The dyadic level of conceptualization and analysis: A missing link in multilevel OB research?

Despite burgeoning multilevel research in organizational behavior over the past two decades, our understanding of dyadic relationships at work remains underdeveloped. Focusing on leader–member exchange, we discuss conceptual and methodological challenges that have hampered research at this level and illustrate how and why such analysis might provide new insights. Copyright © 2015 John Wiley & Sons, Ltd.     

磷酸银/树脂复合物的制备及其对亚甲基蓝的光催化降解

以聚乙烯吡咯烷酮(PVP)为稳定剂,采用化学沉积法制备了磷酸银/树脂复合物,降解亚甲基蓝,研究其光催化活性,并对样品进行了XRD和SEM表征。探讨了不同的光源、催化剂投加量、PVP含量、p H值等因素对亚甲基蓝降解率的影响。结果表明,在太阳光(夏天早上9点到11点的阳光)下,偏酸介质中,催化剂用量为0.8 g/L,PVP质量分数为0.01%的磷酸银/树脂复合物,液面高度为15 cm的条件下对亚甲基蓝有最佳降解效果。     

Ion exchange membrane-assisted electro-activation of aqueous solutions: Effect of the operating parameters on solutions properties and system electric resistance

The properties of electro-activated (EA) aqueous solutions as well as the dynamics of their changes were considered in the current study using aqueous solutions of NaCl and NaHCO₃. The concentrations of the salt solutions were 0.5, 0.25, 0.125 and 0.05 M. The tests were performed at the DC current densities of 25, 37.5, and 50 Å/m². The electro-activation reactor consisted of three individual cells assembled together and separated by anion-exchange (AEM) and cation-exchange (CEM) membranes. During the experiments, four configurations of the membrane placements and solutions concentrations were studied. The obtained results showed the dynamics of the electro-activation process that allows obtaining electro-activated solutions with targeted properties such as pH and oxydo-reduction potential (ORP). It was possible to obtain electro-activated solutions at the anodic side (acid anolyte) with pH of 3.0, 3.5, and 4.0 and ORP of +1100 ± 15 mV when NaCl solution was used as electrolyte. Furthermore, several types of electro-activated solutions with high redox potential (ORP = +921 ± 12 mV) and neutral pH (6.48 ± 0.05) were obtained on the anode side when sodium carbonate was used. At the same time, two types of solutions, one with acid pH (2.14 ± 0.14) and the other one with alkaline pH (10.46 ± 0.03) with ORP = +689 ± 10 and 110 ± 21 mV, respectively, were obtained in the central compartment which considered as electro-activated solutions obtained by means of noncontact electro-activation.     

黄姜皂素废酸液在均相离子膜中渗析规律的研究

为了研究皂素水解废液在离子交换膜中的渗析规律,实验考察了废液中电导率、含盐量、氢离子浓度、硫酸盐浓度、Ca离子浓度、Mg离子浓度和有机物浓度随渗析时间的关系。研究结果表明:渗析时间进行100 h后,处理效果达到稳定状态;废液与渗析液的电导率几乎相等;含盐量、H+浓度、SO2-4浓度的分离效率分别为71%、62%、78%;Ca去除效果优于Mg去除效果;大部分有机物无法通过离子交换膜。     

管道中烟道气流动传热及酸凝结规律

针对注烟道气稠油热采中管道输送烟道气酸凝结问题,以连续性方程、能量方程和动量方程为基础建立了烟道气沿管道流动与传热计算模型,计算了烟道气沿管道的压力分布、温度分布和酸凝结点距离,分析了不同入口参数和烟道气成分对管道中烟道气的压力、温度、酸凝结点的影响。结果表明:SO3或水蒸汽含量增加时,烟道气酸凝结点温度提高,凝结点距离减小;入口烟道气压力提高,烟道气压降变小,温降不变,酸凝结点距离减小;入口烟温升高,压降和温降都增大,酸凝结点距离增大;保温层厚度增加,温降减小,酸凝结点距离增大。计算和分析结果表明:减少烟道气中SO3或水蒸汽含量可以有效地增大酸凝结点距离,减轻管道腐蚀问题。     

San copolymer membranes with ion exchangers for Cu(II) removal from synthetic wastewater by electrodialysis

Heterogeneous membranes were obtained by using styrene-acrylonitrile copolymer (SAN) blends with low content of ion-exchanger particles (5 wt.%). The membranes obtained by phase inversion were used for the removal of copper ions from synthetic wastewater solutions by electrodialytic separation. The electrodialysis was conducted in a three cell unit, without electrolyte recirculation. The process, under potentiostatic or galvanostatic control, was followed by pH and conductivity measurements in the solution. The electrodialytic performance, evaluated in terms of extraction removal degree (rd) of copper ions, was better under potentiostatic control then by the galvanostatic one and the highest (over 70%) was attained at 8 V. The membrane efficiency at small ion-exchanger load was explained by the migration of resin particles toward the pores surface during the phase inversion. The prepared membranes were characterized by various techniques i.e. optical microscopy, Fourier transform infrared spectroscopy, scanning electron microscopy, thermogravimetric analysis and differential thermal analysis and contact angle measurements.     

