微电解联合物化法处理维生素B12难降解废水的研究

对使用微电解联合物化法处理维生素B12难降解废水进行了分析。通过实验研究了微电解联合物化法处理维生素B12废水的最佳工艺条件。在最佳工艺条件下,维生素B12废水色度去除达88.46%,COD去除率达到71.06%。该处理方法最后将污染物质直接吸附于改性膨润土上,不产生浓缩废水、酸碱废水等更加难以处理的废水,并且不带入有毒有害物质,可以有效降低水中污染物含量,减少后续生物处理设备的污染负荷。     

Equilibrium study and kinetics of Cu removal from water by zeolite prepared from oil shale ash

Engineered zeolite was produced from oil shale ash by reaction with sodium hydroxide in a closed vessel reactor. This adsorbent was used for removal of copper ions from aqueous solution. The maximum adsorption capacity was 504.6 mg Cu²⁺/g zeolite. Kinetic studies showed that the rate of adsorption of copper is increased with increasing the solution pH and temperature, quantity of the zeolite and agitation speed. The kinetic data were fitted to homogeneous micropore model and found that the mass transfer coefficient and diffusivity of the Cu²⁺ are directly affected by the kinetic parameters. The increase in solution concentration will decrease the mass transfer coefficient while diffusivity is increased.     

Using SWAT to Model Streamflow in Two River Basins With Ground and Satellite Precipitation Data1

Abstract: Both ground rain gauge and remotely sensed precipitation (Next Generation Weather Radar – NEXRAD Stage III) data have been used to support spatially distributed hydrological modeling. This study is unique in that it utilizes and compares the performance of National Weather Service (NWS) rain gauge, NEXRAD Stage III, and Tropical Rainfall Measurement Mission (TRMM) 3B42 (Version 6) data for the hydrological modeling of the Middle Nueces River Watershed in South Texas and Middle Rio Grande Watershed in South Texas and northern Mexico. The hydrologic model chosen for this study is the Soil and Water Assessment Tool (SWAT), which is a comprehensive, physical‐based tool that models watershed hydrology and water quality within stream reaches. Minor adjustments to selected model parameters were applied to make parameter values more realistic based on results from previous studies. In both watersheds, NEXRAD Stage III data yields results with low mass balance error between simulated and actual streamflow (±13%) and high monthly Nash‐Sutcliffe efficiency coefficients (NS > 0.60) for both calibration (July 1, 2003 to December 31, 2006) and validation (2007) periods. In the Middle Rio Grande Watershed NEXRAD Stage III data also yield robust daily results (time averaged over a three‐day period) with NS values of (0.60‐0.88). TRMM 3B42 data generate simulations for the Middle Rio Grande Watershed of variable qualtiy (MBE = +13 to ?16%; NS = 0.38‐0.94; RMSE = 0.07‐0.65), but greatly overestimates streamflow during the calibration period in the Middle Nueces Watershed. During the calibration period use of NWS rain gauge data does not generate acceptable simulations in both watersheds. Significantly, our study is the first to successfully demonstrate the utility of satellite‐estimated precipitation (TRMM 3B42) in supporting hydrologic modeling with SWAT; thereby, potentially extending the realm (between 50°N and 50°S) where remotely sensed precipitation data can support hydrologic modeling outside of regions that have modern, ground‐based radar networks (i.e., much of the third world).     

类氧化硅气凝胶吸附材料的制备及其吸附性能

以有机硅高沸物和Na₂SiO₃·9H₂O为原料,采用溶胶-凝胶法制备出疏水性的类氧化硅气凝胶吸附材料。采用透射电子显微镜、傅里叶变换红外分析仪和比表面与空隙度分析仪对该吸附材料的结构进行表征。表征结果显示,该吸附材料呈海绵状多孔结构,比表面积为294.48 m²/g,孔径分布较宽（为2 ~140 nm）,平均孔径为8.95 nm。实验结果表明：采用该吸附材料常温下静态吸附处理质量浓度为10 mg/L的罗丹明B（RhB）溶液,在类氧化硅气凝胶吸附材料加入量50 g/L、静态吸附时间5 h的最佳静态吸附工艺条件下,RhB去除率为98.8%,吸附后RhB质量浓度为0.124 mg/L;采用该吸附材料常温下动态吸附处理质量浓度为15 mg/L的RhB溶液,吸附4 h后开始穿透,吸附7 h后完全穿透。穿透时间较长,表明该吸附材料具有较大的吸附容量。     

微乳液增敏罗丹明B氧化褪色光度法测定微量亚硝酸根

基于微乳液对亚硝酸根催化溴酸钾氧化罗丹明B褪色反应具有增敏作用的原理,建立了催化动力学光度法测定痕量亚硝酸根的新方法。实验结果表明：该方法的最佳反应条件为1×10^-4 mol/L的罗丹明B溶液加入量0.60 mL,1 mol/L的稀磷酸加入量1.50 mL,0.1 mol/mL的溴酸钾溶液0.50 mL,反应温度20 ℃,反应时间15 min;对亚硝酸根测定的线性范围为ρ（NO₂^-）= 0.048~0.800 μg/mL,检出限为0.003 0 μg/mL;加入微乳液后催化反应的灵敏度增大了3倍。     

