浙江省污水污泥处理处置状况的调查

通过对丽水、宁波、衢州、诸暨等浙江省境内十几个地区的污水处理厂的调查发现:目前浙江省内的污水处理工艺中,A2/O、A/O、氧化沟三种工艺占了近50%的份额。而SBR因其方法特点正在受到越来越多的重视。在污泥处理工艺中,填埋占了最大的一部分,有近70%的污水处理厂将产生的污泥进行填埋处理。目前,污泥处理技术单一,需要继续探寻污泥的减量和资源化技术,为日益增多的污泥探寻出路。     

UASB+接触氧化法处理CMC废水

CMC废水属于高盐分高有机物废水,废水COD为50 000~80 000 mg/L,含盐量为13%左右,不适合直接生化处理。本文采用CMC废水和循环冷却水按一定比例混合后一起处理,混合后的废水采用UASB+接触氧化法的处理工艺处理。工程运行表明:稀释后的CMC废水中的盐分稳定在1.4%以内,该处理工艺能够确保出水达到《污水综合排放标准》(GB8978-1996)中三级排放标准。     

四溴双酚A在污水脱氮除磷过程中迁移转化试验研究

四溴双酚A(TBBPA)是一种使用广泛的阻燃剂,其扩散到环境介质中,会对生态和人体健康构成威胁,以往研究较少关注TBBPA在脱氮除磷工艺中的迁移转化.采用实验室SBR脱氮除磷反应器,研究了TBBPA在工艺长期运行过程中的去除、在典型周期过程中的变化、在硝化和反硝化过程中的去除.TBBPA在工艺长期运行过程中的去除率为48.4%,其中生物去除率为44.4%,吸附去除率为4.0%.在典型周期中TBBPA浓度受pH影响很大.TBBPA在硝化过程的去除主要是生物作用,而在反硝化过程的去除主要是吸附作用.     

利用固定化技术与添加表面活性剂增强双酚A降解率的研究

以SiO_2为载体,戊二醛为交联剂,用以固定游离态漆酶降解双酚A(Bisphenol A,BPA).同时,对比了游离态漆酶与固定化漆酶在不同pH值与温度下的最佳酶活与酶稳定性,再通过添加表面活性剂来增加酶活及BPA去除效果.结果表明,与游离态漆酶相比,固定化漆酶对不同酸碱的适应性与耐热性均有所提高,在pH为2~8时,固定化漆酶的活性均高于游离态漆酶,且最佳活性温度也从游离态漆酶的40℃提高至50℃.在BPA降解率方面,固定化漆酶的降解率皆高于游离态漆酶,反应6 h后,对100 mg·L~(-1)BPA的去除率可分别达到92%与85%.通过添加非离子型表面活性剂Triton X-100,反应4 h后固定化漆酶可完全降解BPA,相对活性为67%;游离态漆酶于6 h将BPA降解完全,相对活性为32%.实验证实Triton X-100可作为酶活诱导剂用以提高漆酶活性及BPA的降解率,降低了处理成本且具有一定的应用前景.     

蚯蚓细胞色素P450酶系对土壤中芘或苯并[a]芘的响应

以赤子爱胜蚓(Eisenia fetida)为受试生物,通过人工污染草甸棕壤微宇宙试验方法,研究了暴露于不同环境浓度芘或苯并[a]芘(添加量分别为0.12、0.24、0.48、0.96 mg·kg~(-1))污染的土壤中14 d后,蚯蚓体内细胞色素P450(CYPs)酶系,如CYPs总量、CYP1A1及CYP2C9活性的变化.结果显示,芘或苯并[a]芘暴露导致蚯蚓CYPs总量、CYP1A1及CYP2C9活性的变化不同.其中,CYPs总量与CYP1A1活性对芘的响应趋势相似:试验3 d后,0.96 mg·kg~(-1)芘导致二者都显著高于对照水平;14 d后,都显著低于对照水平;CYP1A1活性对芘的响应更为敏感.CYPs总量与CYP2C9活性对苯并[a]芘的响应趋势相似:暴露初期,苯并[a]芘最高暴露剂量(0.96 mg·kg~(-1))导致二者都显著低于对照水平;试验结束后,苯并[a]芘最低暴露剂量(0.12 mg·kg~(-1))导致二者都显著高于对照水平,最高剂量暴露导致二者都显著低于对照水平,CYP2C9活性对苯并[a]芘的响应更为敏感.因此,推断CYPs亚酶对污染物的响应具有选择性且亚酶的响应敏感度高于CYPs总量.将CYPs总量与CYP1A1活性结合,或与CYP2C9活性结合分别诊断土壤芘污染或并[a]芘污染,较为准确有效.     

