EDTA-2Na/Fe(Ⅱ)对自养生物体系下硝酸盐还原过程的影响

采用厌氧序批式生物膜反应器(ASBBR),以固定浓度的硝酸盐和硫酸亚铁为基质,按不同梯度条件添加EDTA-2Na,进行长时间的培养驯化,研究铁盐脱氮的启动过程,同时探究不同EDTA-2Na/Fe(Ⅱ)对铁自养反硝化过程以及硝酸盐异化还原为铵(DNRA)的影响.结果表明:经过65d的培养驯化,反应器成功稳定运行.当EDTA-2Na/Fe(Ⅱ)<1.50时,反应器只进行铁自养反硝化过程,NO₃^--N去除率最高仅为71.70%;当EDTA-2Na/Fe(Ⅱ)≥1.50时,反应器同时进行铁自养反硝化与DNRA过程,NO₃^--N去除率最高为99.70%.值得注意的是,在EDTA-2Na/Fe(Ⅱ)=1.50时,铁自养反硝化速率达到最大值1.63mg/(L·h)的同时,DNRA的产氨量也达到最大值9.75mg/L.Visual MINTEQ模拟结果表明:EDTA-2Na与Fe(Ⅱ)的摩尔比会影响进水中EDTA-2Na与Fe(Ⅱ)的存在形态,物质的量比越大,FeEDTA^2-度越高,Fe...     

Policy implementation of the Republic Act (RA) No. 9003 in the Philippines: A case study of Cebu city

Municipal Solid Waste Management (MSWM) is considered to be one of the most serious environmental issues in the Philippines. The annual waste generation was estimated at 10.6 million tonnes in 2012 and this is expected to double in 2025. The Republic Act (RA) No. 9003, widely known as the Ecological Solid Waste Management Act of 2000, provides the required policy framework, institutional mechanisms and mandate to the Local Government Units (LGUs) to achieve 25% waste reduction target through establishing an integrated solid waste management plan based on the 3Rs (reduce, reuse and recycling). Although the initial impact of the LGUs is still very limited in implementing the national mandate, this article highlights the successful experiences of Cebu, the second largest city in the Philippines, in reducing its MSW generation by more than 30% in the past three years. This study also explores the implementation process, innovative actions taken by the Cebu City Government in implementing the national mandate at local level and identifies the factors that influence the policy implementation. The findings suggest that the impacts of the national mandate can be achieved if the LGUs have the high degree of political commitment, planning and development of effective local strategies in a collaborative manner to meet with local conditions, partnership building with other stakeholders, capacity development, adequate financing and incentives, and in the close monitoring and evaluation of performance.     

恐惧诉求对职业驾驶员安全驾驶态度和行为意向的影响

研究以EPPM模型作为理论框架,探讨恐惧诉求对危险驾驶行为(超速和不系安全带)态度和行为意向的作用。54名职业驾驶员在观看交通安全恐惧诉求录像后,完成安全驾驶行为问卷。回归分析表明恐惧诉求的交通事故录像能够改变驾驶员对超速及不系安全带驾驶的态度和行为意向,但作用不完全一致。恐惧情绪唤起通过恐惧情感所引发的威胁评估过程中介对不超速行为意向的影响。最后,对研究的局限和未来的研究进行讨论。     

Penicillin fermentation residue biochar as a high-performance electrode for membrane capacitive deionization

● We have provided an activated method to remove the toxicity of antibiotic residue. ● PFRB can greatly improve the salt adsorption capacity of MCDI. ● The hierarchical porous and abundant O/N-doped played the key role for the high-capacity desalination. ● A new field of reuse of penicillin fermentation residue has been developed. Membrane capacitive deionization (MCDI) is an efficient desalination technology for brine. Penicillin fermentation residue biochar (PFRB) possesses a hierarchical porous and O/N-doped structure which could serve as a high-capacity desalination electrode in the MCDI system. Under optimal conditions (electrode weight, voltage, and concentration) and a carbonization temperature of 700 °C, the maximum salt adsorption capacity of the electrode can reach 26.4 mg/g, which is higher than that of most carbon electrodes. Furthermore, the electrochemical properties of the PFRB electrode were characterized through cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) with a maximum specific capacitance of 212.18 F/g. Finally, biotoxicity tests have showed that PFRB was non-biotoxin against luminescent bacteria and the MCDI system with the PFRB electrode remained stable even after 27 adsorption–desorption cycles. This study provides a novel way to recycle penicillin residue and an electrode that can achieve excellent desalination.     

Using the land transformation model to forecast vacant land

Growing or shrinking cities can experience increases in vacant land. As urban populations and boundaries fluctuate, holes can open in once tight urban areas. Many cities chase growth-oriented approaches to dealing with vacancies. It is critical to understand land-use alteration to accurately predict transformations of physical change in order to make better informed decisions about this phenomenon. This research utilizes the land transformation model (LTM), an artificial neural networking mechanism in Geographic Information Systems, to forecast vacant land. Variable influence on vacant land prediction and accuracy of the LTM is assessed by comparing input factors and patterns, using time-series data from 1990 to 2010 in Fort Worth, Texas, USA. Results indicate that the LTM can be useful in simulating vacant land-use changes but more precise mechanisms are necessary to increase accuracy. This will allow for more proactive decisions to better regulate the process of urban decline and regeneration.     

