膜电解技术处理含氯及重金属的废酸

采用离子交换膜电解技术处理铜冶炼过程产生的含氯及重金属的废酸。考察了废酸处理工艺、电解温度、电解时间、电流密度和催化剂的添加等条件对处理效果的影响。实验结果表明：采用先沉淀重金属后脱氯的废酸处理工艺,氯离子和铜离子的去除效果均较好;当以钛盐为催化剂时,在电解温度为40 ℃、电解时间为2.0 h、电流密度为825 A/m²的最佳工艺条件下,处理后废酸中的氯离子质量浓度为0.22 g/L,氯离子去除率为98.59%,铜离子质量浓度为0.45 g/L,铜离子去除率为95.08%,其他重金属大部分也得到有效去除。净化后的废酸可回用至铜冶炼的生产过程中。     

混凝-超滤短流程工艺处理北方水库原水简

采用混凝-超滤膜短流程工艺对大伙房水库原水进行处理,考察其除污染性能和膜污染情况,并对该短流程工艺参数进行优化。结果表明,当利用超滤膜直接过滤原水时,膜污染较重,并且对污染物质的去除率较低;而采用混凝-超滤短流程工艺时,膜污染得到一定程度上的缓解;当絮凝剂投加量为7 mg/L、膜清洗周期为30 min时,对浊度、COD_Mn和UV₂₅₄的去除率分别为95.61%、40.42%和37.12%,出水水质能够满足生活饮用水卫生标准。     

膜吸收法净化低浓度甲醛和氨气简

基于膜吸收技术自制双层平板式膜吸收器,搭建净化低浓度甲醛和氨气污染模拟系统,考察不同膜结构参数、进气流量、吸收剂流量等因素对其净化效果的影响。结果表明,聚偏氟乙烯PVDF对低浓度甲醛和氨气的净化效率高于聚四氟乙烯PTFE。对同一材质膜,随着膜孔隙率的增大,甲醛和氨气的净化率呈上升趋势。随着进气流量的增加,甲醛和氨气的净化效率降低;而吸收剂流量对其净化效率影响不大。对于所有实验条件,平均膜孔径为0.22 μm的PVDF 4^#在进气流量u_g=120 L/h时,甲醛和氨气的净化效率最高,分别达94.7%和96.3%。     

共代谢膜生物反应器法处理二甲基亚砜废水

采用蔗糖作为共代谢基质与一体式好氧膜生物反应器（MBR）工艺相结合处理二甲基亚砜（DMSO）废水。考察了装置的污泥驯化效果、DMSO去除率、污泥的性能、HRT和冲击负荷对DMSO去除率的影响。试验结果表明：驯化第29天,DMSO去除率达98.5%,表明MBR内的污泥已驯化成功;在MBR运行的正式期,当DMSO处于高负荷状态时,DMSO去除率较低;随蔗糖加入量的增加,DMSO去除率逐渐提高,最终恢复到DMSO高负荷冲击前的DMSO去除效果;正常运行时,装置进水ρ（DMSO）=257~1 448 mg/L（平均值为718 mg/L）、出水ρ（DMSO）=6~22 mg/L（平均值为7 mg/L）,DMSO去除率为96.4%~99.6%（平均值为98.9%）;在MBR运行的正式期,污泥体积指数小于100 mL/g,表明污泥的沉降性能较好,MLVSS/MLSS较高,表明污泥的活性高,MBR内MLSS的平均值为5.52 g/L,MLVSS的平均值为4.78 g/L;MBR适宜的HRT为12 h。     

膜电解法退镀废ABS电镀件及回收铜和镍

采用膜电解法对废丙烯腈-丁二烯-苯乙烯（ABS）电镀件进行退镀处理。以退镀废液作为阴极液和阳极液,在阳极室退镀ABS电镀件,在阴极室电解退镀废液,进行铜镍分离,回收铜粉和NiCl₂。实验结果表明：在阴极电流密度为500 A/m²、初始铜离子质量浓度为24.00 g/L的条件下电解160 min,阴极铜回收率可达97.65%,电流效率达86.60%,得到的铜粉纯度为97%~99%,处理1 L退镀废液可回收铜粉20.0 g,2 mol/L盐酸0.87 L,NiCl₂晶体43.8 g;在阳极电流密度为500 A/m²、液固比为6的条件下电解60 min, ABS电镀件的退镀率为77.22%。     