Cu-SBA-15催化湿式过氧化氢氧化水溶液中罗丹明B

采用水热晶化法合成了不同含铜量的Cu—SBA-15介孔分子筛,并且用XRD、N2吸附、TEM以及uV—vis对所合成的样品进行表征。以Cu—SBA-15为催化剂,H2O2为氧化剂,催化湿式过氧化水溶液中的罗丹明B,主要考察H2O2浓度、催化剂用量、处理温度、初始pH等因素对罗丹明B氧化效果的影响。结果表明,在同样的处理条件下罗丹明的脱色率明显高于TOC去除率,处理温度、初始pH对罗丹明B的脱色与氧化有重要影响。在罗丹明B初始浓度100mg／L,H2O2初始浓度1．8g／L,催化剂量0．3g／L,温度60℃,pH为7．0,处理时间100min时,罗丹明B的脱色率为98．6％,TOC去除率为62．8％。     

Ce-PbO2/C电极的制备及其去除水中酸性红B

采用电沉积法制备铈修饰的PbO2/C电极,通过SEM、XRD、XPS及循环伏安对PbO2/C、Ce-PbO2/C电极进行表征,结果表明,Ce-PbO2/C电极比PbO2/C颗粒细小,表面均匀致密,电化学氧化能力较强,修饰电极中Ce以CeO2的形态存在。以Ce-PbO2/C为工作电极,电解浓度为1 000 mg/L的高盐酸性红B模拟活性染料废水,考察了电压、pH、电解质浓度、极间距对脱色率、氨氮去除率及COD去除率的影响。确定适宜工艺条件为:初始酸性红B溶液浓度为1 000 mg/L,pH值为6,电压10 V,电解时间1 h,电极间距1.5 cm,该条件下脱色率、氨氮去除率和COD去除率分别为99.98%、97.23%和90.17%。通过UV-Vis及GC-MS初步分析了降解过程可能存在的中间产物及降解途径。     

D.radiodurans kat A和kat B基因的结构分析与功能鉴定

以简并引物PCR获得的Cat酶基因片段探针,结合生物信息学方法,探明了耐辐射奇球菌（D.radiodu-rans)基因组中存在两个编码过氧化氢酶（Catalase,Cat)的基因：katA和B.katA和katB基因长2277bp和1611bp,各编码758和536个氨基酸,用pKK223-3表达载体连接katB基因,转入Cat酶缺陷型大肠杆菌（E. coliUM2)进行表达.katB基因表达产物具有Cat酶活性,电泳迁移位置与D.radiodurans CatB酶位置相符,并可重建E.coliUM2对低浓度H2O2损伤的耐受力。     

应用斑马鱼和凡纳对虾诊断污染场地污水的生物毒性

应用斑马鱼(Brachydanio rerio)和凡纳对虾(Penaeus vannamei)对某废弃有机污染场地中有毒有机废弃物堆积产生的污水(1号塘污水)和场地及周边地表径流积水(2号塘污水)的生物毒性进行了试验.结果表明,1号塘污水对斑马鱼和凡纳对虾96 hLC50分别为46.2%和59.6%, 2号塘污水的毒性试验中两种试验生物的死亡率皆为0.化学检测表明,1号塘污水中的主要污染物为苯酚类和酞酸脂类物质,而2号塘污水中均未检出有机污染物.化学检测结果与毒性试验结果具有较好的相关性.     

Dissolution kinetics of sub-millimeter Composition B detonation residues: role of particle size and particle wetting

The dissolution of the 2,4,6-trinitrotoluene (TNT), hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX), and octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine (HMX) from microscale particles (<250 μm) of the explosive formulation Composition B was examined and compared to dissolution from macroscopic particles (>0.5 mm). The dissolution of explosives from detonation soot was also examined. The measured mass transfer coefficients for the microscale particles were one to two orders of magnitude greater than the macroscopic particles. When normalized to particle surface area, mass transfer coefficients of microscale and macroscale particles were similar, indicating that the bulk dissolution processes were similar throughout the examined size range. However, an inverse relationship was observed between the particle diameter and the RDX:TNT mass transfer rate coefficient ratio for dry-attritted particles, which suggests that RDX may be more readily dissolved (relative to TNT) in microscale particles compared to macroscale particles. Aqueous weathering of larger Composition B residues generated particles that possessed mass transfer coefficients that were on the order of 5- to 20-fold higher than dry-attritted particles of all sizes, even when normalized to particle surface area. These aqueous weathered particles also possessed a fourfold lower absolute zeta-potential than dry-attritted particles, which is indicative that they were less hydrophobic (and hence, more wettable) than dry-attritted particles. The increased wettability of these particles provides a plausible explanation for the observed enhanced dissolution. The wetting history and the processes by which particles are produced (e.g., dry physical attrition vs. aqueous weathering) of Composition B residues should be considered when calculating mass transfer rates for fate and transport modeling.