生物提取废水处理工程的设计调试

采用UASB-A/O工艺处理制药废水,在进水COD浓度为37580 mg/L时,经工艺处理后,废水中COD去除率可达98%以上,出水达到设计要求。工程运行实践表明,该技术处理效果良好,是解决高浓度有机废水的有效途径,适于推广。     

Effect of alkalinity on nitrite accumulation in treatment of coal chemical industry wastewater using moving bed biofilm reactor

Nitrogen removal via nitrite （the nitrite pathway） is more suitable for carbon-limited industrial wastewater. Partial nitrification to nitrite is the primary step to achieve nitrogen removal via nitrite. The effect of alkalinity on nitrite accumulation in a continuous process was investigated by progressively increasing the alkalinity dosage ratio （amount of alkalinity to ammonia ratio, mol/mol）. There is a close relationship among alkalinity, pH and the state of matter present in aqueous solution. When alkalinity was insufficient （compared to the theoretical alkalinity amount）, ammonia removal efficiency increased first and then decreased at each alkalinity dosage ratio, with an abrupt removal efficiency peak. Generally, ammonia removal efficiency rose with increasing alkalinity dosage ratio. Ammonia removal efficiency reached to 88% from 23% when alkalinity addition was sufficient. Nitrite accumulation could be achieved by inhibiting nitrite oxidizing bacteria （NOB） by free ammonia （FA） in the early period and free nitrous acid in the later period of nitrification when alkalinity was not adequate. Only FA worked to inhibit the activity of NOB when alkalinity addition was sufficient.     

Characterization of a salt-tolerant bacterium Bacillus sp. from a membrane bioreactor for saline wastewater treatment

High salt concentrations can cause plasmolysis and loss of activity of cells, but the salt-torlerant bacterium can endure the high salt concentrations in wastewater. In this research 7 salt-torlerant bacteria, which could survive in dry powder products and could degrade organic contaminants in saline wastewater, were isolated from a membrane bioreactor. The strain NY6 which showed the fastest growth rate, best property for organic matter degradation and could survive in dry powder more than 3 months was selected and characterized. It was classified as Bacillus aerius based on the analysis of the morphological and physiological properties as well as the 16 S rRNA sequence and Neigh borjoining tree. The strain NY6 could survive in the salinity up to 6% and the optimal growth salinity is2%; it belongs to a slightly halophilic bacterium. The capability of its dry powder products for COD removal was 800 mg COD/(g·day) in synthesized saline wastewater with salinity of 2%. According to salt-tolerant mechanism research, when the salinity was below 2%, the stain NY6 absorbed K+and Na+to maintain osmotic equilibrium, and when the salinity was above 2%, the NY6 kept its life by producing a large amount of spores.     

Performance and microbial diversity of an expanded granular sludge bed reactor for high sulfate and nitrate waste brine treatment

The disposal of waste brines has become a major challenge that hinders the wide application of ion- exchange resins in the water industry in recent decades. In this study, high sulfate removal efficiency （80%-90%） was achieved at the influent sulfate concentration of 3600 mg/L and 3% NaC1 after 145 days in an expanded granular sludge bed （EGSB） reactor. Furthermore, the feasibility of treating synthetic waste brine containing high levels of sulfate and nitrate was investigated in a single EGSB reactor during an operation period of 261 days. The highest nitrate and sulfate loading rate reached 6.38 and 5.78 kg/（m3-day） at SO42--S/NO3-N mass ratio of 4/3, and the corresponding removal efficiency was 99.97% and 82.26% at 3% NaC1, respectively. Meanwhile, 454-pyrosequencing technology was used to analyze the bacterial diversity of the sludge on the 240th day for stable operation of phase X. Results showed that a total of 9194 sequences were obtained, which could be affiliated to 14 phyla, including Proteobacteria, Firmicutes, Chlorobi, Bacteroidetes, Synergistetes and so on. Proteobacteria （77.66%） was the dominant microbial population, followed by Firmicutes （12.23%） and Chlorobi （2.71%）.     

