隧道排污量估算与治污效果预测

通过隧道排污量和排污效果的简单分析，指出了其排污治理过程中应注意的有关事项，如进 行人口控制，改善居民的生活方式，提高环境保护意识和治理技术等，所述分析方法可供其它类似 工程参考。     

榆神矿区矿井水零排放可行性分析

针对榆神矿区给排水现状，分析矿区给排水关系和矿井水的利用途径，并提出矿井水零排放的技术、管理对策，达到减少新水索取，实现零排放。     

Radon exhalation from building materials for decorative use

Long-term exposure to radon increases the risk of developing lung cancer. There is considerable public concern about radon exhalation from building materials and the contribution to indoor radon levels. To address this concern, radon exhalation rates were determined for 53 different samples of drywall, tile and granite available on the Canadian market for interior home decoration. The radon exhalation rates ranged from non-detectable to 312 Bq m⁻² d⁻¹. Slate tiles and granite slabs had relatively higher radon exhalation rates than other decorative materials, such as ceramic or porcelain tiles. The average radon exhalation rates were 30 Bq m⁻² d⁻¹ for slate tiles and 42 Bq m⁻² d⁻¹ for granite slabs of various types and origins. Analysis showed that even if an entire floor was covered with a material having a radon exhalation rate of 300 Bq m⁻² d⁻¹, it would contribute only 18 Bq m⁻³ to a tightly sealed house with an air exchange rate of 0.3 per hour. Generally speaking, building materials used in home decoration make no significant contribution to indoor radon for a house with adequate air exchange.     

Toluene decomposition performance and NOx by-product formation during a DBD-catalyst process

Characteristics of toluene decomposition and formation of nitrogen oxide (NOx) by-products were investigated in a dielectric barrier discharge (DBD) reactor with/without catalyst at room temperature and atmospheric pressure. Four kinds of metal oxides, i.e., manganese oxide (MnOx), iron oxide (FeOx), cobalt oxide (CoOx) and copper oxide (CuO), supported on Al₂O₃/nickel foam, were used as catalysts. It was found that introducing catalysts could improve toluene removal efficiency, promote decomposition of by-product ozone and enhance CO₂ selectivity. In addition, NOx was suppressed with the decrease of specific energy density (SED) and the increase of humidity, gas flow rate and toluene concentration, or catalyst introduction. Among the four kinds of catalysts, the CuO catalyst showed the best performance in NOx suppression. The MnOx catalyst exhibited the lowest concentration of O₃ and highest CO₂ selectivity but the highest concentration of NOx. A possible pathway for NOx production in DBD was discussed. The contributions of oxygen active species and hydroxyl radicals are dominant in NOx suppression.     

Adsorption behavior of ammonium by a bioadsorbent - Boston ivy leaf powder

The adsorption behaviors of ammonium ions from aqueous solution by a novel bioadsorbent,the Boston ivy (Parthenocissus tricuspidata) leaf powder (BPTL) were investigated.The SEM images and FT-IR spectra were used to characterize BPTL.The mathematical models were used to analyze the adsorption kinetics and isotherms.The optimum pH range for ammonium adsorption by BPTL was found to be 5-10.The adsorption reached equilibrium at 14 hr,and the kinetic data were well fitted by the Logistic model.The intraparticle diffusion was the main rate-controlling step of the adsorption process.The high temperature was favorableto the ammonium adsorption by BPTL,indicating that the adsorption was endothermic.The adsorption equilibrium fitted well to both the Langrnuir model and Freundlich model,and the maximum monolayer adsorption capacities calculated from Langmuir model were 3.37,5.28 and 6.59 mg N/g at 15,25 and 35℃,respectively,which were comparable to those by reported minerals.Both the separation factor (RL) from the Langmuir model and Freundlich exponent (n) suggested that the ammonium adsorption by BPTL was favorable.Therefore,the Boston ivy leaf powder could be considered a novel bioadsorbent for ammonium removal from aqueous solution.     