Mobile passive samplers: concept for a novel mode of exposure

Integrative passive sampling with devices such as semipermeable membrane devices generally relies on rigs for month-long static exposures in water. We evaluate here whether mobile exposures of passive samplers can provide reliable estimates of dissolved contaminant concentrations. Mobile exposures were obtained by towing samplers fastened to the end of a benthic trawl net. Significant and reproducible absorption of polycyclic aromatic hydrocarbons during 5 h-long deployments was made possible by high sampling rates resulting from high water turbulences during towing at 1.2-1.5 knots. Sampling rates (72-215 L d⁻¹) estimated from the dissipation of performance reference compounds were supported by in situ calibration with samplers exposed for a 30 days in the vicinity of the test site. Higher fluoranthene and pyrene absorption in samplers exposed to the trawling-induced sediment plume could be attributed to desorption from re-suspended sediments. This mode of exposure has the potential to be used in monitoring programmes.     

初始pH值对磷酸盐还原除磷的影响研究

以超高盐（盐度7％,以NaCI计）高磷榨菜废水为研究对象,考察了初始pH值对磷酸盐还原进程的影响。实验结果表明,初始pH值对磷酸盐还原除磷效能影响显著。初始pH为8时,磷酸盐还原除磷率达到最高,平均值为65．45％。同时,初始pH值还会影响污泥中活性磷的形成以及基体对磷化氢的吸附。此外,偏碱性有利于磷形态转化,且BD-P（主要是一些可溶性的、还原性强的、带有Fe-P化合物的集合）含量的高低调控着生物膜内间隙水中溶解态可反应性磷（DRP）和可还原水溶态磷（RSP）含量,最终决定着磷酸盐还原进程。随着初始pH值的升高,污泥对磷化氢的吸附能力降低导致污泥中结合态磷化氢（MBP）含量不断减少。     

Investigation of titanium liquid/gas diffusion layers in proton exchange membrane electrolyzer cells

In a proton exchange membrane electrolyzer cell (PEMEC), liquid/gas diffusion layer (LGDL) is expected to transport electrons, heat, and reactants/products to and from the catalyst layer with minimum voltage, current, thermal, interfacial, and fluidic losses. In addition, carbon materials, which are typically used in PEM fuel cells (PEMFCs), are unsuitable in PEMECs due to the high ohmic potential and highly oxidative environment of the oxygen electrode. In this study, a set of titanium gas diffusion layers with different thicknesses and porosities are designed and examined coupled with the development of a robust titanium bipolar plate. It has been found that the performance of electrolyzer improves along with a decrease in thickness or porosity of the anode LGDL of titanium woven meshes. The ohmic resistance of anode LGDL and contact resistance between anode LGDL and the anode catalyst play dominant roles in electrolyzer performance, and better performance can be obtained by reducing ohmic resistance. Thin titanium LGDLs with straight-through pores and optimal pore morphologies are recommended for the future developments of low-cost LGDLs with minimum ohmic/transport losses.     

膜蒸馏去除水中砷的研究

采用新型膜蒸馏技术对水中As（III）与As（Ⅴ）的去除展开了研究。实验结果表明,膜蒸馏对水中As (III)及As (Ⅴ)具有较高的去除能力：当产水中砷含量超过10 μg/L时,原水中As (III)与As (Ⅴ)的浓度可分别高达40 mg/L和2 000 mg/L。局部润湿现象的存在导致As (III)及As (Ⅴ)跨膜至产水侧,PVDF微孔膜在溶液中的负电性以及As (III)与 As (Ⅴ)在溶液中存在形式的不同导致膜蒸馏对两者去除能力的差异。360 h连续运行过程中产水通量及电导率稳定,且整个过程中As (III)均低于检测限,说明PVDF微孔膜具有良好的疏水性和稳定的除砷性能。     

好氧硝化颗粒污泥膜生物反应器性能和膜污染研究

实验研究了好氧硝化颗粒污泥膜生物反应器AGMBR的处理性能,并将其与活性污泥膜生物反应器ASMBR进行对比,考察了颗粒污泥在减缓膜污染中所起的作用.好氧硝化颗粒污泥膜生物反应器AGMBR连续稳定运行102 d,系统具有良好的去除有机物和同时硝化反硝化能力,在进水COD和NH+4-N浓度分别为500和200 mg/L时,COD、NH+4-N和TN的去除率分别稳定在86%、94%和45%以上.颗粒污泥有效减缓了膜污染,延长了膜清洗的周期,AGMBR中的膜污染以膜孔堵塞为主,占总阻力的64.81%;滤饼层的阻力为2.1×1012m-1,远小于ASMBR中的16.07×10"m-1;膜清洗周期是相同条件下ASMBR的2.43倍以上;而且AGMBR内不断有新颗粒生成,维持了AGMBR系统性能和运行的稳定.