三氯生在碳纳米管上的吸附

药品和个人护理用品(PPCPs)已成为一个引起广泛关注的新的环境问题。采用碳纳米管（CNTs）对水溶液中的三氯生进行吸附处理,考察了碳纳米管粒径及用量、温度、pH、振荡时间等因素对三氯生去除率的影响。研究结果表明,碳纳米管能快速吸附水中的三氯生,粒径较小的碳纳米管可获得较高的三氯生去除率;低温有利于吸附反应的进行;pH在6.5～7.0时,三氯生的去除率可达97%。三氯生在碳纳米管上的吸附可以很好地用Langmuir和Freundlich吸附等温方程进行描述。     

木棉基活性炭纤维吸附性能的研究

采用浸渍(NH₄)₂HPO₄化学活化法650℃时制备得到3种新型木棉基活性炭纤维,即只浸渍不预氧化方法处理的AK1(activated kapok),先浸渍后预氧化的AK-2和先预氧化后浸渍的AK-3。利用制备得到的活性炭纤维处理苯酚和亚甲基蓝的模拟废水,AK-2具有苯酚最大吸附量(137.00 mg/g),AK-1具有亚甲基蓝最大吸附量(274.11 mg/g)。吸附苯酚时,在静态平衡实验中,更符合Freundlich吸附等温线;在动力学实验中,更符合准一级反应。吸附亚甲基蓝时,在静态平衡实验中,AK-1更符合Langmuir模型,AK-2 、AK-3更符合Freundlich吸附等温线;在动力学实验中,更符合准二级反应。     

污泥活性炭强化SBR法处理垃圾渗滤液的实验研究

为了进一步处理垃圾渗滤液,试验采用污泥活性炭强化序批式间歇反应器（SBR）法进行处理,通过对比普通SBR法试验,得出投加污泥活性炭强化SBR法处理垃圾渗滤液的效果要远远高于普通SBR法。当污泥活性炭的投加量为1.2 g/L,容积负荷为0.5～1.5 kg BOD₅/(m³·d)时,进水1 h,曝气10 h,沉淀1.5 h,闲置1.5 h,处理效果最好,COD的去除率达到了85%,NH³-N的去除率达到了90%。     

生物法同时脱硫脱硝试验研究

采用轻质陶粒生物滴滤塔处理摸拟燃煤烟气中二氧化硫和氮氧化物的试验研究,探讨生物法同时脱硫脱硝的影响因素及生物降解宏观动力学。研究结果表明,生物法能有效同时去除烟气中的二氧化硫和氮氧化物,烟气同时脱硫脱硝效率分别可达99.9%和88.9%。为获得最佳烟气同时脱硫脱硝效果,二氧化硫和氮氧化物进气负荷应分别＜140 g/（m³·h）和20 g/（m³·h）,循环液pH=7～8,空床停留时间为30.28 s,喷淋密度为8.81 L/（m³·h）。     

固定化假单胞菌降解油烟废气的研究

将从受油烟废气污染严重的土壤中分离筛选的具有较强降解油烟能力的假单胞菌利用活性炭为填料吸附固定后制成填料床生物反应器。实验考察了进气浓度、气体流量、气体停留时间、容积负荷等对油烟去除率的影响,初步研究了生物反应器的抗冲击能力。结果表明,活性炭填料对菌体具有良好的吸附能力,当油烟进气浓度小于100 mg/L,气体流速小于8 L/h,停留时间大于30 s,容积负荷为2.6～18.9 g油烟废气/(m³·h),生物反应器的降解效率可达到95%以上,且活性炭填料床反应器具有较强的抗冲击能力。     

Batch sorption dynamics and equilibrium for the removal of lead ions from aqueous phase using activated carbon developed from coffee residue activated with zinc chloride

Lignocellulosic materials are good precursors for the production of activated carbon. In this work, coffee residue has been used as raw material in the preparation of powder activated carbon by the method of chemical activation with zinc chloride for the sorption of Pb(II) from dilute aqueous solutions.The influence of impregnation ratio (ZnCl₂/coffee residue) on the physical and chemical properties of the prepared carbons was studied in order to optimize this parameter. The optimum experimental condition for preparing predominantly microporous activated carbons with high pore surface area (890 m²/g) and micropore volume (0.772 cm³/g) is an impregnation ratio of 100%. The developed activated carbon shows substantial capability to sorb lead(II) ions from aqueous solutions and for relative impregnation ratios of 75 and 100%, the maximum uptake is practically the same. Thus, 75% represents the optimal impregnation ratio.Batch experiments were conducted to study the effects of the main parameters such as contact time, initial concentration of Pb(II), solution pH, ionic strength and temperature. The maximum uptake of lead(II) at 25 °C was about 63 mg/g of adsorbent at pH 5.8, initial Pb(II) concentration of 10 mg/L, agitation speed of 200 rpm and ionic strength of 0.005 M. The kinetic data were fitted to the models of pseudo-first order and pseudo-second order, and follow closely the pseudo-second order model. Equilibrium sorption isotherms of Pb(II) were analyzed by the Langmuir, Freundlich and Temkin isotherm models. The Freundlich model gives a better fit than the others.Results from this study suggest that activated carbon produced from coffee residue is an effective adsorbent for the removal of lead from aqueous solutions and that ZnCl₂ is a suitable activating agent for the preparation of high-porosity carbons.     

