电子束辐照降解水中氯霉素的研究

本研究对氯霉素(CAP)在不同条件下的电子束辐照降解进行了研究.结果表明,电子束辐照可有效去除水中CAP,低浓度CAP在酸性条件下的辐照降解更为显著,且降解过程符合准一级动力学模型.通过添加不同的自由基清除剂,发现HO·在CAP降解中起关键作用,此外,CAP分子也会吸收辐照而发生分解.水中共存的阴离子和腐殖酸(HA)对CAP辐照降解均有抑制作用,这跟其与HO·的反应速率常数大小有关,并且反应速率越大,其抑制能力越强.CAP在去离子水中的去除率高于其他实际水体,但辐照剂量为4 k Gy时,污水厂污水过滤水和胶体浓缩液中的CAP也可分别去除89.1%和81.7%.利用GC-MS检测到辐照后溶液中有6种中间产物,主要是通过脱水、不对称中心断键和脱酰胺作用形成.此外,IC检测有Cl-、NO-3和NO-2的产生,并且TOC在一定程度上降低,说明部分CAP被矿化.     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.     

吸附模式对有机物光催化降解的影响2.H-酸在TiO2表面的光催化降解途径

水溶液中H-酸通过磺酸基团吸附在TiO2表面,UV照射TiO2所产生的自由基首先进攻吸附在TiO2表面的磺酸基团,从而进一步导致萘环开环.pH 2.5条件下,虽然饱和吸附量较大,但由于H-酸仅通过一个磺酸基团吸附在TiO2表面,过程中产生的硫酸根速率较慢,最终的光降解速率也较慢.pH 5.0条件下,虽然饱和吸附量较小,但由于吸附在TiO2表面的两个磺酸基团同时受到来自TiO2表面自由基的进攻,过程中产生的硫酸根速率较快,最终的光降解速率也较快.吸附模式的差异是导致H-酸在不同pH值条件下光催化降解途径和速率差异的关键因素.     

沈阳地区冬季空气颗粒物输送路径及潜在源分析

文章利用2016～2017年冬季沈阳地区气象数据和环境空气污染物浓度数据,综合分析沈阳地区冬季环境空气污染特征,分析颗粒物输送路径以及潜在源区贡献情况.结果表明,沈阳地区冬季污染时段内PM2.5是主要污染物,PM2.5平均浓度达到149μg/m3,最大值达到273 μg/m3.沈阳地区环境空气颗粒物除来源于本地排放外,...     

地下土壤、水中DNAPLs污染的修复技术研究进展

综述了国内外地下土壤、含水层DNAPLs污染的迁移机理及其修复技术研究进展,对该领域的研究前景做了展望.     

Aerobic degradation of methyl tert-butyl ether by a Proteobacteria strain in a closed culture system

The contamination of methyl ten-butyl ether （MTBE） in underground waters has become a widely concerned problem all over the world. In this study, a novel dosed culture system with oxygen supplied by H2O2 was introduced for MTBE aerobic biodegradation. After 7 d, almost all MTBE was degraded by a pure culture, a member of β-Proteobacteria named as PMI, in a closed system with oxygen supply, while only 40% MTBE was degraded in one without oxygen supply. Dissolved oxygen （DO） levels of the broth in closed systems respectively with and without H2O2 were about 5-6 and 4 mg/L. Higher DO may improve the activity of monooxygemase, which is the key enzyme of metabolic pathway from MTBE to tert-butyl alcohol and finally to CO2, and may result in the increase of the degrading activity of PM1 cell. The purge and trap GC-MS result of the broth in closed systems showed that tea-butyl alcohol, isopronol and acetone were the main intermediate products.     

Runoff of pesticides from rice fields in the Ile de Camargue (Rhône river delta, France): field study and modeling

A field study on the runoff of pesticides was conducted during the cultivation period in 2004 on a hydraulically isolated rice farm of 120 ha surface with one central water outlet. Four pesticides were studied: Alphamethrin, MCPA, Oxadiazon, and Pretilachlor. Alphamethrin concentrations in runoff never exceeded 0.001 microg L(-1). The three other pesticides were found in concentrations between 5.2 and 28.2 microg L(-1) in the runoff water shortly after the application and decreased thereafter. The data for MCPA compared reasonably well with predictions by an analytical runoff model, accounting for volatilization, degradation, leaching to groundwater, and sorption to soil. The runoff model estimated that runoff accounted for as much as 18-42% of mass loss for MCPA. Less runoff is observed and predicted for Oxadiazon and Pretilachlor. It was concluded that runoff from rice paddies carries important loads of dissolved pesticides to the wetlands in the Ile de Camargue, and that the model can be used to predict this runoff.     