微波在废树脂中的穿透厚度研究

通过对不同功率微波在不同规格钢桶中对不同含水率的树脂中的穿透厚度的研究可知,微波在树脂中的穿透厚度主要与树脂自身含水率有关,与钢桶的规格尺寸也有一定的关系,而微波功率的影响则可基本忽略不计;对于含水率50％左右的树脂,微波在12L钢桶中的穿透厚度是130 mm;在200L钢桶中的穿透厚度是70mm.该研究成果对微波干燥工艺的具体参数的选取和扩大规模台架装置的设计研究等有重要意义.     

Measurement of air exchange rates in different indoor environments using continuous CO2 sensors

A new air exchange rate (AER) monitoring method using continuous CO₂ sensors was developed and validated through both laboratory experiments and field studies. Controlled laboratory simulation tests were conducted in a 1-m³ environmental chamber at different AERs (0.1-10.0 hr^-1). AERs were determined using the decay method based on box model assumptions. Field tests were conducted in classrooms, dormitories, meeting rooms and apartments during 2-5 weekdays using CO₂ sensors coupled with data loggers. Indoor temperature, relative humidity (RH), and CO₂ concentrations were continuously monitored while outdoor parameters combined with on-site climate conditions were recorded. Statistical results indicated that good laboratory performance was achieved: duplicate precision was within 10%, and the measured AERs were 90%-120% of the real AERs. Average AERs were 1.22, 1.37, 1.10, 1.91 and 0.73 hr^-1 in dormitories, air-conditioned classrooms, classrooms with an air circulation cooling system, reading rooms, and meeting rooms, respectively. In an elderly particulate matter exposure study, all the homes had AER values ranging from 0.29 to 3.46 hr??1 in fall, and 0.12 to 1.39 hr^-1 in winter with a median AER of 1.15.     

印染废水RO浓水水质分析

以江苏某印染废水处理厂反渗透（RO）浓水为研究对象,采用多种分析手段分析了RO浓水的水质特征.首先采用IC和ICP-MS对水中的无机离子进行了定性和定量分析,采用GC-MS对废水中的半挥发性有机物进行定性和定量分析.结果表明,RO浓水中无机离子以Na⁺、Cl^-和SO₄^2-为主,半挥发性有机物邻苯二甲酸二（2-乙基己）酯（DEHP）为主要成分,其浓度为1.452mg/L.为分析RO浓水中的溶解性有机物（DOM）特征,进一步采用超滤膜分子量分级法和树脂亲疏水分离技术对废水中的DOM进行分离解析,分析了不同组分的溶解性有机碳（DOC）、UV₂₅₄、SUVA含量和分布情况,应用三维荧光光谱对各组分物质进行了定性分析.超滤分级表明,RO浓水中相对分子量<1k的有机物占56.98%,相对分子质量5~10k有机物仅占2.19%,但其芳香化程度较高.树脂分离结果表明,RO浓水中亲水性物质（HPI^*）、疏水性物质（HPO^*）和过渡性物质（TPI^*）的DOC含量差异不大,其中HPO^*的芳香构造化程度最高,含有较多的色氨酸类芳香族蛋白质,而HPI^*中含有较多的溶解性微生物代谢产物类物质.     

C/C复合材料不同碳基体的纳米压痕行为研究

目的研究碳基体微观结构对材料整体性能的影响。方法用酚醛浸渍-碳化、中温煤沥青浸渍-碳化、甲烷为碳源前驱体,经化学气相沉积制备得到不同碳基体C/C复合材料。采用偏光显微镜对C/C复合材料不同碳基体的显微结构进行观察分析,采用XRD和Raman光谱对C/C复合材料的树脂碳基体、沥青碳基体和热解碳基体的微晶尺寸进行表征,以玻璃碳作为参比样品,通过纳米压痕测试不同碳基体试样的弹性模量和硬度。结果碳基体为热解碳和沥青碳的石墨微晶缺陷少,完整度较好,石墨化程度高。玻璃碳和树脂碳基体中石墨微晶排列紊乱,有序度低,石墨化程度低。酚醛浸渍-碳化得到的树脂碳的微晶尺寸Lc最小,为1.69 nm,弹性模量和硬度最大,分别为(23.17±0.54) GPa和(3.26±0.10) GPa;光滑层热解碳和粗糙层热解碳的弹性模量和硬度次之;沥青碳的微晶尺寸最大,Lc为9.36nm,而弹性模量和硬度最小,分别为(12.53±2.29) GPa和(0.72±0.14) GPa。结论不同碳基体的C/C复合材料中,碳基体的石墨化度越高,微晶尺寸越大,各向异性越显著,材料的弹性模量和硬度越低。