碳纳米管电极原位产生过氧化氢及其对亚甲基蓝脱色效果简

将碳纳米管固定化制成多孔疏水性导电薄膜构建电化学阴极还原体系,实现过氧化氢在阴极的原位产生。电极特性研究表明,电极在较宽的电压范围内均具有较好的活性。考察了阴极电位、电极成分、氧气流量和电解质浓度对过氧化氢原位产生的影响,在优化条件下经过120 min后过氧化氢达到66.17 mg/L,并探讨过氧化氢原位产生的机理。在此基础上考察原位过氧化氢氧化工艺下对亚甲基蓝的脱色效果,并分析其脱色机理。     

A method to estimate the impact of clear-cutting on nutrient concentrations in boreal headwater streams

Large-scale forestry operations, like clear-cutting, may impair surface water quality if not done with environmental considerations in mind. Catchment and country level estimates of nutrient loads from forestry are generally based on specific export values, i.e., changes in annual exports due to the implemented forestry operations expressed in kg ha⁻¹. We introduce here a specific concentration approach as a method to estimate the impact of clear-cutting on nutrient concentrations and export in headwater streams. This new method is potentially a more dynamic and flexible tool to estimate nutrient loads caused by forestry, because variation in annual runoff can be taken into account in load assessments. We combined water quality data from eight boreal headwater catchment pairs located in Finland and Sweden, where the effect of clear-cutting on stream water quality has been studied experimentally. Statistically significant specific concentration values could be produced for total nitrogen, nitrate, ammonium, and phosphate. The significant increases in the concentrations of these nutrients occurred between 2 and 6 years after clear-cutting. Significant specific concentration values could not be produced for total phosphorus and total organic carbon with the whole dataset, although in some single studies significant increases in their concentrations after clear-cutting were observed. The presented method enables taking into account variation in runoff, temporal dynamics of effects, and the proportional size of the treated area in load calculations. The number of existing studies considering large site-specific variation in responses to clear-cutting is small, and therefore further empirical studies are needed to improve predictive capabilities of the specific concentration values.     

An Avoidable Tragedy at the Sea Cliff (Rincon) Oil Field

Three men were killed and four others were injured during a well drill operation on Hobson Well C-10A in the Sea Cliff Oil Field (also known as Rincon Oil Field), in Ventura County, California, United States, on August 10, 1994, as a result of errors made by the work supervisors at the site. The oil field was under management by Vintage Petroleum, Ltd., which was sued for negligence by the families of the deceased and injured. The coroner's autopsy examination concluded that the cause of the deaths was due to the inhalation of the toxic gas carbon monoxide (CO). This gas was assumed to have been released from the firing of high-energy guns (HEGs) using carbon-rich explosive pentaerythritol tetranitrate (PETN) in an oxygen-depleted environment, during a fracking operation by Schlumberger Corporation on Well C-10A. The author of this article was appointed as an expert witness by Schlumberger to evaluate if the coroner's conclusion was correct. A series of chemical analytical analyses were conducted on the vapor phase of samples, in addition to dissolved components in water from Well C-10A and two adjacent wells. Stable isotope analyses were also conducted on hydrogen (H₂), methane (CH₄), nitrogen (N₂), CO, and water (H₂O) 3 weeks after the accident, as well as on four additional occasions from September to December 1994. Control test analyses were performed on the products from HEG firings, using the same explosives as those used in the perforation of Well C-10A in control chambers at a Schlumberger facility in Houston, Texas. The conclusion reached was that the dominant products of PETN detonations are H₂, CH₄, CO, and N₂. However, the isotope ratios (D/H and ¹³C/¹²C) of methane in the control experiments were different in Well C-10A, following the detonation on August 10, 1994, than those resulting from controlled PETN explosions. The conclusion reached in this study was that the fracking of the well at a depth of around 2,150 ft had increased the permeability of the sediment layers in the Padres Zone at that depth to allow the rapid release of a large quantity of natural gas, primarily CH₄, which supersaturated the water in the well. This event caused the formation of a large bubble, which ballooned out of the well to the surface, displacing air in the location where the men were working, and thus causing asphyxiation, which resulted in the death of the three men. The judge accepted this interpretation.     

以聚己内酯作为生物反硝化固体碳源的研究

为解决水体因低碳氮比而导致脱氮效率差的问题,将颗粒聚己内酯(PCL)重新塑形为阶梯环状,研究其作为反硝化过程的生物膜载体与固相碳源的反硝化性能。结果表明,在静态实验中,平均反硝化速率为8.57 mg NO3-N/(L·h);反硝化过程为零级反应。连续填充床实验中,超过90%的硝酸盐可被去除,出水NO2-N质量浓度低于0.20 mg/L;出水NH3-N质量浓度略有上升;出水溶解性有机碳(DOC)先上升后降低至1 mg/L左右。电子扫描显微镜扫描显示,PCL阶梯环反应表面空隙率较高,表面生物膜以杆菌为主,反应后被明显腐蚀;液相色谱检测显示PCL阶梯环分子量反应前后略有下降,其结构未受到破坏;表明该材料适合作为反硝化反应的碳源的同时,又可以作为载体供微生物附着生长。     

