河流与海洋溶解有机物荧光激发-发射矩阵光谱的测定

通过对河流与海洋现场样品、微藻培养液和牛血清蛋白溶液的实验,确定了HITACHI F-4500型荧光分光光度计的测定河流和海洋溶解有机物荧光激发-发射矩阵光谱的激发和发射通带分别为5 nm和10 nm,波长扫描速度为12 000 nm/min,标准偏差在0.6%~8%。     

北京密云水库流域水体夏季POM浓度及来源分析

为有效控制流域水质污染,保障饮用水水源的水质安全,通过测定北京境内密云水库流域水体夏季悬浮颗粒有机质(POM)的浓度水平及其碳、氮同位素特征,同时以京密引水渠水体为参比,对密云水库汇水流域水体POM的来源进行研究.结果 表明,密云水库流域水体夏季颗粒态有机碳(POC)浓度的变化范围为0.04～0.71 mg/L,平均值...     

Experimental study of the venting characteristics of dust explosion through a vent duct

To further understand the dynamic mechanism of dust explosion through a vent duct, we designed a small-scale cylindrical vessel connected with a vent duct and performed a dust explosion venting experiment under different opening pressures using corn starch as the explosive medium in this study. The results show that weakening effect of duct on venting is positively correlated with the opening pressure. The explosion pressure in the duct presents a three-peak-structure with time, successively caused by the membrane breaking shock wave, the secondary explosion in the tube, and the continuous combustion, and decreases gradually with the propagation distance. Meanwhile, the three pressure peaks are positively correlated with the opening pressure, while the time interval between them goes to contrary. The increase of opening pressure leads to the increase of secondary explosion intensity and reverse flow in the vessel, further accelerates the reaction rate in the vessel, and then shortens the duration of combustion in the vessel until the phenomenon of flame reignition in the vessel disappears.     

Accelerated ash accumulation method for diesel particulate filter and its characterization: a review

ABSTRACT

It is well known that high-efficiency wall-flow particulate filter is the most commonly used technology that can effectively reduce both particulate matter (PM) and particulate number (PN) to comply with the latest emission legislations. Ash, defined as the noncombustible, non-evaporative residue derived mostly from lubricants, has critical impact on engine backpressure, particulate filter filtration efficiency and durability performance, therefore, the investigation of ash impact on particulate filter is of great importance. Due to cost-saving potential, several published methods from different laboratories for accelerated ash loading under carefully controlled conditions are described in this review, including some characterization methods that have been used for the evaluation of filter performance. In addition, the impact of ash deposit on back pressure and regeneration performance are also discussed in this review.     

Dibutyl phthalate adsorption characteristics using three common substrates in aqueous solutions

• DBP adsorption was tested using three kinds of substrates in constructed wetlands. • The DBP adsorption capacity followed the order: steel slag>gravel>shell sand. • High temperatures increased the DBP adsorption capacity in the substrates. • DOM consistently inhibited the DBP adsorption onto steel slag and gravel. In recent years, the presence and adverse impacts of phthalic acid esters in aquatic environments have gained increasing attention. This work investigated the adsorption behavior of a typical phthalic acid ester, dibutyl phthalate (DBP), onto steel slag, gravel, and shell sand (substrates commonly used in constructed wetlands). The influence of dissolved organic matter (DOM) on DBP adsorption was investigated using humic acid as a proxy for DOM. The results demonstrated that the adsorption of DBP to three substrates reached equilibrium within 96 h, and the adsorption kinetics were well fitted by a pseudo-second-order model. The DBP adsorption isotherms were best fitted by the Langmuir adsorption model. The DBP adsorption capacity decreased in the order of steel slag>gravel>shell sand, with values of 656 mg/kg, 598 mg/kg, and 6.62 mg/kg at 25°C, respectively. DBP adsorbed to the surface of all substrates in a monolayer via an endothermic process. The DBP adsorption capacities of steel slag and gravel decreased as the DOM content increased. The DBP adsorption mechanisms to steel slag and gravel mainly involved the surface coordination of DBP with –OH or –COOH groups and electrostatic interactions. The results of this work suggest that steel slag and gravel may be ideal substrates for use in constructed wetlands to treat wastewater polluted with DBP.     

Diphenylarsinic acid sorption mechanisms in soils using batch experiments and EXAFS spectroscopy

