Selective reduction of NO by photo-SCR with ammonia in an annular fixed-film photoreactor

Gaseous NO was photocatalytically reduced at room temperature by photo-assisted selective catalytic reduction (photo-SCR) with ammonia over TiO₂ in this study. NO reduction efficiency and N₂ selectivity were determined from gases composition at the outlet stream of photoreactor. Effect of operating conditions, e.g. light intensity and inlet concentrations of ammonia and oxygen, on the NO reduction efficiency and N₂ selectivity were discussed to determine the feasible operating condition for photocatalytic reduction of NO. Experimental results showed that selective catalytic reduction of NO with ammonia over TiO₂ in the presence of oxygen was a spontaneous reaction in dark. The photoirradiation on the TiO₂ surface caused remarkable photocatalytic reduction of NO to form N₂, NO₂, and N₂O under 254 nm UV illuminations, while almost 90% of N₂ selectivity was achieved in this study. The ammonia and oxygen molecules played the roles of reductant and oxidant for NO reduction and active sites regeneration, respectively. The reduction of NO was found to be increased with the increase of inlet ammonia and oxygen concentrations until specific concentrations because of the limited active sites on the surface of TiO₂. The kinetic model proposed in this study can be used to reasonably describe the reaction mechanism of photo-SCR.     

加压溶氧光催化反应器降解活性艳红X-3B

探讨了加压溶氧条件对活性艳红X-3B的降解与脱色的作用,考察了加压条件下pH值,TiO2投加量及温度等对活性艳红X-3B降解的影响.结果表明,加压条件与常压条件下变化趋势基本一致.加压充氧有助于活性艳红X-3B的降解与脱色,加压充N2对反应基本没有作用,说明增加活度不是关键因素,加压使溶液中溶解氧增加是导致活性艳红X-3B降解与脱色的主要原因.光催化降解过程,发色基团最易被打碎,60min内降解效果显著,而萘环和苯环降解效果不十分明显.CODCr的降解与色度的褪除成正相关,脱色率越高,COD的降解率也越高.     

无机离子对磷钨酸光催化活性艳橙脱色降解的影响

报道了10种无机离子(NO3-,SO42-,CO32-,PO43-,Cl-,Mg2+,Ca2+,Cu2+,Mn2+和Al3+)对磷钨酸光催化活性艳橙(KGN)溶液反应的影响.研究表明,NO3-,SO42-,CO32-和PO43-对光催化KGN溶液降解有一定的促进作用,但随着NO3-浓度的增大,该促进作用不再增大;SO24-和CO23-在不同浓度下对光催化反应有较强的促进作用,但随着SO42-和CO32-浓度的增长,其促进作用呈降低趋势;当PO34-浓度高于0.15mmol.l-1时,随着PO34-浓度的增大,光催化反应发生抑制,并且随着浓度的增长,抑制作用有增强的趋势;Cl-对光催化脱色反应存在较强的抑制作用,除在0.075mmol.l-1的浓度时,Cl-对反应无明显影响外,其它浓度下都使光催化反应发生抑制,并且随着Cl-浓度的增加,抑制作用明显增强.Mg2+和Ca2+在不同浓度下对磷钨酸光催化KGN反应略微有促进作用;Cu2+对活性艳橙光催化脱色反应影响不显著;而Mn2+和Al3+离子对光催化反应效率存在一定抑制作用.     

掺Fe^3＋A-TiO2粉末的水热法制备及其光催化降解甲基橙

以硫酸钛为原料用水热法制备了掺Fe^3＋TiO2粉末,用SEM和XRD测定了样品的形貌和晶型,研究了以自制的掺Fe^3＋A-TiO2对甲基橙溶液的光催化降解作用。结果表明：所制备的TiO2为锐钛矿型TiO2即A-TiO2。365nm紫外光照射下,用自制的掺Fe^3＋A-TiO2降解甲基橙溶液的最佳条件是：10mg·L^-1的甲基橙溶液中加入0.050g掺5%Fe^3＋（物质的量比）A-TiO2粉末,用HNO3调节溶液成酸性后,18℃恒温反应4h,降解率达到57.8%。     

花瓣状ZnO光催化处理双酚A和Cr(Ⅵ)废水

以乙酸锌、柠檬酸三钠和氢氧化钠为原料,在室温下磁力搅拌制得ZnO。经XRD、SEM和TEM表征,ZnO具有良好的结晶度,为花瓣状形貌。在模拟太阳光的照射下,光催化反应80 min,ZnO对质量浓度为25 mg/L的双酚A溶液中双酚A的去除率仅为32.0%,对质量浓度为20 mg/L的Cr（Ⅵ）溶液中Cr（Ⅵ）的去除率为60.2%。将双酚A与Cr（Ⅵ）溶液混合后,ZnO对双酚A和Cr（Ⅵ）的去除率分别提高至77.6%和94.2%。     

