流化床O2/CO2气氛下添加SiO2对燃煤PM2.5的控制

采用小型流化床研究了在O2/CO2气氛下添加SiO2对PM2.5(空气动力学直径小于2.5 μm的颗粒物)的控制,试验在1123 K、O2/CO2气氛下进行,并采用荷电低压撞击器(ELPI)采集和分析燃烧后的PM2.5.结果表明,添加SiO2是燃烧过程中影响PM2.5生成的重要因素.添加SiO2后,生成PM1的质量浓度均降低,而PM1-2.5的质量浓度均略有增加;PM2.5质量粒径分布均呈双峰分布,峰值分别出现在0.2 μm和2.0μm左右.随着SiO2添加量的增加,PM2.5中的S、K、Na、Cu和Pb元素的含量呈减少的趋势;随着颗粒粒径减小,S、K、Na、Cu和Pb元素的含量有增高的趋势.     

单光子/光电子在线质谱实时分析聚氯乙烯热分解/燃烧产物

实验室研制了低能光电子磁场增强电离(MEPEI)和单光子电离(SPI)复合电离源,该电离源具有电离化合物范围宽、碎片离子少、质谱图简单等优点,结合飞行时间质谱(TOF-MS)实现了聚氯乙烯(PVC)热分解/燃烧产物的在线分析.针对不同的目标化合物,MEPEI/SPI复合电离源通过调节电离区电场强度,可以快速在SPI和SPI-MEPEI之间切换.PVC热分解/燃烧产物中电离能大于光子能量(10.60 eV)的HCl和CO2(12.74 eV、13.77 eV)利用MEPEI模式电离;而烯烃、二氯乙烯、苯系物、氯苯、苯乙烯、茚满及萘系物等可通过SPI-MEPEI复合模式电离.通过实时监测PVC主要燃烧产物的信号强度随温度的变化趋势可推断出,PVC燃烧产物主要是通过两种机制生成:①250～370℃时,PVC发生脱氯及分子内环化反应,产生大量的HCl、苯和萘;②380～510℃时,PVC发生分子间交联反应,生成烷基芳烃,如甲苯和二甲苯/乙苯等.实验结果表明,SPI/SPI-MEPEI复合离子源TOF-MS分析速度快,应用范围广,在在线分析中具有广泛的应用前景.     

基于BP神经网络的煤层自燃预测

在全面分析影响煤层自燃因素的基础上,建立了煤层自燃预测的人工神经网络模型.应用该模型对某煤田的多个煤层样本进行了训练和预测,网络经过10次训练后,误差达到设定的最小值,6次预测测试中最大误差仅为0.027 8,最小的为0.000 1.研究表明,该模型精度较高,可用于预测煤层自燃的实际应用.     

含硫油品储罐腐蚀产物自燃性的研究

通过模拟储油罐中硫铁化物的生成方式, 分析和研究了H2S气体在无氧条件下,与不同相对湿度的Fe2O3、Fe3O4和Fe(OH)3反应所生成的硫铁化物的自燃性.不同相对湿度的试样经6 h硫化后,其自燃性明显不同.以Fe2O3试样为例,相对湿度为0的硫化产物氧化升温最高为256 ℃,平均升温速率为10.8 ℃/min; 相对湿度为5%、10%和15%的硫化产物,氧化升温最高温度分别为474 ℃、408 ℃和388 ℃,平均升温速率分别为20.5 ℃/min、18.3 ℃/min和13.5 ℃/min.实验结果表明, 不同相对湿度、不同物质的硫化产物,其自燃性有显著差异,样品的相对湿度对硫化产物的自燃性有重要影响.对各种干燥样品的硫化产物进行电镜分析发现,由不同物质硫化所生成的硫化产物结构不同,致使其自燃性有较大差异.硫铁化物氧化反应放热是引发油罐着火的主要因素.     

Modification of Ce02-ZrO2 catalyst by potassium for NOx-assisted soot oxidation

Potassium-modified ceria-zirconia catalyst was synthesized by wetness impregnation method. The ageing treatment was performed in static air at 800℃ for 20 hr to evaluate the thermal stability of the catalyst. The catalysts were characterized by X-ray diffraction,BET surface area, oxygen storage capacity, NOx-temperature programmed desorption and soot-temperature programmed oxidation measurements. By introduction of potassium, the maximum soot oxidation rate temperature (Tm) of the ceria-zirconia based catalyst decreased from 525 to 428℃ in the presence of NO under a loose contact mode. The shift of Tm of the K-modified catalyst after ageing is only 15℃. The enhanced activity of the aged catalyst mainly lies in the promotional effect of potassium on the NOx/oxygen storage cacity as well as the soot-catalyst contact.     

