循环式超声强化光催化降解双酚A

设计了一种循环式超声强化光催化反应器,以TiO2作为光催化剂,研究了超声功率、TiO2加入量、循环液流速和空气流量对双酚A(BPA)降解效果的影响。实验结果表明:超声与光催化过程在循环式超声强化光催化反应器中实现了较好的协同效应;在初始BPA质量浓度为20.0mg/L、超声功率为600W、TiO2加入量为7g/L、循环液流速为4.05×10-2m/s、空气流量为200mL/min的条件下,反应150min后,BPA降解率可达90.5%,溶液中剩余BPA质量浓度仅为1.8mg/L,反应240min后TOC去除率可达84.5%。     

BiFeO3可见光催化降解甲基紫

采用柠檬酸-硝酸盐燃烧法制备了光催化剂BiFeO₃。采用SEM,XRD,FTIR等技术对光催化剂BiFeO₃进行表征。表征结果显示,光催化剂BiFeO₃晶相纯、粒径小、比表面积大,存在Fe#x02014;O的弯曲振动和伸缩振动。实验结果表明：通过鼓气及加入H₂O₂可有效提高BiFeO₃对甲基紫可见光催化降解的效率;在300mL质量分数为1.5#x000d7;10^-5的甲基紫溶液中加入0.9g光催化剂BiFeO₃和0.1mL质量分数为30%的H₂O₂溶液,当反应时间为240min时,甲基紫去除率可达99%。     

碘掺杂Ti02可见光光催化性能研究

在低于100℃温度条件下,采用溶胶一凝胶法以钛酸正丁酯为钛源,碘酸钾为碘源,制备了I掺杂纳米TiO2催化剂（I-TiO2）,运用x-射线衍射（XRD）、透射电镜（TEM）及x-射线光电子能谱（XPS）等对催化剂进行表征,结果表明,TiO2及I-TiO2催化剂均为锐钛矿,I吸附并包裹在TiO2表面或以间隙进入的形式存在,并未进入TiO2晶格。通过在可见光照射下（A〉420nm）以罗丹明B（RhodamineB,RhB）的光催化降解为探针反应研究了在不同条件下制备催化剂的催化性能,结果表明,掺杂比为n1：n^ti=0．05：l,焙烧温度为400℃,降解介质条件pH=7时,l-TiO2光催化活性明显优于未掺杂的TiO2。光催化降解过程通过红外光谱（IR）,总有机碳（TOC）跟踪测定,比较了TiO2掺杂前后降解RhB和对氯苯酚（4-CP）的光催化特性差异;同时采用苯甲酸荧光光度法跟踪测定体系中的氧化物种,表明在可见光下,I-TiO2光催化体系中产生·OH高活性氧化物种从而氧化降解目标化合物。     

A convective wind resource model for Solar Vortex power generation

ABSTRACT

Climate change has increased the need for clean, nonpolluting energy sources to decrease dependence on fossil fuels. Alternative energy sources, mainly solar and horizontal wind, have been the primary focus for producing clean energy. New technologies are being developed, such as the Solar Vortex (SoV), which was developed at the Georgia Institute of Technology, and relies on a vertical wind resource to generate power. The National Renewable Energy Lab (NREL) has resource models representing solar and horizontal wind resources across the 48 United States. This research developed a vertical wind resource model that is comparable in resolution to NREL’s solar and horizontal wind resource models and uses the model for estimating power output for the SoV. This model complements NREL’s existing resource models and supports the deployment of an additional clean energy generation technology. The model was applied to Mesa, Arizona to find feasible sites for a small-scale vertical wind farm.     

A new photoproduct of the drug furosemide in aqueous media

The solar phototransformation of furosemide has been investigated in aqueous media. Irradiation of the drug in distilled water, in water and humic acids or nitrate ions, and in sewage sludge water affords a new dehalogenated dimer. The formation of the dimer has been explained by the formation of a cation radical intermediate. The low-measured environmental concentration of furosemide with respect to predicted environmental concentration in the Po and Lambro Rivers could be justified by its phototransformation.     

磷酸银/树脂复合物的制备及其对亚甲基蓝的光催化降解

以聚乙烯吡咯烷酮(PVP)为稳定剂,采用化学沉积法制备了磷酸银/树脂复合物,降解亚甲基蓝,研究其光催化活性,并对样品进行了XRD和SEM表征。探讨了不同的光源、催化剂投加量、PVP含量、p H值等因素对亚甲基蓝降解率的影响。结果表明,在太阳光(夏天早上9点到11点的阳光)下,偏酸介质中,催化剂用量为0.8 g/L,PVP质量分数为0.01%的磷酸银/树脂复合物,液面高度为15 cm的条件下对亚甲基蓝有最佳降解效果。     

Feasibility Assessment of Basin Solar Stills

The present study assesses the feasibility of exploiting single- and double-basin solar stills in our daily lives. An investigation is carried out to determine the thermal performance and economic viability of making use of solar stills in water desalination. The climatic conditions of Tehran (35°44?N, 51°30?E) are considered to assess the feasibility of the basins. Transient energy and mass balance equations are utilized for modeling the thermal performance. The equations are solved by using fourth-order Runge–Kutta method in FORTRAN. The daily productivities of single- and double-basin solar stills are found to be 5.22 kg/m² and 7.73 kg/m², respectively, while the effect of different water masses (20–100 kg) on the productivity of each system was found to be optimum at 20 kg/m². The results are compared with experimental work performed under different climatic conditions to examine the validity of the feasibility of basins in general. A life cycle cost analysis performed for Tehran, yields that single- and double-basin solar stills have savings-to-investment ratios of 4.2 and 4.8, respectively, indicating that they are economically feasible.     

BiOCl/TiO_2复合材料的可见光活性及机理研究

采用水热法和溶胶凝胶法制备新型BiOCl/TiO2复合材料并明确了最优的掺杂比例(2%).随后利用X射线衍射(XRD)、紫外可见漫反射(DRS)、透射电镜(TEM)和X射线光电子能谱(XPS)对该材料进行表征.由于禁带宽度较大,纯BiOCl和TiO2的可见光催化性能极差,然而二者复合后,同条件下的苯降解率却大幅提升,可以达到40%以上.经证实,催化剂制备过程中,Bi的状态发生变化,在TiO2导、价带之间插入新的能级,使其禁带宽度变窄,电子可以实现可见光跃迁.     

太阳能驱动的一体化设备在农村污水处理中的应用

以太湖流域环境敏感区内某村为例,介绍了太阳能驱动的污水处理一体化设备对农村生活污水处理的应用。连续6个月的运行及监测数据表明,污水处理实际消耗电量与光伏发电量比值为54.3%,能够有效地保证污水处理所需动力。污水处理部分采用A/O-BF一体化技术,生活污水经处理以后,出水水质达到GB 18918-2002《城镇污水处理厂污染物排放标准》中一级A标准。太阳能驱动的污水处理一体化设备运行稳定、故障率低、无需投加药剂且无运行费用,适宜在太湖流域的农村地区推广应用。     

弹药库房挥发性有机物吸附-光催化降解复合材料研究进展

综述了弹药库房中有毒有害气体的来源和危害,以及去除挥发性有机物的技术方法,介绍了光催化降解理论基础、光催化剂的结构和改性措施、吸附剂的种类和吸附-光催化复合材料的制备方法,指出了当前光催化降解挥发性有机物存在的主要问题,结合弹药库房实际环境,提出了未来主要的研究方向。