光/电法氨氮降解过程中协同作用的研究

为了研究光/电法在氨氮降解过程中的协同作用,采用光/电法降解模拟工业循环冷却水中的氨氮,并对氨氮降解过程中的各影响因素进行了研究,考察了氯离子浓度和溶液p H对降解效率的影响。结果表明,与传统的光催化法和电化学法相比,光/电法在氨氮降解过程中存在良好的协同效应,因而具有更高的氨氮去除率,这主要归功于溶液氯离子的促进作用。另外,在酸性条件下,氨氮降解效率得到进一步加强。当p H在4~5之间,电流密度为10 m A/cm2,Na Cl浓度为100 mg/L时,在经过90 min光/电法处理后氨氮去除率高达95%,且N2占总氨氮降解产物的84.2%。     

微生物絮凝剂M-C11处理高岭土悬浊液的响应曲面优化

采用响应曲面法对微生物絮凝剂M-C11处理高岭土悬浊液的过程参数进行优化,选取中心复合实验设计(CCD),以p H、M-C11投加量和Ca Cl2投加量等因素为自变量,以处理后的高岭土悬浊液絮凝率(Fr)为响应值,并借助扫描电镜对絮凝剂的作用机理进行初步探讨。结果表明,微生物絮凝剂M-C11可显著改善高岭土悬浊液的絮凝性能,且选取的3种单因素水平均可影响絮凝剂活性。经多元回归拟合分析,在M-C11投加量为2.56 m L,Ca Cl2投加量为0.37 g/L的最优条件下,微生物絮凝活性实验值可达92.37%,接近模型预测值(92.30%)。Ca Cl2投加量对絮凝效果的影响高于M-C11投加量(PCa Cl2相似文献   

腐殖酸修饰凹凸棒对U(Ⅵ)的吸附性能及机理

采用腐殖酸(HA)修饰凹凸棒(ATP)制备得到腐殖酸/凹凸棒(HA/ATP),用于去除废水中的U(Ⅵ).通过静态吸附实验,研究了溶液初始pH、投加量、吸附时间和初始浓度对吸附的影响,并用扫描电镜(SEM),X射线能谱图(EDS),傅里叶红外光谱仪(FITR)分析吸附机理.实验结果表明,去除率随时间的增大而增大,在120 min内可以达到平衡;吸附剂投加量越大,溶液pH =6左右时越有利于U(Ⅵ)的去除;HA/ATP能多次重复使用,且经过5次吸附解吸后对U(Ⅵ)的去除率仍能达到96％.吸附过程均符合Langmuir和Frendlich等温方程.较之准一级动力学,准二级动力学模型能更好地拟合实验数据.SEM-EDS、FITR分析结果表明,U(Ⅵ)被成功地吸附到了HA/ATP的表面,吸附机理为络合作用.     

甲苯对UASB反应器中溶解性微生物产物的影响

以乙酸钠为外加碳源,考察了UASB反应器内甲苯对可溶性微生物产物（SMP）的影响。实验结果表明：低质量浓度（20~70 mg/L）的甲苯对微生物有刺激作用,使得污泥增殖速率变小,SMP的质量浓度也逐渐减少,经过一段时间的驯化后,系统COD和TOC的去除率分别达到93%和94%以上,下降趋势较小;较高质量浓度（70~200 mg/L）的甲苯对微生物有抑制作用,污泥活性下降,反应器运行状况开始恶化,SMP的质量浓度也逐渐增大,经过一段时间的驯化后,系统COD和TOC的去除率分别维持在81%和83%以上;当甲苯质量浓度超过200 mg/L时,表现为污泥活性严重下降,对COD的去除效果极差。     

