PM2.5在线监测技术概述

针对PM2.5颗粒物监测技术和PM2.5的监测网络的建设,重点介绍了美国多年来对PM2.5的监测状况,以及采用的Beta射线法、Beta射线光浊度法、微量振荡天平法等监测技术的方法和原理;指出综合国内外多年的监测经验,PM2.5的在线监测需要经过大量手工经典方法数据作为比对和校验,才能给出有效而高质量的PM2.5监测数据。     

新农村建设污水处理工程实例

山海关区新民居污水治理工程采用水解酸化+接触氧化+曝气生物滤池为主的工艺进行污水治理,实际运行结果表明:系统运行稳定,处理出水COD≤48 mg.L-1,BOD5≤9 mg.L-1,SS≤10 mg.L-1,NH3-N≤4.5 mg.L-1,TP≤0.47 mg.L-1,处理出水达到《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级A标准,出水用于农村绿化和农灌,经济效益和环境效益明显。     

Minimization of the formation of disinfection by-products

The drinking water industry is required to minimize DBPs levels while ensuring adequate disinfection. In this study, efficient and appropriate treatment scheme for the reduction of disinfection by-product (DBPs) formation in drinking water containing natural organic matter has been established. This was carried out by the investigation of different treatment schemes consisting of enhanced coagulation, sedimentation, disinfection by using chlorine dioxide/ozone, filtration by sand filter, or granular activated carbon (GAC). Bench scale treatment schemes were applied on actual samples from different selected sites to identify the best conditions for the treatment of water. Samples were collected from effluent of each step in the treatment train in order to analyze pH, UV absorbance at 254 nm (UVA₂₅₄), specific UV absorbance at 254 nm (SUVA₂₅₄), dissolved organic carbon (DOC), haloacetic acids (HAAs) and trihalomethanes (THMs). The obtained results indicated that using pre-ozonation/enhanced coagulation/activated carbon filtration treatment train appears to be the most effective method for reducing DBPs precursors in drinking water treatment.     

厌氧滤池处理纺织印染废水的中试研究

对厌氧滤池反应器处理难降解印染废水进行中试研究。结果表明,厌氧滤池反应器水力停留时间(HRT)在8.1～14.6 h之间,进水COD浓度波动较大(500～1 000 mg/L)时,对COD平均去除率为20%。印染废水的BOD5/COD由0.23提高到0.35,废水可生化性明显改善。印染废水中硫酸根浓度略有下降,去除浓度为70 mg/L左右。厌氧滤池进出水颜色明显变化,由紫红色变为蓝黑色,紫外可见光谱分析表明废水中的有机物结构发生变化。     

一体化臭氧-曝气生物滤池处理酸性玫瑰红印染模拟废水

针对含酸性玫瑰红印染废水高色度、难生物降解的特点,分别采用了一体化和分离式臭氧-曝气生物滤池(O3-BAF)工艺处理。与分离式工艺相比,一体化工艺的特点是在一个反应器内部同时实现臭氧氧化和生化的协同作用,降低了处理设施的基建和运行费用。实验结果表明,一体化工艺处理效果明显优于分离式工艺,脱色率达92%,COD去除率达60%,处理效果良好。     

烟气同时脱硫脱氮生物膜填料塔的适用外加碳源

实验分别考察了外加乙酸钠、葡萄糖、酒石酸钾钠、甲醇等4种低分子有机碳源对生物膜填料塔烟气同时脱硫脱氮效率的影响。结果表明,外加乙酸钠的脱氮效果最佳,对NOx的平均去除率为62.05%;外加葡萄糖、酒石酸钾钠、甲醇时的NOx平均去除率分别为51.03%、46.98%、58.71%。乙酸钠、酒石酸钾钠、甲醇均能使SO2的去除率达到100%,葡萄糖显著降低了SO2的去除率。乙酸钠是在生物膜填料塔烟气同时脱硫脱氮技术中适宜的外加碳源。     

以焦炭为填料的生物滴滤塔处理含挥发性脂肪酸臭气

在以焦炭为填料的生物滴滤塔对挥发性脂肪酸臭气的处理研究中考察了空床停留时间、臭气浓度、体积负荷以及进气温度等参数对净化效果的影响。结果表明,空床停留时间较长时对臭气降解有利。在停留时间超过97 s时,能实现完全降解;此外,净化率随臭气浓度和体积负荷的不断增加呈先增加后降低的趋势。当臭气浓度为24.29 mg/m³即臭气的体积负荷为3 g/（m³·h）时,去除率约为96%;当臭气浓度增至1 345.74 mg/m³即体积负荷增至18 g/（m³·h）,去除率达100%;然而,当臭气浓度增至4 934.38 mg/m³即体积负荷增至66 g/（m³·h）时,去除率降至73.1%。另外,进气温度对净化率也有一定程度影响。当进气温度较低时,净化效率相对较高。     

臭氧-BAF组合工艺对石化行业废水深度处理的中试研究

采用臭氧-曝气生物滤池（BAF）组合工艺对中石化九江分公司二级生化出水进行深度处理中试实验。探讨了臭氧投加量、进水水质冲击负荷等因素对该组合工艺出水COD、NH₄⁺-N的影响。中试结果表明,在该水质条件下,臭氧最佳投加量为20~25 mg/L;组合工艺处理后出水COD低于40 mg/L,NH₄⁺-N低于5 mg/L,达到中水回用设计标准;该组合工艺能够经受一定冲击负荷。     

不同类型生物活性滤床对诺氟沙星的去除

诺氟沙星作为一种抗生素广泛应用于人类日常生活,并大量进入水体环境,给水环境质量和生态系统安全带来隐患。研究了由3种不同填料组成的水平流和复合垂直流生物活性滤床对诺氟沙星的去除效果,结果表明,在水力负荷为0．1m^3／（m^2·d）、进水诺氟沙星浓度为392．11—686．17μg／L（平均浓度为500．97μg／L）条件下,复合垂直流滤床对诺氟沙星去除效果普遍好于水平潜流滤床,以沸石为填料的复合垂直流生物活性滤床对诺氟沙星的去除效果最好,平均去除率为80．61％,说明选择合适填料和合适类型的生物活性滤床可以作为去除诺氟沙星的一种有效方法。     

Wastewater management in small- and medium-size enterprises: case studies

Wastewater management in small and medium-sized enterprises representing the chemical and food industries was investigated. The results showed that wastewater discharged from an ink-production factory was highly contaminated with organic pollutants. Anaerobic biological treatment followed by chemical coagulation using ferric chloride aided with lime proved to be very effective and produced an effluent that complied with national regulatory standard for wastewater discharge into public sewage network. Also, management of wastewater from a confectionery factory representing the food sector was carried out. Aerobic biological treatment using plastic-packed trickling filter proved to be an effective treatment method. However, application of in-plant control measures alleviated the requirement for the construction of a wastewater treatment plant. The applied pollution prevention and cleaner production measures involved good housekeeping, recovery of spent chocolate, modification of floor cleaning and installation of suction devices for the removal of sugar and starch powders. All improvement measures were documented by cost/benefit analysis.