钢渣吸附-微波降解法处理碱性品红废水

研究了钢渣对碱性品红染料的吸附性能、影响因素以及微波对吸附在钢渣-焦炭上的染料的降解作用。实验表明,在中性条件下,钢渣对碱性品红具有优良的吸附性能,饱和吸附量可达到42．4mg／g。以钢渣处理质量浓度为100mg/L的碱性品红溶液,当固液质量比为1：50、振荡吸附1h后,染料溶液脱色率达97％。实验还表明,焦炭可吸收微波产生高温,用钢渣-焦炭混合物（质量比1：1）吸附染料后,以微波辐照可使物料达到665℃的高温,吸附的染料降解。吸附剂再生后重复使用4次,脱色率都达到95％以上。     

脱除SO2活性炭的再生方法

分别用溶剂和气体对脱除SO2后失活的活性炭进行了再生。在固定床反应器上考察了再生后活性炭的脱硫性能。实验结果表明：用溶剂再生时,质量分数为60％的HNO3溶液的再生效果最好,活性炭的再生率达到80％以上。用气体再生时,400℃左右时的再生效果最好,活性炭的再生率达到70％以上。再生后活性炭的比表面积和pH是衡量活性炭再生效果的重要参数。在实际脱硫生产中,用H2O对失活活性炭进行反复洗涤再生,是一种经济、实用的方法,活性炭的再生率达60％以上。     

钢渣预处理含铬废水及其废渣与铬渣的固化

用钢渣对含铬废水进行预处理,探讨了钢渣粒度、用量、废水pH值和添加硫酸亚铁还原剂的影响.结果表明,经硫酸亚铁还原处理后再用钢渣处理比单纯用钢渣处理的效果明显提高,采用钢渣/总铬质量比为40的100目钢渣处理经硫酸亚铁还原后的含铬废水,总铬和Cr6 去除率分别达79%和84%,采用钢渣柱进行的两级淋滤实验进一步表明该方法可作为工业上含铬废水处理的预处理段.处理后的废钢渣同工业铬渣一起进行水泥固化,标准养护20 d后固化体表面Cr6 浸出率、破碎至5 mm粒径以下和酸雨淋溶下的浸出液Cr6 浓度均符合安全标准,可作为普通建材或进行填埋处置.     

Integrated Risk Framework for Onsite Wastewater Treatment Systems

Onsite wastewater treatment systems (OWTS) are becoming increasingly important for the treatment and dispersal of effluent in new urbanised developments that are not serviced by centralised wastewater collection and treatment systems. However, the current standards and guidelines adopted by many local authorities for assessing suitable site and soil conditions for OWTS are increasingly coming under scrutiny due to the public health and environmental impacts caused by poorly performing systems, in particular septic tank-soil adsorption systems. In order to achieve sustainable onsite wastewater treatment with minimal impacts on the environment and public health, more appropriate means of assessment are required. This paper highlights an integrated risk based approach for assessing the inherent hazards associated with OWTS in order to manage and mitigate the environmental and public health risks inherent with onsite wastewater treatment. In developing a sound and cohesive integrated risk framework for OWTS, several key issues must be recognised. These include the inclusion of relevant stakeholders throughout framework development, the integration of scientific knowledge, data and analysis with risk assessment and management ideals, and identification of the appropriate performance goals for successful management and mitigation of associated risks. These issues were addressed in the development of the risk framework to provide a generic approach to assessing risk from OWTS. The utilisation of the developed risk framework for achieving more appropriate assessment and management techniques for OWTS is presented in a case study for the Gold Coast region, Queensland State, Australia.     

玻璃纸生产废气中CS2和H2S的治理

阐述了玻璃纸生产中CS2和H2S废气产生的原理,介绍了该废气处理的现状,总结了目前普遍采用的冷凝法、活性炭吸附法、活性碳纤维吸附法、改性活性炭吸附法、螯合铁氧化法、吸收-吸附法等处理方法的特点和效果。介绍了一种先采用螯合铁氧化法、再采用冷凝法、最后采用活性炭吸附法的综合处理工艺,可使废气达标排放。     

Effect of fipronil on biogas production performance during anaerobic digestion of chicken manure and corn straw