活性炭在膜生物反应器中的应用研究进展

活性炭是一种非常优良的吸附剂,具有物理吸附和化学吸附的双重特性。本文介绍了近年来向膜生物反应器中投加活性炭的应用研究进展,表明投加活性炭可以提高膜生物反应器的处理效果,同时对改善膜污染有很好的效果。     

Kinetics of carbon dioxide absorption into mixed aqueous solutions of MDEA and MEA using a laminar jet apparatus and a numerically solved 2D absorption rate/kinetics model

New comprehensive numerically solved 1D and 2D absorption rate/kinetics models have been developed, for the first time, to interpret the experimental kinetic data obtained with a laminar jet apparatus for the absorption of carbon dioxide (CO₂) in CO₂ loaded mixed solutions of mixed amine system of methyldiethanolamine (MDEA) and monoethanolamine (MEA). Three MDEA/MEA weight ratios ranging from 27/03 to 23/07, over a concentration range of 2.316–1.996 kmol/m³ for MDEA and of 0.490–1.147 kmol/m³ for MEA were studied. The models take into account the coupling between chemical equilibrium, mass transfer, and the chemical kinetics of all possible chemical reactions involved in the CO₂ reaction with MDEA/MEA solvent. The partial differential equations of the 1D model were solved by two numerical techniques; the finite difference method (FDM) based on in-house coded Barakat–Clark scheme and the finite element method (FEM) based on COMSOL software. The FEM comprehensive model was then used to solve the set of partial differential equations in the 2D cylindrical coordinate system setting. Both FDM and FEM produced very accurate results for both the 1D and 2D models, which were much better than our previously published simplified model. The reaction rate constant obtained for MEA blended into MDEA at 298–333 K was k_MEA = 5.127 × 10⁸ exp(−3373.8/T). In addition, the 2D model, for the first time, has provided the concentration profiles of all the species in both the radial and axial directions of the laminar jet, thereby enabling an understanding of the correct sequence in which the reaction steps involved in the reactive absorption of CO₂ in aqueous mixed amines occur.     

Ru/γ-Al_2O_3和Ru/AC催化剂的制备及其对氨氧化反应的催化性能

分别以γ-Al_2O_3和活性炭(AC)为载体,采用浸渍法制备了Ru质量分数均为2.0%的Ru/γ-Al_2O_3和Ru/AC催化剂,并用X射线衍射仪和透射电子显微镜等方法对催化剂结构进行了表征.实验结果表明:Ru/AC中Ru沉积在AC表面,分散度较低;而Ru/γ-Al_2O_3中Ru进入到γ-Al_2O_3内部,形成了一种高度分散体系.Ru/γ-Al_2O_3对氨的催化活性高于Ru/AC,氨在Ru/γ-Al_2O_3和Ru/AC上的起活温度分别为200 ℃和266 ℃,T_(90)(氨去除率达90%时的反应温度)分别为267℃和320 ℃.随混合气体空速增大,Ru/γ-Al_2O_3催化剂的T_(90)逐渐升高,气体空速分别为3 600,4 800,5 400 h~(-1)时,T_(90)分别为235,266,303 ℃.随反应前混合气体中氨质量分数增加,氨的去除率降低.     

N掺杂TiO_2光催化剂的制备及其H_2O_2改性的研究

以钛酸四丁酯为前驱物,采用水解沉淀法制备了N掺杂TiO_2光催化剂和H_2O_2改性的N掺杂TiO_2光催化剂.实验表明,H_2O_2改性的N掺杂TiO_2光催化剂的最佳制备条件为:氨水(质量分数28%)加入量20 mL,焙烧温度500 ℃,H_2O_2(质量分数30%)加入量2.0 mL.日光下,N掺杂TiO_2光催化剂及H_2O_2改性的N掺杂TiO_2光催化剂在反应90 min时的活性红紫去除率达99%,它们对活性红紫的去除率远高于P_(25)TiO_2光催化剂.H_2O_2改性的N掺杂TiO_2光催化剂中N质量分数比改性前明显提高,制备的两种催化剂中不仅含有N元素,同时还含有C和H元素.