厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。     

Cost pass-through to higher ethanol blends at the pump: Evidence from Minnesota gas station data

We examine the pass-through of wholesale prices to retail prices in the market for E85, which contains 51%–83% ethanol, and in the much larger market for E10, which contains 10% ethanol. We use a panel dataset consisting of monthly observations from 2007 to March 2015 on wholesale and retail prices for 274 Minnesota gas stations that sell both E10 and E85. Consistent with prior research, the cumulative pass-through coefficient for E10 is 1.00 after one month. In contrast, the E85 market is sparse, and although pass-through increased over time, we estimate it to be only 0.53 statewide from 2012 to 2015. Pass-through is higher at stations with more local E85 competitors. In the Twin Cities, which has a high density of E85 stations, pass-through is nearly complete, but outside the Twin Cities slightly less than half the wholesale discount of E85, relative to E10, is passed on to the consumer.     

双室微生物燃料电池处理硝酸盐废水

基于双室微生物燃料电池(microbial fuel cell,MFC),针对阴极分别接种活性污泥(A-MFC)和反硝化细菌(D-MFC),研究其产电情况和硝酸盐废水去除效果。结果表明,在产电的同时都可有效去除废水中的硝酸盐污染物。在外接电阻100Ω的情况下,2种MFC均具有良好的产电性能,A-MFC和D-MFC达到的最大输出电压分别为119.6 mV和117.2mV,最大功率密度分别为23.40 mW/m2和26.63 mW/m2;同时两者在阴极室的平均反硝化速率分别为1.86 mg/(L.d)和2.19 mg/(L.d),阳极室的平均COD去除率分别为81.9%和82.4%。另外,通过扫描电镜观察可知,A-MFC和D-MFC阴极碳布表面形貌存在差异,并且阳极与阴极碳布表面形貌差异显著。     

利用废弃物衍生燃料的热化学处理法制富含氢气合成气

为了探讨利用热化学方式从城市垃圾中制取富含氢气合成气过程的要素影响,解析氢气发生特性及其与主要影响要素之间的关系。在分析了城市生活垃圾组分特性的基础上,将其加工成组分均一的废弃物衍生燃料(refuse derived fuel,RDF),并在700、800和900℃等3个温度条件下,分别开展了RDF的热解、气化及水蒸汽气化等实验。研究表明,RDF的加工不但可有效降低垃圾含水率,还可将垃圾热值提高近1倍。温度和添加水蒸汽是从RDF中制取富含氢气合成气过程中的关键影响要素。其中,温度对氢气生成起到至关重要的决定作用,温度的提高对促进H2浓度的提高有利,同时,在气化过程中添加水蒸汽,可有效促进CO和H2等有价气体组分生成。在900℃的高温水蒸汽气化处理过程中,可获得H2浓度最高为34.13%的合成气。另外,800℃热解过程所产生的合成气热值最高,达到14 509 kJ/Nm3。     

Fine-resolution mapping of wildfire fuel types for Canada: Fuzzy logic modeling for an Alberta pilot area

The Canadian Forest Fire Danger Rating System (CFFDRS) is used daily across Canada for evaluating forest fire danger. Fuel-type information is one of the inputs required by the models used in the CFFDRS. In this project, three fuel-type maps with a 25 m resolution were produced for a pilot study area located in Alberta using land cover only; land cover and biomass; and, land cover, biomass and leaf area index data derived from satellite imagery. The relationships between inputs and fuel types were determined mainly by the opinions of forest fire scientists and incorporated into a computer program using fuzzy set methodology. Not all the CFFDRS fuel types could be distinguished using these inputs; three of the coniferous types had to be grouped into one common fuel type. Overall accuracy was between 74 and 83% based on ground-truth comparisons. The most accurate map resulted from land cover and biomass data. Detailed accuracy assessment indicated that the overall accuracy increased up to 86% if ambiguous fuel type identification was considered. No combination of inputs was able to define a fuel type with absolute certainty, which is a reflection of differing expert opinions and the small number of inputs used to produce the maps.     

Selective collection as a pretreatment for indirect solid recovered fuel generation

Effective selective collection (SC) has been increasing in many countries of the European Union. As a consequence the composition of residual municipal solid waste (RMSW) is changing not only because of economic development, but also due to the collection system. The input of RMSW treatment plants is thus not homogeneous. This paper analyses two case studies involving a total of five SC scenarios and their impact on the generation of solid recovered fuel (SRF) with/without bio-drying, post-treatment and packaging take back programs (TBPs). These case studies are based on two types of SC: kerbside and drop-off. The latest regulation on SRF classification is taken into account: energy content, Cl and Hg concentrations are assessed and discussed. The role of the respirometric index (RI) is also analyzed. Results show that when SC is highly efficient RMSW can be classified directly as SRF, but only if the introduction of RI does not set stringent respirometric targets. The role of packaging TBPs is important as the residual waste remaining after the packaging has been processed, can be valorized increasing the lower heating value (LHV) of the residual RMSW and minimizing the streams that should be landfilled. The source separation of food waste has a significant impact on the suitability of bio-drying: when the SC of food waste is very efficient, its percentage in the RMSW may be too low for effective bio-drying.     

An investigation on the fuel savings potential of hybrid hydraulic refuse collection vehicles

Refuse trucks play an important role in the waste collection process. Due to their typical driving cycle, these vehicles are characterized by large fuel consumption, which strongly affects the overall waste disposal costs. Hybrid hydraulic refuse vehicles offer an interesting alternative to conventional diesel trucks, because they are able to recuperate, store and reuse braking energy. However, the expected fuel savings can vary strongly depending on the driving cycle and the operational mode. Therefore, in order to assess the possible fuel savings, a typical driving cycle was measured in a conventional vehicle run by the waste authority of the City of Stuttgart, and a dynamical model of the considered vehicle was built up. Based on the measured driving cycle and the vehicle model including the hybrid powertrain components, simulations for both the conventional and the hybrid vehicle were performed. Fuel consumption results that indicate savings of about 20% are presented and analyzed in order to evaluate the benefit of hybrid hydraulic vehicles used for refuse collection.     

Climate change, urban air problems and transport policy in the European Union

This paper surveys some recent studies on conventional air pollution and climate change in the transport sector in Europe. Fuel efficiency standards, car emission standards and transport pricing instruments are analysed from an economic perspective taking into account environmental and economic efficiency objectives. This revised version was published online in July 2006 with corrections to the Cover Date.     

汽车制动系统的匹配设计

通过对汽车制动系统的原理及结构性能的探讨,进一步掌握整车新产品开发设计中制动系统的匹配计算.     

Investigation of seat belt use among the drivers of different education levels

Seat belt use habit has been investigated according to the education level of drivers. Copies of a questionnaire were distributed to 1000 participants of four different education levels. Factors such as seat belt usage habit, restricting factors and crash data have been investigated. Data have been analyzed with SPSS 15.0 software. Increased level of education leads to increased seat belt usage, lower numbers of crashes and crash severities. The factors restricting seat belt use are lack of habit, discomfort and short distance driving. The use of precaution signal and increases in comfort can increase seat belt usage. The primary and high school education on traffic safety and seat belt usage has been serving the purpose.