Comparison of Three Extraction Methods for 17 β-Estradiol in Sand,Bentonite, and Organic-Rich Silt Loam

Extraction is an important procedure for samples that contain soil because other compounds in soil may affect analysis of estrogens. This study was conducted to evaluate three different extraction methods for 17β-estradiol in soil. Sand, bentonite, and organic-rich silt loam were spiked with 1 mg kg^{? 1} of 17β-estradiol as a model compound of estrogens. 17β-estradiol and its metabolites, estrone and estriol, were extracted using (i) a modified Bligh and Dyer extraction, (ii) a pressurized fluid extraction, and (iii) a diethyl ether extraction, and measured by liquid chromatography tandem mass spectrometry. There were significant differences in the extraction efficiency for 17β-estradiol among the extraction methods and the soils: the efficiencies ranged from 10% to 97%. Overall, the diethyl ether extraction method had the largest efficiency of 17β-estradiol with 45% and 57% for bentonite and silt loam, respectively. Transformation of 17β-estradiol to estrone and estriol in the different extraction methods was less than 3.6% during the extraction procedures. This study underlined the importance of sample preparation for estrogen analysis in soil samples.     

Use of co-combustion bottom ash to design an acoustic absorbing material for highway noise barriers

The present study aims to determine and evaluate the applicability of a new product consisting of coal bottom ash mixed with Portland cement in the application of highway noise barriers. In order to effectively recycle the bottom ash, the influence of the grain particle size of bottom ash, the thickness of the panel and the combination of different layers with various particle sizes have been studied, as well as some environmental properties including leachability (EN-12457-4, NEN-7345) and radioactivity tests. Based on the obtained results, the acoustic properties of the final composite material were similar or even better than those found in porous concrete used for the same application. According to this study, the material produced presented no environmental risk.     

原子吸收石墨炉技术测定水中痕量阴离子洗涤剂

本文研究了用乙二胺铜(Ⅱ)—氯仿作为络合—萃取体系,石墨炉原子吸收技术间接测定水中痕量阴离子洗涤剂的一种方法。其检出限为2.0ug/1,加标回收率为89.6%～104.5%。具有选择性好、灵敏度高、快速简便等特点。同时还研究了水样的酸度和共存离子对测定的影响。对于用原子吸收进行有机分析具有一定的实际意义。     

剥壳机系统噪声控制技术

剥壳机生产系统将胡豆打碎和去壳时发出严重的扰民噪声,对产生噪声的设备和管道采用隔声和吸声控制措施。结果表明,效果十分明显,达到了国家环境噪声排放标准。     

AAS与ICP－AES间接测定天然水中硫酸盐

本文以与过量形成ＢａＳＯ＿４沉淀反应为基础，较详细地讨论了反应条件、从而拟定了用ＡＡＳ和ＩＣＰ－ＡＥＳ间接测定天然水中的方法、确定了方法的精密度，ＡＡＳ法的ＲＳＤ％为１．５，ＩＣＰ－ＡＥＳ法为３．２．两种方法对比分析的结果接近，误差为１．０％（相对）。用于天然水中的测定，获得满意的结果。     

Effects of Starch Moisture on Properties of Wheat Starch/Poly(Lactic Acid) Blend Containing Methylenediphenyl Diisocyanate

Methylenediphenyl diisocyanate was found to improve the interfacial interaction between poly(lactic acid)(PLA) and granular starch. The objective of this research was to study the effect of starch moisture content on the interfacial interaction of an equal-weight blend of wheat starch and PLA containing 0.5% methylenediphenyl diisocyanate by weight. Starch moisture (10% to 20%) had a negative effect on the interfacial binding between starch and PLA. The tensile strength and elongation of the blend both decreased as starch moisture content increased. At 20% moisture level, the starch granules embedded in the PLA matrix were observed to be swollen, resulting in poor strength properties and high water absorption by the blend.     

环境水样阴离子表面活性剂光度测定法

本文通过实验研究,提出了对河水及生活废水阴离子表面活性剂的水相直接测定方法,此方法具有简便、快速的特点,且有良好的准确性和再现性。     

AFS-830型双道原子荧光光度计同时测定饮用水中砷、汞

主要探讨应用AFS-830型双道原子荧光光度计，在饮用水监测中同时测定水中砷、汞的方法和技术。此法是在硝酸介质，以硼氢化钠作还原剂，进行原子化，被测元素原子激发出荧光强度值在一定范围内与被测元素的浓度成正比。砷与汞的检出限分别为0．0618和0．0158ug／L。     

省沽油中硒含量及其测定方法研究

采用消化液硝酸／高氯酸消解法、硝酸-硫酸消解法和微波消解方法消化省沽油，用原子吸收分光光度法测定硒（Se）含量。比较了3种消解方法在测定省沽油中的硒含量。发现微波消解法测定野生省沽油（干菜）中Se含量准确性好、时间段效率高、对环境污染少、操作简单。     

在线衍生化吹扫捕集-气相色谱/质谱分析水中的五氯酚

建立了通过乙酸酐衍生化-吹扫捕集-气相色谱／质谱分析水中五氯酚的新方法，探讨了吹扫时间、样品池温度、离子强度以及衍生化试剂的加入量等条件对捕集效果的影响。结果表明：采用吹扫时间25min、样品池温度60℃、离子强度20％氯化钠以及衍生化试剂的量200μl等条件对水中的五氯酚有较好的捕集效果，用于水中五氯酚的测定，结果满意。