg·d);当NH₄⁺-N≥700 mg/L时,出水亚硝酸氮和氨氮相继出现明显累积,比硝化速率随之下降至0.4kg/(kg·d)以下,反应器内生物量从3 200 mg/L上升至6 700 mg/L.反应器中的氨氧化菌维持在10⁷CFU/mL,亚硝酸盐氧化菌从10⁶CFU/mL下降至10³CFU/mL.系统内的溶解性微生物产物(以TOC表示)升至65 mg/L后保持稳定,出水TOC一直维持在3～4mg/L;细胞外分泌物(EPS)在膜的截流作用下随运行时间的延长积累至600 mg/L.     

硝化菌与膜生物反应器结合处理生活污水中氨氮

研究了硝化菌与膜生物反应器结合处理生活污水中氨氮，实验用水采用食堂与化粪池混合水，实验装置采用膜生物反应器，进水氨氮在4mg／L左右，出水氨氮值接近0，实验结果表明出水能够达到国家工业冷却回用水的指标要求，同时COD也降至30mg／L以下，能满足回用要求。     

MBR-PAC系统影响因素的研究

向膜生物反应器内投加40 g·L-1粉末活性炭处理尾水,运行效果良好.排泥和水力停留时间对处理效果有很大影响,流量和曝气量在一定程度上决定了膜污染的进程,粉末活性炭吸附降解了一些易引起膜污染的有机物,改变了污泥的性质,使膜通量得到改善.气洗和反冲洗能很好的维持膜通量,离线清洗可使膜通量基本恢复.     

Laboratory scale studies on removal of chromium from industrial wastes

Chromium being one of the major toxic pollutants is discharged from electroplating and chrome tanning processes and is also found in the effluents of dyes,paint pigments,manufacturing units etc.Chromium exists in aqueous systems in both trivalent(Cr^3 )and hexavalent (Cr^6 )forms.The hexavalent form is carcinogenic and toxic to aquatic life,whereas Cr^3 is however comparatively less toxic.This study was undertaken to investigate the total chromium removal from industial effluents by chemical means in order to achieve the Pakistan NEQS level of 1 mg/L by the methods of reduction and precipitation.The study was conducted in four phase Ⅰ,the optimum pH and cost effective reducing agent among the four popular commercial chemicals was selected.As a result,pH of 2 was found to be most suitable and sodium meta bisulfate was found to be the most cost effective reducing agent respectively.Phase Ⅱ showed that lower dose of sodium meta hisulfate was sufficient to obtain 100% efficiency in reducing Cr^6 to Cr^3 ,and it was noted that reaction time had no significance in the whole process.A design curve for reduction process was established which can act as a tool for treatment of industrial effluents.Phase Ⅲ studies indicated the best pH was 8.5 for precipitation of Cr^3 to chromium hydroxide by using lime.An efficiency of 100% was achievable and a settling time of 30 minutes produced clear effluent.Finally in Phase Ⅳ actual waste samples from chrome tanning and electroplating industries,when precipitated at pH of 12 gave 100% efficiency at a settling time of 30 minutes and confirmed that chemical means of reduction and precipitation is a feasible and viable solution for treating chromium wastes from industries.     

膜生物反应器在高浓度有机废水处理中的应用

介绍了膜生物反应器 (MBR)在高浓度有机废水中的应用。实验结果表明 ,系统对COD、氨氮的去除率较高 ,但出水浓度仍然较高 ,出水几乎监测不到SS。另外 ,膜的通量下降很快 ,维持在较低的水平。     

A pilot scale anoxic/oxic membrane bioreactor (A/O MBR) for woolen mill dyeing wastewater treatment

A pilot-scale( 10 m^3/d) anoxic/oxic membrane bioreactor( A/O MBR) was tested for dyeing wastewater treatment of woolen mill without wasting sludge in 125 days operation. Results showed that the effluent quality was excellent, i.e. effluent COD less than 25 mg/L,BOD5 under 5 mg/L, turbidity lower than 0.65 NTU, and colour less than 30 DT, and met with the reuse water standard of China. The removal rates of COD, BOD5, colour, and turbidity were 92.4%, 98.4%, 74% and 98.9%, respectively. Constant-flux operation mode was carried out in this study, and backwash was effective for reducing membrane fouling and maintaining constant flux. Membrane fouling had heavy impact on energy consumption. More attention should be paid on pipe selection and design for the sidestream MBR system, too.     

印染废水集中处理工程的实例分析

针对印染企业集中园区产生的综合废水复杂多变,必要选择合式的处理工艺,因此,以某印染企业集中园区的污水处理厂为例,采用厌氧＋好氧＋物化组合工艺,并对废水的脱色和可生化性的改善进行了试验研究,通过类比调查,优化工程设计参数;经工程实践证明,综合印染废水经该工艺处理后,能达到一级排放标准.     

Ecotoxicological and chemical evaluation of phenolic compounds in industrial effluents

The aim of this paper was to evaluate the ecotoxicological response of industrial effluents containing phenolic compounds. All complex effluents collected from a chemical plant and then after both a chemical–physical and biological treatment were characterised with chemical analysis, biodegradability tests and four ecotoxicological tests (Daphnia magna, Artemia salina, Brachionus plicatilis and Vibrio fisheri with Microtox^®). The evaluation of the chemical and ecotoxicological data was useful for predicting the effect of the raw effluent on the treatment plant and the impact of the final treated effluent on the receiving water. Besides the toxicity of the effluent from the chemical plants, the acute toxicity of its main components was also determined. The results of the tests and toxicity data from literature were transformed in Toxic Units (TUs). Effluent toxicity was under- or over-estimated by calculating the sum of the TUs of the individual components, depending on which toxicity data and test organisms were used.     

气-水联合反冲洗膜污染防治技术研究

采用气水联合反冲洗技术,考察了气水比(Qg/Ql)、反冲洗周期及其对膜污染的防治效果。结果表明,气水联合反冲洗较单独气或水反冲洗效果好;在过滤周期20min,反冲洗时间1min,气水比1.5时,气水联合反冲洗能够恢复膜通量到膜清水通量的80%以上。此法可大幅度清除沉积在膜表面的泥饼层,恢复膜通量,维持膜过滤性能的稳定,是一种较为有效的膜污染防治技术。     

悬浮填料对厌氧氨氧化MBR运行的影响特性及机理

向厌氧氨氧化（anammox）膜生物反应器（MBR）投加悬浮填料,考察其对反应器脱氮性能和膜污染的影响特性,并探究了相关机理.试验结果表明,投加填料后,反应器脱氮性能良好.当进水氨氮（NH₄⁺-N）160mg/L、亚硝态氮（NO₂^--N）180mg/L时,出水NH₄⁺-N和NO₂^--N均在15mg/L以下,硝态氮（NO₃^--N）在30mg/L以下,总氮去除率可达90%.投加填料显著减轻了膜污染,跨膜压差（TMP）稳定在8kPa左右.混合液中溶解性微生物产物（SMP）和胞外聚合物（EPS）成分分析结果表明,在第67~149d,蛋白质总量、多糖总量和总有机碳总量分别下降了49%、43%和61%,它们浓度的下降有利于延缓膜污染;此外,悬浮填料对膜组件的机械碰撞也起到了物理清洗作用.高通量测序结果显示,悬浮填料生物膜在anammox菌相对丰度方面显著高于混合液污泥,说明anammox菌更适宜于附着生长,投加填料可以为其提供更加稳定的生长环境.