吸附—电化学法组合工艺处理废乳化液

以季铵盐改性硅藻土为吸油剂,采用吸附—电化学组合工艺处理拉丝废乳化液,优化了工艺条件。实验结果表明,在乳化液pH为5.0、吸油剂加入量为20 g/L、反应温度为25 ℃的最优条件下吸附除油15 min,然后在清液pH为8.5、阳极电流密度为4 A/dm²的最优条件下电化学反应4 h后,废水无色无味,COD为43 mg/L,ρ（NH₃-N）=0,ρ（Cu）= 1.6 mg/L,ρ（Zn）= 3.7 mg/L,浊度为1.1 NTU,达到GB 8978—1996污水综合排放标准。     

乳状液膜法处理煤制兰炭废水

以磷酸三丁酯(TBP)为载体、煤油为膜溶剂、NaOH水溶液为内水相,采用乳状液膜法处理兰炭废水。实验结果表明:当TBP体积分数为4%、表面活性剂质量分数为4%、内水相NaOH质量分数为12%、油内比(乳状液的油相与内水相的体积比)为3∶2、乳水比为1∶5、萃取时间为15min时,废水中的酚类(以苯酚计)去除率达到85%以上,COD去除率达83%以上。     

Leaching,mobility and persistence of tebufenozide in columns packed with forest litter and soil

Abstract

Leaching, downward mobility and persistence of tebufenozide was investigated under laboratory conditions in columns packed with forest litter and soil, after fortification with the analytical grade material (purity > 99.6%) and with two commercial formulations, RH‐5992 2F (aqueous flowable) and RH‐5992 ES (emulsion suspension). Two types of litter and soil were used: one type with relatively high amounts of sand and the other with high amounts of clay.

The concentrations eluted in the leachates were lower when the analytical material (dissolved in acetone) was used for fortification, than when the two formulations (diluted with water) were used. The amount leached was higher for RH‐5992 2F than for RH‐5992 ES. The type of substrate, i.e., sandy or clay type, had only marginal influence on the amounts eluted in the leachates. Downward movement of tebufenozide from the top 2‐cm layer to the untreated middle and bottom layers (3‐cm segments) was consistently lower when the analytical material was used for fortification, than when the two formulations were used. Downward movement was higher for RH‐5992 2F than for RH‐5992 ES. Persistence of tebufenozide in substrates, maintained under submerged conditions for 70 days after leaching, indicated an initial 2‐week lag period prior to the onset of degradation. Formulation‐related differences were observed in the half‐life (DT₅₀) values. When the analytical material was used for fortification, the DT₅₀ ranged from ca 54 to 59 d. However, when the formulations were used for fortification, the DT₅₀ showed a higher range, i.e., from ca 62 to 67 d for RH‐5992 2F and ca 70 to 80 d for RH‐5992 ES. Formulation ingredients appear to have caused enhanced adsorption of tebufenozide onto the substrates, thus delaying degradation.     

乳状液膜法在湿法冶锌废水深度处理中的研究

提出深度处理湿法冶锌废水的二段液膜处理流程 ,并实验考察了分别回收锌、镉的适宜液膜条件 ,使得这 2种金属离子的达标排放与回收能够兼顾。     

乳状液膜分离法预处理垃圾渗滤液氨氮的试验研究

用span-80表面活性剂制作的乳状液处理垃圾渗滤液中氨氮,考察了表面活性剂span-80用量、膜内相硫酸浓度、膜增强剂用量、油内比、乳水比、外相水pH值因素对氨氮去除率的影响。结果表明,在最佳反应条件下,用乳状液膜分离法预处理垃圾渗滤液中的氨氮,分离速度快,处理效果达到87%以上。     

关于用能量同化波浪作用下溢油乳化的研究思想和思考

介绍加拿大学者用能量概念解决化学实验室锥形瓶或烧杯,水动力学物理模拟实验室水槽以及自然界海岸线波浪破碎等不同尺度下波浪同溢油乳化行为之间关系的同化方法和针对某些特殊问题所采取的措施以及新的尝试.从物理模拟实验室尺度和自然界海岸线尺度提出一些思考问题,并从发展的角度和中国同加拿大研究设备、能力和观点上的差异,提出中国曾经开展的类似研究是否有再度崛起的可能性,使得研究成果成为溢油乳化和溢油清理科学技术的基础,并带动解决冻结水域溢油乳化现象的理论解释.     

Performance of a diesel engine with water emulsified diesel prepared with optimized process parameters

An attempt has been made to produce stable water–diesel emulsion with optimal formulation and process parameters and to evaluate the performance and emission characteristics of diesel engine using this stable water–diesel emulsion. A total of 54 samples were prepared with varying water/diesel ratio, surfactant amount and stirring speed and water separation was recorded after 24 and 48 hr of emulsification. The recorded data were used in artificial neural network (ANN)-particle swarm optimization (PSO) technique to find the optimal parameters to produce water–diesel emulsion for engine testing. The predicted optimal parameters were found as 20% water to diesel ratio, 0.9% surfactant and 2200 rpm of stirrer for a water separation of 14.33% in one day with a variation of 6.54% against the actual value of water separation. Water–diesel emulsion fuel exhibited similar fuel properties as base fuel. The peak cylinder gas pressure, peak pressure rise rate and peak heat release rate for water–diesel were found higher as compared to diesel at medium to full engine loads. The improved air-fuel mixing in water–diesel emulsion enhanced brake thermal efficiency (BTE) of engine. The absorption of heat by water droplets present in water–diesel emulsion led to reduced exhaust gas temperature (EGT). With water–diesel emulsion fuel, the mean carbon monoxide (CO), unburned hydrocarbon and oxides of nitrogen (NO_x) emissions reduced by 8.80, 39.60, and 26.11%, respectively as compared to diesel.     

BS-Ⅰ型乳液抑尘剂防治矿山运输路面扬尘

由2.0—5.0%乳化油、0.05%乳化剂和水制备而成的BS-Ⅰ型乳液抑尘剂,在山东铝厂矿山公司使用表明,一次喷洒0.8—2.0kg/m²,能使砂土或砂石运输路面粉尘从9.6—33.3mg/m³(平均19.5mg/m³)。在10—15昼夜内降至10mg/m³以下(平均4.3—5.8mg/m³)。使用该抑尘剂,大大减轻了路面扬尘污染,同时降低了车辆磨损和油耗。乳液抑尘剂良好的防尘效果主要是由其自身的物理化学性质决定的。     

乳化液膜法处理含氨基J酸工业废水中破乳的实验研究

针对当前乳化液膜法中关键步骤—破乳进行了实验性研究。对于煤油—LMA－1—NaOH膜体系,研究了化学法和交流低电压电破乳的可行性,重点研究了电破乳的方法及温度、液膜体系及电场强度对破乳的影响。结果表明：对本实验的膜体系,化学法破乳效果不佳,而低电压破乳效果较好,破乳后的LMA－1油相可重复使用,具有良好的工业化应用前景。     

无机超滤技术和生化处理技术在宝钢冷轧含油废水处理中的应用

冷轧废水处理是轧钢工艺中的难点之一。宝钢 2 0 30冷轧废水处理改造工程 ,首次将生化处理技术引入到冷轧含油废水处理工艺 ,并在工程中采用了无机陶瓷超滤技术 ,从而实现了冷轧废水处理的国产化及国内技术总成