含氨氮催化剂生产废水的处理

采用加入淀粉的短程硝化-反硝化一体化技术处理低碳含NH3-N催化剂废水。通过中试确定了适宜的工艺参数,并在工业化装置上进行了验证。试验结果表明：在DO为0.5 mg/L左右、淀粉加入量为0.25 kg/ m3、HRT=30 h的条件下,短程硝化-反硝化一体化技术具有较好的处理效果,NH3-N去除率大于97%,且具有较强的抗冲击负荷的能力; 出水的COD<100 mg/L,ρ（NH3-N）<10 mg/L,达到GB 8978—1996《污水综合排放标准》的一级排放标准。工业化装置的运行费用以NH3-N计为2.3 元/kg、以废水计为4.6 元/t。该法适用于中低浓度（ρ（NH3-N）<300 mg/L）废水的处理。     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

Investigation into the effect of high concentrations of volatile fatty acids in anaerobic digestion on methanogenic communities

A study was conducted to determine whether differences in the levels of volatile fatty acids (VFAs) in anaerobic digester plants could result in variations in the indigenous methanogenic communities. Two digesters (one operated under mesophilic conditions, the other under thermophilic conditions) were monitored, and sampled at points where VFA levels were high, as well as when VFA levels were low. Physical and chemical parameters were measured, and the methanogenic diversity was screened using the phylogenetic microarray ANAEROCHIP. In addition, real-time PCR was used to quantify the presence of the different methanogenic genera in the sludge samples. Array results indicated that the archaeal communities in the different reactors were stable, and that changes in the VFA levels of the anaerobic digesters did not greatly alter the dominating methanogenic organisms. In contrast, the two digesters were found to harbour different dominating methanogenic communities, which appeared to remain stable over time. Real-time PCR results were inline with those of microarray analysis indicating only minimal changes in methanogen numbers during periods of high VFAs, however, revealed a greater diversity in methanogens than found with the array.     

Estimation of building-related construction and demolition waste in Shanghai

One methodology is proposed to estimate the quantification and composition of building-related construction and demolition (C&D) waste in a fast developing region like Shanghai, PR China. The varieties of structure types and building waste intensities due to the requirement of progressive building design and structure codes in different decades are considered in this regional C&D waste estimation study. It is concluded that approximately 13.71 million tons of C&D waste was generated in 2012 in Shanghai, of which more than 80% of this C&D waste was concrete, bricks and blocks. Analysis from this study can be applied to facilitate C&D waste governors and researchers the duty of formulating precise policies and specifications. As a matter of fact, at least a half of the enormous amount of C&D waste could be recycled if implementing proper recycling technologies and measures. The appropriate managements would be economically and environmentally beneficial to Shanghai where the per capita per year output of C&D waste has been as high as 842 kg in 2010.     

城市道路沉积物氮、磷溶出特性

国内外众多研究表明,城市不透水表面沉积物是雨水径流中污染物的重要来源。以北京市某道路沉积物为研究对象,对城市道路沉积物的粒径分布进行了分析,并通过批量实验,研究了不同粒径道路沉积物中氮、磷营养物及有机物(COD)的溶出特性。实验结果表明,粒径较大的沉积物中氮含量较高,而粒径较小的沉积物中磷含量较高;虽然TP、PO3-4、TN、NO-3、NH+4、COD的溶出浓度、溶出速率变化特征各不相同,但总体趋势是粒径越小氮、磷及COD溶出浓度和溶出速率越大,且最大溶出速率都出现在前5 min。因此,为实现对城市雨水径流污染的有效控制,应采用源头控制措施对小粒径道路沉积物和初期雨水进行有效控制。     

间歇曝气潜流人工湿地的污水脱氮效果

采用间歇曝气运行方式,提升潜流人工湿地生活污水处理系统中的溶解氧浓度,强化脱氮效果。结果表明,间歇曝气运行方式有效提高了湿地内部溶解氧水平,曝气时溶解氧浓度可达6~9 mg/L,停止曝气后,溶解氧浓度迅速下降至0.5 mg/L以下,在湿地内部营造了一种交替的好氧和缺氧环境,分别促进好氧硝化和缺氧反硝化作用。在水力停留时间为3 d的情况下,间歇曝气潜流人工湿地系统对氨氮、总氮和COD的去除率分别可达到98.0%、87.6%和96.3%,较常规潜流人工湿地系统分别提高了74.1%、56.4%和18.1%,实现了氨氮、总氮和COD的同步高效去除。