改性SCAC催化臭氧氧化去除布洛芬效能与反应活性位点研究

采用不同的表面改性方法(去矿化处理、氧化改性、碱改性和还原改性)对污泥基活性炭(SCAC)进行处理,分别获得了表面金属含量低、碱位低、碱性官能团含量高及Lewis碱含量高的4种改性SCAC(SCAC-D、SCAC-S、SCAC-OH和SCAC-N),对比考察了改性前后SCAC催化臭氧氧化去除布洛芬(IBP)的效能,并探讨了SCAC催化臭氧氧化反应的主要活性位点。结果表明,5种SCAC催化活性顺序为:SCAC-N>SCAC-OH>SCAC>SCAC-S>SCAC-D;金属组分减少会直接影响SCAC的催化活性,碱位减少对其催化活性的影响相对较弱,说明SCAC表面较为丰富的金属组分是其催化臭氧氧化反应的主要活性位点;增加SCAC表面碱位(Lewis碱和碱性官能团),减少表面酸性官能团有助于提高其催化活性。     

快腐剂对畜禽粪便堆肥过程中腐熟度的影响

以牛粪、菌糠和鸡粪等为材料按照两种比例调配为混合基质,在添加或不添加快腐剂的条件下在发酵桶中进行为期38 d的堆肥发酵实验,通过对发酵产物的温度、p H值、总有机碳、C/N、硝铵态氮含量和种子发芽指数等指标变化的研究,揭示了快腐剂对发酵过程的影响。结果表明,虽然快腐剂对有机物料的温度、C/N比无显著的影响,但可以促进铵态氮向硝态氮的转化,在16 d时使发酵产物NH+4-N/NO-3-N比值降为0.15,达到腐熟标准(0.16);提升种子发芽指数,在腐解29 d时使种子发芽指数达到82.76%,达到完全腐熟指标(0.8),比不添加快腐剂的处理提前了4 d左右。快腐剂的作用效果受腐解物料配比的影响。     

纳米TiO2-石墨烯光催化剂的水热合成及其光催化性能

以钛酸四正丁酯和石墨为原料,通过水热法制备了锐钛矿型为主的纳米TiO2复合光催化剂（纳米TiO2-石墨烯）,并采用XRD,FTIR,FESEM,TEM技术对其进行了表征。通过紫外光照射降解溶液中的罗丹明B（RhB）研究了TiO2-石墨烯的光催化活性,分析了初始罗丹明B质量浓度、催化剂加入量、溶液pH和催化剂使用次数等影响降解效果的因素。实验结果表明：在初始RhB质量浓度为20 mg/L、溶液pH为7.10、催化剂加入量为1.000 g/L的条件下,紫外光照射30 min时,纳米TiO2-石墨烯对RhB的降解率高达98.69%,明显高于纳米TiO2的44.69%;纳米TiO2-石墨烯稳定性较强,可多次重复使用。     

某“W”型锅炉炉效低的综合治理

针对某锅炉经济性差的问题,从设备、运行及自动控制等方面分析,并进行了相应整改。影响炉效的主要因素有煤质恶化、灰渣含碳量高、排烟温度高和CO浓度高等,同时炉膛燃烧不稳定也是影响燃烧效率的重要因素。通过漏风整改、制粉系统优化、燃烧优化调整和控制系统优化等方法有效提高了锅炉经济性。研究表明：分析锅炉经济性降低的影响因素时应抓住主要因素,兼顾其他,科学的生产管理是保证锅炉运行经济性的重要基础;入炉煤质恶化是最主要的外在因素;良好的自动控制系统能有效稳定燃烧参数,提高燃烧效率;降低飞灰含碳量的主要工作应集中在制粉系统优化调整;完整而系统的燃烧调整试验能够保证锅炉运行控制参数的科学合理,并需要正确调整氮氧化物排放和锅炉效率之间的关系。     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

活性炭纤维负载TiO2催化剂的制备及其电催化性能

采用溶胶-凝胶法制备了活性炭纤维负载TiO₂催化剂（TiO₂/ACF）,并通过SEM和XRD等手段对TiO₂/ACF进行了表征。以邻苯二甲酸二甲酯（DMP）为目标降解物,考察了催化材料的电催化活性。实验结果表明：在反应温度为25 ℃、初始DMP质量浓度为100.0 mg/L、电解质Na₂SO₄质量浓度为100 mg/L、电流密度为62.5 mA/cm²、电极板间距为4 cm的条件下,经过40 min的降解,DMP质量浓度为1.8 mg/L,DMP去除率为98.2%;TiO₂/ACF在反应过程中可以原位再生,经6次重复使用后仍保持很高的催化活性,对DMP的去除率仍达90%以上。