无机阴离子对TiO2/SiO2光催化降解酸性红B活性的影响

以酸性红B为模型化合物，分别考察了6种常见的无机阴离子对TiO2/SiO2复合光催化剂活性的影响，并考察了导致催化剂失活的无机阴离子的最低浓度。结果表明，除了HCO3^-能引起催化剂部分不可逆中毒外，其余5种离子并没有在催化剂形成占位。失活的催化剂通过简的HCl冲洗即可再生。另外，对催化剂的失活机制作了初步探讨。     

膨胀珍珠岩负载TiO2光催化脱色性能的研究

以钛酸四丁酯为原料 ,膨胀珍珠岩为载体 ,用溶胶 -凝胶法制备可漂浮于水面的负载型TiO2 。利用该负载型TiO2 对罗丹明B(RB)进行光催化脱色实验 ,结果表明 ,浸渍 3次的负载型TiO2 光催化活性最高 ,催化剂最佳用量为 5 0 0mg/10 0mLRB ,经 5h光照 ,对 10 0mL浓度为 1mg/L和 2 .5mg/LRB脱色率分别为 76 .6 7%和 4 7.2 7% ;该催化剂使用寿命长 ,2 5h后催化剂脱色性能没有减弱 ,可重复使用 ;经 8h光照 ,染料废水脱色效果好。     

Quinone-mediated decolorization of sulfonated azo dyes by cells and cell extracts from Sphingomonas xenophaga

The effects of various quinone compounds on the decolorization rates of sulfonated azo dyes by Sphingomonas xenophaga QYY were investigated. The results showed that anthraquinone-2-sulfonate (AQS) was the most effective redox mediator and AQS reduction was the rate-limited step of AQS-mediated decolorization of sulfonated azo dyes. Based on AQS biological toxicity tests, it was assumed that AQS might enter the cells to kill them. In the cytoplasmic extracts from strain QYY, AQS effectively increased decolorization rates of sulfonated azo dyes than other quinone compounds. In addition, we found a NADH/FMN-dependent AQS reductase using nondenaturing polyacrylamide gel electrophoresis (Native-PAGE).     

纺织废水集中处理厂升级改造关键技术

某纺织废水集中处理厂接纳的主要废水为棉纺织、染整、洗毛、化工等综合性废水。这种废水成分复杂．污染程度高,混合废水CODCr质量浓度高达2000mg／L,pH值达13。为响应江苏省DB32／1072--2007《湖地区城镇地区水处理厂及重点工业行业主要水污染物排放限值》的新标准,研究了老污水厂升级改造的关键技术：首先采用清浊分流,将高浓度的退浆废水与洗毛废水经8d厌氧预处理,使CODCr质量浓度由8000mg／L降至1800mg／L．然后与印染废水混合,使调节池出水CODCr质量浓度从1600mg/L降至800mg／L左右;污泥量减少40％～50％;并深化曝气生物滤池处理工艺,采用气水联合反冲洗,节约80％反冲洗水,并使曝气生物滤池出水CODCr质量浓度稳定在60mg／L以下。     

滑动弧等离子体处理三种染料废水的研究

偶氮染料酸性橙Ⅱ、吩嗪染料中性红和三苯甲烷染料碱性艳蓝BO是3种具有代表性的常用工业染料。通过气液两相滑动弧放电等离子体产处理这3种染料,对其脱色效果、反应动力学、降解效果及降解路径进行了分析。实验结果显示:当放电电压10 k V、频率50 Hz、载气(空气)流速0.8 m~3/h、液体流速60 m L/min、染料溶液体积500 m L、浓度200 mg/L,放电处理60 min时,滑动弧等离子体对染料溶液的具有较好的脱色效果,酸性橙II、中性红和碱性艳蓝BO的脱色率分别为84.1%、72.7%与89.7%。3种染料的脱色反应符合一级反应动力学规律,其中碱性艳蓝在前30 min的脱色速率最快,可达0.0631 min~(-1),远大于酸性橙II和中性红,而后30 min的反应速率均明显放慢,低于酸性橙II和中性红的同期脱色速率。滑动弧等离子体对3种染料的降解效果(COD去除率)不高,经过60 min的处理降解率分别仅为27.4%、37.3%和28.2%。最后,通过降解过程中的UV-Vis色谱变化对3种染料的降解路径作了初步推测,即等离子体先破坏染料的发色体系与共轭体系,随后发生开环反应,最后再降解为小分子结构。     

反硝化菌的偶氮染料脱色研究

从活性污泥中分离到几株反硝化能力的偶氮染料脱色菌。它们在合成培养基吧有使大多数所试偶氮染料脱色,而在反硝化条件下很难使偶氮染料脱色,只有菌株１７在培养２０ｄ后才有较好的脱色效果。酵母粉等有机物作为生长因子时,对菌株１７反硝化条件下的偶氮染料脱色有非常明显的促进作用;     

新生态MnO2吸附法处理水溶性阴离子染料废水的研究

研究了各种水溶性阴离子染料在新生态MnO2表面的脱色作用。结果表明,9种不同模拟染料废水(包括直接染料、酸性媒介染料、活性染料)的脱色效果均十分显著．且脱色过程受pH的影响较大。另外。通过CHN元素分析、差热分析、紫外光谱及滴定分析等测试手段．初步认为在酸性介质下．新生MnO2质子化的表面可以吸附阴离子型染料,从而将其去除。     

含氮芳香化合物的厌氧生物降解研究回顾

回顾了硝基芳香化合物和偶氮化合物在厌氧条件下的生物脱毒、转化和矿化作用的研究成果。这些研究表明 ,由于硝基和偶氮基具有强烈的吸电子性 ,好氧条件下很难降解。但是 ,硝基和偶氮基芳香化合物在产甲烷菌群作用下较易还原脱毒 ,转化为相应的芳香胺类 ,其毒性要小几个数量级 ,因而有些毒性很高的芳香化合物废水可利用厌氧反应器处理 ,而且反应过程中发现一些芳香胺类化合物可被完全矿化 ,表明一些含氮芳香化合物可作为厌氧菌的碳源和能源 ,在厌氧条件下被完全生物降解。     

Photocatalytic degradation of dye effluent by titanium dioxide pillar pellets in aqueous solution

Photocatalytic oxidation (PCO) process is an effective way to deal with organic pollutants in wastewater which could be difficult to be degraded by conventional biological treatment methods. Normally the TiO2 powder in nanometre size range was directly used as photocatalyst for dye degradation in wastewater. However the titanium dioxide powder was arduous to be recovered from the solution after treatment. In this application, a new form of TiO2(i. e. pillar pellets ranging from 2.5 to 5.3 mm long and with a diameter of 3.7 mm) was used and investigated for photocatalytic degradation of textile dye effluent. A test system was built with a flat plate reactor(FPR) and UV light source(blacklight and solar simulator as light source respectively) for investigating the effectiveness of the new form of TiO2. It was found that the photocatalytic process under this configuration could efficiently remove colours from textile dyeing effluent. Comparing with the TiO2 powder, the pellet was very easy to recovered from the treated solution and can be reused in multiple times without the significant change on the photocatalytic property. The results also showed that to achieve the same photocatalytic performance, the FPR area by pellets was about 91% smaller than required by TiO2 powder. At least TiO2 pellet could be used as an alternative form of photocatalyst in applications for textile effluent treatment process, also other wastewater treatment processes.