Chlorothalonil binding to aquatic humic substances assessed from gas purge studies

Abstract

Fate of the fungicide chlorothalonil (TCIN) binding to dissolved organic acid fractions was quantified using gas‐purge desorption studies. Binding studies were conducted to measure the dissolved organic carbon partition constant (K_DOC) with aquatic fulvic and humic acid fractions purified from cranberry bog water. Desorption studies at DOC concentrations up to 50 mg L^‐1 resulted in mean log K_DOC values of 4.63 (s.d.=0.5, n=8) and 4.81 (s.d.=0.7, n=7) for fulvic and humic acids, respectively. These values deviated from reported K_OC (organic carbon) values by 0.5 to 1.5 orders of magnitude. The relationship between K_OC and K_DOC did not conform to accepted ratios of 10: 1 to 3: 1, although these studies were conducted with the strong hydrophobic fraction of DOC. Binding was rapid suggesting hydrophobic partitioning or weak Van Der Waals forces as binding mechanisms. The strong binding potential for TCIN to aquatic humic substances corresponds to increased solubility in the aqueous system. Sorption to DOC suggests a possible transport mechanism which may result in elevated concentrations of TCIN in cranberry bog systems.     

Modeling polychlorinated biphenyl sorption isotherms for soot and coal

Sorption isotherms (pg-ng/L) were measured for 11 polychlorinated biphenyls (PCBs) of varying molecular planarity from aqueous solution to two carbonaceous geosorbents, anthracite coal and traffic soot. All isotherms were reasonably log-log-linear, but smooth for traffic soot and staircase-shaped for coal, to which sorption was stronger and more nonlinear. The isotherms were modeled using seven sorption models, including Freundlich, (dual) Langmuir, and Polanyi-Dubinin-Manes (PDM). PDM provided the best combination of reliability and mechanistically-interpretable parameters. The PDM normalizing factor Z appeared to correlate negatively with sorbate molecular volume, dependent on the degree of molecular planarity. The modeling results supported the hypothesis that maximum adsorption capacities (Q_max) correlate positively with the sorbent’s specific surface area. Q_max did not decrease with increasing sorbate molecular size, and adsorption affinities clearly differed between the sorbents. Sorption was consistently stronger but not less linear for planar than for nonplanar PCBs, suggesting surface rather than pore sorption.     

Sorption of imidacloprid and its metabolites on tropical soils

Abstract

The sorption of imidacloprid (l‐[(6‐chloro‐3‐pyridinyl)‐methyl]‐N‐nitro‐2‐imidazolid‐inimine) (IMI) and its metabolites imidacloprid‐urea (l‐[(6‐chloro‐3‐pyridinyl)‐methyl]‐2‐imidazol‐idinone) (IU), imidacloprid‐guanidine (l‐[(6‐chloro‐3‐pyridinyl)‐methyl]‐4,5‐dihydro‐lH‐imidazol‐2‐amine) (IG), and imida‐cloprid‐guanidine‐olefin ( 1 ‐[(6‐chloro‐3‐pyridinyl)methyl]‐lH‐imidazol‐2‐amine) (IGO) was determined on six typical Brazilian soils. Sorption of the chemicals on the soil was characterized using the batch equilibration method. The range and order of sorption (Kd) on the six soils was IG (4.75–134) > IGO (2.87–72.3) > IMI (0.55 ‐16.9) > IU (0.31–9.50). For IMI and IU, Kd was correlated with soil organic carbon (OC) content and CEC, the latter due to the high correlation between OC and cation exchange capacity (CEC) (R²=0.98). For IG and IGO, there was no correlation of sorption to clay, pH, OC or CEC due to the high sorption on all soils. Average Koc values were IU = 170, IMI = 362, IGO = 2433, and IG = 3500. Although Kd and Koc values found were consistently lower than those found in soils developed in non‐tropical climates, imidacloprid and its metabolites were still considered to be slightly mobile to immobile in Brazilian soils.     

