紫外光降解对生物过滤塔去除氯苯性能的影响机制研究

紫外-生物过滤联合工艺中的紫外单元促进了后续生物过滤单元的氯苯去除性能.为了进一步揭示紫外光降解对生物过滤塔运行性能的影响机制,本研究系统分析了紫外光降解对生物过滤塔填料层pH、生物膜特性和填料层结构特性等方面的影响.结果表明,氯苯紫外光降解产物导致了生物过滤单元填料层pH的下降(从pH 6～8降至pH 4～7);另外,紫外单元产生的臭氧降低了生物过滤单元生物膜厚度和生物膜的EPS含量,改善了生物膜的特性,提高了氯苯和营养物质在生物膜内的传质效率.同时,臭氧可以有效控制生物量过量积累,增加了填料层的比表面积(从784 m2.m-3增加至880 m2.m-3),优化了填料层的结构特性,提高了污染物的反应速率.上述各方面的综合作用最终促进了生物过滤单元的氯苯去除性能.     

紫外辐射对小球藻混凝效果作用途径探讨

针对藻类在常规水处理过程中难以被有效去除的现状,采用紫外辐射对藻类混凝过程进行强化处理.结果表明,随着紫外照射时间的增加,混凝后对藻细胞和浊度的去除均呈先上升后下降的趋势,并在照射50 min时达到最大值.PAC(聚合氯化铝)投加量为5 mg·L~(-1)时,照射样的除藻率和去浊率达到最大,分别比空白样高20.1%和18%左右.pH值在6~9范围内,紫外辐射强化混凝效果的变化较小.溶液pH=8、紫外照射50 min,混凝后的除藻率和去浊率分别达到了93.5%和90.6%.此时,藻细胞Zeta电位最大,同时释放出藻黏液,有利于混凝沉降.而当紫外照射超过60 min后,出现细胞膜破裂,胞内有机物渗出,使得溶液中的有机物浓度急剧上升,Zeta电位开始下降,不利于后续混凝的进行.     

染料探针技术对二级出水中优势污染物的定量检测

分别以刚果红和中性红为染料探针,建立了牛血清蛋白质(BSA)和海藻酸多糖(SA)含量与共振光散射(RLS)发射光谱强度间的线性关系;以甲苯胺蓝为染料探针,建立了腐殖酸(HA)含量与紫外吸光度间的线性关系;优化了3种标准物质的检测浓度范围及溶液p H值条件;考察了染料探针分析方法对标准物的二元和三元混合样品中的回收率.结果表明在适宜的浓度范围内,BSA、HA、SA浓度与染料探针光谱强度间的线性相关系数R0.98,3种标准物在混合样品中的回收率不小于95%,标准误差低于0.11%.以紫外光谱和3D-EEM光谱特征作为城市污水二级出水样品中蛋白质、多糖和腐殖酸的定性依据,确认了4种二级出水样品中的优势污染物.通过染料-探针技术与国标法测得的多糖和蛋白质质量浓度的相对偏差在1.2%~0.04%之间.     

Denaturing high-performance liquid chromatography (DHPLC)-based prenatal diagnosis for tuberous sclerosis

Tuberous sclerosis (TSC) is a frequent autosomal-dominant condition (affecting 1 in 6000 individuals) caused by various mutations in either the hamartin (TSC1) or the tuberin gene (TSC2). This allelic and non-allelic heterogeneity makes genetic counseling and prenatal diagnosis difficult, especially as a significant proportion of TSC cases are due to de novo mutations. For this reason the identification of the disease causing mutation is mandatory for accurate counseling, yet current mutation detection methods such as single-strand conformation polymorphism (SSCP) or denaturing gradient gel electrophoresis (DGGE) are labor intensive with limited detection efficiency. Denaturing high-performance liquid chromatography (DHPLC) is a high-throughput, semi-automated mutation detection system with a reported mutation detection rate close to 100% for PCR fragments of up to 800 bp. We used a recently described DHPLC assay allowing the efficient detection of mutations in TSC1 to analyze the DNA extracted from a chorion villus sample in order to perform a prenatal diagnosis for TSC. The fetus was found not to have inherited the deleterious mutation and the DHPLC diagnosis was confirmed by haplotype analysis. This represents the first DHPLC-based prenatal diagnosis of a genetic disease. Copyright © 2001 John Wiley & Sons, Ltd.     

Role of Amino Acids on <Emphasis Type="Italic">In Situ</Emphasis> Photografting of Jute Yarn with 3-(Trimethoxysilyl) Propylmethacrylate

To improve the mechanical performance of natural lignocellulosic jute yarn, grafting with [3-(trimethoxysilyl) propylmethacrylate] (TMSPM) monomer has been performed on in situ UV radiation and optimized the monomer concentration (30%) and irradiation time (30 min). Effect of various amino acids (1%) as additives in TMSPM with photografted jute yarn at optimized system has been studied. The polymer loading (PL) and tensile properties like tensile strength (TS) and elongation at break (Eb) of treated samples were enhanced by incorporation of amino acids and the highest properties (TS = 300% and Eb = 386%) achieved by the sample treated with l-Arginine (Arg) with 32.5% PL value. Weak acid like 3% acetic acid and inorganic acid like 1% sulfuric acid were also incorporated in the optimized system of TMSPM grafting and compared their effect on the tensile properties with amino acid treated samples. Water absorption and weathering resistance of treated and untreated samples were also performed and treated sample showed lesser water uptake as well as less weight loss and mechanical properties as compared to untreated samples.