• DPAA sorption data was found to fit the Freundlich equation. • K_f was significantly positive correlated with oxalate-extractable Fe₂O₃. • Ligand exchange was the main mechanism for DPAA sorption on soils. • Bidentate binuclear and monodentate mononuclear DPAA bonds were identified. Diphenylarsinic acid (DPAA) is a phenyl arsenic compound derived from chemical warfare weapons. Macroscopic and microscopic work on DPAA sorption will provide useful information in predicting the partitioning and mobility of DPAA in the soil-water environment. Here, batch experiments and extended X-ray absorption fine structure (EXAFS) spectroscopy were used to investigate the sorption mechanisms of DPAA. The DPAA sorption data from 11 soil types was found to fit the Freundlich equation, and the sorption capacity, K_f, was significantly and positively correlated with oxalate-extractable Fe₂O₃. The K_f values of eight of the 11 untreated soils (1.51–113.04) significantly decreased upon removal of amorphous metal (hydr)oxides (0.51–13.37). When both amorphous and crystalline metal (hydr)oxides were removed from the untreated soils, the K_f values either decreased or slightly increased (0.65–3.09). Subsequent removal of soil organic matter from these amorphous and crystalline metal (hydr)oxide-depleted samples led to further decreases in K_f to 0.02–1.38, with only one exception (Sulfic Aquic-Orthic Halosols). These findings strongly suggest that ligand exchange reactions with amorphous metal (hydr)oxides contribute most to DPAA sorption on soils. EXAFS data provide further evidence that DPAA primarily formed bidentate binuclear (²C) and monodentate mononuclear (¹V) coring-sharing complexes with As-Fe distances of 3.34 and 3.66 Å, respectively, on Fe (hydr)oxides. Comparison of these results with earlier studies suggests that ²C and ¹V complexes of DPAA may be favored under low and high surface coverages, respectively, with the formation of ¹V bonds possibly conserving the sorption sites or decreasing the steric hindrance derived from phenyl substituents.     

长沙市夏季大气颗粒物中重金属的形态及其源解析

对长沙市高开区、经开区、开福区以及马坡岭4个采样点夏季的大气颗粒物(TSP)浓度以及颗粒物中的重金属元素Cu、Zn、Mn、Pb和Cd的浓度和形态分布进行了研究分析,利用污染因子(Cf)对重金属元素的可保持能力进行了评价,并利用因子分析方法(PCA)分析TSP中重金属元素的主要来源。结果显示长沙市夏季TSP平均浓度为220.7μg/m3,表明长沙市颗粒物污染较严重。TSP中重金属元素浓度大小顺序为:ZnPbCuMnCd。从形态分布来看,大约63.3%~89.0%的Cu主要存在于可氧化态(F3),而Mn在这一态中分布最少。元素Zn、Cd则主要分布在弱酸提取态,分别占了70%和35%。Pb主要分布在残渣态,大约为24%~43%。由污染因子计算可知Cu、Cd和Zn比Mn、Pb有更高的迁移性。     

The importance of physico-chemical parameters on the speciation of natural radionuclides in riverine ecosystems

External gamma radiation levels were measured in the catchment areas of the Sharavathi River and the dose rates in air were found to be in the range 26.0-61.0 nGy h⁻¹. Soil and sediment samples of the riverine environment were analysed for natural radionuclides such as ²²⁶Ra, ²³²Th and ⁴⁰K using a NaI(Tl) gamma spectrometer. The activity concentration of ²¹⁰Pb and ²¹⁰Po in soil and sediment samples was determined by radiochemical separation techniques. Evaluation of the activity concentration of radionuclides with grain size revealed an increase in the activity of ²²⁶Ra, ²³²Th and ⁴⁰K towards fine grain size. The activity concentrations for all isotopes in all samples were not significantly correlated with pH. However, the activity of ²¹⁰Po and ²¹⁰Pb in sediment showed a moderate positive correlation with organic matter content and a good correlation with clay content of sediment.     

Dynamic modelling of atmospherically-deposited Ni, Cu, Zn, Cd and Pb in Pennine catchments (northern England)

Simulation modelling with CHUM-AM was carried out to investigate the accumulation and release of atmospherically-deposited heavy metals (Ni, Cu, Zn, Cd and Pb) in six moorland catchments, five with organic-rich soils, one with calcareous brown earths, in the Pennine chain of northern England. The model considers two soil layers and a third layer of weathering mineral matter, and operates on a yearly timestep, driven by deposition scenarios covering the period 1400-2010. The principal processes controlling heavy metals are competitive solid-solution partitioning of solutes, chemical interactions in solution, and chemical weathering. Agreement between observed and simulated soil metal pools and surface water concentrations for recent years was generally satisfactory, the results confirming that most contemporary soil metal is from atmospheric pollution. Metals in catchments with organic-rich soils show some mobility, especially under more acid conditions, but the calcareous mineral soils have retained nearly all anthropogenic metal inputs. Complexation by dissolved organic matter and co-transport accounts for up to 80% of the Cu in surface waters.     

Quantifying the influence of humic acid adsorption on colloidal microsphere deposition onto iron-oxide-coated sand

This article describes an approach for quantifying microsphere deposition onto iron-oxide-coated sand under the influence of adsorbed Suwannee River Humic Acid (SRHA). The experimental technique involved a triple pulse injection of model latex microspheres (microspheres) in pulses of (1) microspheres, followed by (2) SRHA, and then (3) microspheres, into a column filled with iron-coated quartz sand as a water-saturated porous medium. A random sequential adsorption model (RSA) simulated the gradual rise in the first (microsphere) breakthrough curve (BTC). Using the same model calibration parameters a dramatic increase in concentration at the start of the second particle BTC, generated after SRHA injection, could be simulated by matching microsphere concentrations to extrapolated RSA output. RSA results and microsphere/SRHA recoveries showed that 1 μg of SRHA could block 5.90 ± 0.14 × 10⁹ microsphere deposition sites. This figure was consistent between experiments injecting different SRHA masses, despite contrasting microsphere deposition/release regimes generating the second microsphere BTC.