聚丙烯基高分子功能材料吸附卷烟烟气中多种有害成分的应用

为了寻找能同时降低卷烟烟气中甲醛、乙醛、巴豆醛和颗粒物有害成分含量的离子交换树脂吸附材料,采用电镜扫描方法观察聚丙烯基阳离子树脂高分子功能材料的表面特征,应用压汞法分析其平均孔径、中值孔径、比孔容和比表面积,并测试了该材料的交换容量,采用环境试验舱检测法对比测试了该材料和活性炭降低卷烟烟气中甲醛、乙醛、巴豆醛和颗粒物有害成分含量的效果.结果表明,聚丙烯基高分子功能材料表面多斑点状突起,凹凸状明显,微孔和缝隙多,平均孔径为0.26 μm,中值孔径为149.3 μm,比孔容为19.23 cm3/g,比表面积为293.42 m2/g,交换容量为5.16 mmol/g,对烟气中甲醛、乙醛、巴豆醛和颗粒物的净化率分别达到79.6％、79.8％、82.8％和64.7％,而活性炭的净化率分别为20.3％、0、6.4％和54.2％.研究表明,该聚丙烯基高分子功能材料具有物理吸附和化学吸附性能,净化卷烟烟气中多种有害成分的效果明显优于活性炭.     

Spatial allocation of material flow analysis in residential developments: a case study of Kildare County,Ireland

Studies of urban metabolism provide important insights for environmental management of cities, but are not widely used in planning practice due to a mismatch of data scale and coverage. This paper introduces the Spatial Allocation of Material Flow Analysis (SAMFA) model as a potential decision support tool aimed as a contribution to overcome some of these difficulties and describes its pilot use at the county level in the Republic of Ireland. The results suggest that SAMFA is capable of identifying hotspots of higher material and energy use to support targeted planning initiatives, while its ability to visualise different policy scenarios supports more effective multi-stakeholder engagement. The paper evaluates this pilot use and sets out how this model can act as an analytical platform for the industrial ecology–spatial planning nexus.     

危险品运输网络优化设计研究综述

为分析当今反恐新形势下的危险品运输网络优化设计问题的研究现状,系统总结国内外关于一般场景和恐怖袭击威胁2种情况下危险品运输网络优化设计研究的主要模型和方法,梳理两者现有的研究内容,并讨论其共性及恐怖袭击威胁情景下的研究的新特点。结果发现:目前关于解决危险品运输网络优化设计问题模型的鲁棒性研究较为缺乏,尤其是模型在更为复杂和不确定性更强的恐怖袭击情景中适用性不强;危险品运输的鲁棒优化模型即使在突发事件条件下,也可以使决策者能够作出相对满意的决策;鲁棒性危险品运输网络能够规避风险扰动,可用来防止在恐怖袭击中因危险品车辆爆炸等造成更大的危害。     

Preparation of steel slag porous sound-absorbing material using coal powder as pore former

The aim of the study was to prepare a porous sound-absorbing material using steel slag and fly ash as the main raw material, with coal powder and sodium silicate used as a pore former and binder respectively. The influence of the experimental conditions such as the ratio of fly ash, sintering temperature, sintering time, and porosity regulation on the performance of the porous sound-absorbing material was investigated. The results showed that the specimens prepared by this method had high sound absorption performance and good mechanical properties, and the noise reduction coefficient and compressive strength could reach 0.50 and 6.5 MPa, respectively. The compressive strength increased when the dosage of fly ash and sintering temperature were raised. The noise reduction coefficient decreased with increasing ratio of fly ash and reducing pore former, and first increased and then decreased with the increase of sintering temperature and time. The optimum preparation conditions for the porous sound-absorbing material were a proportion of fly ash of 50% (wt.%), percentage of coal powder of 30% (wt.%), sintering temperature of 1130°C, and sintering time of 6.0 hr, which were determined by analyzing the properties of the sound-absorbing material.     

关于焦化行业CO2排放核算方法的探讨

本文分析了适用于焦化行业通用CO₂排放核算方法,在此基础上结合我国焦化行业工艺和原料的特征,采用排放因子法和物料衡算法等两种方法对10家典型焦化企业CO₂排放进行核算。结果表明:物料衡算法能很好地反映不同类型焦化企业的排放特征;排放因子法对我国独立焦化企业存在碳排放量系统性高估的可能。为此,建议我国焦化企业可借鉴德国焦化企业的碳核算经验,采用碳平衡法对不同类型的焦化企业(单元)的碳排放量进行核算,并完善相关的统计和监测技术。