A2O工艺好氧末段溶解氧变化对脱氮除磷影响

采用连续流A2O工艺处理实际的生活污水,研究好氧末段在不同溶解氧(DO)浓度条件下对污泥沉降性能、系统脱氮除磷的影响,同时考察了DO对污泥硝化活性、厌氧释磷速率和反硝化脱氮速率的影响.结果表明,随着末段溶解氧的提高,污泥容积指数SVI从140降至100左右,后又升高到120～170;系统的硝化效果提高,氨氮的去除率从6...     

pH、盐度对微生物还原硫酸盐的影响研究

采用厌氧生物处理工艺,研究了在不同盐度下pH连续降低对硫酸盐还原和有机物去除率的影响。实验结果表明,硫酸盐还原菌有很强的适应pH变化的能力,在pH值达到4以下仍有60％的硫酸盐去除率。NaCl浓度由4g／L增加到50g／L抑制了各厌氧菌的活性,导致硫酸盐和有机物去除率的下降,但硫酸盐还原菌耐受性高于产甲烷菌等其他厌氧菌,在NaCl浓度为50g／L下,硫酸盐去除率能达到50％,而有机物去除率则低于30％。qRT—PCR表明了系统菌落中SRB随着环境的变化情况与化学指标结果相一致,该反应器体系中SRB在整个厌氧菌群落中只占了很小部分。     

三元复合驱采出水中悬浮固体的控制方法

采用向三元复合驱采出水中加入水质稳定剂的方法有效降低采出水中悬浮固体的质量浓度。实验结果表明,将100 g采出水依次经滤纸和孔径为0.45μm的醋酸纤维素膜过滤后,加入1.0 g WSBL-3型水质稳定剂,混合均匀后置于80℃的水浴中静置4 h,取出后再置于40℃的水浴中静置5 min,由此可将采出水中的悬浮固体质量浓度由107 mg/L降至2 mg/L。     

微波消解-原子吸收光度法测定土壤中铜锌铅镉镍铬

用微波消解－原子吸收光度法测定土壤中铜，锌，铅，镉，镍和铬。通过硝酸－氢氟酸－过氧化氢体系消解液对土壤样品消解，选择出微波最佳消解条件。对硝酸－盐酸－过氧化氢体系消解液和硝酸－氢氟酸－过氧化氢体系消解液进行消解对比试验，发现前者不能将土壤样品完全消解，后者能将样品消解完全，但需将消解液中剩余的酸赶尽，否则测定结果将明显偏低。微波消解土壤与传统电热消解相比，操作简便快速，可提高工作效率。     

离子液体对废旧印刷线路板中铜、锌、铅的浸出规律

以离子液体1-丁基磺酸-3-甲基咪唑三氟甲烷磺酸盐([BSO_3HMIm]OTf)为浸出剂,初步研究了WPCBs浸铜过程中锌和铅浸出率的影响因素。实验结果表明:铜、锌的浸出率随着WPCBs粒径的减小、H_2O_2溶液加入量的增大而增大,铜的浸出率随浸出温度的升高先增大后减小,锌的浸出率受浸出温度影响不大;铅的浸出率受5种因素影响不大,且总体处于较低水平。在WPCBs粒径为0.100~0.250 mm、离子液体加入量为60.0%(φ)、H_2O_2溶液加入量为7.5%(φ)、固液比为1∶15、浸出温度为50℃的条件下,铜、锌、铅的浸出率分别为99.84%,93.25%,22.46%。     

A Two-Stage Particle Swarm Optimization Algorithm for MPPT of Partially Shaded PV Arrays

The power-voltage (P-V) characteristic curves of a PV array are nonlinear and have multiple peaks under partially shaded conditions (PSCs). This paper proposes a novel maximum power point tracking (MPPT) method for a PV system with reduced steady-state oscillation based on a two-stage particle swarm optimization (PSO) algorithm. The grouping method of the shuffled frog leaping algorithm (SFLA) is incorporated in the basic PSO algorithm (PSO-SFLA), ensuring fast and accurate searching of the global extremum. An adaptive speed factor is also introduced into the improved PSO to further enhance its convergence speed. Test results show that the proposed method converges in less than half the time taken by the conventional PSO method, and the power is improved by 33% under the worst PSCs, which confirms the superiority of the proposed method over the standard PSO algorithm in terms of tracking speed and steady-state oscillations under different PSCs.     

