宁波市大气可吸入颗粒物PM1o和PM2.5的源解析研究

在宁波市布设4个代表性点位,于2010年春季、夏季和冬季进行大气PM10和PM2.s的采样,同时采集了多种颗粒物源样品,建立了PM10、PM2.5和源样品的化学成分谱.采用化学质量平衡模型(CMB)对宁波市PM10、PM2.5进行源解析.结果表明,城市扬尘、煤烟尘、机动车尾气尘是宁波市PM10、PM2.5的3大污染源,...     

Accumulation and quantitative estimates of airborne lead for a wild plant (Aster subulatus)

Foliar uptake of airborne lead is one of the pathways for Pb accumulation in plant organs. However, the approximate contributions of airborne Pb to plant organs are still unclear. In the present study, aerosols (nine-stage size-segregated aerosols and total suspended particulates), a wild plant species (Aster subulatus) and the corresponding soils were collected and Pb contents and isotopic ratios in these samples were analyzed. Average concentration of Pb was 96.5 ± 63.5 ng m⁻³ in total suspended particulates (TSP) and 20.4 ± 5.5 ng m⁻³ in the fine fractions of size-segregated aerosols (SSA) (<2.1 μm), higher than that in the coarser fractions (>2.1 μm) (6.38 ± 3.71 ng m⁻³). Enrichment factors show that aerosols and soils suffered from anthropogenic inputs and the fine fractions of the size-segregated aerosols enriched more Pb than the coarse fractions. The order of Pb contents in A. subulatus was roots > leaves > stems. The linear relationship of Pb isotope ratios (²⁰⁶Pb/²⁰⁷Pb and ²⁰⁸Pb/²⁰⁶Pb) among soil, plant and aerosol samples were found. Based on the simple binary Pb isotopic model using the mean ²⁰⁶Pb/²⁰⁷Pb ratios in TSP and in SSA, the approximate contributions of airborne Pb into plant leaves were 72.2% and 65.1%, respectively, suggesting that airborne Pb is the most important source for the Pb accumulation in leaves. So the combination of Pb isotope tracing and the simple binary Pb isotope model can assess the contribution of airborne Pb into plant leaves and may be of interest for risk assessment of the exposure to airborne Pb contamination.     

Spectral estimation of global levels of atmospheric pollutants

Underlying levels of atmospheric pollutants, assumed to be governed by smoothing mechanisms due to atmospheric dispersion, can be estimated from global emissions source databases on greenhouse gases and ozone-depleting compounds. However, spatial data may be contaminated with noise or even missing or zero-valued at many locations. Therefore, a problem that arises is how to extract the underlying smooth levels. This paper sets out a structural spatial model that assumes data evolve across a global grid constrained by second-order smoothing restrictions. The frequency-domain approach is particularly suitable for global datasets, reduces the computational burden associated with two-dimensional models and avoids cumbersome zero-inflated skewed distributions. Confidence intervals of the underlying levels are also obtained. An application to the estimation of global levels of atmospheric pollutants from anthropogenic emissions illustrates the technique which may also be useful in the analysis of other environmental datasets of similar characteristics.     

Quantification of nitrate leaching from German forest ecosystems by use of a process oriented biogeochemical model

Simulations with the process oriented Forest-DNDC model showed reasonable to good agreement with observations of soil water contents of different soil layers, annual amounts of seepage water and approximated rates of nitrate leaching at 79 sites across Germany. Following site evaluation, Forest-DNDC was coupled to a GIS to assess nitrate leaching from German forest ecosystems for the year 2000. At national scale leaching rates varied in a range of 0–>80 kg NO₃–N ha⁻¹ yr⁻¹ (mean 5.5 kg NO₃–N ha⁻¹ yr⁻¹). A comparison of regional simulations with the results of a nitrate inventory study for Bavaria showed that measured and simulated percentages for different nitrate leaching classes (0–5 kg N ha⁻¹ yr⁻¹:66% vs. 74%, 5–15 kg N ha⁻¹ yr⁻¹:20% vs. 20%, >15 kg N ha⁻¹ yr⁻¹:14% vs. 6%) were in good agreement. Mean nitrate concentrations in seepage water ranged between 0 and 23 mg NO₃–N l⁻¹.     