Development of a risk-based index for source water protection planning, which supports the reduction of pathogens from agricultural activity entering water resources

Source water protection planning (SWPP) is an approach to prevent contamination of ground and surface water in watersheds where these resources may be abstracted for drinking or used for recreation. For SWPP the hazards within a watershed that could contribute to water contamination are identified together with the pathways that link them to the water resource. In rural areas, farms are significant potential sources of pathogens. A risk-based index can be used to support the assessment of the potential for contamination following guidelines on safety and operational efficacy of processes and practices developed as beneficial approaches to agricultural land management. Evaluation of the health risk for a target population requires knowledge of the strength of the hazard with respect to the pathogen load (massxconcentration). Manure handling and on-site wastewater treatment systems form the most important hazards, and both can comprise confined and unconfined source elements. There is also a need to understand the modification of pathogen numbers (attenuation) together with characteristics of the established pathways (surface or subsurface), which allow the movement of the contaminant species from a source to a receptor (water source). Many practices for manure management have not been fully evaluated for their impact on pathogen survival and transport in the environment. A key component is the identification of potential pathways of contaminant transport. This requires the development of a suitable digital elevation model of the watershed for surface movement and information on local groundwater aquifer systems for subsurface flows. Both require detailed soils and geological information. The pathways to surface and groundwater resources can then be identified. Details of land management, farm management practices (including animal and manure management) and agronomic practices have to be obtained, possibly from questionnaires completed by each producer within the watershed. To confirm that potential pathways are active requires some microbial source tracking. One possibility is to identify the molecular types of Escherichia coli present in each hazard on a farm. An essential part of any such index is the identification of mitigation strategies and practices that can reduce the magnitude of the hazard or block open pathways.     

A method for evaluating transport energy consumption in suburban areas

Urban sprawl is a major issue for sustainable development. It represents a significant contribution to energy consumption of a territory especially due to transportation requirements. However, transport energy consumption is rarely taken into account when the sustainability of suburban structures is studied. In this context, the paper presents a method to estimate transport energy consumption in residential suburban areas. The study aimed, on this basis, at highlighting the most efficient strategies needed to promote awareness and to give practical hints on how to reduce transport energy consumption linked to urban sprawl in existing and future suburban neighborhoods. The method uses data collected by using empirical surveys and GIS. An application of this method is presented concerning the comparison of four suburban districts located in Belgium to demonstrate the advantages of the approach. The influence of several parameters, such as distance to work places and services, use of public transport and performance of the vehicles, are then discussed to allow a range of different development situations to be explored. The results of the case studies highlight that traveled distances, and thus a good mix between activities at the living area scale, are of primordial importance for the energy performance, whereas means of transport used is only of little impact. Improving the performance of the vehicles and favoring home-work give also significant energy savings. The method can be used when planning new areas or retrofitting existing ones, as well as promoting more sustainable lifestyles regarding transport habits.     

Chemical oxidation of sulfadiazine by the Fenton process: Kinetics,pathways, toxicity evaluation

This paper investigated sulfadiazine oxidation by the Fenton process under various reaction conditions. The reaction conditions tested in the experiments included the initial pH value of reaction solutions, and the dosages of ferrous ions and hydrogen peroxide. Under the reaction conditions with pH 3, 0.25 mM of ferrous ion and 2 mM of hydrogen peroxide, a removal efficiency of nearly 100% was achieved for sulfadiazine. A series of intermediate products including 4-OH-sulfadiazine/or 5-OH-sulfadiazine, 2-aminopyrimidine, sulfanilamide, formic acid, and oxalic acid were identified. Based on these products, the possible oxidation pathway of sulfadiazine by Fenton's reagent was proposed. The toxicity evaluation of reaction solutions showed increased antimicrobial effects following the Fenton oxidation process. The results from this study suggest that the Fenton oxidation process could remove sulfadiazine, but also increase solution toxicity due to the presence of more toxic products.