Theoretical and Experimental Investigation of a Novel Hybrid Heat-Pipe Solar Collector

Abstract

This article describes a novel flat plate heat-pipe solar collector, namely, the hybrid heat-pipe solar collector. An analytical model has been developed to calculate the collector efficiency as well as simulate the heat transfer processes occurring in the collector. The effects of heat pipes/absorber, top cover, flue gas channel geometry, and flue gas temperature and flow rate, on the collector efficiency were investigated based on three modes of operation, i.e., solar only operation, solar/exhaust gas combined, and solar, exhaust gas and boiler combined. Experimental testing of the collector was also carried out for each of these modes of operation under real climatic conditions. The results were used to estimate the efficiency of the collector and determine the relation between the efficiency and general external parameter. The modeling and experimental results were compared and a correlation factor was used to modify the theoretical predictions. It was found that the efficiency of the collector was increased by about 20–30% compared to a conventional flat-plate heat pipe solar collector.     

TiO2薄膜光催化体系中羟基自由基的水杨酸分子探针法测定

以水杨酸为分子探针物,以分光光度法测定了纳米TiO2薄膜光催化体系中产生的羟基自由基(·OH).结果表明,水杨酸的自然氧化程度较低,可以作为分子探针测定·OH的产生;实验中最佳的光照时间为60min;水杨酸浓度对·OH的测定影响较大,其最佳值为50 mg·L-1;pH值对·OH的测定影响较大,最佳值为6;最佳实验条件下,分析得到·OH的稳态浓度为1.68×10-14 mol·L-1.     

纳米Cu2O/珍珠贝壳复合光催化材料的制备与表征

以煅烧后的珍珠贝壳为载体,采用原位水解法制备出纳米Cu2O/珍珠贝壳复合光催化材料.通过活性大红染料B-3G的脱色实验对光催化材料的活性进行讨论,并采用XRD、SEM、EDS、FT-IR和UV-Vis对材料进行表征.结果表明,以1050℃煅烧的珍珠贝壳为载体制备的纳米Cu2O/珍珠贝壳复合材料的光催化活性最强.Cu2O...     

铜卟啉修饰In2TiO5纳米带的制备及其光催化性能

以5,10,15,20-四苯基铜卟啉（CuTPP）和5-（4-氨基苯基）-10,15,20-三苯基铜卟啉（CuAPTPP）为敏化剂,采用溶剂热法成功制备了铜卟啉敏化In₂TiO₅复合光催化剂.利用紫外、FT-IR、XRD、SEM、UV-vis DRS和N₂吸附脱附曲线对所得铜卟啉及复合光催化剂进行表征和分析.结果表明,铜卟啉负载于In₂TiO₅纳米带表面,复合光催化剂的禁带宽度及比表面积出现一定程度的减小,但未改变In₂TiO₅的晶型及形貌.其中,CuTPP敏化In₂TiO₅复合光催化剂的光催化活性最强,在模拟太阳光的照射下,120 min时罗丹明B（RhB）的降解率高达98.9%,而In₂TiO₅纳米带对RhB的降解率仅为33.5%,且循环使用5次后其光催化降解率仍保持在95%以上.     

光催化与生物膜直接耦合降解4-氟苯酚废水

为了实现4-氟苯酚（4-FP）废水的快速持续降解,本文构建了光催化与生物膜直接耦合系统.该耦合系统由N掺杂TiO₂涂覆光催化光纤束、生物膜、核孔膜和紫外-可见LED光源构成.实验研究了单独光催化、单独微藻生物膜及光催化-生物膜耦合3种体系对4-FP的降解性能.研究发现：光催化系统降解4-FP速率慢、脱氟效率低,12h内降解率为94.3%,脱氟率仅为24.7%.微藻生物膜在第一个周期内对4-FP的降解性能高于单独光催化,10h内降解率达到98.9%,脱氟率达到90.9%,但3个周期后4-FP降解率降低至75.5%,脱氟率降低至69.5%.在耦合系统中,生物膜中微生物种群发生了自适应调整,富集了大量的红球菌、假单胞菌和无色杆菌,导致了光催化、生物降解及光合作用三者亲密协作,实现了4-FP快速持续地降解,运行12个周期后,5h即可将4-FP完全降解,同时溶解有机碳及脱氟率分别达到89.4%和78.3%.