Fe3O4稳定化纳米Pd/Fe对水中2,4-D的催化还原脱氯研究

采用四氧化三铁(Fe3O4)稳定化纳米Pd/Fe催化脱氯水溶液中的2,4-二氯苯氧乙酸(2,4-D),获得了良好的处理效果.实验考察了Fe3O4投加量、pH、钯化率、温度、搅拌速率等因素对2,4-D去除的影响.2,4-D去除率随Fe3O4投加量增加而提高,投加量为4.0 g·L-1时,反应210 min后,2,4-D去除率为93.5%,而未稳定的纳米Pd/Fe,去除率为47.3%.低pH可促进2,4-D还原脱氯,pH为2.6~4.1时,2,4-D在110 min内几乎完全去除.2,4-D去除率随钯化率增加而提高.随着钯化率由0.25%、0.50%增加到0.75%,210 min后,2,4-D的去除率也由51.4%、93.5%提高到99.9%.温度在16.5~30.0℃范围内,反应210 min后,2,4-D去除率均可超过90.0%.温度升高到35.0、40.0℃时,去除率显著下降.2,4-D去除率随着搅拌速率加快而提高.Fe3O4的加入可以使纳米Pd/Fe分散和稳定.此外,Fe0可通过Fe3O4将电子传递给H+和2,4-D,促进2,4-D的还原脱氯.     

基于纳米TiO2添加的新型航空涂料性能研究

目的解决纳米TiO_2在涂料中的团聚问题,同时实现增强涂层防腐蚀、疏水性能和耐紫外老化性能。方法以氯醚树脂为航空涂料的主要成膜物质,以经氟硅烷改性后的金红石型纳米TiO_2颗粒为主要吸光剂和疏水剂,配合其他合适填料和颜料制备一种新型航空涂料,通过拉拔法、硬度测试法、电化学极化曲线法、接触角测试法和人工紫外加速老化等测试手段分别对涂层的力学性能、电化学性能、疏水性能和耐紫外老化性能进行研究。结果改性后的金红石型纳米TiO_2颗粒的分散性及与氯醚树脂的相容性得到改善。当添加量为2%~3%时,涂层腐蚀防护性能、表面疏水性、耐紫外老化性能达到最佳,附着力、硬度等力学性能达到航空涂料的基本使用要求。结论该涂料有效地解决了纳米TiO_2在涂料中的团聚问题,提高了涂层的防腐蚀、疏水性能和耐紫外老化性能。     

纳米级Pd/Fe-MWCNTs-Fe3O4体系对2,3-DCB的降解研究

为有效抑制纳米级Pd/Fe颗粒的团聚和钝化及改善磁分离效果,以多壁碳纳米管(MWCNTs)和磁性纳米级Fe_3O_4颗粒为载体,在超声波辐照下利用液相还原法制备纳米级Pd/Fe-MWCNTs-Fe_3O_4颗粒,并采用XRD、TEM、SEM、EDX及BET表征其物性,最后以2,3-二氯联苯(2,3-DCB)为目标污染物,探究其对2,3-DCB还原脱氯的影响因素、降解机理和动力学.结果表明:制备的纳米级颗粒粒径均匀、分散性好、比表面积大;体系中纳米级Pd/Fe投加量、钯化率、纳米级Fe_3O_4投加量、MWCNTs投加量、反应温度、溶液初始pH及共存阴离子均会对2,3-DCB的降解效果产生明显影响;本研究推测出纳米级Pd/Fe-MWCNTs-Fe_3O_4体系对2,3-DCB的降解机理,发现其降解符合拟一级动力学关系.     

两性高分子螯合絮凝剂与Cu(Ⅱ)、Pb(Ⅱ)、Cd(Ⅱ)、Ni(Ⅱ)的螯合稳定性

采用紫外分光光度法测定了两性高分子螯合絮凝剂(ACPF)与Cu2+、Cd2+、Pb2+、Ni2+形成螯合物的吸收光谱,考察了螯合沉淀物的稳定性,探讨了螯合物的组成,并计算其稳定常数.结果表明,ACPF分别在204、251和285 nm处出现最大吸收峰;ACPF中—CSS-基团与Cu2+、Pb2+、Cd2+和Ni2+等离子均按物质的量比2:1形成稳定螯合物,分别在319、310、313.5和326 nm处出现最大吸收峰,最大吸收峰发生显著红移.ACPF与Cu2+、Pb2+、Cd2+和Ni2+形成的螯合物的稳定常数分别为1.37 ×1012、3.26 ×1011、2.05×1011和3.04×1010.螯合沉淀物中重金属离子的溶出率随溶出液pH值升高而降低.PH≥5.6时,ACPF-Cu2+、ACPF-Ni2+ 、ACPF-Pb2+和ACPF-Cd2+都很稳定,浸出60.D后溶出液中Cu2+、Ni2+、Pb2+和Cd2+浓度都分别低于相应的国家污水综合排放标准(GB8979-1996).     

