PRB强化垂直流人工湿地系统处理煤矿废水

针对常规人工湿地系统处理高浊含氮磷的有机煤矿废水不佳的问题,采用PRB与人工湿地耦合的方法,进行砂箱模拟实验研究。实验结果表明,由无烟煤、钢渣及沸石构建的PRB强化垂直流人工湿地系统对NH4+-N、PO34--P、Mn2+、COD、SS的去除率分别达到88.84%、96.08%、98.98%、85.78%和94.00%,与常规人工湿地相比,具有处理效率高、水力负荷大、占地面积小等特点,更便于运行管理。     

煤矿火灾烟气流动传播过程仿真研究

煤矿发生火灾后会生成大量有毒气体并产生火风压,烟气在火灾动力的影响下出现状态紊乱,研究煤矿火灾烟气流动传播过程对控制火情有着重要意义。基于国内外研究现状,对燃烧及风流特点进行分析,建立了煤矿火灾烟气流动数学模型,并利用CFD软件进行仿真。研究表明:无通风工况下的烟气为对称流动;随着风速增加,出口处温度降低,烟气向风流入口处的流速减小。     

煤炭企业环境成本核算及控制浅议

随着我国环境保护方面的法律法规逐步完善,以及公众对环保的日益重视,对煤炭环境成本进行核算十分必要.本文论述了煤炭企业环境成本核算的重要性,分析了煤炭企业现有成本核算存在问题,提出了完善煤炭企业环境成本核算的对策.     

肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

Management of mine spoil for crop productivity with lignite fly ash and biological amendments

Long-term field trials using lignite fly ash (LFA) were carried out in rice crops during the period 1996-2000 at Mine I, Neyveli Lignite Corporation, Tamil Nadu. LFA, being alkaline and endowed with an excellent pozzolanic nature, silt loam texture, and plant nutrients, has the potential to improve the texture, fertility, and crop productivity of mine spoil. The rice crops were the first, third, fifth, and sixth crops in rotation. The other crops, such as green gram (second) and sun hemp (fourth), were grown as green manure. For experimental trials, LFA was applied at various dosages (0, 5, 10, 20, 50, 100, and 200 t/ha), with and without press mud (10 t/ha), before cultivation of the first crop. Repeat applications of LFA were made at the same dosages in treatments of up to 50 t/ha (with and without press mud) before cultivation of the third and fifth crops. Press mud, a lightweight organic waste product from the sugar industry, was used as an organic amendment and source of plant nutrients. Also, a recommended dosage of chemical fertilizer, along with gypsum, humic acid, and biofertilizer as supplementing agents, was applied in all the treatments, including control. With one-time and repeat applications of LFA, from 5 to 20 t/ha (with and without press mud), the crop yield (grain and straw) increased significantly (p < 0.05), in the range from 3.0 to 42.0% over the corresponding control. The maximum yield was obtained with repeat applications of 20 t/ha of LFA with press mud in the third crop. The press mud enhanced the yield in the range of 1.5-10.2% with various dosages of LFA. The optimum dosage of LFA was 20 t/ha for both one-time and repeat applications. Repeat applications of LFA at lower dosages of up to 20 t/ha were more effective in increasing the yield than the corresponding one-time applications of up to 20 t/ha and repeat applications at 50 t/ha. One-time and repeat applications of LFA of up to 20 t/ha (with and without press mud), apart from increasing the yield, evinced improvement in the texture and fertility of mine spoil and the nutrient content of crop produce. Furthermore, some increase in the content of trace and heavy metals and the level of gamma-emitters in the mine spoil and crop produce was observed, but well within the permissible limits. The residual effect of LFA on succeeding crops was also encouraging in terms of eco-friendliness. Beyond 20 t/ha of LFA, the crop yield decreased significantly (p < 0.05), as a result of the formation of hardpan in the mine spoil and possibly the higher concentration of soluble salts in the LFA. However, the adverse effects of soluble salts were annulled progressively during the cultivation of succeeding crops. A plausible mechanism for the improved fertility of mine spoil and the carryover or uptake of toxic trace and heavy metals and gamma-emitters in mine spoil and crop produce is also discussed.     

长广七矿通风阻力测定及分析

矿井通风阻力测定是矿井安全管理工作的重要内容之一。本文介绍了气压计基点法的测定原理及测定步骤,并将该方法应用于长广七矿通风系统阻力的测定中,通过对测定数据的整理分析,揭示了该矿通风阻力分布和风量分配的基本情况,并针对存在的问题提出了相应的技术对策,为该矿井实现通风管理的科学化和制订合理的技术改造方案提供基本依据。     

煤矿危险源风险预警与控制的研究

根据现代安全管理的理论与方法,结合煤矿人-机-环境特点和不同煤矿事故的发生机理,对煤矿危险源风险预警和控制的基本理论和方法进行了探讨,提出了基于危险源的煤矿风险预警与控制的一般流程,给出煤矿危险源辨识、风险评价、监控和预警的方法,为煤矿安全管理信息系统提供理论基础。     

蜂窝煤燃烧氟污染的控制

以碳酸钙为固氟添加剂,以炉渣及粉煤灰等低氟材料取代全部或部分粘土作为粘结剂来制作蜂窝煤,进行了燃煤降氟的试验研究.结果表明,添加碳酸钙能有效降低蜂窝煤燃烧时候的氟排放,当煤:粘土:CaCO3的质量比为70:17:13时,碳酸钙的固氟效果最佳,氟的排放率可降低64.1%.以炉渣为粘结剂制作蜂窝煤能够显著降低燃烧时向外界排放的氟化物量,当煤:炉渣:CaCO3为80:8:12时,蜂窝煤燃烧排氟量较小且趋于稳定.已拌有一定剂量粉煤灰粘结剂的煤中添加15%的粘土后碳酸钙的固氟效果明显改善,当煤:粘土:粉煤灰:CaCO3为70:15:9:6时固氟效果最佳,此时蜂窝煤氟逸出率仅为18.2%,氟的减排率达到77.9%,显著优于未添加粘土时碳酸钙的固氟效果,蜂窝煤添加碳酸钙固氟剂进行高效固氟时,需同时适当增加粉煤灰加入量,以稳定固氟剂的高温固氟效果.     

超细粉煤灰基成型吸附剂的动态吸附实验

以粉煤灰为原料制备成型吸附剂,对水溶液中亚甲基蓝和Cr⁶⁺进行动态吸附研究,绘制穿透曲线,利用Origin软件对实验数据分析处理,得出穿透曲线的通式C_t=A₁－A₂〖〗1+(t/t₀)^p+A₁。结果表明,初始浓度C₀=25 mg/L,填料高度不同时,达到穿透点的时间随填料高度的增加而增加;填料高度h=200 mm,初始浓度不同时,达到穿透点的时间随初始浓度的增加而减小;该吸附剂对有机染料和重金属离子均有较好的吸附性能;穿透曲线通式的回归线性相关系数表明,该通式可很好地反映超细粉煤灰成型吸附剂的动态吸附过程。