基于固态碳源的自养-异养耦合生物脱氮工艺研究

采用基于固态碳源的厌氧氨氧化与反硝化耦合脱氮工艺处理高氮低碳的金属热处理废水。通过接种城市生活污水处理厂剩余污泥和厌氧氨氧化絮状污泥,研究了以固态碳源（3-羟基丁酸脂和3-羟基戊酸脂共聚物,PHBV）和沸石为组合填料的分区式耦合反应器的启动和运行特性。经过76 d的运行,耦合反应器的总氮去除速率达1.05 kg/（m³·d）,且具有良好的出水COD稳定性。废水经过反应器沸石区后,氨氮去除率达97%,亚硝态氮去除率达81%,而硝态氮去除率几乎为零;经过PHBV区后,硝态氮去除率达76%,亚硝态氮去除率达99%,氨氮去除率达97%。沸石区主要进行厌氧氨氧化反应,PHBV区主要进行反硝化反应,功能分区明确,耦合效果较好。     

改性聚偏氟乙烯中空纤维超滤膜处理乳化液废水

应用改性聚偏氟乙烯中空纤维超滤膜处理乳化液废水(COD浓度100~300 g/L、含油量30~100 g/L),考察了在不同压力、温度及流速条件下,膜处理能力的变化,并研究了清洗方法对膜性能的恢复效果。结果表明,在组合预处理条件下,乳化液废水的COD去除率可达95%以上,油去除率可达99%以上,采用金属清洗剂可使膜的透过量恢复率达97%以上。该项研究为膜处理技术用于乳化液废水处理奠定了基础。     

珠江口地区总悬浮颗粒中金属元素沉降通量

于2002年5月至2004年10月在珠江口大万山海洋环境监测站地面气象观测场上设立一个监测站,共采样了120多个大气气溶胶样品,用无火焰原子吸收分光光度法测定了元素Cu、Pb、Cd的浓度,讨论了这几种元素入海通量的月变化和年平均值。结果表明,三种元素在珠江口地区沉降通量的变化规律是Pb>Cu>Cd。三元素在5月、8月、10月内的沉降通量占全年的比例均少于20%,而且比例的变化规律是10月>5月>8月。     

含内热源松散煤体热湿迁移特性研究

为研究松散煤体内部热湿迁移规律,建立松散煤体多场-相变-扩散耦合数学模型,对热力驱动下的温、湿度场时空演变规律进行仿真研究;通过热湿迁移特性实验平台,对数值模拟结果的有效性与准确性进行验证。研究结果表明：温度相对误差小于5%,含湿量相对误差小于8%;松散煤体温度逐渐升高,温升速率逐渐减小,温度最终趋于稳定值,沿轴线方向温度呈指数性降低;松散煤体湿度场可分为煤体含水率和空气含湿量,在空间上可分为含水率减少区、含水率增大区和含水率不变区,随着计算进行,峰值含水率逐渐增大且向远离热源方向移动;含湿量相较于实验初期均有所增大,沿轴线方向先呈线性降低,后呈指数性降低且线性区域越来越大,指数性区域越来越小。     

污垢系数对热交换器的影响

环保、冶金及建材行业余热利用中的热交换器,常因管内污垢系数上升、换热面粘附粉尘而失效.研制用于某硅铁电炉高温烟尘治理余热利用中设有脉冲喷吹自动清灰装置的热交换器,可有效解决因粉尘粘附而导致的传热系数下降,从而保证了换热器长期稳定运行.     

火电厂冷却池热污染治理初探

通过系统的模型试验,以色水为示踪剂模拟热水,探讨排、取水口分列式布置的三维时间连续点源如何采用工程设施转换成无限长二维面源,以利用水面热交换解决火电厂冷却池热污染的治理问题。给出了出流近区流速分布及流量沿程变化的近似计算式。此研究成果对挖掘冷却池散热潜力,增加电厂装机容量具有实用推广价值     

旋转流膜生物反应器特性的探索

通过人工配水方式对旋转切向流膜生物反应器与一体式膜生物反应器在CODCr去除率、NH3 N去除率、膜透水性能等方面进行了对比试验 ,研究表明虽然二者在有机物去除方面相差不大 ,但前者膜抗污染能力强、透水量大。     

基于三维图像分析的浮力扩散火焰几何与辐射特性研究

火焰几何特性和辐射特性是刻画火灾规模及其危害的重要参量。利用三维火焰重构技术,获取了丙烷浮力扩散火焰的火焰高度、表面积、体积和火焰面元视角系数的变化规律。结果表明,三维重构的火焰能够表征真实火焰形态的动态变化。平均火焰表面积和体积均可较好地拟合为热释放速率的幂函数,火焰表面积热释放速率随火焰热释放速率的增加趋于常数。平均火焰高度、表面积和体积与火焰外部平均辐射热流之间具有较好的幂函数关系,且拟合指数随着与火源距离的增大而减小。此外,将点源、圆柱辐射模型和火焰面元积分方法得到的辐射计算值与辐射测量值进行比较,发现火焰面元积分方法能够更好地预测火焰外围的瞬时和平均辐射热流分布。     

A comprehensive review of the energy efficiency on nano coated fin and tube condenser

The condenser is a piece of equipment used to effectively transfer heat from water to the environment. The fin and tube condenser is the most commonly used in commercial applications. The improved performance of heat transfer in the fin and tube condenser is a significant area of study all over the world because optimizing the efficiency of heat transfer in the condenser will contribute to enhancing the effectiveness of system performance. The vapor deposition, plasma spray, and thermal spray techniques are being used, and it is determined that a heat transfer enhancing coating improves condenser performance. This review discusses the nanomaterial coating over the fin and tube condenser in detail. The various nanomaterial coatings with various propositions and coating methods had been discussed with the evidence of previous researchers. At a 50-degree inclination angle on the condensate plate, the condensate over the coating surface increases by more than 30%. The thermal properties of the working fluid are improved over the condenser, and the overall effectiveness of the condenser is increased by approximately 40% over the non-coated condenser. A 1% volumetric concentration of Nanoparticles in the coated material achieves a maximum efficiency increase of 78.7%.     

Mine rescuers’ heat load during the expenditure of physical effort in a hot environment,using ventilated underwear and selected breathing apparatus

Mine rescuers’ heat load under the same physical effort load (25% of the maximal oxygen uptake), using three types of breathing apparatus, in newly developed heat-removing underwear and outerwear was assessed for typical work conditions of mine rescuers, under milder and harsher ambient conditions of 32 and 38?°C, respectively, both at relative humidity of 85% and air velocity of 1.0?m/s. Expending physical effort at the same load while using different kinds of breathing apparatus resulted in a similar heat load. Under both milder and harsher ambient conditions, heat storage and sweating intensity were greater than the average limit value recommended by hygienic standards, which indicates that the use of breathing apparatus significantly hinders heat exchange with the environment. The developed clothing for mine rescuers was highly rated, and was considered by most people to be better than that used currently.