重金属螯合捕集剂NBMIPA的合成及其捕集Cu2+、Zn2+性能

以间苯二甲酰氯(IPC)和巯基乙胺盐酸盐(CHC)为原料,采用一步法合成重金属螯合捕集剂N,N’-双(2-巯基乙基)—1,3-苯二甲酰胺(NBMIPA),重点研究了物质的量比(n(CHC):n(IPC))和反应温度对NBMlPA产率的影响,并研究了NBMIPA投加量和pH对Cu2+、Zn2+捕集性能的影响.结果表明:重金属螯合捕集剂NBMIPA的最佳合成工艺为n(CHC):n(IPC) =2.8、反应温度-5℃,此时NBMIPA的最高产率为78.64％;NBMIPA对Cu2+和Zn2+的捕集性能优良,NBMIPA投加量越大,捕集性能越高;NBMIPA对pH具有较宽的适应性.当NBMIPA投加量分别为45 mL和30 mL时,NBMIPA对Cu2+和Zn2+的捕集效果最佳,Cu2+的去除率达到99.33％,残余Cu2+浓度为0.46 mg·L-1,Zn2+的去除率达到97.49％,残余Zn2+浓度为1.84 mg·L-1.     

Electrochemical dechlorination of chloroform in neutral aqueous solution on palladium/foam-nickel and palladium/polymeric pyrrole film/foam-nickel electrodes

Electrochemical dechlorination of chloroform in neutral aqueous solution was investigated using palladium-loaded electrodes at ambient temperature. Palladium/foam-nickel （Pd/foam-Ni） and palladium/polymeric pyrrole film/foam-nickel （Pd/PPy/foam-Ni） composite electrodes which provided catalytic surface for reductive dechlorination of chloroform in aqueous solution were prepared using an electrodepositing method. Scanning electron microscope （SEM） micrographs showed that polymeric pyrrole film modified the electrode-surface characteristics and resulted in the uniform dispersion of needle-shaped palladium particles on foam-Ni supporting electrode. The experimental results of dechlorination indicated that the removal efficiency of chloroform and current efficiency in neutral aqueous solution on Pd/PPy/foam-Ni electrode could be up to 36.8% and 33.0% at dechlorination current of 0.1 mA and dechlorination time of 180 min, which is much higher than that of Pd/foam-Ni electrode.     

Dechlorination of disinfection by-product monochloroacetic acid in drinking water by nanoscale palladized iron bimetallic particle

Nanoscale palladized iron(Pd/Fe)bimetallic particles were prepared by reductive deposition method.The particles were characterized by X-ray diffraction(XRD),X-ray fluorescence(XRF),scanning electron microscope(SEM),transmission electron microscope(TEM),and Brunauer-Emmett-Teller-nitrogen(BET-N_2)method.Data obtained from those methods indicated that nanoscale Pd/Fe bimetallic particles containedα-Fe~0.Detected Pd to Fe ratio by weight(Pd/Fe ratio)was close to theoretical value. Spherical granules with di...     

多功能富氧净水器在养殖领域的研究与应用

多功能富氧净水器的研究,采用聚丙烯微孔滤膜、复合活性炭纤维、酸性洗涤纤维及复合炭粒作为过滤吸附材料,并采用三碘树脂杀菌剂和载银活性炭复合杀菌剂进行灭菌,应用"综合过滤渗透法"的机理,将净化、矿化、灭菌、增氧等有机结合并进行反复的研究和试验,有效去除了水中微生物、污染物,降低化学需氧量和水的硬度,达到净化水质,增加水中溶解氧等预期效果,成功的应用在水产养殖等领域。     

螯合剂在植物修复重金属污染土壤中的应用

向土壤中添加螯合剂促进植物对重金属的吸收是目前一项比较有发展前景的土壤修复技术。本文通过对植物修复技术的机理和特点,即对超累积植物对重金属的富集机理及植物修复技术的局限性的讨论,介绍了螯合剂在植物修复重金属污染土壤中的应用,其中详细介绍了螯合剂强化植物修复技术的机理、螯舍剂的使用方式,以及它的外部影响条件。最后对螯合剂在植物修复重金属污染土壤应用中存在的问题进行了讨论,并对未来螯合刺在该领域的研究重点进行了展望。     

Distribution of Platinum group elements in road dust in the Beijing metropolitan area, China

Dust samples collected from the Beijing metropolitan area （China） were evaluated to determine the distribution and the concentration of platinum group elements （PGEs）. The dust particles that were smaller than 100 mesh size fraction （150 μm） were analyzed after aqua regia digestion. Concentrations ofPt, Rh, and Pd were found to be between 3.96 and 356.3 ng/g, 2.76 and 97.11 ng/g, and 0.1 and 124.9 ng/g, respectively, in the urban areas of Beijing, whereas for the background samples collected from the suburbs of Beijing, the concentrations of Pt, Pd, and Rh were very low and ranged from 0.1 to 0.9 ng/g, 0.5 to 1.4 ng/g, and 0.8 to 2.2 rig/g, respectively. The distributions of PGEs in road dust were an accurate reflection of the levels of pollution and were found to match with the local traffic conditions. A strong positive correlation was established among all the dements found in road dust. This suggests that emissions of abraded fragments from vehicle exhausts may be the source of the high concentration of Pt, Rh, and Pd in road dust along the main roads of Beijing.