Fipronil is a broad-spectrum insecticide that has a good control effect on pests of commercial poultry. Although many studies have reported the environmental fate of fipronil, the influence of residual fipronil in poultry waste on biogas production has not been further explored yet. In this article, an experimental comparative study on anaerobic digestion (AD) of chicken manure (CM) and corn straw (CS) with different fipronil concentrations (FCs) was carried at 8% of total solid (TS) and mid-temperature (35?±?1)°C. The results showed that fipronil had a significant effect on biogas production during AD of CM and CS. When the FC is at a low level (≤10?mg·kg^?1), the biogas production rate is increased and the digestion period was shortened, while higher FC (≥ 20?mg·kg^?1) showed an inhibitory effect. During the monitoring of enzyme activity, low FC showed no significant effect on cellulase and saccharase, but the urease activity increased in the early stage. High FC showed inhibition of activity of cellulase and urease, but the saccharase activity was significantly inhibited until FC reached 40?mg·kg^?1. This study also confirms that the environment in anaerobic digester is favorable for the degradation of fipronil, and its half-life is about 15.83?days.     

经济型阳离子淀粉絮凝剂的制备及其对印染废水的处理效果

采用玉米淀粉为原料、氯化缩水甘油三甲基铵（GTA）作阳离子化试剂、水-乙醇混合液作分散剂、NaOH作碱催化剂,制备了经济型阳离子淀粉絮凝剂（简称经济型阳离子淀粉）。实验结果表明：在淀粉加入量110g、GTA加入量30g、NaOH加入量1．6g、分散剂中m（水）：m（乙醇）=1：1、m（分散剂）：m（淀粉）=0．50：1、反应温度80℃、反应时间2．5h的条件下,可制得取代度（DS）为0．31的经济型阳离子淀粉;用该经济型阳离子淀粉与聚丙烯酰胺（PAM）联用处理印染废水,当经济型阳离子淀粉加入量为140mg／L、PAM加入量为4mg/L、废水pH为8时,印染废水的色度去除率和COD去除率分别达92％和82％。该方法絮凝效果好,药剂费用低,产生的污泥少。     

微量金属元素及其配合物对厨余垃圾甲烷发酵的影响

生物可利用的微量金属元素不仅能够保证污染物以最大的速率转化,而且还可以使某些特殊的转化得以发生,并提高微生物对有毒污染物质的耐受能力。在研究厨余垃圾总固体浓度(total solid, TS)、接种量和C/N比对厨余垃圾厌氧发酵影响的基础上,重点探讨微量金属元素钴及其配合物丝氨酸对厨余垃圾厌氧发酵甲烷产量及关键酶含量的影响。结果表明,当TS为0.5%、接种污泥量为100 mL/L和C/N比为20∶1时,厨余垃圾厌氧发酵的甲烷产率较高,为367 mL/g COD;添加2 μmol/L的微量金属元素钴-配合物丝氨酸时,甲烷产率则提高到432 mL/g COD,相应地,辅酶M的含量由空白实验的41.21 μmol/g VSS提高到54.64 μmol/g VSS,辅酶F₄₂₀的含量由0.31 μmol/g VSS提高到0.48 μmol/g VSS。     

厌氧序批式反应器内挥发性脂肪酸积累特性研究

小试规模的厌氧序批式反应器（ASBR）,通过人工配水,研究了启动3个月时间以及一个运行周期内反应器内挥发性脂肪酸（VFA）的积累情况,并通过分析期间产甲烷活性的变化说明了控制VFA积累的重要性。经过近120 d的运行,乙酸和丙酸的最大比产甲烷活性分别提高了1.8和2.2倍,说明反应器的启动过程即是微生物群落的优化和选择的过程,ASBR的抗冲击的能力较强说明随启动的进行和种群的优化,活性污泥凝聚性能增强,对VFA的降解能力增强。     

含磁粉生物反应器处理苯酚废水

采用含磁粉生物反应器对质量浓度为120～350 mg/L的苯酚模拟废水进行强化生物处理.实验结果表明:添加适量磁粉可使废水中DO提高约10%;与不含磁粉生物反应器比较,含磁粉生物反应器工艺使填料挂膜时间缩短1～2 d,填料上附着微生物量增多;质量浓度为350 mg/L的苯酚模拟废水在20 h内的苯酚去除率可达80%,降解时间缩短了10 h.初步分析了添加磁粉提高生物反应器处理废水效率的机理.实验证实了含磁粉生物反应器工艺的合理运用是强化处理含酚废水的有效途径.