Benzene, toluene, ethyl benzene and xylenes in ambient air and Pinus sylvestris L. needles: a comparative study between Belgium, Hungary and Latvia

Concentrations of benzene, toluene, ethyl benzene and xylenes (BTEX) in ambient air and in 1 yr old Pinus sylvestris pine needles were monitored along a busy road, petrol station and rural area of Belgium, Hungary and Latvia in a 1 yr period. To test P. sylvestris as a possible biomonitor for the BTEX concentrations, samples were taken in the four seasons. As the distribution of data was not normal, the level of pollution on different sites and seasons was compared and evaluated by non-parametric tests. The measured air concentrations did not differ significantly from one season to another throughout the year. There were, however, differences between sampling places. The C₂-alkylbenzene and toluene concentrations in the needles were similar in the autumn/winter and spring/summer periods but a significant decrease in their concentration was observed in every place between winter and spring. This effect was less obvious for toluene.     

Sorption behavior of bensulfuron-methyl on andisols and ultisols volcanic ash-derived soils: Contribution of humic fractions and mineral-organic complexes

Bensulfuron-methyl sorption was studied in Andisol and Ultisol soils in view of their characteristic physical and chemical properties, presenting acidic pH and variable charge. Humic and fulvic acids (HA and FA) and humin (HUM) contributions were established. Sorption was studied by using two synthetic sorbents, an aluminum-silicate with iron oxide coverage and the same sorbent coated with humic acid. Freundlich model described Bensulfuron-methyl behavior in all sorbents (R² 0.969-0.998). K_f for soils (8.3-20.7 μg^1−1/n mL^1/n g⁻¹) were higher than those reported in the literature. Organic matter, halloysite or kaolinite, and specific surface area contributed to the global process. The highest K_f for HA, FA and HUM were 539.5, 82.9, and 98.7 μg^1−1/n mL^1/n g⁻¹. Model sorbents described the participation of variable charge materials with high adsorption capacity. The constant capacitance model was used to assess effects of Bensulfuron-methyl adsorption on the distribution of SOH, SOH₂⁺ and SO⁻ sites of sorbents.     

Sorption and Desorption of Three Endocrine Disrupters in Soils

Sorption of the estrogens estrone (E1), 17β-estradiol (E2) and 17α-ethynylestradiol (EE2) on four soils was examined using batch equilibrium experiments with initial estrogen concentrations ranging from 10 to 1000 ng mL^?1. At all concentrations, >85% of the three estrogens sorbed rapidly to a sandy soil. E1 sorbed more strongly to soil than E2 or EE2. Partial oxidation of E2 to E1 was observed in the presence of soils. Autoclaving was more effective at reducing this conversion than inhibition with sodium azide or mercuric chloride, and had little effect on sorption, relative to the chemical microbial inhibitors. Sorption of EE2 was greater for fine-textured than coarse-textured soils, but greater than 90% of EE2 sorbed onto all four soils. The greatest degree of desorption of estrogens from the sandy soil occurred with the lowest initial concentration of 10 ng mL^?1 and reached levels ≥80% for E1 and E2. Desorption of EE2 was greater in coarser textured soils than finer-textured soils. Again, relative desorption from all soils was greatest with low initial concentrations. Therefore, at environmentally relevant concentrations, estrogens quickly sorb to soils, and soils have a large capacity to bind estrogens, but these endocrine-disrupting compounds can become easily desorbed and released into the aqueous phase.     

Sorption of organic pollutants by marine sediments: implication for the role of particulate organic matter

The objective of this study was to quantify sorption properties for kerogen/black carbon (BC)-bearing sediments. Single-solute sorption isotherms were measured for five pristine marine sediments using phenanthrene, naphthalene, 1,3,5-trichlorobenzene, and 1,4-dichlorobenzene as the sorbates. The results showed that the sorption isotherms were nonlinear and that the organic carbon normalized single point K_OC values were comparable to those reported in the literature for the purified keorgen and BC, but are much higher than the data reported for HA and kerogen/BC-containing terrestrial soils and sediments. It is likely that koergen and BC associated with these pristine marine sediments may not be encapsulated with humic acids or Fe and Mn oxides and hydroxides as often do in terrestrial soils and sediments. As a result, they may be fully accessible to sorbing molecules, exhibiting higher sorption capacities. The study suggests that competition from background HOCs and reduced accessibility when kerogen and BC are associated with terrestrial sediments may dramatically increase variability of sorption reactivities of geosorbents. Such variability may lead to large uncertainties in the prediction of sorption from the contents of kerogen and/or BC along with TOC.     

