Dairy washwater treatment using a horizontal flow biofilm system

In Ireland, dairy farmyard washwater commonly comprises farmyard run-off and dairy parlour washings. Land-spreading is the most widely used method for treating this wastewater. However, this method can be labour intensive and can cause, in some cases, the degradation of surface and ground waters, mainly due to nitrogen contamination. In this study, a horizontal flow biofilm reactor (HFBR) with step-feed was constructed and tested in the laboratory, to remove organic carbon and nitrogen from a agricultural strength synthetic washwater (SWW). The HFBR had an average top plan surface area (TPSA) of 0.1002 m(2) and consisted of a stack of 45 polystyrene horizontal sheets--15 sheets embedded with 25 mm deep frustums above 30 sheets with 10 mm deep frustums. The frustums acted as miniature reservoirs. The sheets were alternately offset to allow the wastewater to flow horizontally along each sheet and vertically from sheet to sheet down through the reactor. Biofilms developed on the sheets and treated the wastewater. During the 212-d study, the total hydraulic loading rate based on the TPSA of the sheets was 35 l m(-2) d(-1). SWW was pumped for 10 min each hour, in a step feed arrangement at a rate of 23.33 l m(-2) d(-1) on to the top sheet during Phases 1 and 2, and 11.67 l m(-2) d(-1) onto Sheet 16 during Phase 1 (days 1-92) and onto Sheet 30 during Phase 2 (days 93-212). The substrate loading rate during Phases 1 and 2 was 94.8 g total chemical oxygen demand (COD) m(-2) d(-1) and 10.5 g total nitrogen (TN) m(-2) d(-1), based on the TPSA. At steady state in Phase 2, the unit achieved excellent carbon removal of 99.7% 5-day biochemical oxygen demand (BOD(5)) and 96.7% total COD, equivalent to TPSA removal rates of 67.5 g BOD(5)m(-2)d(-1) and 91.7 g COD m(-2) d(-1). The nitrogen removal percentages were 98.3% total ammonium-nitrogen (NH(4)-N(t)) and 72.8% TN, which equated to TPSA removal rates of 4.8 g NH(4)-N(t) m(-2) d(-1) and 7.6g TN m(-2) d(-1). No sloughing of solids or clogging of media occurred during the study. The unit was simple to construct and operate, with little maintenance.     

Source identification and characterization of the accumulating non-biodegradable organics in Korean reservoirs

An increase in the chemical oxygen demand (COD) has been noticed in most Korean reservoirs. Therefore, this research systematically investigated the causes of organic accumulation. Samples of soil affecting the quality of water of reservoirs were collected at various sources and analyzed for their organic characteristics. The COD to biochemical oxygen demand (BOD) ratio was used as the key parameter in the evaluation of non-biodegradable (NBD) organic accumulation in the reservoirs. Soil samples containing plant roots were agitated, with the supernatant showing COD/BOD ratios of less than 2.8, while those of the composted tree leaves were greater than 5.0, suggesting that humic substances produced in forest areas are a major cause of NBD organic accumulation in reservoirs. In addition, the organic fractionation of the leachate from leaching tests showed that of the various types of hydrophobic natural organic matter (NOM), the larger molecular weight humic acid makes a greater contribution than fulvic acid to the increase in the NBD COD in Korean reservoirs.     

Sorption of native polyaromatic hydrocarbons (PAH) to black carbon and amended activated carbon in soil

Organic pollutants (e.g. polyaromatic hydrocarbons (PAH)) strongly sorb to carbonaceous sorbents such as black carbon and activated carbon (BC and AC, respectively). For a creosote-contaminated soil (Sigma15PAH 5500 mg kg(dry weight(dw))(-1)) and an urban soil with moderate PAH content (Sigma15PAH 38 mg kg(dw)(-1)), total organic carbon-water distribution coefficients (K(TOC)) were up to a factor of 100 above values for amorphous (humic) organic carbon obtained by a frequently used Linear-Free-Energy Relationship. This increase could be explained by inclusion of BC (urban soil) or oil (creosote-contaminated soil) into the sorption model. AC is a manufactured sorbent for organic pollutants with similar strong sorption properties as the combustion by-product BC. AC has the potential to be used for in situ remediation of contaminated soils and sediments. The addition of small amounts of powdered AC (2%) to the moderately contaminated urban soil reduced the freely dissolved aqueous concentration of native PAH in soil/water suspensions up to 99%. For granulated AC amended to the urban soil, the reduction in freely dissolved concentrations was not as strong (median 64%), especially for the heavier PAH. This is probably due to blockage of the pore system of granulated AC resulting in AC deactivation by soil components. For powdered and granulated AC amended to the heavily contaminated creosote soil, median reductions were 63% and 4%, respectively, probably due to saturation of AC sorption sites by the high PAH concentrations and/or blockage of sorption sites and pores by oil.     

