金属冶炼企业大气污染的安全评价

随着我国现代工业的发展,金属冶炼过程中产生的SO2烟气及重金属尘毒对环境的污染越来越严重。针对湖南水口山矿务局主要金属冶炼企业的大气污染进行了调查、统计、分析和安全评价。评价结果表明：造成大气污染的危险源主要是冶炼企业所排放废气中含有大量的SO2烟气及重金属尘毒。在查明了污染源和危害的基础上,提出了科学治污的措施与方法。     

Washing out heavy metals from contaminated soils from an iron and steel smelting site

Washing is a promising method for separating contaminants bound to the particles of soil ex-situ by chemical mobilization. Laboratory batch washing experiments were conducted using deionized water and varying concentrations of oxalic acid, citric acid, tartaric acid, acetic acid, hydrochloric acid and ethylenediaminetetra acetic acid (EDTA) to assess the efficiency of using these chemicals as washing agents and to clean up heavy metals from two heavily polluted soils from an iron and streel smelting site. The toxicity reduction index and remediation costs were analyzed, and the results showed that the soils were polluted with Cd, Pb and Zn. Hydrochloric acid and EDTA were more efficient than the other washing agents in the remediation of the test soils. The maximum total toxicity reduction index showed that 0.5 mol·L^-1 hydrochloric acid could achieve the remediation with the lowest costs.     

线性扫描溶出伏安法同时测定水样中铅镉铜锌

通过多壁碳纳米管-Nafion复合膜修饰电极,建立水样中痕量铅、镉、铜、锌同时测定的线性扫描溶出伏安分析法,优化支持电解质及pH值、修饰剂用量、富集电位及时间等测定条件。实验结果表明,在pH 4.0的NaAc-HAc缓冲液中,-1.20V富集5min后,在电位-1.04V、-0.72V、-0.45V及-0.16V附近分别产生锌、镉、铅、铜的灵敏溶出峰,测定各元素的线性关系良好,相对标准偏差均小于5.4%。该法已成功应用于实际水样中痕量铅、镉、铜、锌的同时测定,加标回收率在93.3%~106.7%之间,结果满意。     

钽铌冶炼厂含氟废水资源化治理技术

采用合金膜电渗析法分离富集钽铌冶炼厂含氟废水中的F^-和SO₄^2-。最优的工艺运行条件为：膜对电压0.500 V,膜面流速4.09 cm/s。在此条件下电渗析30 min,F^-去除率达97.53%,SO₄^2-去除率接近100%。优化条件下运行电渗析器,一段淡水中大部分的F^-和SO₄^2-均被去除,可以直接回用。一段电渗析的浓水再经多段电渗析浓缩,以LiOH·H₂O沉淀F^-得到LiF产品,该LiF产品纯度达99.06%,满足GB/T 22666—2008标准的3级品要求。LiF收率为84.92%,F^-整体回收率为79.45%。     

脉冲电湿式脱硫除尘技术及其在精锌冶炼炉的应用

介绍脉冲电湿式脱硫除尘技术及其在精锌冶炼炉上的应用。     

再生铅冶炼行业典型工艺的铅污染物质流分析

将物质流分析应用于我国再生铅冶炼行业典型工艺(铅膏炼前预脱硫—还原熔炼—精炼)的铅污染研究,构建了再生铅冶炼过程的铅元素流图,并针对铅污染提出了应对措施。研究结果表明:再生铅典型工艺的铅直收率、铅回收率、铅废物循环利用率分别为85.38%,93.96%,97.57%;应重点监控的铅有组织排放依次为外排烟气、熔炼渣、脱硫石膏渣;针对外排烟气中铅烟尘的PM2.5占比高及铅烟尘活性较高易于释放的特点,应选用高效除尘器,进一步提高细烟尘的捕集率;铅无名损失的重点工序依次为熔炼工序、电解精炼工序、合金熔铸工序;冶炼烟尘返回熔炼炉时,应增加制粒工序,以降低熔炼炉的烟尘率。     