Biosorption of Cu(II) and Zn(II) onto a lignocellulosic substrate extracted from wheat bran

We studied the removal of copper and zinc ions from aqueous solutions using a lignocellulosic substrate obtained by an acido-basic treatment of wheat bran. The sorption capacity of this material was investigated through batch and column experiments. Batch experimental results showed that the retention capacity of the lignocellulosic substrate was 0.20×10^–3 mol g^–1 at pH 4.5 for copper(II) and 0.24×10^–3 mol g^–1 at pH 6.5 for zinc(II). Column experiments showed a reduced sorption capacity for both ions compared to batch experiments. Batch and column data were analysed using the Langmuir equation in order to determine the affinity constant and the binding capacity of the sorbent and to compare both retention processes.     

Diphenylarsinic acid sorption mechanisms in soils using batch experiments and EXAFS spectroscopy

• DPAA sorption data was found to fit the Freundlich equation. • K_f was significantly positive correlated with oxalate-extractable Fe₂O₃. • Ligand exchange was the main mechanism for DPAA sorption on soils. • Bidentate binuclear and monodentate mononuclear DPAA bonds were identified. Diphenylarsinic acid (DPAA) is a phenyl arsenic compound derived from chemical warfare weapons. Macroscopic and microscopic work on DPAA sorption will provide useful information in predicting the partitioning and mobility of DPAA in the soil-water environment. Here, batch experiments and extended X-ray absorption fine structure (EXAFS) spectroscopy were used to investigate the sorption mechanisms of DPAA. The DPAA sorption data from 11 soil types was found to fit the Freundlich equation, and the sorption capacity, K_f, was significantly and positively correlated with oxalate-extractable Fe₂O₃. The K_f values of eight of the 11 untreated soils (1.51–113.04) significantly decreased upon removal of amorphous metal (hydr)oxides (0.51–13.37). When both amorphous and crystalline metal (hydr)oxides were removed from the untreated soils, the K_f values either decreased or slightly increased (0.65–3.09). Subsequent removal of soil organic matter from these amorphous and crystalline metal (hydr)oxide-depleted samples led to further decreases in K_f to 0.02–1.38, with only one exception (Sulfic Aquic-Orthic Halosols). These findings strongly suggest that ligand exchange reactions with amorphous metal (hydr)oxides contribute most to DPAA sorption on soils. EXAFS data provide further evidence that DPAA primarily formed bidentate binuclear (²C) and monodentate mononuclear (¹V) coring-sharing complexes with As-Fe distances of 3.34 and 3.66 Å, respectively, on Fe (hydr)oxides. Comparison of these results with earlier studies suggests that ²C and ¹V complexes of DPAA may be favored under low and high surface coverages, respectively, with the formation of ¹V bonds possibly conserving the sorption sites or decreasing the steric hindrance derived from phenyl substituents.     

Enhancement of phosphorus sorption onto light expanded clay aggregates by means of aluminum and iron oxide coatings

Phosphorus (P) loading from non-point or point sources increases the eutrophication risk of natural waters. The functioning of constructed wetlands (CWs) used as natural water treatment systems can be improved by means of additional materials adsorbing soluble P. In this study, light expanded clay aggregates (LECA) and LECA coated with aluminum (Al) oxide (Al-LECA) or iron (Fe) oxide (Fe-LECA) were tested for their efficiency as P sorbents in the pH range 3–8. The oxide coatings duplicated the actual sorption capacity calculated from the sorption isotherms at the P concentration in the equilibrium solution of 20 μg L⁻¹, assumed to be the allowable P level in purified water. In the oxide-coated LECAs the sorption was fast and followed both the first- and second-order Lagergren kinetic models, suggesting that the formation of a binuclear surface complex was feasible. In LECA, sorption was markedly slower and followed the first-order kinetic model, indicating that retention occurred through a monodentate attachment. These findings were in harmony with the degree of P saturation (DPS) of the sorbent surfaces at the highest P addition level (200 μg L⁻¹), DPS being decisively higher for LECA than for the oxide-coated sorbents. Accordingly, at higher pH values the competition by hydroxyl ions diminished the sorption in LECA relatively more than that in the coated sorbents. In agreement with the acidity of Al³⁺ being 100 times lower than that of Fe³⁺, at elevated pH the sorption by Al-LECA proved to be less reversible than that by Fe-LECA. The results provide evidence that in CWs Al-coated sorbents are superior to Fe-coated ones that are also redox-sensitive and may lose their sorption properties in anoxic conditions.