7B04铝合金和30CrMnSiA钢短期腐蚀的电化学行为研究

目的研究7B04铝合金和30CrMnSiA合金钢试样的电化学性能。方法采用电化学实验、扫描电子显微镜(SEM)、腐蚀坑深度测试分别对7B04铝合金和30CrMnSiA合金钢试样在是否经过天然海水浸泡的情况下进行测试分析,得到微观腐蚀形貌和腐蚀坑深度以及试样表面不带锈和带锈时的电化学性能。结果随着Na Cl浓度增大,7B04铝合金和30CrMnSiA钢的自腐蚀电流变大,两者之间存在明显的电位差,接触后会发生电偶腐蚀。电偶电流与阴阳极面积比和Na Cl浓度有关,阴阳极面积比增大或Na Cl浓度升高均会导致电偶效应增强。经过海水短期浸泡后,7B04铝合金表面的锈层不仅没有起到抑制腐蚀的作用,反而使自腐蚀加重,但电偶效应确实有所减弱。结论沿海设备在使用过程中应竭力避免铝合金在锈层下工作。     

厦门市气候特征变化与酸雨形成研究

对地面风场的研究表明,厦门存在局地和海陆风环流,自1955年以来年平均风速、混合层厚度均呈现下降趋势,大气污染物的水平和垂直扩散能力也呈下降趋势。降水酸度随海拔高度的变化情况表明,海陆风环流有利于酸性污染物的积累,且锋面降水过程中的光化学污染加重了降水的酸化程度。     

倾斜岩层大断面隧道塌方机制的数值模拟*

塌方是隧道施工中出现的主要安全事故,研究隧道塌方产生的机制对于保证隧道施工安全具有重要意义。以穿越倾斜岩层段某隧道塌方事故为工程背景,基于围岩的工程力学特性,采用数值分析和现场监测方法研究隧道塌方的力学机制。结果表明:在开挖爆破振动荷载作用下,隧道断面拱部左侧节理岩层极易出现超挖,隧道左侧拱腰处的塑性区显著大于右侧,使左侧拱腰处内侧出现拉应力;左侧拱腰处围岩压力显著大于右侧,造成支护结构的受力不均,初支喷层极易开裂,随着松动区范围逐渐增大,围岩压力逐渐增大,隧道变形迅速增大,极易造成围岩失稳而导致隧道坍塌。     

An Experimental Methodology for Monitoring Contaminant Transport Through Geotechnical Centrifuge Models

In this paper, an attempt has been made to highlight an experimental methodology for monitoring contaminant transport through locally available silty soil and commercially available clay in geotechnical centrifuge models, for different compaction states. Use of multiple depth sensors to determine depth distribution of sodium chloride in the soil column has been detailed. The obtained results have been compared with argentometric method. To validate the centrifuge modelling, modelling of models has been used. The test setup developed can simulate contaminant transport mechanisms through the soil mass, which is approximately 10 m deep, over a period of 600 days. R _e and P _e are found to be N times higher in the centrifuge models. These numbers are found to be several orders less than unity. This indicates that laminar flow prevails and the dominating Cl⁻ transport mechanism in centrifuge is diffusion. The study also highlights the fact that the geotechnical centrifuge modelling can be used as a viable alternative to field scale experimentation.     

Sudden high concentration of TSP affected by atmospheric boundary layer in Seoul metropolitan area during duststorm period

Hourly concentrations of TSP, PM(10), PM(2.5) near the surface at Seoul city were examined from March 20 to March 25, 2001 (duststorm event) in order to investigate the effect of a duststorm generated in China on the local aerosol concentration in Korea, The ratios of fine to coarse particles such as TSP to PM(10), TSP to PM(2.5) and PM(10)-PM(2.5) to PM(2.5) showed that a great amount of dust transported from the origin of the duststorm was remarkable with a maximum ratio of 9.77 between TSP and PM(2.5). Back trajectories every 6 h showed the movement of dust particles in the lower atmosphere near 500 m to 1500 m (atmospheric boundary layer), which implied transport from Baotou in inner Mongolia of northern China to the direction of Seoul city in Korea and then the back trajectories passed near the southern border of Mongolia and Baotou through Zengzhou in the midlevels (3000 m) and low levels (500 m) of China, finally reaching Seoul city. So, the TSP concentration at Seoul city was partially influenced by the duststorm, under the prevailing westerly wind and the transported aerosols could influence high concentrations of pollutants of TSP, PM(10) and PM(2.5) in Seoul. The sudden high concentrations of TSP and PM(10) were found for a few hours, especially at 1500 to 1800 LST, March 22. At 1200 LST, before the passage of a cold front through the Korean peninsula, the convective boundary layer (CBL) near Seoul was not shallow, but at 1500 LST, under the frontal passage, the CBL was remarkably thinner (less than 300 m), due to the compression of the boundary layer by the intrusion of cold air. This resulted in the increase of the TSP concentration, even though the mixed layer above maintained almost the same depth. At 1800 LST shortly after the frontal passage, that is, near sunset, the nocturnal cooling of the ground caused air parcels to cool, thereby enhancing the shallower nocturnal surface inversion layer and producing the maximum concentration of TSP of 1388 microg/m(3) near Seoul city.     