A comparison of pretreatments on release of sugars from sweet sorghum bagasse for bioethanol production

Dilute acid pretreatment and steam pretreatment were evaluated for maximum sugars release and ethanol production from sweet sorghum bagasse (SSB). The fermentation potential of the condensate and hydrolysate obtained from steam pretreatment (10 kg/cm², 10 minutes) and dilute acid hydrolysis (1% (w/w) sulphuric acid, 25% substrate loading) respectively, was checked with Pichia stipitis NCIM 3497 and Debaryomyces hansenii sp. Ethanol production and yield using acid hydrolysate was higher with Debaryomyces hansenii sp. (28.4 g/L and 0.37 g/g respectively) as compared with Pichia stipitis NCIM 3497 (21.9 g/L and 0.29 g/g respectively).     

羟基乙叉二膦酸镀铜废液的处理及Cu~(2+)的高附加值资源化回收

采用Na BH4还原法将羟基乙叉二膦酸(HEDP)镀铜废液中的Cu~(2+)制备成纳米铜粉,并采用聚丙烯酰胺(PAM)对还原反应后的废液进行絮凝处理。研究了n(Cu~(2+))∶n(Na BH4)、还原反应温度、还原反应时间及PAM添加量对废液中剩余Cu~(2+)质量浓度的影响,并对回收的纳米铜粉进行了XRD和TEM表征。实验结果表明:当n(Cu~(2+))∶n(Na BH4)=4∶6、还原反应温度为50℃、还原反应时间为2 h时,废液中剩余Cu~(2+)质量浓度降低至1.1 mg/L,Cu~(2+)还原率达99.99%;可获得粒径为20~45 nm的近球型、高纯度、由多晶组成的纳米铜粉;当PAM添加量为10 mg/L时,废液中剩余Cu~(2+)质量浓度降至0.35 mg/L以下,达到GB 21900—2008《电镀污染物排放标准》(小于0.5 mg/L)的要求。     

金属冶炼进口物料的固体废物鉴别方法

建立了金属冶炼进口物料的固体废物鉴别方法,并利用该方法对海关查扣的3种金属冶炼进口物料进行了固体废物鉴别。鉴别结果显示:物料1、2和3的自然属性分别为砷含量超标铜精矿、锰阳极泥、回转窑氧化锌,产生来源分别为有害物质超标的产品、污染控制设施产生的物质、有意识加工的目标产物;物料1和2属于我国禁止进口的固体废物,物料3不属于固体废物。本文建立的固体废物鉴别方法可行,可为金属冶炼进口物料的固体废物鉴别和监管提供参考。     

Detection of DDT and its metabolites in two estuaries of South China using a SPME-based device: First report of p,p′-DDMU in water column

A solid-phase microextration-based sampling method was employed to determine the concentrations of 1,1,1-trichloro-2,2-bis(p-chlorophenyl)ethane (DDT) and its metabolites, 1,1-dichloro-2,2-bis(p-chlorophenyl)ethane (DDD), 1,1-dichloro-2,2-bis(p-chlorophenyl)ethene (DDE) and 1-chloro-2,2-bis(p-chlorophenyl)ethene (DDMU), in two estuarine bays, Daya Bay and Hailing Bay, of South China. Six DDT components including p,p′-DDT, o,p′-DDD, p,p′-DDD, o,p′-DDE, p,p′-DDE, and p,p′-DDMU were detected in Hailing Bay, while only p,p′-DDD was found in Daya Bay. p,p′-DDD was the most abundant DDT component in both bays, sharply different from the previous finding in the water column of the Palos Verdes Shelf, California, USA that p,p′-DDE was prevalent. In addition, the occurrence of p,p′-DDMU (with a range of 0.047-0.21 ng/L in Hailing Bay) has not been reported around the globe, and its presence in our study region appeared to stem from dehydrochlorination of p,p′-DDD, favored under aerobic conditions, but further investigations are clearly needed to confirm the mechanism for generation of DDMU in estuarine environments.