小型燃煤工业锅炉NO_x形成与释放规律模拟研究

NOx是我国十二五期间重点控制的污染物,燃煤工业锅炉是其重要来源。为了研究燃煤工业锅炉NOx的形成与释放规律,在实验室模拟了不同煤种的燃烧过程。采用原煤/焦炭燃烧法分别研究挥发分氮和焦炭氮生成NOx的反应,探讨燃料型NOx的形成与释放规律,并解释试验模拟条件下燃煤NOx产污系数和现场实测值的差异。结果表明,试验中烟煤、无烟煤、煤焦的NO转化率平均值分别为25.77%,22.17%和11.98%,产污系数平均值分别为4.31,5.08和2.00kg/t,高于现场实测结果核算值。燃煤工业锅炉NOx以燃料型为主,燃料型NOx的形成和释放是一个复杂的多相反应过程,由挥发分氮的氧化还原反应和焦炭氮的氧化还原反应组成,煤种、温度、空气流量、粒径、氧含量等因素对4种反应各自影响及影响程度并不相同。     

La-Co-Fe-Cu/HZSM-5在尾气碳颗粒燃烧中的催化性能

采用柠檬酸络合低温浸渍法制备分子筛负载钙钛矿型复合氧化物催化剂。采用XRD、SEM和H2-TPR等手段对催化剂性能进行表征,并在微型固定床反应器中对催化剂进行活性评价。结果表明,在钙钛矿型复合氧化物中进行B位离子掺杂,可以改善催化活性,碳颗粒燃烧温度降低。在20%LaCoO3/HZSM-5催化剂中用铁离子部分取代钴离子可以改善碳颗粒的燃烧性能,取代量增加碳颗粒燃烧温度降低,但是生成CO2的选择性也降低,以20%LaCo0.2Fe0.8O3/HZSM-5为催化剂,Tig、Tm和Tf分别为256℃、399℃和403℃,但生成CO2的选择性只有72.5%。在20%LaCo1-xFexO3/HZSM-5中的钙钛矿型复合氧化物B位离子中加入铜离子后,在碳颗粒燃烧反应中生成CO2的选择性得到明显改善,Sco2提高10个单位以上。以20%LaCo0.2Fe0.6Cu0.2O3/HZSM-5为催化剂,在碳颗粒燃烧反应中生成CO2的选择性可以达到94.7%,Tig、Tm和Tf分别为242℃、427℃和445℃。     

脉动频率对低浓度瓦斯脉动燃烧的影响研究

本文将低浓度瓦斯与脉动燃烧结合,主要研究了脉动频率对低浓度瓦斯燃烧的影响。实验结果发现：频率为99Hz至120Hz之间的脉动燃烧不仅可以降低贫燃极限．实现瓦斯在5％浓度下稳定而充分的燃烧,而且在相同温度下提高了瓦斯燃烧效率,污染物的排放也得到了改善。     

Mo-modified Pd/Al2O3 catalysts for benzene catalytic combustion

Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction（XRD）, X-ray photoelectron spectroscopy（XPS）, temperatureprogrammed desorption of NH3（NH3-TPD）, H2temperature-programmed reduction（H2-TPR）, and high-angle annular dark-field scanning transmission electron microscopy（HAADF-STEM）. The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion.     

Pd/activated carbon sorbents for mid-temperature capture of mercury from coal-derived fuel gas

Higher concentrations of Hg can be emitted from coal pyrolysis or gasification than from coal combustion, especially elemental Hg. Highly efficient Hg removal technology from coal-derived fuel gas is thus of great importance. Based on the very excellent Hg removal ability of Pd and the high adsorption abilities of activated carbon（AC） for H2 S and Hg, a series of Pd/AC sorbents was prepared by using pore volume impregnation, and their performance in capturing Hg and H2 S from coal-derived fuel gas was investigated using a laboratory-scale fixed-bed reactor. The effects of loading amount, reaction temperature and reaction atmosphere on Hg removal from coal-derived fuel gas were studied. The sorbents were characterized by N2 adsorption, X-ray diffraction（XRD） and X-ray photoelectron spectroscopy（XPS）. The results indicated that the efficiency of Hg removal increased with the increasing of Pd loading amount, but the effective utilization rate of the active component Pd decreased significantly at the same time. High temperature had a negative influence on the Hg removal. The efficiency of Hg removal in the N2-H2S-H2-CO-Hg atmosphere（simulated coal gas） was higher than that in N2-H2S-Hg and N2-Hg atmospheres, which showed that H2 and CO, with their reducing capacity, could benefit promote the removal of Hg. The XPS results suggested that there were two different ways of capturing Hg over sorbents in N2-H2S-Hg and N2-Hg atmospheres.