大宝山矿区水体和沉积物中重金属的污染评价

分别于丰水期和枯水期对广东省大宝山矿区铁龙拦泥坝至凉桥河段水体中溶解态的重金属进行了调查,应用EPA推荐的健康风险评价模型发现,水体中非致癌物通过饮水途径所导致平均个人年风险排列顺序是Cu〉Pb〉Zn,最大值的平均个人年风险在丰水期和枯水期的平均值分别是2.14×10-7 a-1和4.13×10-7 a-1,小于国际防辐射委员会（ICRP）推荐的最大可接受平均个人年风险5.0×10-5a-1。致癌物Cd的平均个人年风险在丰水期和枯水期的平均值分别是3.52×10-4 a-1和4.53×10-4 a-1,大于ICRP推荐的最大可接受值,同时也大于非致癌物3～4个数量级。另外,通过对枯水期沉积物的重金属总量分析,发现凉桥槽对坑支流受水体pH的影响,导致其沉积物重金属的浓度最高。根据Long和Macdonald利用生物效应数据库法建立的沉积物质量基准,发现除冷水泾外,其他采样点的平均效应中值指数（mERMQ）值都大于1.5,可见沉积物中的重金属会对当地底栖生物产生毒害作用。     

有机物降解产气率模型研究

根据重庆市生活垃圾的组成特点,自配垃圾试样进行有机物降解实验,根据实验期间试样的质量变化,结合降解反应方程式,计算试样的产气量,并建立产气率模型.实验结果表明,试样质量随时间逐渐降低,呈指数型衰减规律.试样在实验初期产气率增加较快,达到产气高峰后逐渐降低.用建立的产气率模型进行计算,计算结果与实测数据比较接近,说明该产...     

凹凸棒土的氨氮吸附性能研究

在以氨氮去除率为指标,在振荡时间60 min,振荡温度25℃,振荡速度140r/min的条件下发现凹凸棒土的最佳投加量2.5 g;添加凹凸棒土可以加强SBR生物系统去除氨氮的能力;拟合凹凸棒土吸附氨氮的等温线方程符合Freundlich吸附模型.     

Validation of a booted finite element model of the WIAMan ATD lower limb in component and whole-body vertical loading impacts with an assessment of the boot influence model on response

Objective: A novel anthropomorphic test device (ATD) representative of the 50th percentile male soldier is being developed to predict injuries to a vehicle occupant during an underbody blast (UBB). The main objective of this study was to develop and validate a finite element (FE) model of the ATD lower limb outfitted with a military combat boot and to insert the validated lower limb into a model of the full ATD and simulate vertical loading experiments.

Methods: A Belleville desert combat boot model was assigned contacts and material properties based on previous experiments. The boot model was fit to a previously developed model of the barefoot ATD. Validation was performed through 6 matched pair component tests conducted on the Vertically Accelerated Loads Transfer System (VALTS). The load transfer capabilities of the FE model were assessed along with the force-mitigating properties of the boot. The booted lower limb subassembly was then incorporated into a whole-body model of the ATD. Two whole-body VALTS experiments were simulated to evaluate lower limb performance in the whole body.

Results: The lower limb model accurately predicted axial loads measured at heel, tibia, and knee load cells during matched pair component tests. Forces in booted simulations were compared to unbooted simulations and an amount of mitigation similar to that of experiments was observed. In a whole-body loading environment, the model kinematics match those recorded in experiments. The shape and magnitude of experimental force–time curves were accurately predicted by the model. Correlation between the experiments and simulations was backed up by high objective rating scores for all experiments.

Conclusion: The booted lower limb model is accurate in its ability to articulate and transfer loads similar to the physical dummy in simulated underbody loading experiments. The performance of the model leads to the recommendation to use it appropriately as an alternative to costly ATD experiments.