改良倒置A2/O工艺设计

在目前广泛采用的AO、A2O、倒置A2O等工艺的基础上,为提高脱氮除磷效率,提出改良倒置A2O工艺。并对其工艺的特点、设计和脱氮除磷效率进行了详细的研究和分析。     

MBBR与A/O法对污水中有机物及氮处理效果的研究

实验在不同水力停留时间（HRT）、进水COD浓度和不同COD容积负荷条件下考察了移动床生物膜反应器（MBBR）和活性污泥A/O工艺对污水中有机物及氮的处理效果。结果表明,MBBR工艺去除有机物和脱氮效果均优于A/O工艺。在进水COD和NH₃－N浓度分别为1000和25 mg/L,HRT为8 h时,MBBR的COD和TN去除率分别为92％和94％,而A/O工艺分别为78％和82％。造成这种结果的原因是MBBR的生物活性高,并且在生物膜内发生了同时硝化反硝化。MBBR脱氮能力受COD冲击明显小于A/O,但在较低进水COD浓度下,两者TN去除率均较低。     

Immunotoxicity of bisphenol a to Carassius auratus Lymphocytes and macrophages following in vitro exposure

Bisphenol A （BPA） is the monomer component of polycarbonate plastics and classified as an endocrine disrupting chemical （EDC）. The reproductive toxicity of BPA has been extensively studied in mammals; however, relatively little information is available on the immunotoxic responses of fish to BPA. In this study, we investigated the effects of BPA on the immune functions of lymphocytes and macrophages in Carassius auratus. The effects of BPA were compared with those of two natural steroid hormones, estradiol and hydrocortisone. Proliferation of the two types of cells in response to PHA was measured using colorimetric MTT assay. Macrophage respiratory burst stimulated by Con A was measured using chemiluminescence assay. Results showed that BPA （0.054-5.4 mg/L）, estradiol （0.0002-2.0 mg/L） and hydrocortisone （5-50 mg/L） significantly induced Carassius auratus lymphocyte proliferation while higher doses of hydrocortisone （500-5000 mg/L） appeared to be inhibitory. BPA （0.005-50 mg/L）, estradiol （0.005-800 mg/L） and hydrocortisone （0.005-500 mg/L） markedly enhanced macrophage proliferation, whereas higher doses of BPA （500-1000 mg/L） appeared to inhibit cell proliferation. Furthermore, higher dosage of BPA （50 mg/L） and hydrocortisone （50 and 500 mg/L） suppressed the macrophages respiratory burst while estradiol is stimulative all the doses tested （0.05-500 mg/L）. In conclusion, BPA could have immunotoxicity to Carassius auratus and functional changes of lymphocyte and macrophage in Carassius auratus may be different between low and high dosages.     

Organic matter and concentrated nitrogen removal by shortcut nitrification and denitrification from mature municipal landfill leachate

An UASB＋Anoxic/Oxic （A/O） system was introduced to treat a mature landfill leachate with low carbon-to-nitrogen ratio and high ammonia concentration. To make the best use of the biodegradable COD in the leaehate, the denitrifieation of NOx^--N in the reeireulation effluent from the elarifier was carried out in the UASB. The results showed that most biodegradable organic matters were removed by the denitrifieation in the UASB. The NH4^＋-N loading rate （ALR） of A/O reactor and operational temperature was 0.28- 0.60 kg NH4^＋-N/（m^3-d） and 17-29℃ during experimental period, respectively. The short-cut nitrification with nitrite accumulation efficiency of 90%-99% was stabilized during the whole experiment. The NH4^＋-N removal efficiency varied between 90% and 100%. When ALR was less than 0.45 kg NH4^＋-N/（m^3.d）, the NH4^＋-N removal efficiency was more than 98%. With the influent NH4^＋-N of 1200-1800 mg/L, the effluent NH4^＋-N was less than 15 mg/L. The shortcut nitrification and denitrifieation can save 40% carbon source, with a highly efficient denitrifieation taking place in the UASB. When the ratio of the feed COD to feed NH4^＋-N was only 2-3, the total inorganic nitrogen （TIN） removal efficiency attained 67%-80%. Besides, the sludge samples from A/O reactor were analyzed using FISH. The FISH analysis revealed that ammonia oxidation bacteria （AOB） accounted for 4% of the total eubaeterial population, whereas nitrite oxidation bacteria （NOB） accounted only for 0.2% of the total eubaeterial population.     

Biosorption of nickel(II) from aqueous solution by Aspergillus niger: Response surface methodology and isotherm study

In the present study, the effects of biosorbent Aspergillus niger dosage, initial solution pH and initial Ni(II) concentration on the uptake of Ni(II) by NaOH pretreated biomass of A. niger from aqueous solution were investigated. Batch experiments were carried out in order to model and optimize the biosorption process. The influence of three parameters on the uptake of Ni(II) was described using a response surface methodology (RSM) as well as Langmuir and Freundlich isotherm models. Optimum Ni(II) uptake of 4.82 mg Ni(II) g⁻¹ biomass (70.30%) was achieved at pH 6.25, biomass dosage of 2.98 g L⁻¹ and initial Ni(II) concentration of 30.00 mg L⁻¹ Ni(II). Langmuir and Freundlich were able to describe the biosorption isotherm fairly well. However, prediction of Ni(II) biosorption using Langmuir and Freundlich isotherms was relatively poor in comparison with RSM approaches. The biosorption mechanism was also investigated by using Fourier transfer infrared (FT-IR) analysis of untreated, NaOH pretreated, and Ni(II) loaded A. niger biomass.