Predicting occurrence of juvenile shark habitat to improve conservation planning

Fishing and habitat degradation have increased the extinction risk of sharks, and conservation strategies recognize that survival of juveniles is critical for the effective management of shark populations. Despite the rapid expansion of marine protected areas (MPAs) globally, the paucity of shark‐monitoring data on large scales (100s–1000s km) means that the effectiveness of MPAs in halting shark declines remains unclear. Using data collected by baited remote underwater video systems (BRUVS) in northwestern Australia, we developed generalized linear models to elucidate the ecological drivers of habitat suitability for juvenile sharks. We assessed occurrence patterns at the order and species levels. We included all juvenile sharks sampled and the 3 most abundant species sampled separately (grey reef [Carcharhinus amblyrhynchos], sandbar [Carcharhinus plumbeus], and whitetip reef sharks [Triaenodon obesus]). We predicted the occurrence of juvenile sharks across 490,515 km² of coastal waters and quantified the representation of highly suitable habitats within MPAs. Our species‐level models had higher accuracy (? ≥ 0.69) and deviance explained (≥48%) than our order‐level model (? = 0.36 and deviance explained of 10%). Maps of predicted occurrence revealed different species‐specific patterns of highly suitable habitat. These differences likely reflect different physiological or resource requirements between individual species and validate concerns over the utility of conservation targets based on aggregate species groups as opposed to a species‐focused approach. Highly suitable habitats were poorly represented in MPAs with the most restrictions on extractive activities. This spatial mismatch possibly indicates a lack of explicit conservation targets and information on species distribution during the planning process. Non‐extractive BRUVS provided a useful platform for building the suitability models across large scales to assist conservation planning across multiple maritime jurisdictions, and our approach provides a simple for method for testing the effectiveness of MPAs.     

Vertical migration of radionuclides in undisturbed grassland soils

Literature data on numerical values obtained for the parameters of the two most popular models for simulating the migration of radionuclides in undisturbed soils have been compiled and evaluated statistically. Due to restrictions on the applicability of compartmental models, the convection–dispersion equation and its parameter values should be preferred. For radiocaesium, recommended values are derived for its effective convection velocity and dispersion coefficient. Data deficiencies still exist for radionuclides other than caesium and for soils of non-temperate environments.     

Modelling plant species richness using functional groups

Conservation biologists increasingly rely on spatial predictive models of biodiversity to support decision-making. Therefore, highly accurate and ecologically meaningful models are required at relatively broad spatial scales. While statistical techniques have been optimized to improve model accuracy, less focus has been given to the question: How does the autecology of a single species affect model quality? We compare a direct modelling approach versus a cumulative modelling approach for predicting plant species richness, where the latter gives more weight to the ecology of functional species groups. In the direct modelling approach, species richness is predicted by a single model calibrated for all species. In the cumulative modelling approach, the species were partitioned into functional groups, with each group calibrated separately and species richness of each group was cumulated to predict total species richness. We hypothesized that model accuracy depends on the ecology of individual species and that the cumulative modelling approach would predict species richness more accurately. The predictors explained plant species richness by ca. 25%. However, depending on the functional group the deviance explained varied from 3 to 67%. While both modelling approaches performed equally well, the models of the different functional groups highly varied in their quality and their spatial richness pattern. This variability helps to improve our understanding on how plant functional groups respond to ecological gradients.     

A comparative assessment of waste incinerators in the UK

The uptake in Europe of Energy from Waste (EfW) incinerator plants has increased rapidly in recent years. In the UK, 25 municipal waste incinerators with energy recovery are now in operation; however, their waste supply chains and business practices vary significantly. With over a hundred more plant developments being considered it is important to establish best business practices for ensuring efficient environmental and operational performance. By reviewing the 25 plants we identify four suitable case study plants to compare technologies (moving grate, fluidised bed and rotary kiln), plant economics and operations. Using data collected from annual reports and through interviews and site visits we provide recommendations for improving the supply chain for waste incinerators and highlight the current issues and challenges faced by the industry. We find that plants using moving grate have a high availability of 87–92%. However, compared to the fluidised bed and rotary kiln, quantities of bottom ash and emissions of hydrogen chloride and carbon monoxide are high. The uptake of integrated recycling practices, combined heat and power, and post incineration non-ferrous metal collections needs to be increased among EfW incinerators in the UK. We conclude that one of the major difficulties encountered by waste facilities is the appropriate selection of technology, capacity, site, waste suppliers and heat consumers. This study will be of particular value to EfW plant developers, government authorities and researchers working within the sector of waste management.