Anoxic gas recirculation system for fouling control in anoxic membrane reactor

Anoxic gas recirculation system was applied to control the membrane fouling in pilot-scale 4-stage anoxic membrane bioreactor(MBR). In the anaerobic-anoxic-anoxic-aerobic flow scheme,hydrophilic polytetrafluoroethylene(PTFE) membrane(0.2 μm, 7.2 m2/module) was submerged in the second anoxic zone. During 8 months operation, the average flux of the membrane was 21.3L/(m2·hr). Chemical cleaning of the membrane was conducted only once with sodium hydroxide and sodium hypochlorite. Dissolved oxygen(DO) concentration in the second anoxic zone was maintained with an average of 0.19 ± 0.05 mg/L. Gas chromatography analysis showed that the headspace gas in the second anoxic reactor was mainly consisted of N2(93.0% ± 2.5%), O2(3.8% ± 0.6%), and CO2(3.0% ± 0.5%), where the saturation DO concentration in liquid phase was 1.57 mg/L. Atmospheric O2 content(20.5% ± 0.8%) was significantly reduced in the anoxic gas. The average pH in the reactor was 7.2 ± 0.4. As a result, the recirculation of the anoxic gas was successfully applied to control the membrane fouling in the anoxic MBR.     

ABR-MBR一体化工艺节能降耗措施优化研究

能耗高和膜污染是限制膜生物反应器(MBR)广泛应用的重要因素.为降低工艺运行能耗和延缓膜污染,以厌氧折流板反应器(ABR)-MBR工艺处理生活污水为例,对工艺结构和脱氮除磷运行条件进行优化.结果表明,通过优化ABR-MBR工艺结构,可降低43%的运行能耗,同时可保持较高的COD、NH+4-N、TN和TP去除效果,平均去除率分别为91%、85%、76%和86%.另外,添加颗粒填料可有效延缓膜污染,不过也改变了膜污染的形成过程,膜内部污染物含量显著增多,碳水化合物含量增加,而蛋白质含量减少,碳水化合物/蛋白质比明显增大.最终,增强了MBR反应器的实际应用性能.     

高硫酸盐难降解废水高温厌氧处理中限量曝气的应用及影响

由于硫酸盐还原的影响,普通高温UASB反应器处理亚硫酸盐纸浆厂排出的高硫酸盐难降解废水过程中甲烷菌活性受到了严重抑制.考虑到空气对硫化氢的吹脱和对硫化物的氧化作用可能减轻硫化物对甲烷菌的抑制,本研究在厌氧反应器中引入限量曝气措施.试验结果表明,反应器的运行稳定性和处理能力均得到大幅提高.在有机负荷提高到原来2倍的情况下,曝气后COD去除率仍有提高,从40%～50%提高到60%～70%.试验证明部分甲烷菌可以耐氧,而某些种类的水解酸化细菌则对不完全厌氧环境比较敏感.     

膜生物反应器中膜过滤特征及膜污染机理的研究

以膜生物反应器处理市政污水,通过对活性污泥进行终端过滤来反映膜污染机理,实验表明,最初很短时间内膜污染受膜孔堵塞模型控制,之后受沉积层阻力模型控制,后一阶段是膜污染的主要控制阶段;膜的相对通量随过滤时间呈指数衰减趋势,压力越大,通量衰减越快;污泥沉积层存在压密过程,这一过程中的污泥比阻随压力增大而增大,并得到处理市政污水的污泥压密指数为0.807 8;阻力分布实验表明沉积层阻力占总阻力的90%以上,是膜过滤污染阻力的主要组成部分;活性污泥各组分对膜污染均有贡献,其中悬浮固体、胶体颗粒和溶质产生的阻力分别占87.98%、6.20%和5.82%;根据实验和计算结果,探讨了MBR处理市政污水过程中可能的膜污染机理.     

基于CFD的超薄平板膜MBR流态模拟及优化分析

随着MBR的广泛应用,为控制膜污染导致高运行成本问题,优化新型平板膜MBR的曝气条件成为目前的一个研究热点.本研究通过使用CFD Fluent软件,结合多相流模型和湍流模型进行超薄平板膜MBR的高质量流态模拟,量化膜面剪切力,并从流场及膜污染角度分别对3种气水比(10∶1、15∶1和20∶1)工况下的MBR进行了优化分...     

新型厌氧内循环反应器处理酒精废水的应用研究

介绍了新型内循厌氧流化床对酒精行业所产生废水的治理。经工程实际运行可知:进水容积负荷在9.4~19.2 kg COD/(m3·d)变化范围内,COD值去除率基本能维持在85%以上。系统运行稳定,处理效率高。为其它类似水质的实施具有指导作用。