电化学法处理含盐染料废水

研究了电化学法处理含盐染料废水的可行性及其处理效果．结果表明,电化学法对废水的色度和COD具有良好的去除效果,电解过程中余氯的产生对色度和COD的去除有决定性作用．实验确定的高浓度含盐废水电化学处理条件为：电流密度0．017A/cm²,电压10．3V,平均电导率12．35ms/cm,电解60min,色度和COD的去除率分别为85％和99．8％．电解过程无难以继续反应的中间产物生成．     

新型膜生物反应器的研究和应用

膜生物反应器 (MBR)是膜技术与生物反应器相结合而形成的一种新型的废水处理工艺。文章介绍了新型膜生物反应器对各种特种废水的处理效果 ,详细介绍了膜生物反应器在国内外的应用情况 ,探讨了存在的问题和解决的途径。     

基因工程菌在厌氧膜生物反应器中对偶氮染料废水的脱色

印染和染料废水色度大,COD高,可生化性差.采用基因工程菌Escherichia coli JM109(pGEX-AZR)在厌氧膜生物反应器中,对模拟偶氮染料废水进行脱色研究.结果表明,系统对酸性红B有很好的脱色能力,且启动期短,脱色效率高,脱色率稳定在95%以上,对COD的去除率能达到68%.系统运行过程中,反应器内生物量稳定在0.4 g/L.EPS与生物量变化趋势一致,先升高后降低;pH值在运行初期由6.5降至6.2,后维持在6.6左右.系统运行27 d后进行第一次膜清洗,膜通量恢复为初始值的92%,系统运行周期约为26 d.     

两级序批式MBR膜污染特性研究

采用两级SBR与膜法相结合的两级序批式MBR工艺处理生活污水,考察两级序批式运行模式对膜污染特性的影响.对运行111 d后的平板膜污染阻力分布进行了测算,并对两级序批式MBR与连续流单级好氧MBR的平板膜污染速率进行对比试验.结果表明: 两级序批式MBR的平板膜污染阻力以凝胶极化阻力为主,占总阻力的43%,沉积阻力较低,仅占总阻力的10%;与连续流单级好氧MBR相比,两级序批式MBR可以在更高的膜通量下运行,保持更低的膜污染速率,在运行42 d后,过膜流量从100 L/h下降至85 L/h,过膜压差从1.52×10~4 Pa增加至2.22×10~4 Pa;而连续流好氧MBR系统,过膜流量从61 L/h降低至39 L/h,过膜压差却从1.01×10~4 Pa增加至2.63×10~4 Pa.研究表明,两级序批式MBR工艺可以改善膜过滤过程的水力条件,从而有效地减缓浓差极化,降低沉积污染及凝胶层污染,序批式、膜间歇运行与空曝的结合起到了关键性作用.     

不同污泥龄膜生物反应器内微生物的群落结构特征

为研究不同污泥龄MBR(膜生物反应器)内的微生物群落结构特征,构建了SRT(污泥龄)分别为10、20、40和80 d的4个平行的MBR,通过PCR-DGGE技术获得各MBR内微生物的DNA指纹图谱,并对条带进行切胶测序. 结果表明,SRT不影响MBR对废水的处理效果,不同SRT下MBR对NH₄+-N和COD_Cr的去除率均能达到90%以上. DGGE结果表明,在运行过程中,各MBR内的微生物群落结构均发生了明显变化,并且不同SRT的MBR内总细菌群落结构变化特征相同;SRT影响同一微生物在各MBR中的出现速率;总细菌Shannon-Wiener多样性指数和丰富度指数均随着SRT的增加而升高,SRT为80 d的MBR内Shannon-Wiener多样性指数最高. 测序结果表明,不同SRT的MBR内的优势种属不同,其中Arcobacter sp.、beta proteobacterium及Thiothrix sp.为不同SRT的MBR中共同存在的关键菌属,对MBR的运行起着重要作用.      

Heavy metals distribution and risk assessment in soils affected by tannery effluents