Sorption of polar and nonpolar organic contaminants by oil-contaminated soil

Sorption of nonpolar (phenanthrene and butylate) and polar (atrazine and diuron) organic chemicals to oil-contaminated soil was examined to investigate oil effects on sorption of organic chemicals and to derive oil–water distribution coefficients (K_oil). The resulting oil-contaminated soil–water distribution coefficients (K_d) for phenanthrene demonstrated sorption-enhancing effects at both lower and higher oil concentrations (C_oil) but sorption-reducing (competitive) effects at intermediate C_oil (approximately 1 g kg⁻¹). Rationalization of the different dominant effects was attempted in terms of the relative aliphatic carbon content which determines the accessibility of the aromatic cores to phenanthrene. Little or no competitive effect occurred for butylate because its sorption was dominated by partitioning. For atrazine and diuron, the changes in K_d at C_oil above approximately 1 g kg⁻¹ were negligible, indicating that the presently investigated oil has little or no effect on the two tested compounds even though the polarity of the oil is much less than soil organic matter (SOM). Therefore, specific interactions with the active groups (aromatic and polar domains) are dominantly responsible for the sorption of polar sorbates, and thus their sorption is controlled by available sorption sites. This study showed that the oil has the potential to be a dominant sorptive phase for nonpolar pollutants when compared to SOM, but hardly so for polar compounds. The results may aid in a better understanding of the role of the aliphatic and aromatic domains in sorption of nonpolar and polar organic pollutants.     

微波萃取技术在分析土壤中有机污染物的应用

介绍了微波萃取技术及其使用的试剂、设备和条件,对微波萃取在分析土壤中有机污染物的应用予以综述,阐述了微波萃取技术是分析土壤中有机污染物的好方法。     

上海市饮用水源地优先控制有机污染物筛选

综合考虑国外优先控制污染物筛选的方法,根据上海市集中式生活饮用水源地特定80项和地表水控制的109项以外项目、全市挥发性和半挥发性有机项目、水源地突发性应急事故有机污染物等实际监测数据和历年来微量有机污染物研究成果,制定饮用水源地优先控制有机污染物筛选的原则、程序和过程,对出现频率高、超标几率高、浓度高,可能对人体健康产生影响的有机污染物进行筛选,提出包括多环芳烃、酞酸酯、卤代烃和其他共4类7种上海市饮用水源地优先控制有机污染物名单.     

我国水环境有机物分析前处理技术

介绍了我国水环境有机物分析中常用的前处理技术,包括液液萃取、树脂吸附、固相萃取、固相微萃取、液膜萃取、半透膜被动采样、顶空、吹扫-捕集等,归纳了各种方法的原理、应用及优缺点,并对环境中有机污染物前处理技术的发展方向进行了展望。     

Modeling the carbon dynamics of the La Grande hydroelectric complex in northern Quebec

A mechanistic semi-empirical carbon cycle model of the La Grande reservoir complex in northern Quebec, Canada was conceived in order to investigate the climate impact of such a large alteration of the continental water cycle. The model includes inputs from the drainage basin, organic matter release from flooded soils, CO₂ emissions across the water-atmosphere interface and sedimentation. Most input data stems from previous research by our group on those ecosystems. The model includes the seven reservoirs of the La Grande complex and was run for periods of 50 and 100 years. Terrigeneous dissolved, particulate and suspended soil carbon fluxes and concentrations were computed. Over 100 years, 31.3 × 10¹² g C are released from flooded soils, equivalent to 28-29% of inputs from the drainage basin. 40-74% of dissolved organic carbon is mineralized. CO₂ fluxes over 100 years are 50.5-79.8 × 10¹² g C, 46.4-67.9 × 10¹² g C more than in the absence of reservoirs. The increase in mineralization of organic matter and in CO₂ emissions is a result of the increase in cumulated water residence time due to the creation of the reservoirs. Changes in other carbon sinks and sources likely offset a part of this additional carbon flux to the atmosphere. In the first years following flooding of the reservoir, organic carbon release from flooded soils exceeds CO₂ emissions, implying the downstream export of large quantities of eroded soil organic carbon. After this initial period, CO₂ emissions are fuelled by organic carbon originating from the drainage basin.     

Particulate organic matter in the Northern and Central Adriatic

The particulate organic matter distribution and its elemental composition in the northern and central Adriatic Sea during different seasonal periods are shown, highlighting the principal processes and factors influencing their distribution and characteristics. In the low salinity waters the concentrations of particulate carbon, nitrogen and phosphorus were higher and more variable than in the dense waters, mainly due to dilution effects which induce an abundant phytoplankton growth. Generally in summer the particulate organic matter distribution followed the trophic gradient while in winter resuspension events often became more important. Differences between summer and winter were more evident in the diluted waters and were mainly due to the seasonal heat exchanges and to the fresh water inputs. Marked differences in C/P ratios were observed in the POM: high ratios in the northern diluted waters and low in the more saline waters and in the central Adriatic.     

Inorganic and methyl-mercury speciation in sediments of the Swarzędzkie Lake

Sediment samples were analysed for mercury and methylmercury content in different parts of the bottom sediment of Swarz ?dzkie Lake, which were influenced by different external pollution sources. The results of determination with two methods of mineralization using two separate media (HNO₃/H₂O₂ and HF) were compared. The accuracy of the studied methods was analysed using certified reference material IAEA 405 of river sediment. The recovery of mercury was satisfactory and ranged from 97.5 to 98.8%. Methylmercury compounds in the studied sediments were found in limited concentrations. Their concentrations ranged from 0.26 to 58.1 μg kg^?1, i.e. 1.0–7.4% of the total mercury content. The depth profile displayed high values of both total and methylmercury content at a depth of 10–20 cm, related to the heavy pollution of the lake in the 1980s. Canonical analysis displayed the relationship of both total mercury and methylmercury concentrations with organic matter and phosphorus content in bottom sediments.