有色冶金区土壤-蔬菜系统重金属污染特征及健康风险分析

采用对应采样方法研究大冶有色冶炼厂周围地区土壤、蔬菜中Cd、Cu、Pb和As的含量,并对蔬菜重金属污染状况、富集能力及健康风险进行了分析。结果表明,研究区土壤重金属污染严重,Cd、Cu、Pb和As平均含量分别达5.28、193.37、93.83和36.56 mg/kg,分别为湖北省对应元素土壤背景值的31.06、6.30、3.51和2.97倍,表现为以Cd为主的多种重金属共同污染。与《食品中污染物限量》(GB2762-2012)标准比较,蔬菜中Cd和Cu含量的样本超标率分别为68%和6%,而As、Pb的含量均不超标。蔬菜中重金属富集能力的排序为:CdCuAsPb,叶菜类蔬菜对Cd、Cu、Pb和As的富集系数均高于非叶菜类蔬菜。土壤和蔬菜重金属综合质量指数达10.07,为重度污染。研究区人群通过蔬菜摄入As、Cd的目标危险系数均大于1,存在As、Cd暴露的健康风险;成人和儿童食用蔬菜而摄入重金属的TTHQ分别为2.11~5.06和2.78~6.64,儿童比成人遭受的健康风险更大,并且距离冶炼厂越近,所遭受的健康风险越大。蔬菜中重金属的复合污染已使大冶有色冶炼厂周围居民面临潜在的健康风险。     

Acute and chronic effects of nano- and non-nano-scale TiO2 and ZnO particles on mobility and reproduction of the freshwater invertebrate Daphnia magna

Among the emerging literature addressing the biological effects of nanoparticles, very little information exists, particularly on aquatic organisms, that evaluates nanoparticles in comparison to non-nanocounterparts. Therefore, the potential effects of nano-scale and non-nano-scale TiO₂ and ZnO on the water flea, Daphnia magna, were examined in 48-h acute toxicity tests using three different test media, several pigment formulations – including coated nanoparticles – and a variety of preparation steps. In addition, a 21-d chronic Daphnia reproduction study was performed using coated TiO₂ nanoparticles. Analytical ultracentrifugation analyses provided evidence that the nanoparticles were present in a wide range of differently sized aggregates in the tested dispersions. While no pronounced effects on D. magna were observed for nano-scale and non-nano-scale TiO₂ pigments in 19 of 25 acute (48-h) toxicity tests (EC50 > 100 mg L⁻¹), six acute tests with both nano- and non-nano-scale TiO₂ pigments showed slight effects (EC10, 0.5–91.2 mg L⁻¹). For the nano-scale and non-nano-scale ZnO pigments, the acute 48-h EC50 values were close to the 1 mg L⁻¹ level, which is within the reported range of zinc toxicity to Daphnia. In general, the toxicity in the acute tests was independent of particle size (non-nano-scale or nano-scale), coating of particles, aggregation of particles, the type of medium or the applied pre-treatment of the test dispersions. The chronic Daphnia test with coated TiO₂ nanoparticles demonstrated that reproduction was a more sensitive endpoint than adult mortality. After 21 d, the NOEC for adult mortality was 30 mg L⁻¹ and the NOEC for offspring production was 3 mg L⁻¹. The 21-d EC10 and EC50 values for reproductive effects were 5 and 26.6 mg L⁻¹, respectively. This study demonstrates the utility of evaluating nanoparticle effects relative to non-nano-scale counterparts and presents the first report of chronic exposure to TiO₂ nanoparticles in D. magna.     

Source term characterisation using concentration trends and geochemical associations of Pb and Zn in river sediments in the vicinity of a disused mine site: Implications for contaminant metal dispersion processes

River sediment at a disused lead-zinc mine was analysed to provide an understanding of the chemical nature of the source term for contaminated sediment exported from the site. Changes in concentration and geochemical associations of Pb and Zn were measured using aqua regia digestion and the BCR sequential extraction procedure. Sediment in the immediate vicinity of the mine was highly contaminated with Pb (max. c. 11,000 mg kg⁻¹) and Zn (max. c. 30,000 mg kg⁻¹), but these values declined rapidly within 1 km of the mine due to dilution and hydraulic sorting. Lead fractionation changed from being predominantly in the reducible fraction to being in the acetic acid-extractable fraction, whereas Zn was predominantly in the residual fraction. This material is transported as fine sediment in the river system.     

铅锌冶炼行业工业共生模式实例研究

在探讨企业发展循环经济模式的基础上,提出企业构建工业共生模式是发展循环经济的有效途径;根据铅锌冶炼行业发展现状,指出铅锌冶炼行业构建工业共生模式的必要性,并以某企业为例进行了案例分析,剖析了工业共生模式的共生关系,产业链关系及经济、环境效益.结果表明:构建工业共生模式,可以提高企业的资源利用效率,减少污染物排放,降低企业生产成本,获得经济效益和环境效益的统一;同时也应注意工业共生关系构建中新的环境污染.