Effluents collected from tanneries in Sialkot showed considerably higher levels of heavy metals. Sodium (12 660.91 mg/L) among macronutrients and Cr (592.20 mg/L) among heavy metals were found in the highest concentrations. Effluent parameters, i.e. biological oxygen demand (BOD; 12.40), chemical oxygen demand (COD; 16.53), Cd (5.90), Cr (592.20) and Fe (18.59) were the respective times higher than Pakistan National Environmental Quality Standards and their continuous unchecked discharge into agricultural soils poses a potential risk. Mean concentrations (mg/L) of Cr (592.20), Ni (2.66), Mn (1.16), Fe (37.17), Zn (0.90), Cd (0.59) and Pb (1.18) in this study exceeded levels recorded to date from different tanning hubs in Pakistan. Factor analysis/principal components analysis (FA/PCA) for the effluent parameters resulted in six varimax factors, i.e. VF1 (salinity, electrical conductivity, total dissolved solids, chloride, phosphate, BOD and COD; including characteristic tannery effluent features), VF2 (pH, Cr and alkalinity; tanning operations), VF3 (Cd and Pb; dyeing processes), VF4 (Mn and Fe; finishing operations), VF5 (Ni; retaining processes) and VF6 (hardness, Ca and Cu; bating processes). Cluster analysis performed on metal data resulted in three clusters confirming metal–metal relations obtained either from FA/PCA or a correlation matrix. The results of this study are useful for heavy metal source apportionment, assessment of risk to peripheral soils and the future management of environments around tanneries.     

Impact of heavy metals of industrial plant wastewater on benthic communities of Bizerte Lagoon (Tunisia)

ABSTRACT

The aim of this study was to assess the consequences of human impact on the characteristics of sediments heavy metal concentration, grain size and its influence on the structure of the microbial and meiofaunal community assemblages. A survey was carried out in July 2013 within six sites located in the Bizerte Lagoon (Tunisia), both downstream and upstream of industrial effluents. The highest total sediment metal concentrations were detected in stations located close to the industrial sewage discharge points. In these stations, the lowest densities of the total meiofauna (33?±?13?ind/10?cm^?2) and conversely the highest densities of cultivable bacteria that are heavy metal resistant have been reported (16?±?80.34?CFU?g^?1). Univariate (ANOVA) and multivariate (MDS/CCA) analyses demonstrate high dissimilarity (0.06) in meiofaunal and bacterial community structures between downstream and upstream industrial sewages. Furthermore, canonical correspondence analysis CCA results indicated that heavy metal sediment contamination promoted bacteria that are resistant to heavy metals, while heterotrophic bacteria supported the development of meiofauna taxa. The results highlight the importance of bacteria/meiofauna interactions, as both meiofaunal and microbial communities give indications of the ecological impact of heavy metal contamination in sediment.     

废水处理系统中生物聚集体胞外多聚物研究进展

胞外多聚物(Extracellular polymeric substances,EPS)是废水生物处理系统中生物聚集体(包括絮体污泥、生物膜、颗粒污泥等)的重要组成部分,直接包裹于微生物细胞壁外,其理化性质及所处的特殊位置决定了它在生物聚集体中的重要作用.综述了EPS对废水生物处理系统污泥沉降性能、脱水性以及膜生物反应器膜污染影响的相关研究,分析认为EPS组成与结构特性改变污泥表面电位、疏水性等,进而影响污泥沉降与脱水性能、膜污染程度;以好氧颗粒污泥为典型的生物聚集体代表,总结了EPS组分含量与分布对颗粒污泥的形成与结构稳定性的影响,并在EPS提取方法标准化、现代理化技术与分子生物学技术综合分析等方面进行了展望,进一步的研究有望揭示生物絮凝体形成过程EPS的产生与调控机制.     

MBR去除水中新型微污染物PPCPs的效果及影响因素

结合MBR和新型微污染物药品和个人护理用品(PPCPs)的特性,论述了MBR对水中PPCPs的去除效果,并分析其处理过程中的主要影响因素,以期为进一步的研究应用提供理论基础及参考。     

SMBR-IVCW系统处理高浓度综合污水

为了提高污水处理的质量和效率,将高效的生物处理技术--膜.生物反应器(SMBR)与生态净化技术--复合垂直流人工湿地(IVCW)进行有效复合而成的SMBR-IVCW复合系统应用于高浓度综合污水的高效处理与回用中.通过对不同水力负荷组合条件下SMBR-IVCW系统对污染物净化效果的比较,得到了该复合系统的较好水力组合条件.结果表明,SMBR-IVCW具有良好的净化功效及稳定性,SMBR单元在有机物的去除、硝化作用中起到主要贡献,而IVCW单元在反硝化脱氮、深度除磷等方面进一步补充,两者的有机结合能充分发挥各自的优势,并得到了较优的水力负荷组合条件:SMBR为1000L·d-1,IVCW为375mm·d～;在该条件下.SMBR-IVCW系统总停留时问为19.22h.处理后出水中CODcr、TP、NH 4-N浓度分别为11.0、0.086、0.44mg·L-1,均可达地表水环境质量Ⅲ类标准(GB 3838.2002).SMBR-IVCW系统在此类污水处理方面具有良好的潜力.