佛山地区干季边界层垂直风温结构对空气质量的影响

利用佛山地区2013年12月大气边界层观测试验得到的垂直风温资料和相应逐日AQI资料、逐时PM_(2.5)浓度资料,研究了佛山地区大气边界层垂直风温结构对空气质量的影响.结果表明:佛山地区干季持续存在的逆温结构是导致PM_(2.5)污染较重的重要原因.干季污染日近60%的最低逆温层高度低于1000 m,而非污染日低于1000 m的最低逆温层仅占36%,污染日佛山贴地逆温频率高达31.2%.逆温层出现高度较低,将污染物压缩积累在贴地层大气中导致污染较重.在大陆冷高压控制下,佛山地区的边界层结构演化非常典型,最大边界层高度和最大边界层通风量表现出了显著相关,污染日日平均边界层高度始终维持在较低的水平,多数时候不足500 m,最大边界层高度则大部分小于1000 m,日平均边界层通风量主要分布在500~1500 m~2·s~(-1)之间,在极端情况下甚至不足300 m~2·s~(-1),最大边界层通风量大部分处于1500~5000 m~2·s~(-1)之间,导致污染物始终聚集在较低的大气边界层内,使得PM_(2.5)浓度长时间维持在较高的污染水平.佛山地区风场存在显著的3层结构,较小的底层风速意味着大气的输送和扩散能力较弱,高度较低的中层使得污染物进一步被压缩累积在大气底层,垂直风场的不稳定性使得污染日佛山地区局地回流活跃,回流(RF)指数极小值多分布在0.2~0.4之间,污染日RF指数普遍小于非污染日,垂直风场的有效输送能力被显著削弱.     

武汉市一次污染过程的局地流场和边界层结构的数值模拟

利用2013年11月武汉市逐日空气质量资料、地面气象观测资料、NCEP/NCAR再分析资料和L波段雷达探空资料,通过WRF模式模拟空气污染生消过程中的局地气象条件变化,探讨特殊地形条件下边界层结构变化和局地环流在污染物生消过程中的作用和影响。结果表明：（1）武汉地区当背景环流场强的时候,由地形引起的局地流场对污染物扩散的影响就弱,反之当背景环流场弱的时候, 地形对流场影响明显:夜间为山风,白天为谷风。夜间山风与偏西北气流及偏东气流在武汉及周边地区辐合,形成气流汇聚带,在武汉地区形成一个反复污染带,即由地形引起的局地流场对污染物扩散的贡献就大;（2）武汉地区发生空气污染时,地面湿度较高,边界层呈上干下湿状态,其特征为暖而干且有偏东小风,这导致污染物不断堆积和重污染过程的形成。     

钢铁企业工作场所煤气泄漏扩散规律的研究

以钢铁企业管网煤气泄漏为研究对象,以煤气泄漏扩散规律为研究主题,在确定煤气泄漏相似于浮力射流的基础上,建立煤气泄漏扩散的数学模型.采用CFD软件PHOENICS数值模拟气体泄漏过程的速度场及其浓度分布.在已有煤气泄漏检测系统的基础上,选择性实验模拟煤气泄漏浓度与扩散时间、扩散方向的变化.数值模拟和实验模拟表明,虽然两种方法所得结果存在一定差异,从定性分析角度而言,却能够反映工作场所煤气泄漏后在有限空间内运移扩散的一般规律.     

洞庭湖钉螺扩散与水情变化规律

洞庭湖区是目前我国钉螺分布范围最广且血吸虫病疫情最难防治的疫区。为揭示近年来洞庭湖区钉螺扩散与疫区水情变化的关系,从洪水对钉螺扩散及其孳生地环境淹没时间影响考虑,提出了表征疫区钉螺扩散及孳生地变化的水情指标,选用最能综合反映洪水年水情变化的汛期平均水位作为疫区水情变化的表征指标,并以洞庭湖为例定量分析了洞庭湖区钉螺扩散与以城陵矶站汛期平均水位为指示性指标的疫区水情的相关关系。其结果显示洞庭湖区钉螺面积与湖区汛期平均水位线性相关性显著,其相关关系式为y＝0.107 2x+14382(r=0822,p<005),其中y为洞庭湖区钉螺分布面积,x为城陵矶站汛期平均水位。     

基于技术扩散的全社会能源效率空间条件收敛分析

我国各地区能源效率存在明显的差距,如何缩小地区能源效率差距成为了能源经济领域的热点问题.本文依据2000-2010年中国30省面板数据,运用空间误差条件β收敛模型分析了技术扩散对全社会能源效率收敛的影响,研究结果表明:①2000-2010年间,全社会能源效率呈现2000-2002、2002-2005和2005-2010的三阶段特征,经历上升、下降、再上升的变化过程,其中,2005-2010年提升速度最快,其经验值得借鉴;②全社会能源效率的绝对β收敛呈现由收敛至发散的三阶段变化过程;③全社会能源效率存在显著的空间滞后现象,其增长率的空间相依性不显著,但空间因素对全社会能源效率β收敛的正面影响有加强的趋势;④技术扩散从总体上使全社会能源效率的收敛速度提高1.8倍以上,且影响程度逐渐增强;⑤外商直接投资有助于提升全社会能源效率及其收敛速度;⑥不同时段的技术扩散对全社会能源效率的影响不同,且技术引进和国内技术市场技术流入对收敛的作用不显著.因此,引进外资是缩小地区间全社会能源效率差距的重要措施.